• Journal of the Korean Electrochemical Society
• /
• v.17 no.1
• /
• pp.37-43
• /
• 2014

In this study, capacitive deionization (CDI) was introduced for desalination of mining water. Ion-exchange polymer coated carbon electrodes (IEE) were used in CDI to desalt mining water. The CDI performance using the IEE for desalination of mining water was carried out and then was compared with that using general carbon electrodes without ion-exchange polymer coating (GE). Moreover, to investigate the effect of the concentration of influent solutions on CDI performance, the CDI performance using the IEE for desalination of brackish water (NaCl 200 ppm) was also performed and analyzed. As a result, the higher salt removal efficiency, rate and the lower energy consumption in the CDI process using the IEE and mining water were obtained compared with those using the GE and mining water. It is mainly due to higher non-Faradaic current, low ohmic resistance of the influent, overlapping effect of electric double layers in micropore of the electrode. In addition, the CDI process using the IEE and brackish water shows much higher salt removal efficiency and lower salt removal rate than that using the IEE and mining water. This results from the lower concentration (i.e., higher ohmic resistance) and salt amount of the influent.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.8
• /
• pp.66-75
• /
• 2016

Due to aggressive scaling of device sizes and reduced noise margins, physical defects caused by aging and process variation are continuously increasing. Additionally, with scaling limitation of metal wire and the increasing of communication volume, fault tolerant method in manycore network-on-chip (NoC) has been actively researched. However, there are few researches investigating reliability in NoC with voltage-frequency-island (VFI) regime. In this paper, we propose a table-based routing technique that can communicate, even if link failures occur in the VFI NoC. The output port is alternatively selected between best and the detour routing path in order to improve reliability with minimized hardware cost. Experimental results show that the proposed method achieves full coverage within 1% faulty links. Compared to $d^2$-LBDR that also considers a routing method for searching a detour path in real time, the proposed method, on average, produces 0.8% savings in execution time and 15.9% savings in energy consumption.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.4
• /
• pp.549-553
• /
• 2006

In this study, the effects of granite-grit offered free-choice on voluntary intakes of grit and subsequently on some morphologic traits of the digestive tract and performance of broilers were investigated. A total of 240 7d-old male broiler chicks (Ross 308) were allotted randomly to 10 floor pens supplied with wood shavings. The experiment lasted for 42 days. There were 2 dietary treatments, each consisting of 5 replicates. Each replicate consisted of 24 birds kept in an experimental unit with a floor size of $2{\times}2m$. Dietary treatments consisted of control (C) in which broilers were fed standard broiler rations, and acid insoluble granite-grit choice (AIGG) in which broilers were fed standard broiler rations and grit in separate troughs. Mean amounts consumed varied quite widely from week to week, but on average broilers ate 3.41 g per d per bird during the experimental period. Birds had a higher voluntary intake of granite-grit at an early age (7 to 21 d of age) than later (22 to 42 d of age). The voluntary intake of granite-grit of AIGG broilers increased (p<0.05) from 2.7 g/day at 7-14 d to 4.4 g at 15-21 d of age, and then it decreased to 3.4, 3.2 and 3.4 g/day between 22-28, 29-35 and 36-42 d of age, respectively. This level of grit intake increased (p<0.05) weights of empty gizzard (0.97 vs. 1.30 g), edible inner organs (3.51 vs. 3.69 g), and length of gut (8.86 vs. 9.01 cm) as a proportion of body weight and the content of insoluble ash (8.4 vs. 42.2 g/kg) in the faeces compared to the control group. Feeding free-choice grit had little or no effect on final live weights (2,542 vs. 2,543 g), daily gains (69 vs. 69 g), carcass weights (1,924 vs. 1,911), dressing percentages (75.6% vs. 75.1%) and feed efficiencies (1.69 vs. 1.66). Birds given grit did not gain more weight than those not given grit but they tended to have (p<0.07) lower feed intake (116.7 vs. 114.5 g), and consequently lower protein and energy intake. In conclusion, the granite-grit consumed voluntarily by broilers increased gut length and empty gizzard weight without affecting growth performance of broilers. Thus, it can be assumed that the voluntary consumption of granite-grit was too low to affect performance.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.5
• /
• pp.776-784
• /
• 2016

