• 한국전기전자재료학회논문지
• /
• 제16권6호
• /
• pp.538-548
• /
• 2003

We studied effects by Re$_2$O$_3$(R=Dy, Gd, Ho) addition on the properties of Mn-Zn ferrite. The doping concentration range from 0.05 wt% to 0.25 wt%. All samples were prepared by standard fabrication of ceramics. With increasing the rare earth oxides, specific density and initial permeability increased on the whole. But, the tendencies such as upper result had the measured value on limitation and characteristics saturated or decreased properties after that. In case of excessive addition of additive beyond some level, initial permeability properties of ferrite have gone down in spite of anomalous grain. With increasing the content of additive, both the real and imaginary component of complex permeability and the magnetic loss (tan$\delta$) increased. Because the increased rate of real component had higher than imaginary component, magnetic loss increased none the less for increasing the real component related with magnetic permeability. But, the magnetic loss of ferrite doped with the rare earth oxides was lower than that of Mn-Zn ferrite at any rate. The small amount of present rare earth oxides in Mn-Zn ferrite composition led to enhancement of resistivity in bulk, and more so in the grain boundary. It was seem to be due to the formation of mutual reaction such as between iron ions and rare earth element ions.

• 한국자기학회지
• /
• 제5권5호
• /
• pp.487-490
• /
• 1995

With the object of developing a new magnetic core materials for high frequency use, the crystallization behaviors and the soft magnetic properties of amorphous $F_{86-x}Al_{4}B_{10}Zr_{x}\;(5{\leq}x{\leq}10\;at%)$ alloys subjected to annealing treatment at wide temperature range were investigated. For optimally annealed $Fe_{86-x}Al_{4}B_{10}Zr_{x}$ alloys in amorphous state, rather good soft magnetic properties of ${\mu}_{e}=17000~25000,\;H_{c}=20~30$ mOe and $B_{10}{\geq}0.6$ T are obtained. However, as the alloys crystallize, the soft magnetic properties are largely dergely deteriorated, which is attributed principally to the narrow temperature gap between $T_{x1}$ and $T_{x2}$, which allows the nearly co-precipitation of bcc phase and Fe-B compounds in incipient crystallization stage.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1996년도 춘계학술대회 논문집
• /
• pp.27-30
• /
• 1996

In this paper, we prove through the experiments the possibility that Co-amorphous magnetic films can be used as high sensibility materials. We fabricate amorphous film of Fe$\sub$4.7/Co$\sub$74.3/Si$_2$B$\sub$19/ by using sputtering method at high frequency. Then, we not only measure the magnetic Properties of the annealed samples, but also observe the magnetic domain by using an Kerr effect optical-microscope. As the result, we find that the samples have high sensibility

• 한국정밀공학회지
• /
• 제10권2호
• /
• pp.146-153
• /
• 1993

Thd specimens were melited in high frequency induction furnace. The samples for measurements were prepared by machining cylinder of 9.5mm diameter and 15mm height. These samples were then hot-pressed according to strain rate ( .epsilon. ). These samples were decanned and cut out, and subsequently heat treated at 1000 .deg. C for 4hours. These were investigated for the change of microstructure, domain pattern, X-ray diffraction and magnetic properties. The stress distributions in the specimens during compressing process were calculated by a finite element method program(SPID). The calculated stresses were effective stress( .sigma. $_{eff}$), compressive direction stress( .sigma. $_{z}$), and shear stress( .tau. $_{rz}$ ). These stresses were compared with the experimental data.a.a.

• 한국세라믹학회지
• /
• 제28권8호
• /
• pp.640-646
• /
• 1991

Recently intensive studies have been focussed on ferrites which have high magnetic loss because of the increasing need for the prevention of EMI (Electromagnetic Interference). We investigated effects of microstructures of Ni-Zn ferrites on magnetic losses, magnetic properties, and behaviors of electromagnetic wave absorbers. The characteristics of the absorber were influenced by the sintering conditions. A Ni-Zn ferrite with the thickness of 7$^{\circ}C$/min and the cooling rate of 7$^{\circ}C$/min. It satisfied the absorbing properties in the wide frequency ranges including VHF (90∼220 MHz), UHF (470∼770 MHz)

