• Journal of Microbiology and Biotechnology
• /
• v.12 no.1
• /
• pp.1-7
• /
• 2002

The effects of DO and pH on the mass production of pullulan with high molecular weight and the morphology of A. pullulans ATCC 42023 were evaluated. A. pullulans showed a maximum production of pullulan (11.98 g/l) when the initial pH of the culture broth was 6.5 in a shake-flask culture. In a batch culture, the mixture of a yeast-like and mycelial cell forms was found at a pH of 4.5, and the maximum production of pullulan (13.31 g/l) was obtained. However, a high proportion of high molecular weight pullulan (M.W.>2,000,000) was produced at a pH of 6.5, with a yeast-like morphology. The maximum pullulan production yield ($51\%$) was obtained at a pH noncontrol (initial pH 6.5) and DO control (above $50\%$) condition. Pullulan degrading enzyme was activated when the pH of the broth was lower than 5.0 and the portion of low molecular weight pullulan was increased. The formation of a black pigment was observed at an initial stationary phase, at 40 h of fermentation. Therefore, the fermentation should be carried out in a pH noncontrol (initial pH of 6.5) and DO control (above $50\%$) condition, and should be harvested before reaching the stationary phase (around 40 h) for the production of high molecular weight pullulan.

• Environmental Engineering Research
• /
• v.11 no.2
• /
• pp.91-98
• /
• 2006

There is a possibility of the production of the air bubbles in membrane pores due to the reduction in pressure during membrane filtration. The effect of fine air bubbles from dissolved gases on microfiltration was investigated in the submerged membrane bio-reactor (SMBR). The $R_{air}$ (air bubble resistance) was defined as the filtration resistance due to the air bubbles formed from the gasification of dissolved gases. From the results of filtration tests using pure water with changes in the dissolved oxygen concentration, the air bubbles from dissolved gases were confirmed to act as a foulant and; thus, increase the filtration resistance. The standard pore blocking and cake filtration models, SPBM and CFM, respectively, were applied to investigate the mechanism of air bubble fouling on a hollow fiber membrane. However, the application of the SPBM and CFM were limited in explaining the mechanism due to the properties of air bubble. With a simple comparison of the different filtration resistances, the $R_{air}$ portion was below 1% of the total filtration resistance during sludge filtration. Therefore, the air bubbles from dissolved gases would only be a minor foulant in the SMBR. However, under the conditions of a high gasification rate from dissolved gases, the effect of air bubble fouling should be considered in microfiltration.

• Journal of Environmental Science International
• /
• v.9 no.5
• /
• pp.429-436
• /
• 2000

In order to study on the variational characteristics of water quality and chlorolphyll a concentration the water samples were collected daily or three times a week during the period from April 1990 to November 1991 at Kukdong port located in the northern Kamak bay of Southern Korea I made an analysis on biological factor as chlorophyll a concentration as well as physico-chemical factors such as water temperature salinity sigma-t dissolved oxygen, nutrients (ammonia, nitrite, nitrate, phosphate, and silicate) N/P ratio and chemical oxygen demand. In Northern Kamak bay seasonal variations in physical factors such as water temperature salinity and sigma-t were very marked. On the other hand chemical factors such as nutrients concentration and COD were not so. Chemical factors, in particular silicate were influenced by input of freshwater. And the roles of silicate on the seasonal succession of phytoplankton species composition was very low. Phytoplankton biomass as measured by chlorophyll a concentration was very high all the year round and it was controlled by the combination of several factors especially of N/P ratio determined by dissolved inorganic nitrogen.

