• Journal of the Korean Chemical Society
• /
• v.8 no.2
• /
• pp.43-46
• /
• 1964

Quenching constants, q, determined for N,N-dimethylanilines by liquid scintillation counting indicate that the quenching involves an energy transfer process to these compounds causing strong n-${\pi}$ interaction within the quencher molecule, which is then followed by an non-radiative degradation of the excitation energy to ground state.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.11
• /
• pp.985-990
• /
• 2002

The electrical breakdown characteristics of liquid nitrogen(LN$\sub$2/) were studied under simulated quenching conditions for application of HTS apparatus. The experimental results for various quenching condition revealed that the breakdown voltage of LN$\sub$2/ with bubble flow velocity and gap spacing. In the case, breakdown voltage decreases gradually with the bubble velocity. When it is bubble velocity from 0 to 1 $\ell$ /min, breakdown voltage rapidly decreases but decreases from 2 $\ell$/min to 10 $\ell$/min slowly. The breakdown voltage for vertical electrode arrangement is higher than that for horizontal electrode arrangement. Also, it did a electric field and potential distribution interpreting at the liquid nitrogen when the bubble existed. The plots of equipotential lines for three cases are also shown.

• Journal of Soil and Groundwater Environment
• /
• v.12 no.6
• /
• pp.53-59
• /
• 2007

Optimal quenching curves have been studied for the accurate analysis of $^{14}C$ in groundwater polluted by reducing efficiency of volatile organic compounds (VOCs) in liquid scintillation counter (LSC). The quenching parameters (SQP(E)) were measured for ten VOCs such as benzene, toluene, ethylbenzene, o-(m-,p-)xylene, trichloroethylene (TCE), tetrachloroethylene(PCE), carbon tetrachloride and chloroform. The quenching curves were plotted using $^{14}C$ standard solution and chloroform as a quenching agent. Optimal plotting conditions were determined for standard solution, LSC measuring time and the concentration of chloroform. The quenching effects of chlorinated organic compounds such as TCE, PCE, carbon tetrachloride and chloroform were greater than those of BTEX (benzene, toluene, ethylbenzene and xylene). Optimum measuring time was 100 minutes far 7,000 dpm/mL standard solution. A few mL of chloroform should be added for good quenching curves. These quenching curves have good correlation coefficients (> 0.99) and the curves could be applied to accurate analysis of $^{14}C$ in groundwater and tap water.

• Journal of Powder Materials
• /
• v.7 no.3
• /
• pp.143-148
• /
• 2000

NiAl alloy powders were prepared by mechanical alloying method and bulk specimens were produced using hot isostatic pressing techniques. This study focused on the transformation behavior and properties of Ni-Al mechanically alloyed powders and bulk alloys. Transformation behavior was investigated by differential scanning calorimeter (DSC), XRD and TEM. Particle size distribution and microstructures of mechanically alloyed powders were studied by particle size analyzer and scanning electron microscope (SEM). After 10 hours milling, XRB peak broadening appeared at the alloyed powders with compositions of Ni-36at%Al to 40at%Al. The NiAl and $Ni_3Al$ intermetallic compounds were formed after water quenching of solution treated powders and bulk samples at $1200^{\circ}C$, but the martensite phase was observed after liquid nitrogen quenching of solution treated powders. However, the formation of $Ni_3Al$ intermetallic compounds were not restricted by fast quenching into liquid nitrogen. It is considered to be caused by fast diffusion of atoms for the formation of stable $\beta$(NiAl) phase and $Ni_3Al$ due to nano sized grains during quenching. Amounts of martensite phase increased as the composition of aluminium component decreased in the Ni-Al alloy, which resulted in the increasing damping properties.

• Journal of Photoscience
• /
• v.6 no.4
• /
• pp.159-163
• /
• 1999

The fluorescence quenching of 2-phenyl-5-(4-biphenylyl)-1,3,4-oxadiazole (PBD) and 1,4-di-[2-(5-phenyloxazolyl)]-benzene (POPOP) by aniline has been carried out in different solvent mixtures of dioxane and acetonitrile at room temperature. The quenching is found to be appreciable and a positive deviation from linearity was observed in the Stern-Volmer plot in all the solvent mixtures. Various rate constants for the quenching processes have been determined using a modified Stern-Volmer equation. From the positive deviations of linear Stern-Volmer plots and the dependence of rate constants on the polarity of the solvents, it has been concluded that both static and dynamic quenching processes are responsible for the observed positive deviation in the Stern-Volmer plot.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.6 no.5
• /
• pp.27-37
• /
• 1992

