• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.719-724
• /
• 2001

The objective of this investigation was to separate silicon and silica for recycling by the liquid-liquid separation technique. In the preparation of silicon (Si) single crystal, a small amount of silicon is fixed on the surface of silica (quartz, $SiO_2$) crucible. The used crucible is crushed for recycling both silicon and silica in a high purity from the mixed powder. Zeta-potential of silicon and silica are almost the same at pH higher than 3. Their separation by simple flotation is ruled out. However, their hydrophobic characteristics are different in several different organic solvent from the measurement of contact angle. Therefore, the liquid-liquid extraction is employed to separate silicon and silica. The result indicates that the organic solvent mixed with dodecyl ammonium acetate could extracted the silicon powder at high purity (97-100%) with high recovery from the silica powder in the water phase.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.3
• /
• pp.825-827
• /
• 2012

In this study, the variation in surface morphology of copper phthalocyanine (CuPc) thin films treated with a flow of acetone vapor assisted by nitrogen carrier gas was investigated. The CuPc nanorods with similar dimensions were well dispersed throughout the whole film surfaces after ~20 min. of treatment. However, the electronic absorption spectra only changed slightly, which indicates that molecular stacking was not altered during treatment. This treating method is simple and more advantageous compared to other solvent treating technologies such as mixed solvent spray treatment using organic solvents and water since it requires relatively mild treating conditions and does not need the presence of water.

• Proceedings of the Membrane Society of Korea Conference
• /
• 2004.05a
• /
• pp.82-85
• /
• 2004

Microinterface of W/Omicroemulsion prepared by phosphatidylcholine was used as reaction media of hydrolysis of phosphatidylcholine by phospholipaseA$_2$. Phosphatidylcholine was used as an amphiphile and was acted as a substrate. Organic phase of W/Omicroemulsion in this study was prepared by mixed organic solvents i.e. 2,2,4-trimethylpentane (isooctane) as a main solvent and 1-butanol as a co-solvent. The effect of added 1-butanol was remarkable not only on reaction beginning but also on high reaction rate. The hydrolysis reaction was dramatically initiated when 1-butanol was injected into the running isooctane/PC system. The enhancement by 1-butanol addition into single organic solvent was our original finding compare with previous conventional organic solvent. The reaction rate was elevated by the added amount of 1-butanol. The enhanced reaction rate was about 150-folds. This enhancement was speculated as 1-butanol adsorption on the microinterface. The adsorbed 1-butanol improved the properties of microinterface, especially its mobility was increased by difference of the chain length between phosphatidylcholine and 1-butanol. PhospholipaseA$_2$ molecules were located on the microinterface due to modified mobility of microinterface. Located phospholipaseA$_2$ on the microinterface reacted easily with phosphatidylcholine molecule. As a result high reaction rate was obtained. Microinterfacial properties were successfully improved by adsorbed 1-butanol molecule, and were favorable to appear higher reactivity of phospholipaseA$_2$.

• Applied Chemistry for Engineering
• /
• v.10 no.6
• /
• pp.822-827
• /
• 1999

The specific capacitance characteristics which were of the electric double layer capacitors(ELDC) made of phenol based activated carbon fiber(ACF) electrodes and organic electrolytes has been investigated with respect to different specific surface area of electrodes and different kinds of organic electrolytes. Throughout charge-discharge cell tests, it has been found that larger surface area and larger pore diameter of electrodes contribute to increase the specific capacitance. Binary mixture of organic solvent with propylene cabonate(PC) and tetrahydrofuran(THF) for 1 M-$LiClO_4$ electrolyte has a higher specific capacitance than single solvent of PC or mixed solvent with PC and diethyl cabonate(DEC). Also, even though 1 M-tetraethylamonium perchlorate(TEAPC) of organic electrolyte shows higher specific capacitance, it has longer charge time because of its lower ion mobility.

• Journal of environmental and Sanitary engineering
• /
• v.13 no.3
• /
• pp.66-71
• /
• 1998

This study was investigated to evaluate worker exposures to organic solvents by type of print industry. Results were as follows; 1. Workers were exposed to mixture of toluene, isopropyl alcohol(IPA), methyl ethyl ketone(MEK), n-hexane, ethylacetate(EA), acetone. The components of high exposure solvents were toluene, IPA and MEK. 2. Considering additive effects of the compounds, exposure indices(Em) were calculated. The Mean of exposure indices were 1.79 for Gravere, 0.41 for Screen and 0.14 for Opset workplace. The workers of Gravere workplace were estimated to overexpose for solvents. 3. The highest overexposed solvent was toluene for a single component. The rate of overexposed level for toluene was 7.41% for some print workplace and for mixed solvent was 1.85％. 4. Local exhaust systems were inappropriate and respiratory protective devices were not supplied to the workers. 5. Sound level was over 90dB(A) in Opset print workplace and some measures should be performed to get down the sound level.

