• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.1 s.343
• /
• pp.49-56
• /
• 2006

This paper describes the design and the verification of IEEE 802.15.4 LR-WPAN 2.4GHz Physical layer for Ubiquitous Sensor Network(USN). We designed the Carrier Frequency Offset(CFO) compensation satisfied the frequency tolerance of IEEE 802.15.4 LR-WPAN and the adaptive matched filter that re-setting of the threshold for the symbol synchronization of the various USN environment. The multiplications is reduced 1/16 by this method each other at i, q phases and has 0.5dB performance improvement in detection probability. Proposed baseband system is designed with verilog HDL and implemented using FPGA prototype board.

• Korean Journal of Remote Sensing
• /
• v.32 no.5
• /
• pp.403-412
• /
• 2016

Compact Reconnaissance Imaging Spectrometer for Mars(CRISM) is 489-band hyperspectral camera of Mars Reconnaissance Orbiter(MRO) that provided data used on many mineral researches over Martian surface. For the detection of minerals in planet, mineral index using a few spectral bands have been used. In this study, we applied Matched Filter and Adaptive Cosine Estimator(ACE) target detection algorithm on CRISM data over Gusev Crater: landing site of Spirit(Mars Exploration Rover A) to investigate its mineral distribution. As a result, olivine, pyroxene, magnetite, etc. is detected at Gusev Crater's Columbia Hills. These results are corresponding to the Spirit rover's field survey result. It is expected that hyperspectral target detection algorithms can be used as effective and easy to use method for the detection and mapping of surface minerals in planet.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9A
• /
• pp.835-843
• /
• 2010

Energy spreading transform (EST) based equalization is a very effective technique to remove inter symbol interference (ISI) in frequency selective channel. EST based system uses cyclic prefix (CP) similar to orthogonal frequency division multiplexing (OFDM) system. Since CP is a redundancy, it degrades the data transmission rate. RISIC is an algorithm that removes an inter block interference (IBI) caused by insufficient CP length and reconstructs CP. In this paper, we propose a system that combines the existing EST system with quadrature phase shift keying (QPSK) modulation and RISIC algorithm to enhance the efficiency of the transmission. Also we extend the proposed system to 16 quadrature amplitude modulation (QAM) modulation. The proposed system is shown to performance close to matched filter bound (MFB) even with insufficient CP.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.5
• /
• pp.522-533
• /
• 2019

The compressive sensing model for range-Doppler estimation can be expressed as an under-determined linear system y = Ax. To find the solution of the linear system with the compressive sensing method, matrix A should be sufficiently incoherent and x to be sparse. In this paper, we propose a transmission waveform design method that maintains the bandwidth required by the sonar system while lowering the mutual coherence of the matrix A so that the matrix A is incoherent. The proposed method combines two methods of optimizing the sensing matrix with the alternating projection and suppressing unwanted frequency bands using the DFT (Discrete Fourier Transform) matrix. We compare range-Doppler estimation performance of existing waveform LFM(Linear Frequency Modulated) and designed waveform using the matched filter and the compressive sensing method. Simulation shows that the designed transmission waveform has better detection performance than the existing waveform LFM.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.25 no.11
• /
• pp.787-797
• /
• 2015

In this paper, a cochlea-inspired artificial filter bank(CAFB) was developed in order to efficiently acquire dynamic response of structure, and it was also evaluated via dynamic response experiments. To sort out signals containing significant modal information from all the dynamic responses of structure, it was made to adopt a band-pass filter optimizing algorithm(BOA) and a peak-picking algorithm (PPA). Optimally designed on the basis of El-centro and Kobe earthquake signals, it was then embedded into the wireless multi-measurement system(WiMMS). In order to evaluate the performance of the developed CAFB, a vibration test was conducted using the El-centro and Kobe earthquake signals, and structural responses of a two-span bridge were obtained and analyzed simultaneously by both a wired measurement system and a CAFB-based WiMMS. The test results showed that the compressed dynamic responses acquired by the CAFB-based WiMMS matched with those of the wired system, and they included significant modal information of the two-span bridge. Therefore this study showed that the developed CAFB could be used as a new, economic, and efficient measurement device for wireless sensor networks(WSNs) based real time structural health monitoring because it could reconstruct the whole dynamic response using the compressed dynamic response with significant modal information.

