• Wind and Structures
• /
• 제19권3호
• /
• pp.249-270
• /
• 2014

Through comparing the mean wind profiles observed overland during the passages of four typhoons, and the gradient wind speeds calculated based on the sea level pressure data provided by a numerical model, the present paper discusses, (a) whether the gradient balance is a valid assumption to estimate the wind speed in the height range of 1250 m ~ 1750 m, which is defined as the upper-level mean wind speed, in a tropical cyclone over land, and (b) if the super-gradient feature is systematically observed below the height of 1500 m in the tropical cyclone wind field over land. It has been found that, (i) the gradient balance is a valid assumption to estimate the mean upper-level wind speed in tropical cyclones in the radial range from the radius to the maximum wind (RMW) to three times the RMW, (ii) the super-gradient flow dominates the wind field in the tropical cyclone boundary layer inside the RMW and is frequently observed in the radial range from the RMW to twice the RMW, (iii) the gradient wind speed calculated based on the post-landfall sea level pressure data underestimates the overall wind strength at an island site inside the RMW, and (iv) the unsynchronized decay of the pressure and wind fields in the tropical cyclone might be the reason for the underestimation.

• 대한임상전기생리학회지
• /
• 제8권2호
• /
• pp.25-31
• /
• 2010

Purpose : The purpose of this study was to investigate knee muscle strength, balance, and proprioception by walking while giving weight to the ankle joint at a load of 0%, 10%, and 15% gradient on a treadmill. Methods : Twenty-four subjects were divided into three groups. Group A walked on a 0% gradient while giving weight to the ankle joint as a load. Group B walked on a 10% gradient while giving weight to the ankle joint as a load. Group C walked on a 15% gradient while giving weight to the ankle joint as a load. This was performed three times per week for four weeks. The walking speed was set at 4km/hour and the walking time was set at 20 minutes. Measurements were performed before and after the experiment. Biodex medical system and Balance system SD were used as measuring instruments. Results : There was no significant difference between the gradients in muscle strength, balance and proprioception. However, there were differences in pretest and posttest measurements for muscle strength, balance and proprioception in each gradient. In particular, the gradient of 10% showed a significant difference. Conclusion : According to the results of this study, to use a 10% gradient is effective when walking while giving weight to the ankle joint as a load.

• Wind and Structures
• /
• 제18권4호
• /
• pp.347-373
• /
• 2014

Since its development in the early 1980's the force balance technique has become a standard method in the efficient determination of structural loads and responses. Its usefulness lies in the simplicity of the physical model, the relatively short records required from the wind tunnel testing and its versatility in the use of the data for different sets of dynamic properties. Its major advantage has been the ability to provide results in a timely manner, assisting the structural engineer to fine-tune their building at an early stage of the structural development. The analysis of the wind tunnel data has evolved from the simple un-coupled system to sophisticated methods that include the correction for non-linear mode shapes, the handling of complex geometry and the handling of simultaneous measurements on multiple force balances for a building group. This paper will review some of the components in the force balance data analysis both in historical perspective and in its current advancement. The basic formulation of the force balance methodology in both frequency and time domains will be presented. This includes all coupling effects and allows the determination of the resultant quantities such as resultant accelerations, as well as various load effects that generally were not considered in earlier force balance analyses. Using a building model test carried out in the wind tunnel as an example case study, the effects of various simplifications and omissions are discussed.

• 패션비즈니스
• /
• 제25권4호
• /
• pp.151-160
• /
• 2021

The purpose of this study was to investigate whether there were improvements on balance when both ankle-jointed calf muscles and hip muscles, which affect balance capabilities, were activated through taping techniques and EMS. In this study, the One Leg Standing Test, a static balance test, was conducted by experimenting on a flat floor, foam pad, and a stretching board with a gradient of 20 degrees, respectively, to study static balance capabilities in different situations. Nine healthy men in their 20s were measured five times every five minutes considering muscle fatigue, and the difference between each variable was analyzed through post-test using nonparametric statistical analysis. Our results showed an equal increase in static balance capability was similar when EMS was applied only to calf muscles and only to hip muscles. Notably most improvements were seen when wearing calf supporters and taping technology pants, and applying EMS together. It was also found that the difference between EMS electric stimulation and balance capability was greater when wearing and applying supporters and taping technology pants. Based on the results of the present study, a muscle support band and EMS of taping techniques can improve balance capabilities. These findings are expected to form a basis for solutions Improving the balance capabilities

• 대한통합의학회지
• /
• 제2권1호
• /
• pp.91-100
• /
• 2014

Purpose : The purpose of this study was to know the influence of the difference in shoulder slope from balance training. Method : Training was divided that the 10 people were a Trampoline group, 10 people were a Togu group, 8 people were a Balance Board group and 9 people were a Control group. Method of the training was that the Trampoline group was carried out on the Trampoline. The training was carried out totally 2 times of 8 set per a week and had a break time during 10 seconds after carried out 30 seconds per one set. Togu group was carried out totally 2 times of 5 minutes per a week and had a break time during 30 seconds after carried out 2 minutes per one set. Balance Board group was carried out totally 2 times of 5 minutes per a week and had a break time 30 seconds after carried out 2 minutes per one set. Data was analyzed by repeated measure of one way ANOVA and repeated measure ANOVA. Result : The shoulder of the slope difference decreased significantly after balance training. The Trampoline group decreased from $3.13{\pm}1.01$ to $2.37{\pm}1.11$, the Togu group decreased from $3.78{\pm}0.85$ to $3.78{\pm}0.85$, the Balance Board group decreased from $1.78{\pm}0.82$ to $1.65{\pm}0.59$ and the Control group decreased from $1.77{\pm}1.16$ to $1.61{\pm}0.62$. Conclusion : The effectiveness improved in the order Togu group, Trampoline group, Balance Board group and Control group from the result of the balance training about difference of slope shoulder.

