• Geophysics and Geophysical Exploration
• /
• v.15 no.2
• /
• pp.92-101
• /
• 2012

Three-dimensional finite-difference simulation in a small-scale half-sphere basin with planar free-surface is performed for an arbitrary shear-dislocation point source. A new scheme to deal with free-surface boundary condition is presented. Then basin parameters are examined to understand main characteristics on ground-motion response in the basin. To analyze the frequency content of ground motion in the basin, spectral amplitudes are compared with each other for four sites inside and outside the basin. Also particle motions for those sites are examined to find which kind of wave plays a dominant role in ground-motion response. The results show that seismic energy is concentrated on a marginal area of the basin far from the source. This focusing effect is mainly due to constructive interference of the direct Swave with basin-edge induced surface waves. Also, ground-motion amplification over the deepest part of the basin is relatively lower than that above shallow basin edge. In the small-scale basin with relatively simple bedrock interface, therefore, the ground-motion amplification may be more related to the source azimuth or direction of the incident waves into the basin rather than depth of it.

• Economic and Environmental Geology
• /
• v.51 no.3
• /
• pp.233-248
• /
• 2018

Strata of the Central sub-basin in the Gunsan Basin, offshore, western Korea were analyzed by using integrated stratigraphy approach. As a result, five distinct unconformity-bounded units are recognized in the basin: Sequence I (Cretaceous or older(?)), Sequence II (Late Cretaceous), Sequence III (late Late Cretaceous or younger(?)), Sequence IV (Early Miocene or older(?)), Sequence V (Middle Miocene). Since the late Late Jurassic, along the Tan-Lu fault system wrench faults were developed and caused a series of small-scale strike-slip extensional basins. The sinistral movement of wrench faults continued until the Late Cretaceous forming a large-scale pull-apart basin. However, in the Early Tertiary, the orogenic event, called the Himalayan Orogeny, caused basin to be modified. From Late Eocene to Early Miocene, tectonic inversion accompanied by NW strike folds occurred in the East China. Therefore, the late Eocene to Oligocene was the main period of severe tectonic modification of the basin and Oligocene formation is hiatus. The rate of tectonic movements in Gunsan Basin slowed considerably. In that case, thermal subsidence up to the present has maintained with marine transgressions, which enable this area to change into the land part of the present basin.

• Geophysics and Geophysical Exploration
• /
• v.20 no.2
• /
• pp.88-95
• /
• 2017

Chogye basin, which is surrounded by country rock, has a closed-basin form. In such a basin, incident seismic energy can form multiply reflected waves, thus causing energy concentration to occur at this closed-basin area. Microtremor measurement survey was performed at the Chogye basin, which is located in Chogye-myeon and Jeokjungmyeon, Hapcheon-gun, Gyeongsangnam-do, Republic of Korea. Microtremor data were transformed into the frequency domain, and then the horizontal-to-vertical spectral ratios (HVSR) were calculated. Fundamental resonance frequencies were estimated from the HVSR results for every observation point. Using the empirical relationship between site period and thickness for sediment sites in Korea known from the previous study, the distribution of sediment thickness of the Chogye basin was estimated from the fundamental resonance frequencies. Being compared with the mountainous rim with steep slope, the measurement points inside the basin have low values of the fundamental resonance frequency with the minimum of 1.03 Hz, which corresponds to the thickness of sedimentary layer with the maximum depth of about 100 m. A three-dimensional basin model was constructed for bedrock topography of the Chogye basin by an interpolation of basin depths estimated at each measurement site.

• The Korean Journal of Petroleum Geology
• /
• v.7 no.1_2 s.8
• /
• pp.28-34
• /
• 1999

The Cretaceous Poongam sedimentary Basin in Kangwon-do, Korea consists alluvial deposits of conglomerates, sandstones, mudstones or siltstones, and volcaniclastics. The Poongam Basin was formed as a fault margin sag or a transpressional basin developed along a strike-slip fault zone, and received huge amount of clastic sediments from the adjacent fault-scaip. It formed an aggrading alluvial fan system and a volcaniclast-supplied marginal lake environment, while tectonic activity and volcanism attenuated toward the end of basin formation. Following the Folk's classification, the sandstones of the Poongam Basin are identified as lithic wackes or feldspathic wackes. The areal and sequential variation of the mineral composition in the sandstones is not distinct. The results of K-Ar age dating from the intruding andesites, volcaniclastics and volcanic fragments in sedimentary rocks show a range of 70 Ma to 84 Ma. It suggests that volcarism occurred sequentially within a relatively short period as the pre-, syn-, and post-depositional events. It was the short period in the late Cretaceous that the basin had evolved i.e., the basin formation, the sediment input and fill, and the , intrusion and extrusion of volcanic rocks occurred. The Poongam sedimentary sequence is a typical tectonic-controlled coarse sedimentary facies which is texturally immature.