• Journal of the korean society of oceanography
• /
• v.38 no.3
• /
• pp.101-110
• /
• 2003

We made intensive observations on the coastal upwelling off the coast of the southern East Sea from June to August in 2001. The upwelling exhibited a weekly waxing and waning. The coastal upwelling of the year 2001 was characterized by abrupt outbreaks and the small local scale. Upwelling occurred more frequently off the coast of Ulsan and Gampo as reported by the earlier observers. The spread of freshly upwelled colder water was varied by each upwelling event. Generally cold waters were carried away northeastward off Pohang province. The upwelled cold waters were saltier than the resident surface waters. The pH and salinity-normalized alkalinity support the idea that the upwelled waters originate from the interior of the East Sea. The extraordinarily high concentration of dissolved oxygen suggests that the upwelled waters are closely connected to the southward flowing North Korea Cold Current. Although a lower primary productivity was reported for the upwelling region, underway surface fluorescence measurement revealed that the recently upwelled waters supported up to an order of magnitude higher algal biomass than the ambient waters. Because thermohaline circulation of the East Sea is so vigorous, with an estimated time scale of less than one hundred years, that the coastal upwelling should be considered not as an anomaly but as a regular component of a circulatory system. A quantitative understanding of upwelling seems to be a key to elucidate material cycling and the associated biological production in the East Sea.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.46 no.6
• /
• pp.941-947
• /
• 2013

To understand the relationship between various oceanographic factors and seaweed production, we examined the annual accumulated aquaculture production of Undaria pinnatifida with respect to water temperature, salinity, dissolved oxygen, current patterns and nutrients over 21 years (1990-2010) (this date range does not add up to over 21 years) along the coast of Busan, Korea. According to the results of the cross-correlation function, annual production of U. pinnatifida was closely related to the following conditions: low water temperature, low salinity, strong Tsushima Warm Current, and high concentrations of dissolved oxygen and nutrients. In this study, we also considered the Index of Oceanographic factors for U. pinnatifida (IOU) by computation of a simple equation. This index will be used for the prediction of U. pinnatifida aquaculture production off the coast of Busan.

• Corrosion Science and Technology
• /
• v.20 no.6
• /
• pp.325-334
• /
• 2021

In the open system (vessel and pipe), the maximum corrosion rate of carbon steel at ca. 80 ℃ was obtained due to the decrease of dissolved oxygen by increasing the solution temperature. Effect of temperature on the cavitation damage can be explained through several mechanisms. Moreover, when cavitation occurs on the surface of metal and alloys, whether cavitation is erosion or corrosion is still controversial. This work focused on the effect of solution temperature on the corrosion of carbon steel under cavitation in an open system, Tests were performed using an electrochemical cavitation corrosion tester in 3.5% NaCl solution and the effect of solution temperature of carbon steel was discussed. Cavitation corrosion rate can be increased by cavitation, but when the temperature increases, a dissolved oxygen content reduces at a very high speed and thus the maximum cavitation corrosion temperature changed from 80 ℃ to 45 ℃. Below the maximum cavitation temperature, the electrochemical effect was more dominant than the mechanical effect by increasing temperature, but over the maximum cavitation temperature, the mechanical effect was more dominant than the electrochemical effect by increasing temperature.

• Journal of Korean Society on Water Environment
• /
• v.38 no.4
• /
• pp.171-176
• /
• 2022

Recently, an autotrophic single-stage nitrogen removal (ASSNR) process based on the anaerobic ammonium oxidation (ANAMMOX) reaction has been proven as an economical ammonia treatment. It is highly evident that double-layered gel beads are a promising alternative to the natural biofilm for ASSNR because of the high mechanical strength of poly(vinyl alcohol) (PVA)/alginate structure and efficient protection of ANAMMOX bacteria from dissolved oxygen (DO) due to the thick outer layer. However, the thick outer layer results in severe mass transport limitation and consequent lowered bacterial activity. Therefore, the effects of the thickness of the outer layer on the overall reaction rate were tested in the biofilm model using AQUASIM for ammonia-oxidizing bacteria (AOB), nitrite-oxidizing bacteria (NOB) and ANAMMOX bacteria. A thickness of 0.5~1.0 mm is preferred for the maximum total nitrogen (TN) removal. In addition, a DO of 0.5 mg/L resulted in the best total nitrogen removal. A higher DO induces NOB activity and consequent lower TN removal efficiency. The optimal density of AO B and NO B density was 1~10% for a 10% ANAMMOX bacterial in the double-layered PVA/alginate gel beads. The real effects of operating parameters of the thickness of the outer layer, DO and concentrations of biomass balance should be intensively investigated in the controlled experiments in batch and continuous modes.

