• Fisheries and Aquatic Sciences
• /
• v.18 no.2
• /
• pp.159-164
• /
• 2015

A feeding experiment was conducted to determine the effect of dietary distillers dried grain (DDG) on the growth and body composition of juvenile abalone, Haliotis discus hannai. Three diets were formulated to contain 0% (DDG0), 30% DDG (DDG1) replacing wheat flour and 30% DDG (DDG2) replacing fish meal and wheat flour. A commercial feed (CF) was also compared with experimental diets. Three replicate groups of abalone averaging $0.6{\pm}0.01g$ were fed one of the four diets for 14 weeks. The highest survival rate was observed in the abalone fed the DDG2 diet, which was higher than that of abalone fed the DDG0 diet. Weight gain, shell length, shell width and soft body weight of the abalone were not affected by dietary DDG and CF diet (P > 0.05). Proximate and amino acid composition of the soft whole body were not affected by dietary DDG and CF diet (P > 0.05). The result of this experiment suggests that DDG is a good ingredient to replace fish meal and wheat flour in the diet and could be used up to 30% in the diet without negative effects on the growth performance of juvenile abalone Haliotis discus hannai.

• Journal of Korea Foundry Society
• /
• v.31 no.4
• /
• pp.212-217
• /
• 2011

The effects of alloying element and grain refinement on the tensile properties of magnesium alloy poured into sand mold were investigated. The strength of magnesium alloy was greatly increased by the addition of aluminium and that was increased with the increased aluminum content added up to 8.10 wt% and decreased beyond that. Even though the strength of Mg-8.10 wt%Al alloy was rather decreased by the addition of zinc, that was increased with increased zinc content added up to 0.50 wt% and decreased with the increased one beyond that. The maximum tensile strength was obtained with 0.50 wt%Mn added. The strength and elongation were simultaneously increased with grain refinement and the optimum amount of strontium addition for this was 0.30 wt%. The optimum chemical composition was obtained and the yield strength, tensile strength and elongation of the alloy with this composition were 90.2, 176.3MPa and 4.43%, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.05a
• /
• pp.97-100
• /
• 1992

The Degradation mechanism of the ZnO-varistor fabricated with the content of a 3-Composition seed grain is discussed using the method of Thermally Stimulated Current (TSC). The spectra of TSC is measured in the temperature range of -130～270$^{\circ}C$ with a various forming electric fields E$\sub$f/, temperature T$\sub$f/ time tf, and a various rising rate of temperature. It is observed that there are appeared the peaks of ${\alpha}$, ${\alpha}$$_2$, ${\beta}$ and ${\gamma}$from high temperature in a TSC spectrum. It seems that ${\alpha}$$_1$ peak is due to thermal depolarization of donor ions forming the space charge in the depletion layer, and ${\alpha}$$_2$peak is due to the detrapping of trapped electrons in deep trap level of intergranular layer, and ${\beta}$ peak is due to the thermal exciting of carrier existing in the donor level of grain itself, and ${\gamma}$ peak is due to the thermal exciting of trapped carrier in all shallow trap site randomly distributed in the inner of sample and/or a intrinsic impurity existing in it.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.1270-1273
• /
• 2004

The combination of methane-chemical activation and Self-propagating High-temperature synthesis (SHS) has widened the possibilities for both methods. For YBCO systems the investigation showed that a short-term mechano-chemical activation of initial powders before SHS leads to single-phase and ultra-fine products. A new technique for preparation ultra-fine high-temperature superconductors of YBCO composition with a grain size d < $1{\mu}m$ is developed. The specific feature of the technique is formation of the $YBa_2Cu_3O_{7-x}$ crystalline lattice directly from an X-ray amorphous state arising as a result of mechanical activation of the original oxide mixture. The technique allows the stage of formation of any intermediate reaction products to be ruled out. X-ray and magnetic studies of ultra-fine high temperature superconductors (HTS) are carried out. Dimension effects associated with the microstructure peculiarities are revealed. A considerable enhancement of inter-grain critical currents is found to take place in the ultra-fine samples investigated.