• Journal of the Korean association of regional geographers
• /
• v.3 no.1
• /
• pp.51-62
• /
• 1997

In various places of drainage basins of major rivers in South Korea are distributed intermontane basins. Basin floor covered with fluvial deposits carried from the surrounding mountane area becomes alluvial plain. Its productivity is comparatively higher than anywhere else. Thus basin is a local administrative, economic, and cultural core area. Intermontane basin consists of backward mountane area, gentle hills, and alluvial lowland. The purpose of this paper is to elucidate the morpogenetic processes and development age of Angae Basin located in the sedimentary rock region. Hills with the height of a.s.l. $80{\sim}100m$ distributed in Angae Basin are residual landforms, which are the remnants of dissection of the etchplain that results from the denudation of bedrock deeply weathered along tectolineaments under the warm and moist climate, and reflect lithological differentiation of bedrock. Those hills have been comparatively higher ridges since the initial stage of the original etchplain, and they have been immune from fluvial processes. The etchplain appeared as $80{\sim}100m$ hills. the high terrace distributed in upstream reach of Nakdong River drainage basin and the old meander-cut at Seoburi in Wicheon drainage basin, are formed at the same stage when riverbed of Wicheon Stream functioned as a local base level according as the fluvial system of Wichoen arrived at dynamic equilibrium.

• Korean Journal of Mineralogy and Petrology
• /
• v.35 no.3
• /
• pp.235-258
• /
• 2022

We interpreted the evolutionary history of the southwestern part of the Pohang Basin, the largest Miocene basin in the southeastern part of the Korean Peninsula, based on the detailed geological mapping and analysis of the geological structures. The southwestern part of the Pohang Basin can be divided into the Bomun Domain in the west and Ocheon Domain in the east by an NNE-trending horst-in-graben. These two domains have different geometries and deformation histories. The Bomun Domain was rarely deformed after the incipient extension of the basin, whereas the Ocheon Domain is an area where continued and overlapped deformations occurred after the basin fill deposition. Therefore, the Bomun Domain provides critical information on the initial extension mode of the Pohang Basin. The subsidence of the Bomun Domain was led by the zigzag-shaped western border fault that consists of NNE-striking normal and NNW-striking dextral strike-slip fault segments. This border fault is connected to the Yeonil Tectonic Line (YTL), a regional dextral principal displacement zone and the westernmost limit of Miocene crustal deformation in SE Korea. Therefore, it is interpreted that the Pohang Basin was initially extended in WNW-ESE direction as a transtensional fault-termination basin resulting from the movement of NNE-striking normal and/or oblique-slip faults formed as right-stepover in the northern termination of the YTL activated since approximately 17-16.5 Ma. As a result, an NNE-trending asymmetric graben or half-graben exhibiting an westward deepening of basin depth was formed in the Bomun Domain. Afterward, crustal extension and deformation were migrated to the east, including the Ocheon Domain.

• Journal of Korean Society on Water Environment
• /
• v.29 no.3
• /
• pp.438-442
• /
• 2013

According to Geum-River restoration project, given conditions for management of water environment in the Geum-River were changed. Because of those changes, this study was investigated the establishment of water quality standards and water quality target in the Geum-River basin. For management of water environment in the Geum-River, the sub-basins and watersheds are newly divided and the water quality and ecosystem standards in the sub-basins are reestablished. Considering the consistency of water environment policy and legal system, the legal name of sub-basins and watersheds are unified. TMDL (total maximum daily load) should be implemented in the sub-basin where exceeds the water quality standards and the number of water pollutant among the water quality parameters which exceeds the water quality standards are extremely minimized. The water quality target of water pollutant for implementation of TMDL should be established same or higher concentration of water quality standards.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2003.10a
• /
• pp.507-510
• /
• 2003

The development of a basin-wide runoff analysis model is to analysis monthly and daily hydrologic runoff components including surface runoff, subsurface runoff, return flow, etc. at key operation station in the targeted basin. A short-term water demand forecasting technology will be developed taking into account the patterns of municipal, industrial and agricultural water uses. For the development and utilization of runoff analysis model, relevant basin information including historical precipitation and river water stage data, geophysical basin characteristics, and water intake and consumptions needs to be collected and stored into the hydrologic database of Integrated Real-time Water Information System. The well-known SSARR model was selected for the basis of continuous daily runoff model for forecasting short and long-term natural flows.

• Journal of Korean Society on Water Environment
• /
• v.22 no.4
• /
• pp.619-625
• /
• 2006

Amount of soil loss is important information for the proper water quality management, In this research, annual average soil loss of the Geum River basin was estimated using RUSLE (Revised Universal Soil Loss Equation) and GIS (Geographic Information System). Input data were manipulated using ArcGIS ver. 8.3. From crop field which constitute 8.2% of the Geum River Basin, annual average soil loss was estimated as 53.6 ton/ha/year. From the rice paddy field which constitutes 20% of the Geum River Basin, soil loss was estimated as 33.5 ton/ha/year, In comparison, forestry area which constitutes 61.8% of the basin discharged 2.8 ton/ha/year, It could be known from this research that appropriate measures should be implemented to prevent excessive soil loss from the agricultural areas.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.3
• /
• pp.279-290
• /
• 2004

Sludge quantity has increased at "A"water treatment plant due to deterioration of raw water quality and GAC installation. Increased sludge resulted in overloading on sludge handling facilities. The object of this study is to survey sludge quantity and capacity of sludge handling facilities at "A"water treatment plant. Measured quantity of sedimentation sludge considerably exceeded the design capacity of sludge holding basin. Sludge holding basin was properly designed, but low concentration of sludge discharged from sedimentation basin caused production of large volume of the sludge. Timer operated control system for sludge withdrawal unit and leakage through a control valve were suspected to cause the low concentration. Augmentation of the control system by a turbidity meter and addition of a new control valve successfully reduced the sludge volume enough to satisfy the design capacity of sludge holding basin. Unlike sedimentation sludge, measured quantity of washwater was considerably less than the design capacity of washwater basin because it was over-designed.