• Journal of Conservation Science
• /
• v.16 s.16
• /
• pp.110-118
• /
• 2004

In order to evaluate two-step treatment of PEG-freeze drying for highly-degraded waterlogged ash woods (Fraxinus PP.; ca. 5,700 BP), which were excavated from peat lands in western Korea, dimension stability was examined during 45 months after complete treatment. The samples pre-treated with PEG in water solution showed better dimensional stabilities than the ones with PEG in t-butanol(TBA) solution. It suggests that TBA reduced the flexibility of wood cells and overflying by TBA induced micro-checks during freeze drying. Micro-checks results in fragile wood structures and consequently, large shrinkage by moisture absorbances of high PEG contents during exposure in humid condition. The results suggest that PEG in water-solution treatment is better than PEG in t-butanol as pretreament for freeze drying of highly-degraded waterlogged ash woods.

• Journal of Biosystems Engineering
• /
• v.36 no.5
• /
• pp.319-325
• /
• 2011

This study was conducted to figure out the diagnosis basis of cooling performance depending on water amount in the refrigerant of air conditioner, which can be estimated by the temperatures and pressures along the refrigerant circulation line. A car air conditioner of SONATA III (Hyundai motor Co., Korea) was tested at maximum cooling condition at the engine speed of 1500 rpm in the room controlled at 33~$35^{\circ}C$ air temperature and 55~57% relative humidity conditionally. Measured variables were temperature differences between inlet and outlet pipe surfaces of the compressor, condenser, receive drier and evaporator; and high pressure and low pressure in the refrigerant circulation line; and temperature difference between inlet and outlet air of the cooling vent of evaporator. In this study, changes of the water amount in the refrigerant were correlated to the temperatures and pressure changes and also water amount caused poor cooling performance. As water amount increased in the refrigerant in the air conditioner, the performance of the cooling or the heat transfer became worse. Temporal variations of the surface temperature of the evaporator outlet pipe and the low-side pressure showed various patterns that could estimate the water amount. When the water amount caused bad cooling performance, the patterns of the temperature of the evaporator outlet pipe indicated irregular fluctuation greater than $5^{\circ}C$. When the diagnosis system is using just external sensors of the low-side pressure and the temperatures of inlet and outlet air of cooling vent of the evaporator, the precise pattern of bad cooling performance caused by excess water amount in the cooling line was irregular pressure fluctuation, 25 kPa under 120 kPa, and temperature, $12^{\circ}C$ and less.

• Proceedings of the KAIS Fall Conference
• /
• 2010.11b
• /
• pp.878-881
• /
• 2010

For better diagnosis and prescription in Korean traditional medicine, Lee Je-Ma (1837-1900) created Sasang Constitution classification which was divided into four groups of Taeyangin, Soyangin, Taeumin and Soumin based on both body shape and natural disposition. The purpose of this study was to investigate the characteristics of facial skin parameters (hydration, lipid and pH) on forehead and cheek according to Sasang Constitution classifications of Taeumin, Soyangin and Soumin in Korean. Eighty-nine Korean female subjects were recruited for this study and the average age of them was 19.9${\pm}$0.84 years. The four groups by the Sasang Constitution were classified by questionnaire for the Sasang Constitution classification proposed by Kyung-Hee Oriental Medicine Hospital. Consequently, thirty-eight (42.7%) among the subjects were grouped into Soumin, twenty-nine (32.6%) into Taeumin, twenty (22.5%) into Soyangin and two (2%) into Taeyangin. Taeyangin group was excluded from statistical analysis due to small subjects. Hydration, lipid and pH parameters on forehead and cheek were measured by using non-invasive instruments of Corneometer (CM 825, Schwarzhaup, Germany), Sebumeter (SM 815, Schwarzhaup, Germany) and Skin-pH-meter (pH 905, Schwarzhaup, Germany), respectively. The measurements by the same investigator were performed under standardized condition with a room temperature of $21^{\circ}C$ and a humidity level of 40% to 50%. As a result, hydration (F=25.481, p=.000), lipid (F=5.753, p=.005) and pH (F=5.010, p=.009) of the forehead skin showed significant differences in the order of Taeumin, Soyangin and Soumin. Hydration (F=23.216, p=.000), lipid (F=6.898 p=.002) and pH (F=5.070, p=.008) of the cheek skin showed significant differences in the order of Taeumin, Soyangin and Soumin. In conclusion, facial skin surface seemed to be dependent on Sasang Constitution classification in Korean. These findings indicated that Sasang Constitution classification might be an useful esthetic treatment for caring facial skin in the future.

