• Ocean and Polar Research
• /
• v.42 no.3
• /
• pp.249-261
• /
• 2020

This study details grain-size distributions (GSDs) of carbonate and biogenic opal fractions of the sediments retrieved from the South Korea Plateau in the East Sea and draws paleocanographic implications from them. The opal-fraction GSDs show fine modes of 10.3 ㎛ and coarse modes of 102.5 ㎛ on average. The fine-mode grains of opal fractions mainly consist of small diatoms and radiolarians including their broken frustules, while the coarse-mode grains are mostly comprised of large warm-water diatoms and radiolarians. Significant positive correlation between opal contents and abundances of the coarse-mode GSDs in the total GSDs suggests that the abundances of the coarse-mode GSDs were controlled by the increased surface productivity of warm-water diatoms during interglacial stages. The carbonate-fraction GSDs show fine modes of 2.4 ㎛ and coarse modes of 99.1 ㎛ on average. The fine-mode grains mainly consist of coccolithophores, while the coarse-mode grains are mostly comprised of intact or broken planktonic foraminifera. The abundances of coarse-mode and fine-mode GSDs were not correlated with carbonate contents, suggesting a complex control exerted by both the degree of carbonate dissolution and the productivity of coccolithophores on the carbonate-fraction GSDs.

• Proceedings of the Korea Institute of Applied Superconductivity and Cryogenics Conference
• /
• 1999.02a
• /
• pp.3-9
• /
• 1999

The grain morphology, the changes in morphology and Jc with the thermo-mechanical treatment (TMT) history, the field dependence of Jc and the nature of intergranular bonding were studied in $T_{10.8}$$Pb_{.2}$$Bi_{0.2}$$Sr_{1.8}$$Ba_{0.2}$$Ca_{2.2}$$Cu_{3}$$O_{z}$/Ag tapes. As a result, incorporation of intermediate rolling during the final heat-treatment resulted in of plate-like TI-1223 grains, and thus enhanced Jc. Jc's near 2.5$\times$104 A/cm2 at 77 K and 0 T were obtained in just rolled tapes with an excellent reproducibility. The high Jc's seem to grain-connectivity easy recovery of excellent grain-connectivity during final heat-treatment after inter -mediate rolling, probably due to retarded T1 evaporation and excessive Ca content in the present composition. The strong field dependence of Jc even in low fields, however, indicated that there still existed significant weak-links and the degree of directional grain-alignment was far from the desired one. The intergranular binding in the tapes seemed to be mainly dominated by SIS junctions.

• Analytical Science and Technology
• /
• v.6 no.2
• /
• pp.157-165
• /
• 1993

The potentiostatic etching dissolution method, which had been used for the quantification of precipitates in steel, was applied to investigate the origin of cracks occurred in 304 stainless steel during processing. The morphology of crack propagation was observed by SEM. EDS and EPMA were used for the analysis of chemical composition of large precipitates on the grain boundary. The crystal structure of these large precipitates was determined by X-ray diffraction and electron diffraction. In both a stainless steel plate and a wire, the crack propagated along the grain boundary. Large precipitates on the grain boundary were identified to be $M_2C$ and $M_{23}C_6$. Potentiostatic etching dissolution method was found to be appropriate to the sample preparation for the analysis of precipitates in stainless steel.

• Journal of the Korean Ceramic Society
• /
• v.27 no.8
• /
• pp.991-1003
• /
• 1990

A precipitation method, one of the most effective liquid phase reaction methods, was adopted in order to prepare high-tech Al2O3/ZrO2 composite ceramics. Al2(SO4)3.18H2O, ZrOCl2.8H2O and YCl3.6H2O were used as starting materials and NH4OH as a precipitation agent, various types of metal hydroxides were obtained by single precipitation(series A) and co-precipitation(series B) method at the pH condition between 7 and 11. Fine Al2O3-ZrO2 powders were prepared at optimum calcination condition and the effects of ZrO2 on microstructures and mechanical properties of Al2O3 were investigated. The composition of Al2O3/ZrO2 composites wax fixed as Al2O3-15 v/o ZrO2(＋3m/o Y2O3). ZrO2 limited the grain growth of Al2O3 and increased grain size homogeneity of Al2O3 more effectively than MgO.Flexural strength values in Al2O3 and Al2O3/ZrO2 composites were 340-430 MPa and 540-820 MPa, respectively, and the effect of strength improvement showed 20-50% by adding ZrO2 to Al2O3. Fracture toughness of Al2O3/ZrO2 composites was improved by stress-induced phase transformation of tetragonal ZrO2 and toughening effect by microcrack was not observed. Also, ZrO2 particles located at Al2O3 grain junction contributed to toughening, while spherical ZrO2 particles located within Al2O3 grain did not contribute to toughening. Weibull moduli of Al2O3 ceramics and Al2O3/ZrO2 composites of series A and series B were 4.34, 5.17 and 9.06, respectively. Above 0.5 of failure probability, strength values in Al2O3 ceramics and Al2O3/ZrO3 composites of series A and series B were above 400 MPa, 700 MPa and 650 MPa, respectively.