• 한국환경과학회지
• /
• 제24권4호
• /
• pp.495-504
• /
• 2015

To estimate water balance of Pyosun watershed in Jeju Island, a three-dimensional finite difference model MODFLOW was applied. Moreover, the accuracy of groundwater flow modeling was evaluated through the comparison of the recharge rate by flow modeling and the existing one from water balance model. The modeling result under the steady-state condition indicates that groundwater flow direction was from Mt. Halla to the South Sea and groundwater gradient was gradually lowered depending on the elevation. Annual recharge rate by the groundwater flow modeling in Pyosun watershed was calculated to 236 million $m^3/year$ and it was found to be very low as compared to the recharge rate 238 million $m^3/year$ by the existing water balance model. Therefore, groundwater flow modeling turned out to be useful to estimate the recharge rate in Pyosun watershed and it would be available to make groundwater management policy for watershed in the future.

• 한국결정성장학회:학술대회논문집
• /
• 한국결정성장학회 1999년도 PROCEEDINGS OF 99 INTERNATIONAL CONFERENCE OF THE KACG AND 6TH KOREA·JAPAN EMG SYMPOSIUM (ELECTRONIC MATERIALS GROWTH SYMPOSIUM), HANYANG UNIVERSITY, SEOUL, 06월 09일 JUNE 1999
• /
• pp.187-207
• /
• 1999

The thermal distributions near the growth interface of 150mm CZ crystals were measured by three thermocouples installed at the center, middle (half radius) and edge (10m from surface) of the crystals. The results show that larger growth rates produced smaller thermal gradients. This contradicts the widely used heat flux balance equation. Using this fact, it si confirmed in CZ crystals that the type of point defects created is determined by the value of the thermal gradient (G) near the interface during growth, as already reported for FZ crystals. Although depending on the growth systems the effective lengths of the thermal gradient for defect generation are varied, were defined the effective length as 10mm from the interface in this experiment. If the G is roughly smaller than 20C/cm, vacancy rich CZ crystals are produced. If G is larger than 25C/cm, the species of point defects changes dramatically from vacancies to interstitial. The experimental results which FZ and CZ crystals are detached from the melt show that growth interfaces are filled with vacancy. We propose that large G produces shrunk lattice spacing and in order to relax such lattice excess interstitial are necessary. Such interstitial recombine with vacancies which were generated at the growth interface, next occupy interstitial sites and residuals aggregate themselves to make stacking faults and dislocation loops during cooling. The shape of the growth interface is also determined by the distributions of G across the interface. That is, the small G and the large G in the center induce concave and convex interfaces to the melt, respectively.

• 제어로봇시스템학회논문지
• /
• 제16권11호
• /
• pp.1074-1081
• /
• 2010

Today, the research related to the robot is achieved in various part. With the high interest in means of transport, various researches about autonomous mobile robot and next generation transport is continuing. The unicycle robot among these needs much control technique like balance control model and driving model. For autonomous driving of this unicycle robot, from the basic balance control to direction switching control and velocity control are needed. But the environment elements like a gradient and frictional force or unbalanced elements from the structural feature. The unicycle needs the real time balance control so more complex, harder to control. And when functional addition is made, the problem that fall entire reaction velocity or accuracy would be happen. This paper introduces entire dynamics modeling of the unicycle robot and reduced model. And propose the new balance control algorithm using fuzzy controller. Also the evaluation about performance would be made through the test.

• 한국전산유체공학회지
• /
• 제3권2호
• /
• pp.27-38
• /
• 1998

Rotating flow of a stratified fluid contained in a circular cylinder with unstable temperature gradient imposed on the side wall of it has been numerically studied. The temperatures at the endwall disks are constant. The top disk of the container is coider than that of the bottob disk, as much as the temperature difference n${\Delta}$T, (0${\leq}$n${\leq}$3). Flows in the vessel are driven by an impulsive rotation of the hot bottom disk with respect to the central axis of the cylinder. Flow details have been acquired. For this flow, the principal balance in the interior core is characterized by a relationship between the radial temperature gradient and the vertical shear in the azimuthal velocity. As the buoyancy effect becomes appreciable, larger portions of the meridional fluid transport are long-circuit from the bottom disk to the interior region via the side wall.

• Structural Engineering and Mechanics
• /
• 제68권1호
• /
• pp.103-119
• /
• 2018

In the present research, an attempt is made to obtain a semi analytical solution for both nonlinear natural frequency and forced vibration of embedded functionally graded double layered nanoplates with all edges simply supported based on nonlocal strain gradient elasticity theory. The interaction of van der Waals forces between adjacent layers is included. For modeling surrounding elastic medium, the nonlinear Winkler-Pasternak foundation model is employed. The governing partial differential equations have been derived based on the Mindlin plate theory utilizing the von Karman strain-displacement relations. Subsequently, using the Galerkin method, the governing equations sets are reduced to nonlinear ordinary differential equations. The semi analytical solution of the nonlinear natural frequencies using the homotopy analysis method and the exact solution of the nonlinear forced vibration through the Harmonic Balance method are then established. The results show that the length scale parameters give nonlinearity of the hardening type in frequency response curve and the increase in material length scale parameter causes to increase in maximum response amplitude, whereas the increase in nonlocal parameter causes to decrease in maximum response amplitude. Increasing the material length scale parameter increases the width of unstable region in the frequency response curve.