• Journal of Korean Society for Atmospheric Environment
• /
• v.31 no.4
• /
• pp.319-329
• /
• 2015

The characteristics of aerosol light extinction were investigated by comparing measured and calculated extinction coefficient to understand the contribution of air pollutants on visibility impairment for data during 4 months (Jan~ April), 2014. The integrated nephelometer and aethalometer system were installed to measure the scattering and absorption coefficients of aerosol as well as BAM 1020, MARGA, semi-continuous OCEC analyzer, and online-XRF to calculate the extinction coefficient. The IMPROVE_2005 equation was used to determine the contributions of different chemical components on visibility impairment in $PM_{2.5}$ and $PM_{10}$ due to highest correlation with measured data. Sulfate, nitrate, and organic mass by carbon (OMC) of fine aerosol were the major contributors affecting on visibility impairment. Total contributions to light extinction were calculated as $631.0Mm^{-1}$ for the worst-case and $64.4Mm^{-1}$ for the best-case. The concentrations of aerosol component for the worst-case were 38.4 times and 45.5 times larger than those of the best-case for $(NH_4)_2SO_4$ and $NH_4NO_3$, respectively. At lower visibility condition, in which extinction coefficient was higher than $400Mm^{-1}$, extinction coefficient varied according to the relative humidity variation regardless of $PM_{2.5}$.

• Korean Journal of Human Ecology
• /
• v.18 no.5
• /
• pp.1087-1092
• /
• 2009

From the environmental adaptation point of view, the clothing habits made by the thermal sensation and clothing weight of elderly women have changed according to the thermal sensation and health condition. The purpose of this study was to obtain the basic data for developing healthy and comfortable clothing for elderly women. Clothing weight, thermal sensation, clothing microclimate, resistance to cold and heat of 198 elderly women in Taejeon were surveyed from October 9, 2007 to October 19, 2007. 1. Clothing weight per body surface area was $830.4g/m^2$ of total clothing weight, $242.8g/m^2$ of underwear clothing weight, $617.3g/m^2$ of outerwear clothing weight, $419.8g/m^2$ of upper clothing weight, and $420.4g/m^2$ of lower clothing weight. 2. More than 90% of the respondents replied that they felt comfortable when the temperature inside the clothing was $33.5^{\circ}C$ and humidity inside the clothing was 30.2%. 3. The elderly women were more sensible to cold than to hot, those who felt cold had a tendency to wear heavier clothing. 4. The appeal rate for physical pain of older and lower income people, especially those with an income under 1,000,000 won, was higher than that of others. On the other hand, the lower the subjective economic level, the younger they were, and the more the monthly average income was, the higher the rate of mental pain. 5. The heavier the total clothing weight was, the higher the appeal rate for general pain.

• Proceedings of the KIEE Conference
• /
• 2006.10c
• /
• pp.600-602
• /
• 2006

Some abnormal signals diagnostics and analysis through an important equivalent circuits modeling for passive elements under severe accident conditions have been performed. Unlike the design basis accidents, there are inherently some uncertainties in the instrumentation capabilities under the accident conditions. So, the circuit simulation analysis and diagnosis methods are used to assess instruments in detail when they give apparently abnormal readings as an accident alternative method. The simulations can be useful to investigate what the signal and circuit characteristics would be when similar to a variety of symptoms that can result from the environmental conditions such as high temperature, humidity, and pressure condition. In this paper, a new simulator through an analysis of the important equivalent circuits modeling under temperature accident conditions has been designed, the designed simulator is composed of the LabVIEW code as a main tool and the out-put file of the Multi-SIM code as an engine tool is exported to in-put file of the LabVIEW code. The procedure for the simulator design was divided into two design steps, of which the first step was the diagnosis method, the second step was the circuit simulator for the signal processing tool. It has three main functions which are a signal processing tool, an accident management tool, and an additional guide from the initial screen. This simulator should be possible that it could be applied a output signal analysis to some transient signal by variation of the resistance passive elements in the R-L-C equivalent circuit modeling under various degraded conditions in NPPs.

