• Journal of Electrical Engineering and Technology
• /
• v.7 no.6
• /
• pp.852-858
• /
• 2012

This paper describes evaluation results of the wind power penetration limit (WPPL) and the wind energy penetration (WEP) in the Mongolian central power system (MCPS). A wind power plant (WPP) in a power system possesses an output power limit because the power system must maintain a balance between the generation and consumption of electricity at all times in order to achieve an adequate level of quality. The instantaneous penetration limit (IPL) of wind generation at a load is determined as the minimum of the three technical constraints: the minimum output, the ramp rate capability, and the spinning reserve of the conventional generating units. In this paper, a WPPL is defined as the maximum IPL divided by the peak load. A maximal variation rate (VR) of wind power is a major factor in determining the IPL, WPPL, and WEP. This paper analyzes the effects of the maximal VR of wind power on the WPPL, WEP, and capacity factor (CF) in the MCPS. The results indicate that a small VR can facilitate a large amount of wind energy while maintaining a high CF with increased wind power penetration.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.10
• /
• pp.1310-1317
• /
• 2014

In our daily life, the need of energy increases day by day. However, the amount of natural resources on the earth is limited and thus gaining renewable energy as an energy resource is one of the important and urgent problems. Solar energy is one of the most popular available energy sources that can be converted into electricity by using solar panels. In order for solar panels to produce maximal output power, the incident angle of the sunlight needs to be persistently perpendicular to the solar panel. By the way, most of the solar panels are installed at fixed position and direction. Therefore, as the sun's position changes, it is impossible to produce maximal output power inevitably. To improve this problem, in this paper, a sun tracking system using two degree-of-freedom (DOF) active sensor array is proposed so that the solar panel may always direct sunlight perpendicularly. And also a series of software, such as a search mode and a holding mode, which can control the developed sun tracking system is developed. Several experiments using the implemented sun tracking system are executed and the effectiveness of the system is verified from the experimental results.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.481-482
• /
• 2007

This paper demonstrates OFDM with adaptive modulation applied to Multiple-Input Multiple-Output (MIMO) systems. We apply an optimization algorithm to obtain a bit and power allocation for each subcarrier assuming instantaneous channel knowledge. The analysis and simulation is considered in two stages. The first stage involves the application of a variable-rate variable-power MQAM technique for a Single-Input Single-Output(SISO) OFDM system. This is compared with the performance of fixed OFDM transmission where a constant rate is applied to each subcarrier. The second stage applies adaptive modulation to a general MIMO system by making use of the Singular Value Decomposition to separate the MIMO channel into parallel subchannels. For a two-input antenna, two-output antenna system, the performance is compared with the performance of a system using selection diversity at the transmitter and maximal ratio combining at the receiver.

• Journal of Life Science
• /
• v.19 no.12
• /
• pp.1712-1717
• /
• 2009

The purpose of this study was to compare $VO_2$max, maximal power output, and presence of $VO_2$ plateau across 4 protocol durations (5, 8, 12, and 16 min) during incremental cycling exercise to $VO_2$max. Twenty moderately to highly trained subjects ($24.9{\pm}6.6$) participated in the study. The mean $VO_2$max in the 5-min ($3.55{\pm}0.80\;l/min$) and 8-min ($3.66{\pm}0.88\;l/min$) duration protocols had higher and significantly higher mean value in the 8-min duration protocol compared to the 12-min ($3.49{\pm}0.76\;l/min$) and 16-min ($3.45{\pm}0.73\;l/min$) duration protocols. The AMPO across four protocols showed a significant difference. The AMPO for the 5-min protocol was 12%, 24%, and 35% higher than AMPO for the 8-min, 12-min and 16-min protocols. The presence of plateau was 12.5% for the 5 min protocol, 56.25% for the 8 min protocol, 37.5% for the 12 min protocol, and 56.25% for the 16 min protocol. This study indicates that the short duration protocol (<8 min) is a more valid measurement for $VO_2$ max than optimal duration protocol (8-12 min) in moderate to highly trained individuals on the cycle ergometer.

