• Korean Journal of Food Science and Technology
• /
• v.4 no.4
• /
• pp.252-258
• /
• 1972

Methods of separating yeast cells from oil-water-cell emulsion and subsequent purification of the recovered yeast have been studied. In addition, the results of preliminary feeding experiments in which a yeast grown on gas oil was incorporated into chick rations are reported. According to the present study, it appears that the recovery of the yeasts would be easier at pH 9, since the emulsion is relatively more unstable. A class of surface active agent at a concentration of 0.3% was found to facilitate the separation of the yeast from the emulsion. The use of electrolytes such as NaCl and KCl were found to be most effective in breaking the emulsion. Solvent treatment using iso-propyl alcohol and its azeotropic mixture with hexane at $58^{\circ}C$ are particularly suitable for purification of the yeast. In the feeding experiment it was found that 5 percent of the fishmeal in the control ration could be replaced by the yeast with no adverse effect on performance. However, when 8 percent of the fish meal in the control ration was replaced by the yeast, some effect on live-weight gain of the chicks was observed.

• Korean Journal of Food Science and Technology
• /
• v.37 no.4
• /
• pp.513-518
• /
• 2005

Capillary electrophoresis (CE) method was developed to determine (+)-catechin and (-)-epicatechin contents in grape seed ethanol extract. CE separation was achieved using 100 mM phosphate and borate buffer at pH 6.0 as background electrolyte and fused silica capillary with 50 microns x 375 microns O.D. (effective length 20.0cm) maintained at $25^{\circ}C$. The applied voltage was 10kV, and detection was performed by DAD at 210 nm, Two catechins were well separated within 6 min with repeatability of <0.8% RSD for migration time and <2.0% RSD for peak area, and correlation coefficients higher than 0.994 were obtained from 58.0 to 174.0 mg/L with detection limit of 0.035 mg/L. Separated compounds were successfully determined. CE method was easy to handle and showed good reproducibility. CE method was compared with conventional coloring and HPLC methods, and main advantages of CE method were low amount of sample required, simple pre-sample treatment, good recovery rate, and short analysis time.

• The Journal of the Acoustical Society of Korea
• /
• v.42 no.3
• /
• pp.250-261
• /
• 2023

In this study, the noise contributions by the duct, stator and rotor, which are the propulsor components, are evaluated to identify the flow noise source in cavitation and non-cavitation conditions on pumpjet propulsion and the noise levels in both conditions are compared. The unsteady incompressible Reynolds averaged Navier-Stokes (RANS) equation based on the homogeneous mixture assumption is applied on the suboff submarine hull and pumpjet propeller in the cavitation tunnel, and the Volume of Fluid (VOF) method and Schnerr-Sauer cavitation model are used to describe the two-phase flow. Based on the flow simulation results, the acoustic analogy formulated by Ffowcs Williams and Hawkings (FW-H) equation is applied to predict the underwater radiated noise. The noise contributions are evaluated by using the three types of impermeable integral surface on the duct, stator and rotor, and the two types of permeable integral surface surrounding the propulsor. As a result of noise prediction, the contribution by the stator is insignificant, but it affects the generation of flow noise source due to flow separation in the duct and rotor, and the noise is predominantly radiated into the upward and right where the flow separations are. Also, the noise is radiated into the thrust direction due to pressure fluctuation between suction and pressure sides on the rotor blades, and the it can be seen that the cavitation effect into the noise can be considered through the permeable integral surface.

