• Microbiology and Biotechnology Letters
• /
• v.23 no.3
• /
• pp.263-268
• /
• 1995

A screening was performed to isolate exoploysaccharide-producing microorganisms, which synthesized specific exopolysaccharide for the substitutive of commercial polysaccharides, from natural sources. Soil bacterium, one of 378 mucoid isolates, was finally selected as potential producer of polysaccharides which made the culture broth very viscous and thus examined in detail for optimal medium composition. Isolated strain was identified as Xanthomonas sp. EPS- 1 from the results of morphological and biochemical characteristics. The composition of optimal medium for exopolysaccharide production was as follows: 50 g sucrose, 1.5 g peptone, 2 g KH$_{2}$PO$_{4}$, 2 g MgSO$_{4}$, -7H$_{2}$O, 3 g NaCl, 0.05 g CaCO$_{3}$, 0.07 g FeSO$_{4}$-7H$_{2}$O and 0.05 g MnSO$_{4}$-7H$_{2}$O in 1 liter of distilled water. From the experiments of temperature and pH dependence, the optimal conditions for exopolysaccharide biosynthesis seemed to be 30$\circ$C and 8.0, respectively. About 14.9 gram of maximum exopolysaccharide per liter was obtained at the initial pH 8.0, 30$\circ$C and 250 rpm in a flask culture. The exopolysaccharide EPS-1 had such potential as an emulsifying agent and a gelling agent in comparision with commercial exopolysaccharide.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.32 no.5
• /
• pp.607-611
• /
• 1999

Carrageenan are sulfated polymers containing galactose and anhydrogalctose units, and is used for its gelling, thickening, stabilizing, emulsifying, and suspending properties. However, carrageenan is limited to use beyond $0.03\%$ as food additives because of its high degree of gelling and viscosity with low solubility. The use of ultrasound significantly reduced the viscosity of $\lambda$-carrageenan solutions. The optimal parameters of ultrasound for reduction of carrageenan molecular weight were temperature, $10^{\circ}C$ ultrasound intensity, 114.7 $W/cm^2$ ; carrageenan concentration, $2\%$; treatment time, 10 min. The molecular weights of control, ultrasound peak 1, and peak 2 were approximately 250,000, 184,000, and 67,000 daltons, respectively. The lower molecular weight of $\lambda$-carrageenan showed the higher solubility, the lower alcohol precipitation ratio and the lower emulsifying capacity. Browning degree of both control and lower molecular $\lambda$-carrageenans was not significantly different.

• Korean Journal of Food Science and Technology
• /
• v.53 no.5
• /
• pp.553-560
• /
• 2021

Theanine, the major amino acid and a sweet umami component of green tea, has anti-stress effects in humans. From green tea, theanine was extracted at 80℃ for 2 h using a low temperature, high pressure extractor, and caffeine was removed using an HP-20 column with 80% ethanol. Theanine extracts were applied to produce functional jelly using three kinds of gelling agents (I, II, and III) or various concentrations of theanine extracts (10-50%). Theanine jelly was characterized with respect to its physical properties, product stability, and physiological function. Gelling agent III (tamarind gum, xanthan gum, and locust bean gum=2:3:5, w/w/w) and S3 (35% theanine extracts) jelly exhibited the optimum textural properties with lower hardness and high springiness. Among theanine jellies, S3 exhibited optimum product stability, high 1,1-diphenyl-2-picrylhydrazyl (DPPH) scavenging, and acetylcholinesterase inhibitory activity. These results indicate that the anine extracts could be used as a neuroprotective source in the food industry.

• Food Science and Biotechnology
• /
• v.17 no.3
• /
• pp.587-593
• /
• 2008

Microbial exopolysaccharide (EPS) is a biothickener that can be added to a wide variety of food products, where it serves as a viscosifying, stabilizing, emulsifying, and gelling agent. The objective of this study was to investigate the optimum conditions of pH, incubation temperature, and whey protein concentration (WPC) for EPS production by Lactobacillus rhamnosus ATCC 9595. We found that maximal EPS production was achieved at a pH of 5.5 and temperature of $37^{\circ}C$. At the same fermentation conditions, EPS production was affected by the addition of L. rhamnosus GG (a weak-EPS producer). After growth for 24 hr, total EPS production was $583{\pm}15.4mg/L$ in the single culture system, and $865{\pm}22.6\;mg/L$ in the co-culture system with L. rhamnosus GG. Based on the presence of WPC, EPS production dramatically increased from $583{\pm}15.4$ (under no WPC supplementation) to $1,011{\pm}14.7\;mg/L$ (under supplementation with 1.0% WPC). These results suggest that WPC supplementation and the co-culture systems coupled with small portions of weak-EPS producing strain can play an important role in the enhancement of EPS production.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.32 no.1
• /
• pp.75-81
• /
• 2003