• Plant Journal
• /
• v.13 no.1
• /
• pp.37-43
• /
• 2017

This study analyzed the change of gas turbine performance with air temperature decrease by the evaporation cooling system in summer season. Gas turbine performance was tested on the condition that ambient temperature is $29{\pm}1^{\circ}C$. As a result, Air temperature at the compressor inlet was decreased by $4.12^{\circ}C$ after the installation of evaporation cooling system. Decreased air temperature followed by increased air density affected gas turbine performance, Which increased compressor pressure ratio by 0.27, improved compressor efficiency of 0.29 %p, improved gas turbine enthalpy drop efficiency of 0.31 %p, improved the gas turbine efficiency by 0.44 %p, improved electric power output by 4,489 kW. On the other side, the influence of the humidity increase and flow resistance increase was negligible.

• Proceedings of the Plant Resources Society of Korea Conference
• /
• 2018.10a
• /
• pp.86-86
• /
• 2018

This study was conducted to investigate the effects of modified drum priming and 24-Epibrassinolide (24-EBL) treatment to improve the seed quality for export. 40, 50 and 60% seed moisture content (SMC) of hydrated seeds were incubated for 16 and 24 h in a container with a relative humidity of 99% at 26 rpm for a modified drum priming treatment. The treated seeds were sown at $20^{\circ}C$ and $30^{\circ}C$ (12/12h, light/dark) with four replications of 25 seeds on pleated paper. The seeds were hydrated with water or 24-EBL solutions of $10^{-7}$, $10^{-8}$ and $10^{-9}M$, respectively. The germination of the modified drum primed seeds (24 h incubation after 60% SMC hydration) improved to 1.6 days mean germination time (MGT) and $46%{\cdot}day^{-1}$ germination rate (GR), while the untreated seeds showed 2.1 days MGT and $28%{\cdot}day^{-1}$ GR. The modified drum priming (60% SMC and 24 h incubation with $10^{-9}M$ 24-EBL) showed improved results in MGT (1.8 days) and GR (55%) at $20^{\circ}C$, whereas untreated seeds showed 2.3 days MGT and 44% GR. Under $30^{\circ}C$, germination of modified drum primed seeds was significantly improved in GP (80%), GR ($31%{\cdot}day^{-1}$), HS (55%) and MGT (3.3 days), however, untreated seeds showed decreased GP (27%), GR ($22%{\cdot}day^{-1}$), HS (55%) and MGT (4.8 days). This study showed that the germination of lettuce seeds is enhanced by 24 h drum incubation with 24-EBL and this method can be used effectively to achieve the benefits of early germination and uniform seedling development. In addition, these treatments circumvent thermo-dormancy of lettuce seed and have a possibility of high-quality and environment-friendly seed processing.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.7 no.3
• /
• pp.79-89
• /
• 2004

Remote sensing technique is a probable means to estimate distribution of actual evapotranspiration in connection with regional characteristics of vegetation and landuse. The factors controlling evapotranspiration from ground surface are air temperature, humidity, wind, radiation, soil moisture and so on. Not only the vegetation influences directly the evapotranspiration, but also these factors strongly influences the vegetation growth at the area. Therefore, it can be expected that evapotranspiration is highly correlated to vegetation condition. The normalized difference vegetation index (NDVI) showed excellent ability to get the vegetation information. The NDVI is obtained using NOAA/AVHRR have been studied as a tool for vegetation monitoring. In this paper, a simple method to estimate actual avapotranspiration is proposed based on vegetation and meteorological data.

• Geophysics and Geophysical Exploration
• /
• v.18 no.3
• /
• pp.105-114
• /
• 2015

A long-term resistivity monitoring system has been developed for saturated cores in room temperature and humidity condition. A 3-channel water-pump continuously drops the water onto the top of saturated core sample surrounded by shrinkable tube as well as on the paper filters of the electrodes at both sides of the core sample, by which one can monitor the resistivity changes with maintaining full saturation of the rock core for a week or longer. Monitoring the resistivity changes has been performed with 3 kinds of rock samples including biotite gneiss, andesitic tuff, and shale for 9 days using the system. Consequently, it is proposed two hypothesis that conversion speed of temperature coefficient has close relation to the thermal properties of the rock sample and that the ratio of resistance between dry and saturated conditions for a rock sample can be related to the effective porosity of the sample. The ratio between dry and saturated resistance for the three rock types are 48, 705, and 2, while effective porosity was 3.7%, 3.3%, and 13.0%, respectively.