• Wind and Structures
• /
• v.8 no.5
• /
• pp.357-372
• /
• 2005

Mean and extreme pressure distributions on a large cantilevered flat roof model are measured in a boundary layer wind tunnel. The largest peak suction values are observed from pressure taps beneath conical "delta-wing type" corner vortices that occur for oblique winds, then the characteristics and causes of the local peak suctions are discussed in detail. Power spectra of fluctuating wind pressures measured from some typical taps located at the roof edges under different wind directions are presented, and coherence functions of fluctuating pressures are also obtained. Based on these results, it is verified that the peak suctions are highly correlated with the conical vortices. Furthermore, according to the characteristics of wind loads on the roof, an aerodynamic solution to minimize the peak suctions by venting the leading edges and the corners of the roof is recommended. The experimental results show that the suggested strategy can effectively control the generation of the conical vortices and make a reduction of 50% in mean pressures and 25% in extreme local pressures at wind sensitive locations on the roof.

• Journal of Environmental Impact Assessment
• /
• v.11 no.2
• /
• pp.79-91
• /
• 2002

Four dimensional data assimilation (FDDA) technique was considered for 3 dimensional wind field in coastal area and a set of 3 numerical experiments including control experiments has been tested for the case of the synoptic weather pattern of the weak northerly geostrophic wind with the cloud amount of less than 5/10 in autumn. A three dimensional land and sea breeze model with the sea surface temperature (SST) of 290K was performed without nudging the observed wind field and surface temperature of AWS (Automatic Weather System) for the control experiment. The results of the control experiment showed that the horizontal temperature gradient across the coastline was weakly simulated so that the strength of the sea breeze in the model was much weaker than that of observed one. The experiment with only observed horizontal wind field showed that both the pattern of local change of wind direction and the times of starting and ending of the land-sea breeze were fairly well simulated. However, the horizontal wind speed and vertical motion in the convergence zone were weakly simulated. The experiment with nudgings of both the surface temperature and wind speed showed that both the pattern of local change of wind direction and the times of starting and ending of the land-sea breeze were fairly well simulated even though the ending time of the sea breeze was delayed due to oversimulated temperature gradient along the shoreline.

• Atmosphere
• /
• v.23 no.1
• /
• pp.13-21
• /
• 2013

In this study, the effects of atmospheric stability and surface temperature on the microscale local airflow are investigated in a hydrological suburban area using a computational fluid dynamics (CFD) model. The model domain includes the river and industrial complex for analyzing the effect of water system and topography on local airflow. The surface boundary condition is constructed using a geographic information system (GIS) data in order to more accurately build topography and buildings. In the control experiment, it is shown that the topography and buildings mainly determine the microscale airflow (wind speed and wind direction). The sensitivity experiments of atmospheric stability (neutral, stable, and unstable conditions) represent the slight changes in wind speed with the increase in vertical temperature gradient. The differential heating of ground and water surfaces influences on the local meteorological factors such as air temperature, heat flow, and airflow. These results consequentially suggest that the meteorological impact assessment is accompanied by the changes of background land and atmospheric conditions. It is also demonstrated that the numerical experiments with very high spatial resolution can be useful for understanding microscale local meteorology.

• Journal of Environmental Science International
• /
• v.3 no.1
• /
• pp.39-47
• /
• 1994

Dispersion characteristics of air pollutants in the mountainous coastal area are investigated in considering with the mesoscale local circulations using a two dimensional numerical model with two kinds of topograpy of 500m and 300m. In the model, land-sea breezes and mountain-valley wind are mainly considered under the condition of the absence of large scale prevailing flow in the circulation analysis, and the pollutants dispersion is traced by the Lagrangian methods. According to the results, the wind velocity is affected by topography and is stronger in the case of 500m height mountain than that of 300m, the Pollutants that source is near the coast transported over the mountain and dispersed to behind inland area. It is classified that the topography change control affects the wind velocity and the circulations. The pollutants that source is different transported and concentrated to behind inland and/or diffused to the sea area by the combination of the wind system with topographic changes. The results can be applied to the air pollution control with the arrangement design of industrial area and the planning of coastal developments.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.6
• /
• pp.497-505
• /
• 2016

Operating wind turbine generators at maximum power point requires maximum power point tracking (MPPT) control methods. However, conventional methods cannot track the appropriate maximum power point in situations involving wind turbine systems based on a series operation strategy. These systems comprise one or more local maximum power points, and conventional methods can detect only one local maximum power point closed by a current operation point. This study proposes an advanced MPPT method for the series operation strategy of a small, grid-connected wind turbine system. In determining the appropriate maximum point, operations at certain local maximum power points are analyzed. The results show one appropriate point, which is tracked by the proposed MPPT method. The effectiveness of the proposed method is verified by the experimental results.

