• Journal of Institute of Control, Robotics and Systems
• /
• v.13 no.11
• /
• pp.1060-1066
• /
• 2007

When a high-energy ultrasound propagates through a solid body that contains a crack or a delamination, the two faces of the defect do not ordinarily vibrate in unison, and dissipative phenomena such as friction, rubbing and clapping between the faces will convert some of the vibrational energy to heat. By combining this heating effect with infrared imaging, one can detect a subsurface defect in material efficiently. In this paper a detection of the welding defect of thin SUS 304 plates using the UIR (ultrasonic infrared imaging) technology is described. A low frequency (20kHz) ultrasonic transducer was used to infuse the welded thin SUS 304 plates with a short pulse of sound for 280ms. The ultrasonic source has a maximum power of 2kW. The surface temperature of the area under inspection is imaged by a thermal infrared camera that is coupled to a fast frame grabber in a computer. The hot spots, which are a small area around the defect tip and heated up highly, are observed. From the sequence of the thermosonic images, the location of defective or inhomogeneous regions in the welded thin SUS 304 plates can be detected easily.

• Journal of the Society of Naval Architects of Korea
• /
• v.55 no.4
• /
• pp.321-329
• /
• 2018

Resonance phenomena occurs at large vertical pump which is operating to cool down the hot steam using sea water in the power plant. To avoid the resonance, the natural frequency needs to be isolated about 20% from motor operating speed. Yet, excessive vibration occurs especially at low tide. At first, natural frequency of the whole pump system and each part is calculated using ANSYS. As it is revealed in the previous journal papers that only circular pipe part is related to resonance, the FSI technique is applied for free vibration analysis. The natural frequency is reduced to 60% (compared to that) of the frequency measured in air as it is similar to other published results. And the frequency obtained by finite element analysis is almost same to that obtained from modal test. Based on the accurate finite element model and analysis, design change is tried to avoid the resonance by changing the thickness of pipe and base supporting plate. In stead of doing optimization process, design sensitivity is computed and used to find such designs to avoid resonance.

• Biomolecules & Therapeutics
• /
• v.21 no.5
• /
• pp.391-397
• /
• 2013

In the present study, we aimed to analyze the antinociceptive, immunomodulatory and antipyretic activities of nymphayol were investigated in wistar rats and mice. Antinociceptive effect was evaluated by acetic acid induced writhing, formalin induced paw licking and hot-plate tests. Immunomodulatory activity was assessed by neutrophil adhesion test, humoral response to sheep red blood cells, delayed-type hypersensitivity, phagocytic activity and cyclophosphamide induced myelosuppression. Antipyretic activity was evaluated by yeast induced hyperthermia in rats. Nymphayol produced significant (p<0.05) antinociceptive activity in acetic acid induced writhing response and late phase of the formalin induced paw licking response. Pre-treatment with nymphayol (50 mg/kg, oral) evoked a significant increase in neutrophil adhesion to nylon fibres. The augmentation of humoral immune response to sheep red blood cells by nymphayol (50 mg/kg) was evidenced by increase in antibody titres in rats. Oral administration of nymphayol (50 mg/kg) to rats potentiated the delayed-type hypersensitivity reaction induced by sheep red blood cells. Treatment with nymphayol showed a significant (p<0.05) reduction in pyrexia in rats. The results suggest that nymphayol possesses potent anti-nociceptive, immunomodulatory and antipyretic activities.

• Current Photovoltaic Research
• /
• v.4 no.2
• /
• pp.59-63
• /
• 2016

A key point of a soldering process for photovoltaic (PV) modules is to increase an adhesive strength leading a low resistivity between ribbon and cell. In this study, we intended to optimize a heating condition for the soldering process and characterize the soldered joint via physical and chemical analysis methods. For the purpose, the heating conditions were adjusted by IR lamp power, heating time and hot plate temperature for preheating a cell. Since then the peel test for the ribbon and cell was conducted, consequently the peel strength data shows that there is some optimum soldering condition. In here, we observed that the peel strength was modified by increasing the heating condition. Such a soldering property is affected by a various factors of which the soldered joint, flux and bus bar of the cell are changed on the heating condition. Therefore, we tried to reveal causes determining the soldering property through analyzing the soldered interface.

• Journal of Welding and Joining
• /
• v.22 no.6
• /
• pp.19-24
• /
• 2004

The laser welding and its analysis of thin-sheet carbon steels were carried out with high power $CO_{2}$ laser. The main factor of weld quality of laser welding is gap and edge quality. This work was preformed to focus on the gap tolerance problem during laser welding. First, bead on plate welding of thin sheet was examined to investigate the effect of laser welding variables, and to obtain optimum welding condition. Butt welding was also carried out to show the effect of gap on the laser weldability of thin sheet. In order to investigate the effect of gap on formability of welded thin sheet, LDH test was caried out. At high welding speed, the partial penetration was obtained by low heat input. Otherwise, porosity was formed in the bead at low weld speed because of too much heat input. The optimum welding condition of welding was derived from bead width, penetration and hardness property. The maximum gap tolerance on laser welding was observed to be about 0.2mm. This gap size has good relationship with beam size of laser spot(about 0.3mm). The formability of welded sheet was about $80{\%}$ value of base metal and the gap size has not affected on the formability, although weld quality is dependent on the gap size.

