• Nuclear Engineering and Technology
• /
• v.56 no.2
• /
• pp.463-471
• /
• 2024

Average and local convective heat transfer coefficients of nitrogen are measured experimentally in an electrically heated circular tube for a range of Reynolds number from 1.08 × 10⁴ to 3.60 × 10⁴, and wall-to-bulk temperature ratio from 1.01 to 1.77. The exit Mach number is up to 0.17, and the heat flux is up to 46 kW·m^-2. The molybdenum test section has a 62 diameters heated section with an inside diameter of 5 mm and a 30 diameters entrance section to ensure the fully-developed flow. Uncertainty of Nusselt number is less than 1.6 % in this study. The results indicate that the average heat transfer correlations evaluated by both the bulk and the modified film Reynolds numbers agree well with the experimental data. The local heat transfer results based on bulk properties are compared with previous empirical correlations. New prediction correlations are recommended which are significantly affected by the property variation and heated length. The comparison between the proposed correlations and experimental points shows that 88 % of experimental data fall into an error of 10 %, and almost all data are within an error of 20 %.

• Proceedings of the KSR Conference
• /
• 2011.10a
• /
• pp.2373-2382
• /
• 2011

As the government set the direction for Green Growth recently, so local government struggles to obtain carbon emissions trading. In the center of this global environment atmosphere, the quantitative targets would be suggested by some developed countries. In case of a international green movement like this, it would have been being induced from by crystallizing of economic and environmental regulations and legal policies that not only a meter-rate system of carbon emissions but also application for regenerate energy. In this paper, we researched cultivating of energy storage system(ESS) to conjugate regenerative energy of train, an energy efficiency and cultivating cost etc. In conclusion, we would acknowledge a difficulty in cultivating ESS only for cost reduction of energy consumption, so governmental policies for green growth should be thoughtfully examined.

• Proceedings of the KIEE Conference
• /
• 2008.11a
• /
• pp.273-275
• /
• 2008

In Korea, over 97% of local energy demand is imported from other countries. And we have to lift the energy independence level up to 5% with replacement energy(renewable energy) such as solar, wind..etc. by 2011 according to the energy agreement made in Kyoto Protocol. So, we proposed some opinions such as the better improvement of solar thermal industry the people' view, cooperation among industry/university/research institutes, remote control/maintenance and government's legislature and supporting system etc.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.11a
• /
• pp.134-137
• /
• 2006

Tidal power can use conventional technology to extract energy from the tides. It is usually best deployed in areas where there i s a high tical range which includes Western and Southern coastal areas in Korea. However, to extract tical energy, a barrage across an estuary or a bay is to be constructed that is now very hard due to severe environmental impact on local estuary. The recent technology of application of tidal stream provides a new window to extract power minimizing the adverse environmental impact Tidal stream technology which directly exploits these currents is relatively new but is presently generating considerable interest Turbine rotors can be used to extract energy from the flows. Prototype devices currently on test in the UK include the 300kW SeaFlow turbine. In this paper, the recent technology and research on ocean tical stream power are addressed

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.2105-2108
• /
• 2003

The characteristics of upward bubble flow were experimentally investigated in a liquid bath. In the present study, a thermal-infrared camera and high speed CCO camera were used to measure their temperature and local rising velocity, respectively. Heat transfer from bubble surface to water is largely completed within z=10mm from the nozzle, and then the temperature of bubble surface reaches that of water rapidly. The rising velocity of bubble was calculated for two different experimental conditions: 1) bubble flow without kinetic energy 2) with kinetic energy. Bubble flow without kinetic energy starts to undergo the effect of inertia force 10cm away from the nozzle. Whereas, kinetic energy is dominant before 30 cm away from the nozzle in bubble flow, but after this point, kinetic energy and inertial force are applied on bubble flow at the same time.

• Wind and Structures
• /
• v.20 no.4
• /
• pp.565-578
• /
• 2015

A wind energy assessment is an integrated analysis of the potential of wind energy resources of a particular area. In this work, the wind energy potentials for Mauritius have been assessed using a Computational Fluid Dynamics (CFD) model. The approach employed in this work aims to enhance the assessment of wind energy potentials for the siting of large-scale wind farms in the island. Validation of the model is done by comparing simulated wind speed data to experimental ones measured at specific locations over the island. The local wind velocity resulting from the CFD simulations are used to compute the weighted-sum power density including annual directional inflow variations determined by wind roses. The model is used to generate contour maps of velocity and power, for Mauritius at a resolution of 500 m.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.3
• /
• pp.996-1015
• /
• 2016

A common concern regarding cooperative spectrum sensing (CSS) schemes is the occupied bandwidth and the energy consumption during the transmissions of sensing information to the fusion center over the reporting control channels. This concern is intensified if the number of cooperating secondary users in the network is large. This article presents a new fusion strategy for a CSS scheme, aiming at increasing the energy efficiency of a recently proposed bandwidth-efficient fusion scheme. Analytical results and computational simulations unveil a high increase in energy efficiency when compared with the original approach, yet achieving better performances in some situations, and lower implementation complexity.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2007.11a
• /
• pp.228.1-228.1
• /
• 2007

• Solar Energy
• /
• v.16 no.2
• /
• pp.7-14
• /
• 1996

Korean goverment is promoting "the Rural Electrification Project" to replace the diesel generators with PV power supply. The PV-diesel hybrid system are proven more cost effective than that of the existing, especially in the. case of small islands(less than 70 households). In this paper, we intend to introduce the Hahwado island PV system assisted with diesel generator and remote monitoring systems as observator. The purpose of this observator is to have minimum maintenance, to improve economical effciency and system reliability by checking the system periodically at certain time interval, and to make diagnosis of its operating situations. The remote monitoring system was designed to communicate between the central and local site through exclusive telephone line on real-time base, using Window '95 version.

• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.762-764
• /
• 2003

In Korea, over 97% of local energy demand is imported from other countries. And we have to lift the energy independence level up to 5% with replacement energy (renewable energy) such as solar, small hydropower, etc. by 2011 according to the energy agreement made in Kyoto Protocol. So, we proposed some opinions such as the better improvement of small hydropower industry the people' view, cooperation among industry/university/research institutes, remote control/maintenance and goverment's legislature and supporting system etc.