• Korean Journal of Environmental Agriculture
• /
• v.28 no.4
• /
• pp.371-377
• /
• 2009

In this study, simultaneous nitrification and denitrification (SND) from synthetic wastewater were performed to evaluate dissolved oxygen(DO) effects on chemical oxygen demand(COD) and nitrogen removal in a single membarne bio-reactor(MBR). DO levels in MBR at Run 1, 2, and 3 were 1.9~2.2, 1.3~1.6, and 0.7~1.0 mg/L, respectively. Experimental results indicated that DO had an important factor to affect COD and total nitrogen(TN) removal. SND were able to be accomplished in the continuous-aeration MBR by controlling ambient DO concentration. It is postulated that, because of the oxygen diffusion limitation, an anoxic micro-zone was formed inside the flocs where the denitrification might occur. From the results of this study, 96% of COD could be removed at DO of 0.7mg/L. At run 2 72.92% of nitrogen was removed by the mechanisms of SND (7.75mg-TN/L in effluent). In this study, SND was successfully occurred in a MBR due to high MLSS that could help to form anoxic zone inside microbial floc at bulk DO concentrations of 1.3~1.6mg/L.

• Korean Journal of Agricultural Science
• /
• v.49 no.2
• /
• pp.193-202
• /
• 2022

The recurrent neural network (RNN) algorithm has been widely used in water-related research areas, such as water level predictions and water quality predictions, due to its excellent time series learning capabilities. However, studies on water quality predictions using RNN algorithms are limited because of the scarcity of water quality data. Therefore, most previous studies related to water quality predictions were based on monthly predictions. In this study, the quality of the water in a reservoir in Nonsan, Chungcheongnam-do Republic of Korea was predicted using the RNN-LSTM algorithm. The study was conducted after constructing data that could then be, linearly interpolated as daily data. In this study, we attempt to predict the water quality on the 7th, 15th, 30th, 45th and 60th days instead of making daily predictions of water quality factors. For daily predictions, linear interpolated daily water quality data and daily weather data (rainfall, average temperature, and average wind speed) were used. The results of predicting water quality concentrations (chemical oxygen demand [COD], dissolved oxygen [DO], suspended solid [SS], total nitrogen [T-N], total phosphorus [TP]) through the LSTM algorithm indicated that the predictive value was high on the 7th and 15th days. In the 30th day predictions, the COD and DO items showed R² that exceeded 0.6 at all points, whereas the SS, T-N, and T-P items showed differences depending on the factor being assessed. In the 45th day predictions, it was found that the accuracy of all water quality predictions except for the DO item was sharply lowered.

• Journal of Microbiology and Biotechnology
• /
• v.18 no.4
• /
• pp.718-724
• /
• 2008

Dissolved oxygen (DO) and shear stress have pronounced effects on hyaluronic acid (HA) production, yet various views persist about their effects on the molecular weight of HA. Accordingly, this study investigated the effects of DO and shear stress during HA fermentation. The results showed that both cell growth and HA synthesis were suppressed under anaerobic conditions, and the HA molecular mass was only $(1.22{\pm}0.02){\times}10^6 Da$. Under aerobic conditions, although the DO level produced no change in the biomass or HA yield, a high DO level favored the HA molecular mass, which reached a maximum value of $(2.19{\pm}0.05){\times}10^6 Da$ at 50% DO. Furthermore, a high shear stress delayed the rate of HA synthesis and decreased the HA molecular weight, yet had no clear effect on the HA yield. Therefore, a high DO concentration and mild shear environment would appear to be essential to enhance the HA molecular weight.