• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.231-233
• /
• 2001

This paper describes an analytical solution of the voltage commands for instantaneous torque control of an I.M. The analytical solution is expressed as a simple explicit function of the instantaneous torque commands and motor speed. On the basis of the derived analytical solution, the maximum torque change rate of an I.M with a limited voltage-source is analyzed, and also the dynamic influence of rapid changes in motor speed on output torque derivations is investigated. The detailed results of these two analyses are approximated here in term of first-order linear differential equations, and their validities are confirmed through the demonstrative numerical simulations. This paper includes the simulation results of the instantaneous torque control with varied motor parameters for sensitivity analysis.

• 한국전산유체공학회지
• /
• 제5권1호
• /
• pp.27-32
• /
• 2000

This study investigates the problem of phase change from liquid to solid in the inviscid stagnation flow. The instantaneous location of the solid-liquid interface is fixed for all times by a coordinate transformation. Finite difference method is used to obtain the solution of the unsteady problem, and the growth rate of solid and the transient heat transfer from the surfaces of solid are investigated. The transient solution is dependent on the three dimensionless parameters, but the final steady state is determined by only one parameter of temperature ratio/conductivity ratio. It is observed that the instantaneous heat flux at the surface of solid can be obtained with sufficient accuracy by measuring the thickness of the solid or vice versa.

• 대한수학교육학회지:수학교육학연구
• /
• 제27권1호
• /
• pp.1-22
• /
• 2017

본 연구에서는 고등학교 1학년 학생들을 대상으로 학생들이 함숫값의 변화를 인식하는 과정에서 어떠한 변화율 개념을 가지고 있는지 확인하고, 변화율 개념에 따라 어떻게 구간에서 함수의 변화를 인식하고 표현하는지에 대하여 6차시에 걸친 교수실험을 실시하였다. 그 결과 학생들이 함수의 변화를 분석하는데 변화율 개념을 이용되기는 하지만, 학생들의 변화율에 대한 인식과 표현이 다양하고 이에 따라 평균변화율에 대한 인식에 있어서도 차이가 나타나는 것으로 관찰되었다. 다만 이 차이를 질적인 수준차로 보아야할 것인지에 대하여는 추후 연구가 필요할 것으로 보인다. 본 연구는 변화율에 대한 학생의 인식을 세밀하게 조사한 연구로써 향후 변화율 관점에서의 미분학습에 대한 연구에 기초자료가 될 것으로 기대된다.

• Journal of Welding and Joining
• /
• 제17권5호
• /
• pp.61-68
• /
• 1999

For the last two decades, waveform control techniques have been successively developed and applied for the inverter welding machines resulting in the substantial reduction of spatter generated in CO₂ welding. One of the constituents commonly involved in those techniques is to delay the instant of current increase to some extent after the initiation of short-circuiting. Although this technique has been known to be quite effective in reducing the spatter generation through the suppression of is instantaneous short circuiting, the delay time necessary for minimum spatter has not been clearly understood. In this study, the control system for varying the delay time was constructed so that the spatter generation rates could be measured over a wide range of delay time, 0.29-2.0 msec. As a result of this study, it was demonstrated that spatter generation rate(SGR) sharply decreased at delay time of 0.6 msec and longer accompanied with the change in characteristics of short circuit mode from the instantaneous short-circuiting(ISC) dominant to normal short-circuiting(NSC) dominant. Another feature that have been found in current waveform of over 0.6msec was the creation of current pulse right after the arc reignition stage. Because of this current pulses weld pool oscillated in wave-like fashion and it looks like to play an important role in developing short circuiting between electrode and weld pool.

• Journal of Welding and Joining
• /
• 제15권2호
• /
• pp.72-80
• /
• 1997

The spatter generation rate of GMA welding with $CO_2$ gas shielding was measured with the change of welding conditions such as wire feeding rate and welding voltage and then the results were analized with the accompanying changes in metal transfer mode and in bead geometry. The spatter generation rate (SGR) was relatively low not only wit the short circuit transfer but with the truely globular transfer mode. However, the SGR resulted with the mixed mode were consistantly high. The resultant wave pattern of mixed mode was due to the coexistance of short-circuit and globular transfer and characterized by the frequent appearance of instantaneous short circuit. Considering the result of SGR and that of bead geometry, it could be concluded that when the wire feeding rate (or welding current) was either low or high, the optimum bead shape could be obtained along with the low spatter generation. However, in the middle range of wire feeding rate, the optimum bead shape was only obtained in the mixed mode condition resulting in the high spatter generation.

