• 한국방사성폐기물학회:학술대회논문집
• /
• 한국방사성폐기물학회 2019년도 춘계학술논문요약집
• /
• pp.104-105
• /
• 2019

• Korean Chemical Engineering Research
• /
• 제51권6호
• /
• pp.661-665
• /
• 2013

ITO glass 제조공정에서 발생되는 인듐스크랩으로부터 인듐옥살산염의 제조에서 유기산의 영향을 연구하였다. 유기산의 종류, 농도 그리고 반응액의 pH, 온도, 시간 등을 변화시키면서 인듐옥살산염 제조에 미치는 영향을 조사하였다. 불순물 제거 효율은 구연산 및 옥살산 모두 비슷하였으나 구연산은 인듐과 유기산염을 형성하지 못하였다. 인듐옥살산염 제조의 최적 조건은 옥살산 농도 1.5M, pH 7, 반응온도 $80^{\circ}C$, 반응시간 6시간이었다. 한편, pH가 증가하면 회수율은 증가하지만, 순도는 감소하였다. 2회 반복으로 제조된 인듐옥살산염의 순도는 99.995% (4N5)를 나타내었다. 인듐옥살산염은 치환반응, 소성 등에 의해 인듐금속 및 인듐산화물 등으로 전환할 수 있다.

• Nuclear Engineering and Technology
• /
• 제45권5호
• /
• pp.675-682
• /
• 2013

The sequential separation process, composed of an oxygen sparging process for separating lanthanides and a zone freezing process for separating Group I and II fission products, was evaluated and tested with a surrogate eutectic waste salt generated from pyroprocessing of used metal nuclear fuel. During the oxygen sparging process, the used lanthanide chlorides (Y, Ce, Pr and Nd) were converted into their sat-insoluble precipitates, over 99.5% at $800^{\circ}C$; however, Group I (Cs) and II (Sr) chlorides were not converted but remained within the eutectic salt bed. In the next process, zone freezing, both precipitation of lanthanide precipitates and concentration of Group I/II elements were preformed. The separation efficiency of Cs and Sr increased with a decrease in the crucible moving speed, and there was little effect of crucible moving speed on the separation efficiency of Cs and Sr in the range of a 3.7 - 4.8 mm/hr. When assuming a 60% eutectic salt reuse rate, over 90% separation efficiency of Cs and Sr is possible, but when increasing the eutectic salt reuse rate to 80%, a separation efficiency of about 82 - 86 % for Cs and Sr was estimated.

• 한국재료학회지
• /
• 제12권1호
• /
• pp.3-9
• /
• 2002

The corrosion behavior of alloys in a molten salt was investigated along with the oxidation characteristics in the air. The basic composition of alloys in the study was Fe-25Ni-7Cr with Si and RE(rare-earth metal) as additives. The corrosion rate of the alloys was low in a molten salt of LiCl while the rate was high in the mixed molten salt of LiCl and $Li_2O$. When Si is added to the base alloy of Fe-25Ni-7Cr, corrosion resistance was improved as the Si content is increased up to 3%, however, it was observed that the corrosion resistance was getting worse as the Si content is increased. The base alloy with 2.43% of Si and 0.9% of RE(KSA-65), showed higher corrosion rate compared to that of KSA-63 alloy with an equivalent amount of only Si. The corrosion resistance of KSA-65 was similar to that of the base alloy(KSA-60). The oxidation resistance of KSA-65 alloy was greatly increased even at $850^{\circ}C$ for a long term exposure.

• Fisheries and Aquatic Sciences
• /
• 제5권1호
• /
• pp.43-47
• /
• 2002

Jeotgal, salt- fermented sea food, is a kind of Korean traditional foods. We carried out hazard analysis on Changran (stomach and intestine of Alaska pollack) Jeotgal and squid Jeotgal through the whole processing procedures at H Co. located at Guryongpo from April 2000 to September 2001. During this studying period, we educated employee regularly and analyzed hazards on the whole process and then could conclude that pathogenic bacteria and metal particles were most important hazards in Jeotgal. Metal particles in end-product will be eliminated by laser detector before packaging. But bacteria must thoroughly manage through the whole process. Bacteriological qualities of the end products were much improved after education for the employees and by effort for HACCP (Hazard Analysis and Critical Control Point) program introduction. Pathogenic bacteria such as pathogenic Escherichia coli, Salmonella spp., coagulase positive Staphylococcus aureus and Vibrio parahaemolyticus were not detected from not only raw materials but also end products. The falling bacteria in the places such as thawing area, packaging area, seasoning area, fermenting room, subsidiary materials room and storage room were less than 30 CFU per plate for 30 minutes during working time. But those were increased more than 10 times during the resting time. It means that special measures are needed during the break time such as lunch time or exchanging working teams.