• Clean Technology
• /
• v.10 no.2
• /
• pp.73-87
• /
• 2004

In most of industrial fields, cleaning is employed for removing soils on their products or parts. Halogenated cleaning agents such as CFC-113, 1,1,1-TCE(1,1,1-trichloroethane), MC(methylene chloride) and TCE (trichloroethylene) have been used as cleaning ones in most of companies in the world since their excellent performance of cleaning ability and good material compatibility. However, CFC-113 and 1,1,1-TCE which are ozone destruction substances are not used any more in the advanced countries because of the which are ozone destruction substances are not used any more in the advanced countries because of the Montreal protocol. MC and TCE are now used restrictively at small part of industrial fields in most of countries since they are known to be hazardous or carcinogenic materials. Thus, it is indispensible that the alternative cleaning agents which are environmental-friendly and safe, and show good cleaning ability should be developed or utilized for replacement of the halogenated cleaning agents. Aqueous/semi-aqueous cleaning agents are evaluated to be promising alternative ones among various alternatives in environmental and economical view point. In this study, commercially available 12 aqueous and 6 semi-aqueous cleaning agents were selected and their physical properties, cleaning abilities, rinsing abilities and recycling of contaminated rinse water were measured and analyzed. Aqueous cleaning agents with higher wetting index showed better cleaning ability compared with those with lower wetting index. However wetting index did not have any correlation with cleaning ability in semi-aqueous cleaning agents. It was observed that soil concentration in aqueous and semi-aqueous cleaning agents should be maintained below the certain concentrations which depend on types of clearing agents. More than 70% soils in contaminated rinse water by some of aqueous and semi-aqueous clearing agents could be separated by simple settling method. This means that some cleaning agents with high oil-water separation efficiency will be effiective for recycling oil-contaminated rinse water. It was found that contaminated rinse water with aqueous agents was purified easiy by ultrafiltration method with PAN membrane of 30 kDa.

• Reproductive and Developmental Biology
• /
• v.32 no.4
• /
• pp.255-261
• /
• 2008

The early diagnosis of bovine pregnancy is an essential component of successful reproductive planning on farms, because lack of bovine pregnancy over the long term results in reproductive failure and low milk yield-the latter of which is a special concern on dairy farms. This study was designed to identify early pregnancy-specific whey proteins in bovine, by comparing milk samples collected from cattle during pregnancy (Days 30 and 50) and from non-pregnant cattle. In this study, differentially expressed proteins in five pregnant and five non-pregnant Holstein dairy cattle were investigated and compared, using proteomics analysis. The first dimension was applied to a pH $3.0{\sim}10.0$ strip, by loading a 2-mg milk protein sample. After the second-dimension separation was performed, the gels were stained with colloidal Coomassie brilliant blue. The stained gels were scanned and the images were analyzed, to detect variations in protein spots between non-pregnant and pregnant cattle milk protein spots, using ImageMaster, this was followed by analysis with MALDI TOF-MS. Analysis of the 2-DE gel image resulted in a total of approximately $500{\sim}600$ protein spots, of which 12 spots were differentially expressed, six spots were up-regulated, and four spots were down-regulated; two spots were identified as pregnancy-specific proteins. These proteins were identified as lactoferrin, NA-DH dehydrogenase subunit 2, albumin, serum albumin precursor and transferrin. Our results via 2-D PAGE analysis revealed composite profiles of several milk proteins related to early bovine pregnancy, implying the possible use of these milk proteins in the early detection of bovine pregnancy.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.1B
• /
• pp.35-45
• /
• 2009

In this study, a laboratory experiment has been performed on a S-curved channel with two curved sections. In the experiments, effects of 3-D velocity structures on mixing characteristics of tracer material were investigated. As a result, it was clearly noticed that the primary flow travels taking the shortest course of the meandering channel and has a very ununiform distribution at the bends. The secondary cell which was developing at the first bend disappears at the crossover, and then, at the next bend, secondary cell is re-developing in the opposite direction. The experimental results show that mixing of tracer is significantly affected by the combined action of ununiform primary flow and secondary cell. The ununiform primary flow separates the tracer cloud in the longitudinal direction, and the secondary cell further separates the retarding tracer cloud mainly in the transverse direction. As a result, these complex flow structures cause separation and spreading of tracer cloud both in the longitudinal and in the transverse directions. The measured dimensionless transverse dispersion coefficients calculated using 2-D routing procedure ranges 0.012-0.875, and is generally proportional to width to depth ratio (W/h). The predicted values calculated by the theoretical equation overestimate slightly the measured transverse dispersion coefficients.

• Journal of the Korean Vacuum Society
• /
• v.20 no.1
• /
• pp.35-41
• /
• 2011

In this study, the interface soaking effect in InAs/GaAs strained-layer superlattice (SLS) on crystalline phase modulation has been analyzed by the x-ray diffraction (XRD) curve. The strain variation induced by As and/or Sb soaking was determined by the separation angle between the substrate peak and the 0th-order superlattice satellite peak in the XRD spectra. Contrated that the As/InAs soaking arises minor GaAs-like interfacial layer, the Sb/GaSb soaking induces InSb-like one. The Fourier-transformed curves of the Pendellosung interference oscillation shows that the optimum soaking times of As/InAs and Sb/GaSb are 2 sec and 12 sec, at which the highest crystallineity has, respectively. An anomalous twin-peak phenomenon that a satellite peak splits into two peaks was observed in the SLS structure co-soaked by As and Sb at InAs${\rightarrow}$GaSb interfaces. We suggest that it may be resulted from coexistence of two kinds crystalline phases of InAsSb and GaAsSb due to intermixing of In${\leftrightarrow}$Ga and Sb${\leftrightarrow}$As.

