• Journal of the Korean Applied Science and Technology
• /
• v.25 no.3
• /
• pp.275-281
• /
• 2008

The esterification of free fatty acid in Jatropha oil added by propylene glycol using p-TSA catalyst was done, and then the transesterification of Jatropha oil added by 1.0vol% GMS as an emulsifier using TMAH, and mixed catalyst(60wt%-TMAH+ 40wt%-KOH) respectively was followed at $60^{\circ}C$. The esterification conversion at the 1:8 molar ratio of free fatty acid to methanol using 8.0wt% p-TSA was 94.7% within 60min. The overall conversion at the 1:8 molar ratio of Jatropha oil to methanol and $60^{\circ}C$ using mixed catalyst was 95.4%. The kinematic viscosity of Biodiesel using TMAH and mixed catalyst in 24h met the ASTM D-6751 above $30^{\circ}C$, and showed a little more than its criterion.

• International Journal of Fluid Machinery and Systems
• /
• v.4 no.1
• /
• pp.172-178
• /
• 2011

This paper presents an optimization procedure for high-efficiency design of a mixed-flow pump. Optimization techniques based on a weighted-average surrogate model are used to optimize a vane diffuser of a mixed-flow pump. Validation of the numerical results is performed through experimental data for head, power and efficiency. Three-level full factorial design is used to generate nine design points within the design space. Three-dimensional Reynoldsaveraged Navier-Stokes equations with the shear stress transport turbulence model are discretized by using finite volume approximation and solved on hexahedral grids to evaluate the efficiency as the objective function. In order to reduce pressure loss in the vane diffuser, two variables defining the straight vane length ratio and the diffusion area ratio are selected as design variables in the present optimization. As the results of the design optimization, the efficiency at the design flow coefficient is improved by 7.05% and the off-design efficiencies are also improved in comparison with the reference design.

• Computers and Concrete
• /
• v.21 no.2
• /
• pp.139-147
• /
• 2018

Due to enhanced construction requirement, ready mixed concrete are being popular day by day. The current study aimed to develop ready mixed concrete using GBFS contained cement and determine its properties of fresh and hardened states. A real scale experiment was set up in a ready mixed plant for measuring workability and compressive strength. The workability was tested after mixing (within 5 minutes), 30, 60, 90, 120 and 150 minutes of the running of bulk carrier. The ready mixed carrier employed spinning motion i.e., rotating around its axis with 20 RPM and running on road with 1km/h speed. The mixing ratio of cement: sand:gravel, water to cement ratio, super plasticizer were, 1:1.73:2.47, 0.40 and 6% of cement, respectively. The chemical composition of raw material was determined using XRF and the properties of cements were measured according to ASTM standards. The experimental results confirm that the cement with composition of 6.89% of GBFS, 4% of Gypsum and 89.11% of clinker showed the good compressive strength and workability of concrete after 150 minutes of the spinning motion in bulk carrier.

• Textile Coloration and Finishing
• /
• v.21 no.1
• /
• pp.21-29
• /
• 2009

In order to enhance the functionality of a cotton fabric actually used as a clothing material for patients, the fabrics were treated with a chitosan/nanosilver mixed solution. The nanosilver had excellent biocompatibility, provided expectation of an additional performance, did not harm human beings, and supplements chitosan, which was disadvantaged if used alone for fabric treatment. The nanosilver was mixed thereto and a treatment effect due to a mixing ratio was considered. This study was observed through mechanical properties and hand value which were the important function. The treatment of chitosan/nanosilver mixed solution gave a smoother surface than the treatment of chitosan alone. As a result of evaluation of the forms according to KES-FB system, Koshi was deduced, and both Numeri and Fukurami were increased. Thereby, the cotton fabric was a little smooth to provide elasticity, due to the treatment of chitosan/nanosilver mixed solution. THV of the treated fabrics calculated from this basis increased at all mixing ratio as compared with the untreated fabric. The fabrics treated with chitosan/nanosilver mixed solution were shown a better THV than the fabric treated with chitosan alone.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.1
• /
• pp.61-69
• /
• 2015

The objective of this study is to experimentally investigate the mixed flow behaviors and oxygen transfer characteristics of a vertical orifice ejector. The experimental apparatus consisted of an electric motor-pump, an orifice ejector, a circulation water tank, an air compressor, a high speed camera unit and control or measurement accessories. The mass ratio was calculated using the measured primary flow rate and suction air flow rate with experimental parameters. The visualization images of vertically injected mixed jet issuing from the orifice ejector were qualitatively analyzed. The volumetric oxygen transfer coefficient was calculated using the measured dissolved oxygen concentration. At a constant primary flow rate, the mass ratio and oxygen transfer coefficient increase with the air pressure of compressor. At a constant air pressure of the compressor, the mass ratio decreases and the oxygen transfer coefficient increases as the primary flow rate increases. The residence time and dispersion of fine air bubbles and the penetration of mixed flow were found to be important parameters for the oxygen transfer rate owing to the contact area and time of two phases.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.12 no.1
• /
• pp.177-186
• /
• 1992

