• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1159-1165
• /
• 2008

In this paper, a single-feed equilateral-triangular microstrip antenna with truncated corners is used for achieving diverse radiation polarization. The proposed antenna is excited by a microstrip line, which is place parallel to an oblique side of the equilateral-triangular patch. Depending on whether the three identically-sized comers of the triangular patch are cut or not, the equilateral-triangular microstrip antenna shows linear polarization(LP) or left-hand circular polarization(LHCP) or Tight-hand circular polarization(RHCP). Based on the equilateral-triangular microstrip antenna with truncated corners, a novel reconfigurable microstrip antenna with switchable polarization sense is also proposed. The proposed reconfigurable antenna has a simple structure, consisting of a corner-truncated triangular patch, a small triangular conductor, and a microstrip line. Using a biased PIN diode between the patch and the small triangular conductor, it can produce LP or RHCP according to bias voltages. From the measured results, low cross polarization level when operated in the linear state and good axial ratio in the circular state are observed.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.18 no.2
• /
• pp.251-258
• /
• 2023

In this paper, we propose DLP(Dual Linear Polarization) stack antenna for private network. The proposed antenna has general stack structure and design airgap between two substrate to obtain the maximum gain. Also, to improve cross polarization isolation, two feeding port is designed to separate for each substrate. The size of each patch antenna is 17.80 mm(W1)×16.70 mm(L1) for lower patch and 18.56 mm(W2)×18.73 mm(L2) for upper patch, which is designed on the FR-4 substrate which thickness (h) is 1.6 mm, and the dielectric constant is 4.3, and which is 40.0 mm(W)×40.0 mm(L) for total size of substrate. From the fabrication and measurement results, bandwidths of 100 MHz (4.74 to 4.84 GHz) for feeding port 1, and 150 MHz (4.67 to 4.82 GHz) for feeding port 2 are obtained on the basis of -10 dB return loss and transmission coefficient S21 is got under the -20 dB. Also, cross polarization isolation between each feeding port obtained

• Journal of The Korean Astronomical Society
• /
• v.40 no.1
• /
• pp.1-7
• /
• 2007

About 10 percent of quasars are known to exhibit deep broad absorption troughs blueward of prominent permitted emission lines, which are usually attributed to the existence of outflows slightly above he accretion disk around the supermassive black hole. Typical widths up to 0.2c of these absorption roughs indicate the velocity scales in which special relativistic effects may not be negligible. Under he assumption of the ubiquity of the broad absorption line region in quasars, the broad emission line flux will exhibit Thomson scattered components from these fast outflows. In this paper, we provide our Monte Carlo calculation of linear polarization of singly Thomson scattered line radiation with the careful considerations of special relativistic effects. The scattering region is approximated by a collection of rings that are moving outward with speeds ${\upsilon}=c{\beta}<0.2c$ near the equatorial plane, and the scattered line photons are collected according to its direction and wavelength in the observer's rest frame. We find that the significantly extended red tail appears in the scattered radiation. We also find that the linear degree of polarization of singly Thomson scattered line radiation is wavelength-dependent and hat there are significant differences in the linear degree of polarization from that computed from classical physics in the far red tail. We propose that the semi-forbidden broad emission line C III]1909 may be significantly contributed from Thomson scattering because this line has small resonance scattering optical depth in the broad absorption line region, which leads to distinct and significant polarized flux in this broad emission line.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.6
• /
• pp.1037-1044
• /
• 2021

In this paper, we propose DLP(Dual Linear Polarization) array antenna for 3.5 GHz band. The proposed antenna has 1×4 array antenna and design two port network. A cross shape is inserted at the bottom of the patch for impedance matching. The size of each patch antenna is 18.85 mm(W1)×18.85 mm(L1), array antenna is designed on the FR-4 substrate, which is 236.0 mm(W)×60.2 mm(L), thickness (h) 1.6 mm, and the dielectric constant is 4.3. From the fabrication and measurement results, bandwidths of 70 MHz (3.54 to 3.61 GHz) for input port 1, 75 MHz (3.55 to 3.625 GHz) for input port 2 are obtained on the basis of -10 dB return loss and transmission coefficient S21 is under the -20 dB. Also, cross polarization between two port obtained.

• Journal of the Korean Ceramic Society
• /
• v.50 no.1
• /
• pp.82-86
• /
• 2013

A poled lead zirconate titanate (PZT) cube specimen is subjected to impulse-type compressive stress with increasing magnitude in parallel to the poling direction at four room and high temperatures. During the ferroelastic domain switching induced by the compressive stress, electric displacement in the poling direction and longitudinal and transverse strains are measured. Using the measured responses, linear material properties, namely, the piezoelectric and elastic compliance coefficients, are evaluated by a graphical method, and the effects of stress and temperature are analyzed. Finally, the dependency of the evaluated linear material properties on relative remnant polarization is analyzed and discussed.