• 환경위생공학
• /
• 제8권1호
• /
• pp.81-91
• /
• 1993

This paper was carried out to isolate and identify Aeromonas caviae which can degrade Sodium Dodecyl Benzene Sulfonate(SDBS) effectively. And the affecting factors for the ability of bacterial degradation were also studied. Frm October 1991 to February 1992, two hundred samples from sweage in Taegu area and Nakdong river waters in Talsung Gun area were tested. Minimal salt medium which contain SDBS only as a carbon source was used as a culture medium. The isolated new strain was identified as Aeromonas caviae Kim & Kweon. The optimal pH for SDBS degradation were 7.0 and temperature, $32^{\circ}C.$ It was taken 24 hours to degrade SDBS of 20mg/l completely under the optimal pH and temperature. And in the case of 30 mg/l of SDBS, it was taken 36 hours. The nitrogen sources were added to the minimal salt media containing 20mg/l of SDBS, and they were incubated at $32^{\circ}C$ for 14 hours. 86.9% SDBS were degraded after addition of 0.03% peptone as a organic nitrogen source. And 70.5% SDBS after addition of 0.05% ammonium sulfate as a inorganic nitrogen source. In the case of metal compounds(0.015%), the degradation rate for SDBS were 3.5 fold increased in the media containing magnesium chloride and calcium chloride than in the media that were not containing these metal compounds. And where the media containing magnesium chloride was 0.05%, the degradation rate was 65.8%. And above 0.3% NaCI, the degradation rate was decreased slowly.

• 대한화학회지
• /
• 제39권5호
• /
• pp.371-378
• /
• 1995

트리아자크라운 화합물, 1,7-dioxa-4,10,13-triazacyclopentadecane trihydrobromide $salt(Na_3O_2-3HBr)$를 합성하였다. 그리고 이 화합물을 Merrifield peptide resin에 결합시켜 새로운 이온교환체를 만들었다. 이 새로운 이온교환체의 이온교환용량은 3.2 meq/g이었다. 그리고 이 이온교환체에 대한 알칼리 및 알칼리 토금속 이온들의 분포계수를, 여러 농도의 염산 용액 중에서 측정하였다. 또한 여러 염산 농도하에서의 알칼리 및 알칼리 토금속 이온들의 이온교환작용을 논의하였다.

• Composites Research
• /
• 제25권5호
• /
• pp.159-163
• /
• 2012

냉매의 비등이나 응축같은 열전달 향상을 위하여 금속 표면위에 탄소나노튜브(CNT)를 코팅하는 것을 연구하였다. 분산제와 PVA(polyvinyl alcohol) 용액으로 분산 처리된 다중벽 탄소나노튜브/CuO의 복합 분말 코팅액을 구리기판위에 도포한 후 소결을 하였다. 본 논문에서는 CNT/CuO 소결 코팅시 다양한 분산제를 사용하여 소결 전후의 조직 형상 변화 및 특징을 실험적으로 평가하였다. 분산제로는 THF(Tetrahydrofuran), SDBS(Dodecylbenzenesulfonic acid sodium salt), SDS(Sodium dodecy sulfate)가 사용되었다. 각각의 시편들은 주사전자현미경, 열중량분석, 시차주사열량측정법, 라만분광법을 사용하여 분석하였다.

• Bulletin of the Korean Chemical Society
• /
• 제24권10호
• /
• pp.1433-1436
• /
• 2003

A new method for the simultaneous determination of heavy metal ions in cigarette material by microwave digestion and reversed-phase high-performance liquid chromatography (RP-HPLC) has been developed. The cigarette material was digested by microwave digestion. Lead, cadmium, mercury, nickel and tin ions in the digested samples were pre-column derivatized with tetra-(2-chlorophenyl)-porphyrin ($T_2$-CPP) to form color chelates, which were then enriched by solid phase extraction with a $C_{18}$ cartridge. The chelates were separated on a Waters Xterra$^{TM}RP_{18}$ column by gradient elution with methanol (containing 0.05 mol/L pyrrolidine-aceticacid buffer salt, pH = 10.0) and acetone (containin0.05 mol/L pyrrolidine-acetic acid buffer salt, pH = 10.0)as mobile phase at a flow rate of 0.5mL/min and analyzed with a photodiode array detector from 350-600 nm. The detection limits of lead, cadmium, mercury, nickel and tin were 4,3,3,8 and 5 ng/L, respectively, in the original samples. This method was afforded good results.

• Bulletin of the Korean Chemical Society
• /
• 제35권4호
• /
• pp.1117-1120
• /
• 2014

Ru/C-catalyzed hydrogenation of m-xylylene diamine into 1,3-cyclohexanebis(methylamine) was greatly accelerated by the presence of $LiNO_3$, $NaNO_2$, or $NaNO_3$. It was found that the effect of the nitrate salt was significantly affected by the size of cation. The promoting effect of the nitrate salt increased with the decrease of the cation size: $LiNO_3$ ~ $NaNO_2$ > $KNO_3$ > $CsNO_3$ >> [1-butyl-3-methylimidazolium]$NO_3$. XRD analysis of the recovered catalysts after the hydrogenation reactions showed that $LiNO_3$ and $NaNO_2$ were completely transformed into LiOH and NaOH, respectively, along with the evolution of $NH_3$, while $KNO_3$ and $CsNO_3$ remained unchanged.