• Journal of Energy Engineering
• /
• v.12 no.2
• /
• pp.131-138
• /
• 2003

This paper considered the structural mechanism of transitional boundary layer by the experimental approach. In order to measure the turbulence quantity in the boundary layer, we made a wind tunnel with 400${\times}$190${\times}$2500 mm test section and a flat plate with well fabricated leading edge. Hot wire anemometer was used for acquiring the continuous turbulence signal which is processed by special software. The results of experiment show that the region where turbulence spot is dominant moves from near wall to overall layer and thus the anisotropy of velocity fluctuation shows so large value. Also the turbulence energy originally contained in low frequency band comes up to the high frequency band. Finally the turbulence model needs minimum two length scales to consider the pre-transition region.

• Advances in Traditional Medicine
• /
• v.7 no.5
• /
• pp.485-493
• /
• 2008

The present study was carried out to elucidate the potential of, chloroform extract of Pandanus (P.) fascicularis Lamk (Family-Pandanaceae) leaves on antinociceptive, behavioral study and anti-inflammatory effects using various animal models The dried, powdered leaves of, P. fascicularis were extracted successively with petroleum ether ($60\;-\;80^{\circ}C$) and chloroform in soxhlet apparatus. The chloroform extract (yield 21.6% w/w with respected to dry powdered plant material) was selected for all experimental procedure. Two models were employed to investigate the effects on nociception, the tail immersion and hot plate method in Swiss albino mice and anti inflammatory effect were investigated by employing the carrageenan induced rat paw edema test in. adult Wister albino rats. Behavioral study was investigated by elevated plus maze method in Swiss albino mice. Results were revealed that the PFCE was found significant antinociceptive effect (P < 0.001) at the dose levels of 100, 200 and 400 mg/kg, orally in mice and produced remarkable antiinflammatory effect (P < 0.001) at the same dose levels used in the rats. Behavioral study of the PFCE has no significant anxiolysis effect when used orally. It concludes that, PFCE possessed remarkable antinociceptive effect and anti-inflammatory effect but no anxiolytic effect on animal models.

• Korean Journal of Pharmacognosy
• /
• v.36 no.4 s.143
• /
• pp.299-304
• /
• 2005

This study examined the antinociceptive properties of GCSB-5, a herbal formulation consisting of 6 Oriental herbs (Ledebouriellae Radix, Achyranthis Radix, Acanthopanacis Cortex, Cibotii Rhizoma, Glycine Semen, and Eucommiae Cortex) that are used in traditional medicine to treat various bone disorders, mainly of which involve analgesic processes. Peripheral and central analgesic models were established in experimental animals in order to evaluate the antinociceptive effects of the agent. GCSB-5 significantly inhibited the number of acetic-induced writhing (33.3%-34.3% inhibition at 100-600 mg/kg) but increased the pain threshold (38.0% increase at 300 mg/kg) in the Randall-Selitto test. However, GCSB-5 had no effect on the hot plate-induced nociception and hyperalgesia from the tail-pinch method. These results suggest that the antinociceptive effect of GCSB-5 may be mediated via peripheral mechanisms.

• Natural Product Sciences
• /
• v.9 no.2
• /
• pp.97-101
• /
• 2003

This study was undertaken to evaluate the antinociceptive and antiinflammatory effects of the heartwood extract of Rhus verniciflua (Anacardiaceae) and the two major components, sulfuretin and fustin. The MeOH extract, its EtOAc-soluble portion and sulfuretin showed significant antinociceptive activity in writhing and hot plate test assays and antiinflammaory effects in carrageenan-induced hind paw edema in rats. In particular, treatment of sulfuretin with 10 mg/kg dose (i.p.) reduced writhing frequency by 48.0% (p<0.01) compared to that of a control group. Further, the treatment of sulfuretin (5, 10 mg/kg, i.p.) for 7 days prevented the carrageenan-induced hind paw edema significantly (p<0.01). The antiinflammatory effect of sulfuretin was also confirmed by microscopic observation of mast cell numbers in muscle. In addition, sulfuretin suppressed the cyclooxygenase- 2 (COX-2) activity $(IC_{50}\;=\;28.7\;{\mu}M)$ in lipopolysaccharide-activated macrophage cells. This result indicates that the inhibitory effect of sulfuretin on COX-2 may be one of the antinociceptive/antiinflammatory mechanism.

• Mycobiology
• /
• v.34 no.3
• /
• pp.138-142
• /
• 2006

Soil cyanobacteria isolated from the rice paddy fields of 10 different locations across Korea were evaluated by agar plate diffusion test for antifungal activity. Aqueous, petroleum ether, and methanol extracts from one hundred and forty two cyanobacterial strains belonging to the 14 genera were examined for antifungal properties against seven phytopathogenic fungi causing diseases in hot pepper (Capsicum annuum L). Of total cyanobacteria, nine cyanobacteria (6.34%) exhibited antifungal effects. The nine cyanobacteria selected with positive antifungal activities were two species of Oscillatoria, two of Anabaena, three of Nostoc, one of Nodularia, and one of Calothrix. Alternaria alternata and Botrytis cinerea were inhibited by nine and eight species of cyanobacteria, respectively. Rhizopus stolonifer was suppressed by only methanol extract of Nostoc commune FK-103. In particular, Nostoc commune FK-103 and Oscillatoria tenuis FK-109 showed strong antifungal activities against Phytophthora capsici. Their antifungal activity at the late exponential growth phase is related to the growth temperature and not associated with the growth parameters such as cell biomass and $chlorophyll-{\alpha}$ concentration. The high inhibition levels of antibiotics were 22.5 and 31.8 mm for N. commune FK-103 and O. tenuis FK-109, respectively. The optimal temperature for antibiotic productivity was $35^{\circ}C$.