• Journal of Magnetics
• /
• 제11권3호
• /
• pp.126-129
• /
• 2006

The phosphate coating on the $(Fe_{0.97}Cr_{0.03})_{76}(Si_{0.5}B_{0.5})_{22}C_2$ amorphous powders with an average size of 10 ${\mu}m$ in diameter has been carried out in aqueous 1.0-2.0 wt% $H_3PO_4$ solutions, and the consolidation behavior and magnetic properties of their compressed powder cores has been investigated. The phosphate coating could provide efficient electrical insulation between amorphous powders and improved consolidation ability at room temperature. Especially when the powders were treated in more concentrated phosphoric acid solution, enhanced phosphate covering and higher frequency/dc-bias stability were achieved. The powder cores phosphate-coated in 2.0 wt% $H_3PO_4$ solution exhibited constant permeability of 21 up to 10 MHz, 110 of the quality factor at 0.9 MHz, 610 mW/cm3 core loss at 100 kHz/0.1 T and 89 of percent permeability at 100 kHz.

• 대한기계학회논문집A
• /
• 제28권7호
• /
• pp.948-954
• /
• 2004

Induction heating is a process that is accompanied with magnetic and thermal situation. When the high-frequency current flows in the coil, induced eddy current generates heat to conductor. To simulate an induction and induction heating process, the finite element analysis program was developed. A coupling method between the magnetic and thermal routines was developed. In the process of magnetic analysis and thermal analysis, magnetic material properties and thermal material properties depending on temperature are taken into consideration. In this paper, to predict the angular deformation, temperature difference and the shape of heat affected zone were discussed. Also appropriate coil shape and other process variables for maximum angular deformation were proposed.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2003년도 춘계학술발표강연 및 논문개요집
• /
• pp.239-239
• /
• 2003

As a result of the recent miniaturization and enhancement in the performance of thin film inductors and thin film transformers, there are increased demands for the thin films with a high magnetic permeability in the high frequency range, a high saturation magnetization, a high electrical resistivity, and a low coercive force. In order to improve high frequency properties, we will investigate anisotropy field by shape and size of pattern. The Fe-Al-O thin films of 16mm diameter and 1$\mu\textrm{m}$ thickness were deposited on Si wafer, using RE magnetron reactive sputtering technique with the mixture of argon and oxygen gases. The fabricating conditions are obtained in the working partial pressure of 2m Torr, O$_2$ partial Pressure of 5%, Input power of 400w, and Al pellets on an Fe disk with purity of 99.9%. For continuous thin film is the 4Ms of 19.4kG, H$\sub$c/ of 0.6Oe, H$\sub$k/ of 6.0Oe and effective permeability of 2500 up to 100MHz. In this work, we expect to enhanced effect of magnetic anisotropy on patterned of Fe-Al-O thin films.

• 한국재료학회지
• /
• 제14권9호
• /
• pp.655-658
• /
• 2004

Lithium ferrites are a low-cost material which have been prominent in the high frequency core industry because of their excellent temperature performance and high squareness ratio. In order to develope the lithium ferrites with the high squareness and low coercive force, the ferrites of $Li_{0.48}Bi_{0.02}Ni_{0.04}Fe_{2.46-x}O_4$ were investigated the by varying composition, temperature and frequency. Electric loss of the Li-ferrite was lowered with the substitution of $Mn_{2}O_3$. The addition of $Mn_{2}O_3$ increased the magnetic induction (Bm&Br) but decreased the coercive force (Hc) and the squareness ratio (R=Br/Bm). Also, the Br value was stable at environmental temperature variation.

• 마이크로전자및패키징학회지
• /
• 제11권3호
• /
• pp.31-36
• /
• 2004

연자성 차폐필름에 대하여 ASTM 방법 및 2-port flanged coaxial line 방법으로 RF (radio-frequency) 영역에서 전자기파 차폐특성을 측정하여 원역장에서의 차폐요인을 정량적으로 분석하였다. 4-13.5 GHz의 고주파 영역에서 연자성 차폐필름의 차폐효과는 반사손실에 의한 효과가 아니라 주로 흡수손실에 의한 차폐효과를 가졌다.