• The Korean Journal of Pesticide Science
• /
• v.19 no.3
• /
• pp.230-240
• /
• 2015

An IOM sampler equipped with glass fiber filter has been recently utilized instead of solid adsorbent, which was used to measure the inhalation exposure of agricultural operator to pesticides. The aim of this study is to validate the efficacy of an IOM sampler by measuring the trapping efficiency and breakthrough using kresoxim-methyl water-dispersible granule and fenthion emulsifiable concentrate. On LC-MS/ MS, minimum detection level was 12.5 pg and method limit of detection was 5.0 ng/mL. Good linearity ($R^2$ > 0.999) for matrix matched standards was obtained. Recoveries of pesticides from glass fiber filter were 102-109% (kresoxim-methyl) and 97-104% (fenthion) while those from XAD-2 resin were 94-98% (kresoxim methyl) and 93-100% (fenthion). Trapping efficiency test was performed with personal air pumps and IOM sampler (glass fiber filter) connected with solid adsorbent (XAD-2 resin) with two types of formulation (solid and liquid) which were diluted by standard rate and sprayed to IOM sampler. Those pesticides were trapped only in glass fiber filter without any breakthrough to solid adsorbent. After spiking of pesticides to glass fiber filter, breakthrough test was carried out with IOM sampler (glass fiber filter) which was connected with solid adsorbent. As a results, 87-101% of kresoxim-methyl and 96-105% of fenthion remained in spiked glass fiber filter, however, no pesticides were detected in second glass fiber filter and solid adsorbent. In conclusion, IOM sampler which equipped with glass fiber filter can be applied widely for pesticide inhalation exposure study since it has good trapping efficiency and adsorption capacity, regardless of the solid or liquid formulation.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.46 no.3
• /
• pp.52-58
• /
• 2009

If a moving target has a linear characteristics, the Kalman filter can estimate relatively accurate the location of a target, but this performance depends on how the dynamic status characteristics of the target is accurately modeled. In many practical problems of tracking a maneuvering target, a simple kinematic model can fairly accurately describe the target dynamics for a wide class of maneuvers. However, since the target can exhibit a wide range of dynamic characteristics, no fixed SKF(Simple Kalman filter) can be matched to estimate, to the required accuracy, the states of the target for every specific maneuver. In this paper, a new AKF(Active Kalman filter) is proposed to solve this problem The process noise covariance level of the Kalman filter is adjusted at each time step according to the study result which uses the neural network algorithm. It is demonstrated by means of a computer simulation that the tracking capability of the proposed AKF(Active Kalman filter) is better than that of the SKF(Simple Kalman Filter).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.12
• /
• pp.3174-3182
• /
• 1996

In this paper, a new receiver is proposed for the detection of the OFDM(orthogonal frequency division multiplexing) signals in the time-selective multipath fading channel. For the optimal detection, we estimate the transmitted symbols from OFDM demultiplexing signal using the LMLE(linear masimum likelihold estimation) algorithm. Also, in this paper, the lowerbound for BER(bit error rate) using Taylor series approximation is provided. If the matched filter is used for the OFDM receiver in the time-selectivemultipath fading channel, it is known that the SER(symbol error rate) is always greater than $10^{-1}$, due to the cross-talk between adjacent channels. But, the proposed receiver provides of SER with 15dB SNR. Also, it is found that for the receiver implemented using the LMLE algorithm, the performance is shown to be not affected by the increase of th enumber of subchannel and channel path.

• Journal of the Korean Society of Safety
• /
• v.14 no.4
• /
• pp.204-210
• /
• 1999

We propose an optical fingerprint identification system using volume hologram for database of matched filter. Matched filters in VanderLugt correlator are recorded into a volume hologram that can store data with high density, transfer them with high speed, and select a randomly chosen data element. The multiple reference fingerprint photographs of database are prerecorded in a photorefractive material in the form of Fourier transform images, simply by passing the image displayed in a spatial light modulator through a Fourier transform lens. The angular multiplexing method for multiple holograms of database is achieved by controlling the reference directions with a step motor. Experimental results show that the proposed system can be used for secure entry systems to identify individuals for access to a restricted area, security verification of credit cards, passports, and other IDs.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.8
• /
• pp.1220-1225
• /
• 2009

In this paper, a tunable fiber feedback laser based on the use of Sagnac loop filter and fiber Bragg grating (FBG) is proposed. The Sagnac loop filter using a high birefringence fiber provides precise 0.33-nm channel spacing as a multi-wavelength grid filter. Ni-Cr wire wound on the FBG is useful to induce the thermo-optic effect of the fiber. Two types of FBG structures, which have a different length of wire, are demonstrated to show the wavelength shift and separation. To tune FBG by resistant heat, some current is supplied into the wire. When the wavelength matched with one of the cavity modes of Sagnac loop filter, the mode-locked lasing is occurred. The electrical power sensitivity of the resonant wavelength is measured to 1.75pm/mW. This laser configuration can be applied the electrical power system for monitoring the power fluctuation.