• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.7
• /
• pp.597-605
• /
• 2015

Negative impedance converter(NIC)-based non-Foster impedance matching is proposed for an electrically small antenna. The antenna considered in this work is a resistively loaded vee dipole(RVD) antenna, which has considerable reflection at the feed point because of its large negative input reactance. The non-Foster matching circuit built near the feed point consists of two-stage NIC circuit and a capacitor connected between the stages. The NIC is realized by using operational amplifiers(op-amps) and resistors. The circuit is designed by considering of the input impedance according to the finite open-loop gain of the practical NICs. The stability test of the impedance-matched RVD antenna is performed. The non- Foster matching circuit is implemented with the RVD antenna. The measured impedance demonstrates that the proposed non-Foster matching circuit effectively reduces the input reactance of the RVD antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.8
• /
• pp.920-926
• /
• 2008

In this paper, small epsilon negative(ENG) zeroth-order resonance(ZOR) antenna with improved bandwidth is presented. To reduce the size of ENG ZOR antenna without narrowing bandwidth, large shunt inductance is introduced by adding patterns on patch and meandered via. The effective permittivity of meandered via is less dependent of frequency than that of straight via in same size. Thus, ENG ZOR antenna with meandered via has broader bandwidth. As a result, the bandwidth of ENG ZOR antenna with meandered via is 1.38 times as broad as that of spiral ENG ZOR antenna with straight via. On the other hand, the area of ENG ZOR antenna is reduced by 64 % compared with that of conventional mushroom ZOR antenna.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.36 no.8
• /
• pp.843-850
• /
• 2012

To satisfy the operational requirements of surveillance radar and the operational concept of a ship combat system, an active-array-type antenna was designed using solid-state transmitters and receivers. The arrangement of the constituent electronic components of the antenna system, considerably large in size, and therefore, the antenna needs to be housed in a box. The rotational antenna system installed on a ship mast is installed in a sealed housing to protect the interior equipment from environmental conditions. The outer shape of the housing is that the antenna should be capable of rotating normally despite strong winds. Furthermore, in recent times, designs with low radar cross section (RCS) have attracted attention from the viewpoint of improving the stealth of the ship. In this light, four types of models are proposed for the outer shape design of the antenna system, and they are investigated from the viewpoint of low RCS design as well as wind load.

• Current Industrial and Technological Trends in Aerospace
• /
• v.8 no.2
• /
• pp.39-45
• /
• 2010

Satellites are generally put in horizontal configuration to install a weighty, large and deploying SAR antenna which is required precise alignment. It is not to damage an antenna deployment mechanism from impellent strength as SAR antenna rotation axis is aligned with the gravity axis and SAR antenna is put in a zero gravity condition. In order to install such a deploying antenna, satellite should be a same condition of the vertical configuration without the deflection of satellite when it is rotated horizontally. In this paper, it is shown how to measure the deflection of satellite and how to get a reaction force value for compensating the deflection.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.581-586
• /
• 2002

The development of 2-D radiometer is a new technical challenge for space borne remote sensing area. The Y-type antenna array has been proposed as a most efficient configuration because a large alias free FOV and a small-synthesized beam-width can be achieved compared to L-, T-type under the fixed antenna spacing. New configuration of antenna array, which is called sub-Y type configuration, is proposed to obtain a higher angular resolution than the case of Y-type array in the paper. The sub-Y type array is consisted of basic arrays, which are the Y-type array of four antenna elements. To analyze characteristics of the proposed configuration, the synthesized beam pattern is simulated through simulation. The secondary effect of the sub-Y-type is that the reconstructed image is suffered from the alias effect is appeared around the real target. The ghost targets in the reconstructed image can be reduced by the alias suppression algorithm introduced in this paper. In conclusion, the performance evaluation by use of array factor simulation shows more than 37.5% improvement in average for angular resolution and almost similar performance for temperature resolution.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.6 no.3
• /
• pp.162-167
• /
• 2013

The variation of S11 depending on the ground sizes of circular planar monopole UWB antenna was studied. And optimal ground structure and size in UWB application devices are proposed. Radius R of circular monopole UWB antenna as a reference antenna was designed for UWB frequency band, and the measured results of this antenna on the horizontal ground plane was good agreed with the simulated results. When radius R is small, optimal size of ground plane is proposed, and when radius R is more large, minimum size of ground plane is proposed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.7 no.2
• /
• pp.147-156
• /
• 1996

In this paper we proposed a beam steering equation for the planar slotted waveguide array antenna. The tilt angle measured from the rotating axis and the aperture distribution of the antenna were the most important factors for the beam steering. From the equation, we calculated the frequency and phase distribution of the aperture for any desired beam direction. And we developed a high speed control algorithm delivering the phase data to the phase shifters of a one-dimensional phased array antenna. To reduce complexity of the control circuit and the phase delivery time, we proposed the serial phase repeating method. Because of its simplicity, we expect it can be useful for a large 2- dimensional fully phased array antenna.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.20 no.3
• /
• pp.413-420
• /
• 2017

We investigate the performance of a true time delay(TTD) phase shifter to reduce the beam squint caused by frequency changes of a phased array antenna in wideband communication systems. To design a high gain phased array antenna, we need a long TTD, which causes high RF loss, low resolution and large dimension of TTD phase shifters. To overcome the problems, we propose a schematic of dual TTD phase shifters, which consists of short time delay(STD) in radio frequency(RF) part and long time delay(LTD) in intermediate frequency(IF) part. Our analysis results show that the proposed scheme reduces the required bits and delay time in RF band of the TTD compared to the conventional single TTD scheme.

• Proceedings of the IEEK Conference
• /
• 2000.06b
• /
• pp.282-285
• /
• 2000

Four helical resonators are distributed in a 2 ${\times}$ 2 array by modifying upper part of the conventional reactive ion etching(RIE) type LCD etcher in order to prepare a large area plasma source. Since the resonance condition of the RF signal to the helical antenna, one RF power supply is used for delivering the power efficiently to all four helical resonators without an impedance matching network Previous work of 2 ${\times}$ 2array inductively coupled plasma(ICP)requires one matching circuit to each ICP antenna for more efficient power deliverly Distributions of ion density and electron temperature are measured in terms of chamber pressure, gas flow rate and RF power . By adjusting the power distribution among the four helical resonator units, argon plasma density of higher than 10$\^$17/㎥ with the uniformity of better than 7％ can be obtained in the 620 ${\times}$ 620$\textrm{mm}^2$ chamber.

• Journal of Communications and Networks
• /
• v.9 no.2
• /
• pp.141-149
• /
• 2007

Multiple-input multiple-output (MIMO) transmit pre-coding/beamforming can significantly improve system spectral efficiency. However, several obstacles prevent precoding from wide deployment in early wireless networks: The significant feedback overhead, performance degradation due to feedback delay, and the large storage requirement at the mobile devices. In this paper, we propose a precoding method that addresses these issues. In this approach, only 3 or 6 bits feedback is needed to select a precoding matrix from a codebook. There are fifteen codebooks, each corresponding to a unique combination of antenna configuration (up to 4 antennas) and codebook size. Small codebooks are prestored and large codebooks are efficiently computed from the prestored codebook, modified Hochwald method and Householder reflection. Finally, the feedback delay is compensated by channel prediction. The scheme is validated by simulations and we have observed significant gains comparing to space-time coding and antenna selection. This solution was adopted as a part of the IEEE 802.16e specification in 2005.