• Proceedings of the KIEE Conference
• /
• 1989.07a
• /
• pp.48-53
• /
• 1989

We attempt to achieve both high dynamic performance and maximal power efficiency by means of linear decoupling of rotor speed (or motor torque) and rotor flux. The induction motor with our controller possesses the input-output dynamic characteristics of a linear system such that the rotor speed (or motor torque) and the rotor flux are decoupled. The rotor speed (or motor torque) responses are not affected by abrupt changes in the rotor flux and vice versa. The rotor flux need not be measured but is estimated by the well-known flux simulator. The effect of large variation in the rotor resistance on the control performances is minimized by employing a parameter adaptation method. To illuminate the significance of our work. we present simulation and experimental results as well as mathematical performance analyses.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.8
• /
• pp.3-9
• /
• 2015

Under the maximum transmit power constraint and the minimum rate constraint, we propose the optimal number of transmit antennas and transmit power which maximize energy-efficiency (EE) in multi-user multiple-input multiple-output (MIMO) downlink system with the maximal ratio transmission (MRT) precoding. Because the optimization problem for the instantaneous channel is difficult to solve, we use independence of individual channel, average channel gain and path loss to approximate the objective function. Since the approximated EE optimization problem is two-dimensional search problem, we find the optimal number of transmit antennas and transmit power using Lagrange multipliers and our proposed algorithm. Simulation results show that the number of transmit antennas and power obtained by proposed algorithm are almost identical to the value by the exhaustive search.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.179-180
• /
• 2015

High wind penetration might cause the frequency stability problem because a wind power plant (WPP) is operating in a maximum power tracking mode to extract the maximal energy from wind and thus does not react to the system frequency variation. Therefore, the system operators encourage a WPP to participate in frequency control, which includes inertia/orl and primary control. The frequency support capability of a WPP depends on the amount of kinetic energy (KE) and reserve. This paper formulates an optimization problem to maximize KE while retaining the required reserve. The proposed optimization problem would allow wind generators (WGs) with a smaller wind speed to retaine more KE. The performance of the proposed optimization problem was investigated in a 100-MW WPP consisting of 20 units of 5-MW permanent magnet synchronous generators using an EMTP-RV simulator. The results show that the proposed optimization problem successfully improves the frequency nadir more than a conventional reserve allocation that distributes WGs proportional to the current output.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.11
• /
• pp.81-86
• /
• 2004

Hybrid beamformer composed of Direction-of-Arrival (DOA) based scheme followed by Maximal Ratio Combining (MRC) is proposed to overcome the degradation due to inaccurate channel estimation caused by insufficient pilot power, which happens in conventional Single-Input Multiple-Output (SIMO) Code Division Multiple Access (CDMA) reverse link. The proposed scheme could provide more accurate channel estimation and interference reduction at the expense of diversity gam in the spatially correlated SIMO channel. As a result, hybrid scheme outperforms conventional MRC beamformer for six or more antennas in the channel environment, in which Angle-of-Spread (AOS) is within 30$^{\circ}$.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.5
• /
• pp.101-109
• /
• 2009

In this paper, a new method, cascade 3 phase IHCML(Isolated H-bridge Cascade Multi-Level) inverter and a control method is proposed by using two 3-phase transformers that have respectively different transformation rates. Vector control technique in which the highest proximity vector has been used is also put into use. With this process, the switching frequency is almost identical with the output fundamental frequency, which makes less switching loss, and the switching frequency of the small volume of the H-bridge that is in charge of small power is highly controlled, which improves the quality of the output voltage.

• Journal of Communications and Networks
• /
• v.10 no.3
• /
• pp.258-267
• /
• 2008

In this paper, we examine what changes the next-generation wireless communication systems will experience in terms of the technologies, services, and networks and, based on that, we investigate how the inter-cell interference management should evolve in various aspects. We identify that the main driving forces of the future changes involve the data-centric services, new dynamic service scenarios, all-IP core access networks, new physical-layer technologies, and heavy upload traffic. We establish that in order to cope with the changes, the next-generation inter-cell interference management should evolve to 1) set the objective of providing a maximal data rate, 2) take the form of joint management of power allocation and user scheduling, 3) operate in a fully distributed manner, 4) handle the time-varying channel conditions in mobile environment, 5) deal with the changes in interference mechanism triggered by the new physical-layer technologies, and 6) increase the spectral efficiency while avoiding centralized coordination of resource allocation of the users in the uplink channel.