• Corrosion Science and Technology
• /
• v.2 no.1
• /
• pp.30-35
• /
• 2003

In this study, sand cast AZ91E and zirconium grain refined MEZ are representative of two typical groups of magnesium alloys: those containing aluminium and those containing no aluminium but with zirconium as a grain refiner. The corrosion performance of these two alloys was evaluated and compared in 5%wt NaCI solution through measurements of weight loss and polarisation curves and examination of microstructure. Corrosion damage of AZ91E was deeper and more localised than that of MEZ, while MEZ had a lower rate of cathodic hydrogen evolution and a higher rate of anodic dissolution than AZ91E. These differences in behaviour can be related to the differences in microstructure and chemical composition between the two alloys.

• Proceedings of the KSRS Conference
• /
• 1998.09a
• /
• pp.110-115
• /
• 1998

Through the ISODATA method, the micro-landform of Julpo-Bay tidal flat was classified into mudflat, mixedflat, and sandflat using Landsat TM image. Each showed an apparent differences in its topographical characteristics and grain size composition. For example, mudflats are formed with flat faces and tidal channel of dissected gully. Its characteristics of grain size analysis that the grains have less than mean grain size 4 phi. Its sorting is bad (higher than 1 S.D.), and it showed strongly positive skewness. But sandflat is topographically flat without tidal channel. It has developed with ripple marks. According to the grain size analysis of deposits, the soil is coarse size with 90% of sand and its sorting is well(lower than 1 S.D.) Also, it showed strongly negative skewness. Mixed flat is in between mudflat and sandflat in its characteristics.

• International Journal of Safety
• /
• v.8 no.1
• /
• pp.6-9
• /
• 2009

The crack in a J85 engine V.G. actuator arm shaft for a bell crank on the engine compressor was investigated. The crack was observed in twenty two shafts during the inspection of 238 shafts. The failure analysis of shaft cracks was performed by chemical composition analysis using ICP(Inductively Coupled Plasma) and by fracture surface and microstructure analysis using FE-SEM and optical microscope. The crack initiated from the top and bottom and propagated to the center along the grain boundaries. From the chemical composition analysis, the fractography of the fracture surface and the microstructure, it was found that the failure mechanism of the shafts is the inclusion-related intergranular decohesion crack. The inclusion was found out from MnS particle by EDS(Energy Dispersive Spectroscopy). The crack initiated MnS inclusion in the grain boundary and propagated with the increase of applied shear stress during long operation. In order to prevent the fracture, NDI(Nondestructive inspection) is needed periodically as recommended.

• Proceedings of the KIEE Conference
• /
• 1991.11a
• /
• pp.316-320
• /
• 1991

The dielectric properties of the ZnO varistor fabricated by the method of 3-composition seed grain was studied. In this paper, we present the C-V charateristic for the specimen. The dielectric constant and disppation which changed with additives may be explained on the basis of the deplation layer; the presence of deplation layer has been inferred by donor and state density obtained from the $1/C^2$ vs. V.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1991.10a
• /
• pp.40-43
• /
• 1991

The low-voltage ZnO varistor fabricated by a new method with three-composition seed grain are studied. The knee voltage about 5V$\_$0.5[A/$\textrm{cm}^2$]/ for sample #7 among the various samples are observed, and activation energy in the obmic region and trap level in the double sohottky region for each samples are 0.359∼0.450eV and 0.553∼0.620eV, respectively. It is concluded that the change of knee voltage may be caused by trap level in double sohottky region rather than activation energy in the ohmic region.

• Korean Journal of Agricultural Science
• /
• v.42 no.1
• /
• pp.1-5
• /
• 2015

Drought is one of the major abiotic constraints limiting quantity and quality of rice grain. In order to elucidate the effects of drought on chemical compositions of rice grain, seedlings were cultivated in a rainout shelter controlled with well-watered or water-deficit conditions. After harvesting, the key components including proximates, amino acids, fatty acids, minerals, and vitamins of rice grains were analyzed. Drought stress increased the amounts of methionine, phenylalanine, linoleic acid, linolenic acid, calcium, potassium, vitamin B1, and vitamin E in rice grains, whereas it decreased the contents of lignoceric acid. Particularly, drought stress caused a marked increase in vitamin E content. These results indicate drought significantly influence the chemical compositions of rice grains.