• ETRI Journal
• /
• v.28 no.3
• /
• pp.379-382
• /
• 2006

A novel reconfigurable microstrip patch antenna with frequency and polarization diversities is proposed. A U-slot is incorporated into a square patch, and a PIN diode is utilized to switch the slot on and off, which realizes the frequency diversity characteristic. The polarization diversities among linear polarization (LP), right-hand circular polarization (RHCP), and left-hand circular polarization (LHCP) are also obtained by switching three PIN diodes on the slot and the truncating corners of a square patch on and off. The antenna design and experimental results are presented.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.1
• /
• pp.59-65
• /
• 2000

This paper describes the characteristics of a one dimensional narrow-wall slotted waveguide array with a single-layer linear-to-circular polarization converter consisting of a dipole array. An external boundary value Problem of one slot and three dipoles, which approximates the mutual coupling between the dipole array and an edge slot extending over three faces of a rectangular waveguide, is formulated and analyzed by the method of moments; design of polarization conversion is conducted for this model as a unit element. If every unit element has perfect circular polarization, grating lobes appear in the array pattern due to the alternating slot angle: these are suppressed in this paper by changing the dipole angle and degrading the axial ratio of the unit element. The validity of the design is confirmed by the measurements. The dipole array has negligible effects upon slot impedance; the polarization conversion for existing narrow-wall slotted arrays is realized by add-on dipole array.

• Current Optics and Photonics
• /
• v.6 no.1
• /
• pp.23-31
• /
• 2022

Heterodyne efficiency is an indicator to evaluate the performance of space coherent laser communication systems. It is affected by signal light and local oscillator (LO) light amplitude, phase and polarization state. In this paper, based on the common heterodyne efficiency, a heterodyne efficiency model that can reflect polarization aberration of optical system is proposed. The heterodyne efficiency is analyzed when the signal light and the LO light are linearly polarized or circularly polarized. For a coherent communication optical system, when the incident signal light is right-circularly polarized light and the incident LO light is 45° linear polarized light. Based on the three-dimensional ray tracing theory and the heterodyne efficiency proposed in this paper, the change of polarization states and the distribution of heterodyne efficiency of the signal light and LO light influenced by the optical system's polarization aberration are analyzed. Analysis shows that the heterodyne efficiency model proposed in this paper can be used to evaluate coherent communication systems and reflect the influence of optical system polarization aberration.

• The Bulletin of The Korean Astronomical Society
• /
• v.40 no.2
• /
• pp.36.2-36.2
• /
• 2015

We report the first detection of linearly polarized emission at an observing wavelength of 350 mum from the radio-loud active galactic nucleus 3C 279. We conducted polarization observations for 3C 279 using the SHARP polarimeter in the Caltech Submillimeter Observatory on 2014 March 13 and 14. For the first time, we detected the linear polarization with the degree of polarization of $13.3%{\pm}3.4%$ (3.9sigma) and the electric vector position angle (EVPA) of $34.^{\circ}7{\pm}5.^{\circ}6$. We also observed 3C 279 simultaneously at 13, 7, and 3.5 mm in dual polarization with the Korean very long baseline interferometry (VLBI) Network on 2014 March 6 (single dish) and imaged in milliarcsecond (mas) scales at 13, 7, 3.5, and 2.3 mm on March 22 (VLBI). We found that the degree of linear polarization increases from 10% to 13% at 13 mm to 350 mum and the EVPAs at all observing frequencies are parallel within < $10^{\circ}$ to the direction of the jet at mas scale, implying that the integrated magnetic fields are perpendicular to the jet in the innermost regions. We also found that the Faraday rotation measures RM are in a range of $-6.5{\times}102{\sim}-2.7{\times}103$ rad m-2 between 13 and 3.5 mm, and are scaled as a function of wavelength:| {RM}| ${\backslash}propto$ {lambda }-2.2. These results indicate that the millimeter and sub-millimeter polarization emission are generated in the compact jet within 1 mas scale and affected by a Faraday screen in or in the close proximity of the jet.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.299-302
• /
• 2000

In this study, we have made the large holographic surface relief gratings on amorphous chalcogenide $As_{40}$$Ge_{10}$$Se_{15}$$S_{35}$ films by two beam interference using a He-Ne laser(632.8nm) light. The film thickness was about 0.6$\mu\textrm{m}$, we could magnify beam size by using beam expander. We made use $90^{\circ}$ holder which was made of reflection mirror and sample. Formed the surface relief structures were investigated using optical microscope. The diffraction efficiency was obtained by measuring +lst order intensity. In addition we investigated grating formation and diffraction efficiency as a function of polarization states which is linear or circular polarization. The results indicate that the grating was formed by linear polarized beam is better clear than that by circular polarized beam.