• Journal of the Korean Magnetics Society
• /
• v.23 no.1
• /
• pp.12-17
• /
• 2013

Nanocrystalline nickel (Ni) tick films were synthesized by direct current electrodeposition at current density from 1 to $30mA/cm^2$ and pH = 4. The basic composition of the bath, which was prepared by dissolving Ni metal particles in HCl, was 0.2M Ni ions. The effects of the current density on the average grain size of Ni deposits were investigated by XRD and SEM techniques. The results showed that the surface roughness was decreased as the saccharin addition was increased up to 2 g/l. The experimental results showed that the increase in the current density had a considerable effect on the average grain size of the Ni deposits. The perpendicular magnetization was raised as the thickness of coating layer was increased.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.957-967
• /
• 2017

Firing test of the fuel grain for solid fuel ramjet with additives and ignition support material was conducted. Fuel grain consist of HTPB mixed with AP particle 15 wt.%, Boron particle 5 wt.%. To cause the short ignition delay, ignition support consist of $NC/BKNO_3$ and composite propellant was coated to the fuel grain. An oxidant gas having a controlled temperature, pressure and oxygen composition close to the air condition in the ramjet combustor was supplied using the Ethanol blended $H_2O_2$ gas generator. Gas was set to flow at a mass flow rate of 150 g/s and mass flux of $200kg/m^2s$ in the grain port. Through the test, ignition support operated well and ignition delay of 0.5. During the test, stable chamber pressure with 8 bar and high combustion efficiency of 0.86 was confirmed.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.47 no.2
• /
• pp.102-107
• /
• 2002

Cereal grains are rich in phenolic compounds that give beneficial effect in human health. Although several research works have been reported on the effects of phytochemicals of plant origin, such as fruits, vegetables, few studies have examined the antioxidative effects of whole cereal grains. The objective of this study was to determine total antioxidant capacity of 80% ethanolic extracts of cereal grains by testing the ability of the extracts to inhibit UV -induced lipid peroxidation in vitro using linoleic acid in comparison to well-known antioxidant such as ascorbic acid and tannic acid. The total phenolic content of the cereal grain (80% ethanolic extracts) investigated in this study varied from 2.1 mg/g (wheat cv. Olgeurumil) to 10.4 mg/g (barely cv. Seodunchalbori). Highly positive relationship between total phenol compounds and antioxidant activity was found. When the antioxidant activities of all investigated extracts were measured with application of same quantity of phenol compounds, oat grain extracts showed similar antioxidant activity of barely cultivars. However, barely extract appeared as the most potent antioxidant activity of inhibition of UV -induced lipid peroxidation. This indicated that factors such as phenolic compound composition and their individual antioxidant activity could playa crucial role in the total antioxidant activity of cereal grains.

• Journal of Biosystems Engineering
• /
• v.43 no.4
• /
• pp.296-302
• /
• 2018

Purpose: The aim of this study was to determine appropriate threshing and selection conditions for sorghum harvesting using a rice combine-harvester. Methods: Sorghum harvesting performance was tested using an actual rice combine. Through this test, the grain loss rate and the composition of crops according to the engine and fan speeds of the combine were investigated. Furthermore, the optimal threshing and selection conditions were determined by carrying out a harvest test based on the opening size factor of the concave in a test field. Results: The grain loss rate for the sorghum using a concave ($18{\times}18mm$) of the rice combine was the lowest at 0.1% at a chaffer angle of $40^{\circ}$, engine speed of 2000 rpm, and fan speed of 20 m/s, but the sorting sieve clogged frequently. Furthermore, as the engine speed and fan speed increased, the grain loss rate also increased. The sorghum harvesting test results of the combine according to the concave opening size showed that the grain loss rate was 0.5% at a driving speed of 0.5 m/s, with a concave opening diameter of 13 mm, a chaffer angle of $40^{\circ}$, a concave sieve oscillation frequency of 4.8 Hz, a fan speed of 20 m/s, and an engine speed of 2000 rpm. Conclusions: Findings showed that sorghum could be harvested using a head feeding rice combine.

• Journal of The Geomorphological Association of Korea
• /
• v.20 no.3
• /
• pp.1-14
• /
• 2013

This study aims to investigate the formation and sedimentary environment including formative period, grain composition and climate change from loess-paleosol sequence deposited on a gravel bed of river terrace in the Jincheon Basin, Chungbuk Province. The Jincheon section consists downward of a surface layer, loess-paleosol sequence, transitional layer I, transitional layer II and gravel bed. It can be suggested from the OSL age dating that the sequence was deposited during MIS 6 to 4. The sequence can be divided into four horizons based on the variation in the magnetic susceptibility values. Grain size analysis reveals that the sequence indicates similar properties of grain size to loess deposits in Korea and especially, the Y values in the sequence are lower than those in the loess and paleosol horizons in the Chinese Loess Plateau and similar to those in the Red Clay in the Chinese Loess Plateau and Xiashu loess in the lower reaches of the Yangtze River. These Y values in the sequence can be attributed to the remote source and/or experience of intensive weathering process after deposition in the Korean Peninsula.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.38 no.2
• /
• pp.183-188
• /
• 1993

This experiment was conducted to investigate the effect of sulfur containing fertilizers on growth, yield and nutritive quality of soybean as affected by lime application at reclaimed soil. Lime application for neutralization requirements showed the effect of increased grain yield about 32% compared to the non application at newly opened land of red and yellow soil. In case of lime application, the sulfur containing fertilizers combined with super phosphate, ammonium sulfate, and gypsum increased the grain yield by 31%, 11%, and 3%, respectively. When lime was not applied, magnesium carbonate application increased the yield by 47%, super phosphate by 22%, and gypsum by 15%. The protein content of grain was higher at lime application than those of non lime application and was increased by the application of sulfur containing fertilizer. But lipid content was not affected by lime or sulfur application. From the above results obtained it was concluded that sulfur fertilizer effect under lime application was significant when combined with super phosphate or ammonium sulfate application. Magnesium carbonate or super phosphate application was the best combination with sulfur-containing fertilizer.