• 한국방재학회:학술대회논문집
• /
• 2007.02a
• /
• pp.85-89
• /
• 2007

Data of the typhoon affecting Korean peninsula from 1951 to 2005 are obtained from the RSMC best track and six climatological characteristics of the typhoons are examined. Local wind speeds are obtained by the physical model for wind fields. Typhoons are generated by the Monte Carlo simulation and their wind speeds are distributed using Weibull CDF. Simulated typhoon wind speeds are used to obtain different wind speeds corresponding their mean recurrence intervals.

• New & Renewable Energy
• /
• v.18 no.4
• /
• pp.38-53
• /
• 2022

T Recently, the government has been promoting the expansion and supply of renewable energy as an alternative for achieving carbon neutrality and the nationally determined contributions by 2030. In 2020, the Ministries of Industry and Environment and the Korea Forest Service collaborated to build a nationwide onshore wind energy siting atlas considering wind resources and forestry and environmental regulations focused on central regulations. In this study, the ordinances of the local governments were analyzed to examine the effects of regional location regulations on the expansion of onshore wind power energy generation facilities, in addition to those of central regulations. A development permit standard survey of 226 urban plan ordinances of the local governments nationwide showed that presently in 2022, 52 municipalities are applying regulations on wind energy generation facilities by ordinances. This is twice more than that in 2018, when renewable energy power generation facility development was difficult. Additionally, the location regulations applied by these ordinances were organized by items and regions, and regulatory characteristics, such as the number and scope, were analyzed by regions. To analyze the spatial distribution characteristics, JeollaNamdo was selected as the case area. A spatial DB was established for regulated areas based on the regional and central regulations, and the spatial distribution characteristics and the regulatory scope were compared and analyzed.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.327-330
• /
• 2008

This paper presents monitoring system for 750kW-class DFIG wind turbine generator system and an architecture for applying standardized communication, IEC61400-25. Monitoring and control system is consists of wind turbine PLC, Local and Remote I/O Server, HMI. and Web-server. Proposed System has been demonstrated in Daegi-ri, Kangwon-do, which aims to test local and/or remote monitoring and control system and evaluate the performance of 750kW-class WTS. Finally we described the design of logical nodes and services based on IEC61400-25 and its application scheme.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.1
• /
• pp.41-49
• /
• 2012

This paper describes the operation mode development for the grid-tied PMSG(permanent magnet synchronous generator) wind power system combined with a battery energy storage. The development of operation modes was carried out through simulations with PSCAD/EMTDC software and experiments with a 10kW hardware prototype. The detailed simulation models for PMSG wind power system and battery energy storage were developed using user-defined models programed with C-code. A 10kW hardware simulator was built and tested in connection with the local load and the utility power. The simulation and experimental results confirm that the grid-tied PMSG wind power system combined with battery energy storage can supply highly reliable power to the local load in various operation modes.

• Wind and Structures
• /
• v.24 no.6
• /
• pp.637-656
• /
• 2017

In Japan, at least 28 local winds are known by name, most of them associated with downslope windstorms and gap winds. To review these windstorms, we categorize them based largely on the atmospheric conditions and formation mechanisms, and then focus on representative examples. These representative cases include the "Yamaji­kaze", a typical downslope windstorm, the "Hirodo-­kaze", a downslope windstorm induced by a nearby typhoon (intense tropical cyclone), and the "Karak-kaze", a downslope wind with a clear diurnal variation. Other downslope winds such as the "Inami-kaze" and the gap wind "Kiyokawa­dashi" are also described. Among these winds, the "Yamaji-kaze", "Hirodo-kaze", and "Kiyokawa-dashi" are considered the three most notorious due to their destructive power. After describing and comparing these winds, we discuss remaining issues to be considered in future studies.