• Journal of Dairy Science and Biotechnology
• /
• v.34 no.2
• /
• pp.83-89
• /
• 2016

This study was designed to determine the mutagenic potential of hydrolyzed glycomacropeptide (GMP) powder (hereafter referred to as 23%-GNANA; product name: HELICOBACTROL-23) in a micronucleus test using bone marrow in ICR mice. Three experimental groups were used: a 3-step concentration group, with a maximum concentration of 2,000 mg/kg, and other sequentially two-fold lower concentrations, a negative control group, and a positive control group. The test material was administered for 2 d to observe the frequency of micronucleus formation up to 48 h after the test material was absorbed by the body. When the polychromatic erythrocyte (PCE) content of erythrocytes was compared, no significant differences were noted between the negative control group and the test group (p<0.05). Similarly, when the average numbers of micronucleated PCE (MNPCE) in 2,000 PCE per animal were compared, no significant difference was observed between the negative control group and the test group (p<0.05). No dose-response relationship with regard to the concentration of the test material administered was noted. These results allow us to conclude that hydrolyzed whey protein powder does not cause formation of micronuclei in mouse bone marrow cells under the applied conditions. In this study, the average frequency of micronucleus formation in PCE was significantly higher in the positive control group compared with the negative control group; thus, the test conditions were appropriate for detecting the frequency of micronucleus formation induced by the test material. In conclusion, the safety of 23%-GNANA test substance was verified in an in vivo micronucleus test in mice, conducted before the registration of HELICOBACTROL-23 as a food additive.

• Journal of Biosystems Engineering
• /
• v.11 no.2
• /
• pp.31-40
• /
• 1986

Cylindrical and conical types of grain-straw separation equipment which has a stationary crimped sieve drum with rotating inner rotor were constructed. The developed equipments were tested to investigate the characteristics of separating performance under various mechanical conditions and crop conditions. As increase of the inclination of equipment and decrease of pitch of cover vane, the grain recovery was increased while straw rejection was decreased. The grain recovery and overall efficiency were decreased as the rotor speed and feeding velocity were increased for both varieties of rice, moisture contents, and test equipments. Conical prototype equipment performed higher straw rejection, lower grain recovery, and lower power requirement. However, separation performance of conical type equipment was more widely varied with various test conditions compared to cylindrical one. The performance of both equipments showed relatively insensitive to crop feedrate and crop properties, such as variety, moisture content, and grain-to-straw ratio.

• Journal of Bio-Environment Control
• /
• v.24 no.2
• /
• pp.100-105
• /
• 2015

The calculation method of infiltration loss in greenhouse has different ideas in each design standard, so there is a big difference in each method according to the size of greenhouses, it is necessary to establish a more accurate method that can be applied to the domestic. In order to provide basic data for the formulation of the calculation method of greenhouse heating load, we measured the infiltration rates using the tracer gas method in plastic greenhouses equipped with various thermal curtains. And then the calculation methods of infiltration loss in greenhouses were reviewed. Infiltration rates of the multi-span and single-span greenhouses were measured in the range of $0.042{\sim}0.245h^{-1}$ and $0.056{\sim}0.336h^{-1}$ respectively, single-span greenhouses appeared to be slightly larger. Infiltration rate of the greenhouse has been shown to significantly decrease depending on the number of thermal curtain layers without separation of single-span and multi-span. As the temperature differences between indoor and outdoor increase, the infiltration rates tended to increase. In the range of low wind speed during the experiments, changes of infiltration rate according to the outdoor wind speed could not find a consistent trend. Infiltration rates for the greenhouse heating design need to present the values at the appropriate temperature difference between indoor and outdoor. The change in the infiltration rate according to the wind speed does not need to be considered because the maximum heating load is calculated at a low wind speed range. However the correction factors to increase slightly the maximum heating load including the overall heat transfer coefficient should be applied at the strong wind regions. After reviewing the calculation method of infiltration loss, a method of using the infiltration heat transfer coefficient and the greenhouse covering area was found to have a problem, a method of using the infiltration rate and the greenhouse volume was determined to be reasonable.