In this study, green Larix kaempferi lumber was heat-treated by using superheated steam (SHS) at a pilot scale and then various physico-mechanical properties of the heat-treated wood were evaluated and compared with the properties of conventional hot air (HA) heat-treated wood. Decay resistance of brown rot fungi and compressive strength parallel to the grain of the SHS heat-treated wood without occurrence of drying check from green lumber were increased. On the other hand, density, equilibrium moisture content, shrinkage, and bending strength of the SHS heat-treated wood were lower than those of the conventional HA heat-treated wood. Because heat transfer and thermal hydrolysis of SHS heat treatment was accelerated by a large amount of water, the effect of SHS heat treatment on the physico-mechanical properties was higher than that of HA heat treatment at the similar conditions of temperature and time. From the results of this study, because green lumber can be heat-treated without occurrence of cracks or checks by using SHS and similar heat treatment effect on the physico-mechanical properties of wood can be produced despite a low temperature or short time of heat treatment, it is expected that heat time and energy consumption could be reduced by using SHS.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.2 s.344
• /
• pp.60-75
• /
• 2006

The MPEG-21 Multimedia Framework initiative aims to support a wide range of networks and devices in the delivery and consumption of multimedia resources. One of the primary goals of MPEG-21 is universal multimedia access (UMA) through Digital Item Adaptation (DIA), which supports multimedia streaming to heterogeneous devices ensurung the same readability and seamlessness. We pioneer power saving of luminal devices with MPEG-21 DIA, so that the MPEG-21 DIA can also be used to support power saving, even though the framework is not primarily designed for power reduction and only limited power awareness is defined by DIA. We introduce several power-saving techniques conforming to MPEG-21 DIA specifications and show the dependency relation among introduced techniques. We achieve energy savings of up to $66\%$ in hand-held multimedia devices with minor QoS (quality of service) degradation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.9
• /
• pp.4177-4185
• /
• 2012

LEDs are becoming the most suitable candidate replacing traditional fluorescent lamps because of its eco-friendly characteristics. LEDs are also actively used to design green building system and to make outdoor billboard as a back-light system due to its high energy efficiency. In this paper, we have developed AC direct driver for $12{\times}12$ FLB(flexible LED board) and LED flat light without SMPS. It has LID-PC-R101B driver IC that can support the high power factor and be composed of LED switching circuit in group. Also, an elaborate system designs can guarantee a high luminous efficiency, a high reliability and a low power consumption. The proposed FLB has the ultra slim shape of $450{\times}450$ mm, width of 4 mm and weight of 280 g. In the end, we have developed a prototype of FLB for billboard and flat light for room lighting with AC direct driver iposrder to verify the performance of the proposed system.

• The Korean Journal of Quaternary Research
• /
• v.17 no.2
• /
• pp.161-161
• /
• 2003

During the last century, most scientific questions related to climate change were focused on the evidence of anthropogenic global warming (IPCC, 2001). There are robust evidences of warming and also human-induced climate change. We now understand the global, mean change a little bit better; however, the uncertainties for regional climate change still remains large. The purpose of this study is to understand the past climate change over Korea based on the observational data and to project future regional climate change over East Asia using ECHAM4/HOPE model and MM5 for downscaling. There are significant evidences on regional climate change in Korea, from several variables. The mean annual temperature over Korea has increased about 1.5∼$1.7^{\circ}C$ during the 20th century, including urbanization effect in large cities which can account for 20-30% of warming in the second half of the 20th century. Cold extreme temperature events occurred less frequently especially in the late 20th century, while hot extreme temperature events were more common than earlier in the century. The seasonal and annual precipitation was analyzed to examine long-term trend on precipitation intensity and extreme events. The number of rainy days shows a significant negative trend, which is more evident in summer and fall. Annual precipitation amount tends to increase slightly during the same period. This suggests an increase of precipitation intensity in this area. These changes may influence on growing seasons, floods and droughts, diseases and insects, marketing of seasonal products, energy consumption, and socio-economic sectors. The Korean Peninsular is located at the eastern coast of the largest continent on the earth withmeso-scale mountainous complex topography and itspopulation density is very high. And most people want to hear what will happen in their back yards. It is necessary to produce climate change scenario to fit forhigh-resolution (in meteorological sense, but low-resolution in socio-economic sense) impact assessment. We produced one hundred-year, high-resolution (∼27 km), regional climate change scenario with MM5 and recognized some obstacles to be used in application. The boundary conditions were provided from the 240-year simulation using the ECHAM4/HOPE-G model with SRES A2 scenario. Both observation and simulation data will compose past and future regional climate change scenario over Korea.