In this study, the proper mixing ratio of fly ash to bottom ash is evaluated and bearing capacity of this mixed ash is examined for use of highway embankment and subgrade materials in large quantities. Independently of the mixing ratio of fly ash to bottom ash or the method of compaction test, maximum dry density ${\gamma}_{dmax}$ and CBR value of anthracite mixed coal ash is greater than that of bituminous mixed coal ash. The mixed ashes to contain more fly ash than that of which the ratio of fly ash to bottom ash is 8 : 2, are slaked readily when the water contents of compaction are greater than optimum moisture content O.M.C. The proper mixing ratios of fly ash to bottom ash are about 5 : 5 to 6 : 4. Coal ashes mixed with these ratios exhibit proper physical and geotechnical properties for use of highway embankment and subgrade materials, and enable coal ashes to be used in large quantities.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.9
• /
• pp.847-854
• /
• 2013

The objective of this study is to experimentally investigate the mixed flow and oxygen transfer characteristics of a horizontally injected aeration process using an annular nozzle ejector. The flow rate ratio, pressure ratio and ejector efficiency are calculated using the measured flow rate and pressure with the experimental parameters of the ejector pitch and primary flow rate. The visualization images of mixed flow issuing from the ejector are analyzed qualitatively, and the volumetric oxygen transfer coefficients are calculated using the measured dissolved oxygen concentration. The mixed flow behaves like a buoyancy jet or horizontal jet owing to the momentum of primary flow and air bubble size. The buoyancy force of the air bubble and the penetration of mixed flow are found to be important parameters for the oxygen transfer rate owing to the contact area and time of two phases.

• Journal of the Korean Applied Science and Technology
• /
• v.26 no.4
• /
• pp.394-399
• /
• 2009

The esterification of palmitic acid in Jatropha Oil using 8wt% p-TSA catalyst was done at the 1:8 molar ratio of oil to methanol and $65^{\circ}C$. The conversion of palmitic acid appeared to be 95.3% in 60min. After that, the continuous transesterification of the oil using 0.5wt% KOH, 0.8wt% TMAH mixed catalyst[40vol% KOH(0.5wt%) + 60vol% TMAH(0.8wt%)] and 1.1wt% TMAH was conducted with the flow rates and the molar ratios at $65^{\circ}C$. The overall conversion of Jatropha Oil increased with the decrease of flow rate and showed 95.6% with 9ml/min of flow rate at the 1:8 molar ratio of oil to methanol and $65^{\circ}C$. But it showed 87% with 15ml/min of flow rate at the same conditions. The recovery of methanol(%) appeared to be 86% at the 1:8 molar ratio of oil to methanol, mixed catalyst and $65^{\circ}C$.

• Journal of the Korean Statistical Society
• /
• v.19 no.2
• /
• pp.171-175
• /
• 1990

A diagnostic test for detecting nonconstant variance in mixed linear models based on the score statistic is derived through the technique of model expansion, and compared to the log likelihood ratio test.

• Korean Journal of Poultry Science
• /
• v.47 no.1
• /
• pp.29-37
• /
• 2020

This study was performed to investigate the effect of mixed rearing of male and female chickens on the stress response in Korean native chickens. To identify the degree of the stress response, heterophil-lymphocyte ratio (H/L ratio), heat shock protein genes (HSPs) expression, and intracellular nuclear DNA damage rate were analyzed before and after the mixed rearing of male and female chickens. The results showed that the H/L ratio of chickens after mixing males and females was more than thrice as higher than before mixing (P<0.001), but the differences between males and females were not significant. HSP-70, HSP90-α, and HSP90-β expression levels were 2.5 to 3.4 times higher after mixing male and female chickens, compared to before mixing (P<0.01). In the mixed rearing of male and female chickens, the increase in HSPs expression in females was higher than in males. Comet indicators in intracellular DNA damage rate analysis showed a significant increase after mixing male and female chickens compared to before mixing (P<0.001). However, there was no significant difference between males and females with respect to DNA damage rate. Taken together, these results suggest that male and female mixed rearing acts as a strong external stressor in both male and female chickens.