We studied the dielectric and dynamic mechanical losses according to the quenching condition in low density polyethylene being used to power cables. According to severe quenching condition, characteristics of the temperature in internal friction los peak have decreased the magnitude of loss peak as amorphous region lengthen. From now on, the frequency dependent characteristics of dielectric loss have investigated at room temperature, and the dielectric loss peak due to interface polarization, between crystal and amorphous region, occurs about 30[Hz], and that, the peak due to orientation polarization in correspondence to the loss peak in internal friction has observed at about 3 [MHz]. As quenching velocity increased, the effect on quenching condition about the dielectric loss has decreased the magnitude of the loss peak. Thus, estimation has been carried out on the activation energies nd the degree of crystallinity by means of X-ray diffraction are obtained as follows: room quenching : 26.4 [kal/mole] and 54.73 [%], ice quenching : 25.6 [kcal/mole] and 48.47 [%], liquid nitrogen quenching specimens : 22.56 [kcal/mole] and 40.95 [%].

• Journal of Soil and Groundwater Environment
• /
• v.11 no.5
• /
• pp.59-66
• /
• 2006

Optimal method of radon analysis in groundwater was studied using ultra low-level liquid scintillation counter (ULLLSC) which is well known as an analytical instrument for analyzing the alpha and beta radionuclides in environmental materials. Optimization of pulse shape analyzer (PSA) in operating the LSC was performed with $^{241}Am\;and\;^{90}Sr/^{90}Y$ as well as $^{226}Ra$ Also, the chemical quenching of scintillation generation and the color quenching of the generated photon to photomultiplier tubes (PMT) were determined their effects not only to decrease the analytical efficiency but also to change the optimal PSA level and background due to high ion contents of groundwaters. The optimal PSA level was shown in the range of 90 to 110 with less than 5% error. The effects of high ion contents in groundwater for the analytical efficiency show within 10% error from the different ion contents. The chloroform as a quenching agent was used to determine the analytical efficiency with the different amount, showing that the efficiency decreases 20% using the 2% of chloroform.

• Journal of Photoscience
• /
• v.4 no.3
• /
• pp.97-103
• /
• 1997

The effect of temperature on the fluorescence quenching of 2-(4-Methoxyphenyl)-5-(1-naphthyl)-1,3,4-oxadiazole (MPNO1), 2-(4-Methoxyphenyl)-5-(2-naphthyl)-1,3,4-oxadiazote(MPNO2), by aniline, and 2-Phenylindole (2-PI) by CCk, in toluene by steady state method and in benzene by time-resolved method have been carried out in the temperature range 30 - 70$\circ$C. The Stem-Volmer (S-V) plots, I$_0$/I against quencher concentration [Q] at different temperanares show positive deviations. The fluorescence lifetimes determined at different temperatures show no systematic variations and the variations being within the experimental error, the average values of lifetimes $ $\tau$ (t) are taken for further calculations. Rate constants such as Stem-Volmer quenching constants K$_sv}$, quenching rate parameters k$_q$ and k'$_q$, static quenching constant V and kinetic distance r are determined using the modified Stem-Volmer equation and sphere of action static quenching model. In order to see whether the reactions are diffusion limited, equations k$_q$ = e$^{-Eq/RT}$ and k'$_q$ = e$^{-Eq/RT}$ are used to determine the values of E$_q$ and E'$_q$, the activation energies for collisional quenching and the values of E$_q$ are 14.53. 17.28 and 16.20 kJ mole$^{-1}$ for MPNO1, MPNO2 and 2-PI respectively and the values of E'$_q$ are 14.62 and 17.73 for MPNO1 and MPNO2 respectively. From the magnitudes of various quantities it has been concluded that the reactions are diffusion limited and the observed positive deviations in the S-V plot are due to static and dynamic quenching.

• Macromolecular Research
• /
• v.11 no.6
• /
• pp.518-522
• /
• 2003

We fabricated polymeric hollow spheres having macropores, which combine the advantageous properties of porous materials and hollow spheres. To fabricate such spheres, a polystyrene/methylmethacrylate solution was dispersed in water by vigorously stirring and then the suspension was quenched using liquid nitrogen. Water and methyl methacrylate present in the quenched suspension were readily sublimated by freeze-drying. Conclusively, the hollow-sphere structure and the macropores of its shell were created by the processes of liquid nitrogen-quenching and sublimation of methyl methacrylate domains within the shell, respectively.

• Journal of the Korean Society for Heat Treatment
• /
• v.15 no.3
• /
• pp.147-151
• /
• 2002