• Journal of KIISE:Information Networking
• /
• v.34 no.6
• /
• pp.475-482
• /
• 2007

Mobile nodes in ad-hoc wireless networks play roles of router as well as host. Movement of nodes causes network topology changes, which make existing routing information be modified. Therefore many routing protocols for ad-hoc networks were suggested in the literature. In this paper, we suggest an enhanced automatic route shortening method for dynamic source routing(DSR) protocol. DSR is a request/response based protocol which has low routing overhead owing to node movement. The current automatic route shortening is performed on the only nodes which belong to the source route of packets. On the contrary, our suggested method allows all neighbor nodes hearing the packet to participate in automatic route shortening. It makes all possible route shortenings be performed. So we maintain maximal shortened routes of ongoing data connections. Simulation results with ns2 show that our method pays small extra protocol overhead for ARS, but increases the ratio of successful packet transmissions and the number of ARSs performed in our mechanism is from 2 to 5 times higher than in original ARS mechanism and therefore it will improve the network-wide energy consumption in wireless ad-hoc networks.

• Journal of Internet Computing and Services
• /
• v.18 no.4
• /
• pp.43-50
• /
• 2017

Embedded System includes touch, GPS, motion, and acceleration sensor, and can communicate with neighbor devices using wireless communication. Because Arduino with embedded system provides good environment for development and application, developers, engineers, designers, as well as artists, students have a great interest. They utilize Arduino in the robot, home appliances, fashion, culture and so on. In this paper, we design and implement a game using Arduino with embedded system which recognizes the human movement by moving away from one-dimensional game of the existing touch method. Implemented embedded system game measures gyro-sensor to recognize human movement and detects the attack success of the opponent by using touch sensor. Moreover, health of the game player is updated in the real time through the android phone-based database. In this paper, implemented embedded system-based game provides GUI screen of android phone. It is possible to select watching mode and competition mode. Also, it has low energy consumption and easy to expand because it send and receive data packet through recent Bluetooth communication.

• Spatial Information Research
• /
• v.19 no.3
• /
• pp.95-106
• /
• 2011

Recently as efficient processing of aggregate queries for fetching desired data from sensors has been recognized as a crucial part, in-network aggregate query processing techniques are studied intensively in wireless sensor networks. Existing representative in-network aggregate query processing techniques propose routing algorithms and data structures for processing aggregate queries. However, these aggregate query processing techniques have problems such as high energy consumption in sensor nodes, low accuracy of query processing results, and long query processing time. In order to solve these problems and to enhance the efficiency of aggregate query processing in wireless sensor networks, this paper proposes Bucket-based Parallel Aggregation(BPA). BPA divides a query region into several cells according to the distribution of sensor nodes and builds a Quad-tree, and then processes aggregate queries in parallel for each cell region according to routing. And it sends data in duplicate by removing redundant data, which, in turn, enhances the accuracy of query processing results. Also, BPA uses a bucket-based data structure in aggregate query processing, and divides and conquers the bucket data structure adaptively according to the number of data in the bucket. In addition, BPA compresses data in order to reduce the size of data in the bucket and performs data transmission filtering when each sensor node sends data. Finally, in this paper, we prove its superiority through various experiments using sensor data.