• 한국정보통신학회논문지
• /
• 제22권10호
• /
• pp.1379-1385
• /
• 2018

기존의 다중사용자 중첩 전송은 순시 채널 전력의 조건에 따라 데이터 심벌의 전력 할당 계수와 사용자별 수신 신호 처리 방법을 결정한다. 그러나 순시 채널 전력의 이용은 시스템의 복잡도를 증가시킬 수 있기 때문에 본 논문에서는 평균 채널 전력을 이용하는 고정적 다중사용자 중첩 전송을 고려한다. 고정적 다중사용자 중첩 전송 기법은 시간에 따라 느리게 변화하는 평균 채널 전력의 조건을 기반으로 데이터 심벌의 전력 할당 계수와 사용자별 수신 신호 처리 방법을 결정하기 때문에 시스템 복잡도를 감소시킬 수 있다. 본 논문에서는 고정적 다중사용자 중첩 전송에 대한 평균 심벌 오차율을 분석한다. 특히, 레일레이 페이딩 채널을 가정하여 M-ary 직교 진폭 변조에 대한 평균 심벌 오차율의 표현식을 유도한다. 또한, 수치적 결과를 통하여 열악한 채널 환경에 있는 사용자에서 고정적 다중사용자 중첩전송과 기존의 다중사용자 중첩 전송의 평균 심벌 오차율 성능이 유사함을 보였다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.1933-1938
• /
• 2004

Nucleate boiling experiments with constant wall temperature of heating surface were performed using R113 for almost saturated pool boiling conditions. A microscale heater array and Wheatstone bridge circuits were used to maintain a constant wall temperature condition and to measure the heat flow rate with high temporal and spatial resolutions. Bubble images during the bubble growth were taken as 5000 frames a sec using a high-speed CCD camera synchronized with the heat flow rate measurements. The geometry of the bubble during growth time could be obtained from the captured bubble images. The bubble growth behavior was analyzed using the new dimensionless parameters for each growth regions to permit comparisons with previous results at the same scale. We found that the new dimensionless parameters can describe the whole growth region as initial and later respectively. The comparisons showed good agreement in the initial and thermal growth regions. The required heat flow rate for the volume change of the observed bubble was estimated to be larger than the instantaneous heat flow rate measured at the wall. Heat, which is different from the instantaneous heat supplied through the heating wall, can be estimated as being transferred through the interface between bubble and liquid even with saturated pool conditions. This phenomenon under a saturated pool condition needs to be analyzed and the data from this study can supply the good experimental data with the precise boundary condition (constant wall temperature).

• Journal of Information Processing Systems
• /
• 제19권6호
• /
• pp.817-829
• /
• 2023

Variable wireless channel is a big challenge for real-time video applications, and the rate adaptation of realtime video streaming becomes a hot topic. Intra-video coding is important for high-quality video communication and industrial video applications. In this paper, we proposed a novel adaptive scheme for real-time video transmission with intra-only coding over a wireless network. The key idea of this scheme is to estimate the instantaneous remaining capacity of the network to adjust the quality of the next several video frames, which not only can keep low queuing delay and ensure video quality, but also can respond to bandwidth changes quickly. We compare our scheme with three different schemes in the video transmission system. The experimental results show that our scheme has higher bandwidth utilization and faster bandwidth change response, while maintaining low queuing delay.

• 대한기계학회논문집B
• /
• 제29권5호
• /
• pp.633-642
• /
• 2005

Nucleate pool boiling experiments for R11 under a constant wall temperature condition were carried out. A microscale heater array was used for the heating and the measurement of high temporal and spatial resolution by the Wheatstone bridge circuit. Very sensitive heat flow rate data were obtained by the control for the surface condition with high time resolution. The measured heat flow rate shows a discernable peak at the initial growth stage and reaches an almost constant value. In the thermal growth region, bubble shows a growth proportional to $t^{\frac{1}{5}}$. The bubble growth behavior is analyzed with a dimensionless parameter to compare with the previous results in the same scale. As the wall superheat increases, the departure diameter and the departure time increase, and the waiting time decreases. But the asymptotic growth rate is not affected by the wall superheat change. The effect of the wall superheat is resolved into the suggested growth equation. Dimensionless parameters of time and bubble radius characterize the thermal growth behavior well, irrespective of wall condition. The comparison between the result of this study and the previous results shows a good agreement at the thermal growth region. The quantitative analysis for the heat transfer mechanism is conducted with the measured heat flow rate behavior and the bubble growth behavior. The required heat flow rate for the volume change of the observed bubble is about twice as much as the instantaneous heat flow rate supplied from the wall.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2003년도 제20회 춘계학술대회 논문집
• /
• pp.253-257
• /
• 2003

Theoretical-numerical analysis of wave instability is conducted with parametric response function model. Fluctuating instantaneous mass evaporation rate functionally coupled with pressure perturbations with phase lag is assumed to examine the validity of the method. With sufficiently large amplitude and less phase lag to perturbation, combustion response is resonant to pressure waves, unstable waves are amplified, and the system is driven to instability. Magnitude of response is a crucial instability parameter in the determination of a stability margins and makes a critical change of balancing conditions between the amplifying and damping acoustic energies. In the phase regime the unstable waves are amplified, whereas, the acoustic waves are attenuated in the out-of-phase regime. In the intermediate regime, no distinct tendency of unstable waves was determined.