• Journal of the Korean Ceramic Society
• /
• v.32 no.2
• /
• pp.217-226
• /
• 1995

Alumina powders were dispersed using crosslinkable organic molecules by electrosteric stabilization and then consolidated by crosslinking of organic molecules. The effect of processing variables such as the physicochemical properties of both solvent media and organic molecules, the proportions of mixed organic media, etc. were studied. FT-IR was used todeduce the mechanism of organic molecules adsorption on the alumina particle surfaces. The adsorption characteristics and the electrokinetic behavior of alumina suspensions were correlated with the stability of particle in alumina suspension using rheological measurements. The green body of alumina consolidated by the chemical crosslinking of the adsorbed organic molecules after the alumina suspension had been stabilized was tough enough for green machining and the sintered alumina fabricated by this proposed process also showed a high bending strength and a homogeneous microstructure.

• Analytical Science and Technology
• /
• v.6 no.5
• /
• pp.453-462
• /
• 1993

The retention behaviors of polystyrenes influenced by mixed solvents are examined in thermal field-flow fractionation(ThFFF). Experimental data are obtained with polystyrene samples of molecular weights of 35,000, 110,000, 200,000 and 470,000 dissolved in organic solvents. The pure and mixed solvents are tetrahydrofuran(THF), chloroform(CHL), cyclohexane(CH), and benzene(BZ), respectively. The values of retention ratio(R) and thermal diffusion coefficient($D_T$) are measured with change of molecular weight and composition of mixed solvents. Atempts are then made to correlate the measured values with various physicochemical parameters of polymers and solvents. Studies suggest that R is significantly increased with the density of solvent and a good correlation is found between them. $D_T$ values decreases in the mixed solvent having has a higher concentration of poor solvent.

• Journal of the Korean Applied Science and Technology
• /
• v.41 no.2
• /
• pp.520-529
• /
• 2024

Lycium barbarum extract has a high potential to be developed as a health functional food due to the various health-promoting effects of Lycium barbarum. This study analyzed changes in nutritional and functional components depending on the extraction solvent (purified water and a mixture of purified water and alcohol) and the condition of the sample. The nutritional components (carbohydrates, protein, fat, ash), organic acids, amino acids, total phenolic compounds, and total flavonoids of the extract produced during the extraction process were analyzed. The nutritional composition and functional substances of the extracts showed some differences depending on the type of solvent and the condition of the sample. The amounts of crude protein (7.61%), crude fat (1.63%), carbohydrate (90.22%), and ash (0.54%) of dried Lycium barbarum extract using purified water as a solvent were similar to those of the powder sample extract. The highest content of citric acid was 4.31 mg/mL, similar to the case of acetic acid, when the powder sample used a mixture of purified water and alcohol as a solvent. The highest amino acid content was 357.39 mg/mL when the powder sample was mixed with purified water and alcohol as a solvent. The total amount of phenolic compounds was 686.16 g/L when the powder sample was extracted with a mixture of purified water and alcohol as a solvent. The highest total flavonoid content was 111.32 g/L when the powder sample was extracted with a mixture of purified water and alcohol as a solvent.

• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.112-115
• /
• 2002

The green colonial algae Botryococcus braunii is characterized by unusual high hydrocarbon contents, ranging from 15 to 75% of dry weight, as long-chain unsaturated hydrocarbons. In two-phase bubble column using various organic solvents, poor recovery 08 - 32%) of hydrocarbon seems to be caused by insufficient mixing between two phases, which was operated using only aeration on the narrow interface between hydrophobic solvent and cell suspension. In addition, hydrocarbon was entrapped tightly in cell-matrix (formed by exopolysaccharide) of algal colony, which make difficult to extract using two-phase system. To improve recovery efficiency, mixed-solvent of extractive solvent (octane) and biocompatible solvent (octane) was tested in two-phase column for in situ extraction. In two-phase extraction culture using mixed-solvent, the algal growth was intensely inhibited even at low concentration of polar octanol solvent. the hydrocarbon recovery in two-stage cell-recycle extraction showed a 2.9 fold increase (57%) over that in two-phase extraction. Up to 60 % of hydrocarbon could be recovered without serious cell-damage in the case of downstream separation for 6 h at the high recycle flow rate using this process after batch culture.

• Journal of the Korean Applied Science and Technology
• /
• v.22 no.3
• /
• pp.219-227
• /
• 2005

Competitive solvent extraction of the mixure of alkali metal and alkaline earth cation from water into organic solvent containing the crown ether carboxylic acid and anlogous crown ether phosphonic acid was investigated as follows. The lipophilic group is found to strongly influence to the selective extraction in the mixed systems from only alkali metal cation for sym-(n-decyldibenzo)-16-crown-5-oxyacetic acid $\underline{1}$ to mostly alkaline earth metal cation for sym-bis[4(5)-tert-butylbenzo]-16-crown-5-oxyacetic acid $\underline{3}$. Monoethyl sym-(n-decyldibenzo)-16-crown-5-oxymethylphosphonic acid $\underline{2}$. and monoethyl-sym- bis]4(5)-tert-butylbenzo]-16-crown-5-oxymethylphosphonic acid $\underline{4}$ showed good selectivity for $Na^+$ over $Mg^{2+}$, the second extracted ion. Structural variation in the crown ether phosphonic acid somewhat was influenced to the extraction selectivity in the mixed systems. when variation of the ionized group is influenced in the mixed systems, the selectivity of $Na^+$ as the second extracted ion was much better crown ether carboxylic acid $\underline{1}$ than crown ether phosphonic acid $\underline{2}$, while the efficiency of $Na^+$ extraction was better $\underline{2}$ (83% total loading) than $\underline{1}$ (32%).