Rheological properties of micronized full-fat soyflour (MFS ) milk were determined according to solid content, heat-treatment and type of coagulants. Heat-treated MFS milk showed a pseudoplastic flow pattern. The consistency and flow index of heated MFS milk was greatly affected by increasing the concentration of MFS and/or soy protein isolate (SPI). Apparent viscosity of MFS milk was gradually decreased by heating below 6$0^{\circ}C$, but was drastically increased by raising temperature further. Addition of coagulants and SPI resulted in dropping the temperature that allows to increase apparent viscosity drastically. A coagulant for MFS tofu was formulated based on the gelling Property of a single coagulant. The textural properties of MFS tofu were improved using 7.1% total protein fortified with SPI.

• Journal of the Korean Institute of Gas
• /
• v.16 no.6
• /
• pp.115-122
• /
• 2012

Polyurethane foams were synthesized with different contents and kinds of catalysts to know change of properties under various NCO index. UTM(universal testing machine), DSC(differential scanning calorimetry), SEM(scanning electron microscope) and FT-IR(Fourier transform spectroscopy) were used for studying the PUF's physical properties change. Compressive strength of PUF increased with increasing contents of catalyst. Glass transition temperature(Tg) and compressive strength of PUF using PC-8 and 33LV catalyst, increased with increasing NCO index at the aging. According to the results of Infrared spectral analysis, reduction of NCO peak was found in gelling catalyst, because unreacted NCO reacted with polyurethane. Although Tg and compressive strength of PUF using TMR-2, unchanged with increasing NCO index at the aging, because trimerization of isocyanate.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.7 no.1
• /
• pp.7-14
• /
• 2001

The amount of petroleum consumption has been Increased according to the industrialization and It leads to the increase of the possibility of marine oil pollution. In Korea, some countermeasures including oil skimmer, gelling agent and herding agent of oil have been used for the remediation of the pollution. However, most of them have lets of shortcomings in the application under in-situ condition, because they are sensitive to the situation such as geographical feature, the wind and the tide. In reported literature, the natural powdered oil absorbent which is made of peat moss is an effective mean to clean spilled oil from lake or coast. However, the peat moss is a natural resource which is only Produced from a specific cold weather are like Canada. This indicates that the alternative materials which is readily obtained from everywhere are needed for powdered oil absorbent. Therefore. in the study, same natural materials including pine leaves and straw are tested as the alternative materials for the absorbent. The raw materials were dried and treated by heat at various temperature during several Periods and then. shattered by a grain cracking machine. The oil sorption capacity of the prepared materials was compared according to the methods of heat treatment and their sizes. The proportion of hydrogen cyanide to combustion of the absorbents was measured to confirm their final disposal methods. The biodegradability test of the absorbents was carried our to evaluate possibility of a side pollution in the coast. In was found that the heat treatment of pine leaves enhanced the capacity of oil sorption and decreased the water sorption. The maximum oil sorption was observed for the material treated at 18$0^{\circ}C$for 60 min. The amount of hydrogen cyanide from the combustion were 0.09ml/g, 0.07ml/g for pine leaves and straw respectively meaning that the final disposal by combustion might be feasible. The amount or organic carbon extracted from pine leaves during 7 days was up to 0.015g organic carbon from one gram of pine leaves. but the degradation was as fast as for glucose. It is concluded that the pine leaves can be served as a good raw material for the powdered oil absorbent like peat moss.

• Journal of the Korean Applied Science and Technology
• /
• v.17 no.2
• /
• pp.67-75
• /
• 2000

Cosmetic industries have recently developed sun-block products, which are composed of W/O or O/W emulsion system. It was very difficult for waterproofing product to show the stability in W/O emulsion with $TiO_{2}$. To enhance the stability of W/O emulsion, it needs to be combined with the water and oil soluble components as the gelling agents. The emulsifiers used in W/O were 3.0% of cetyl dimethicone copolyol, 2.0% of sorbitan sesquioleate as the basic emulsifiers, and 0.6% of quaternium-18 bentonite and 1.5% of dextrin palmitate as stabilizer were used. The content of titanium dioxide was optimized up to 8.0%. Titanium dioxide was used as the UV scattering powder coated with $Al_{2}O_{3}$(UV-sperse T40/TN). The sunscreen cream prepared with W/O emulsion system by using QB and DP showed higher stability than that of W/O emulsion system by using each QB and DP. W/O emulsion from Formula 3 for passing one year was very durable more than F1 and F2. Within W/O emulsion by observing F1, F2 and F3 for one year, F3 was more excellent than F2 and F3 when they were observed at RT, $4^{\circ}C$, $40^{\circ}C$, because F3 used the mixed QB and DP in W/O emulsion. The zeta potential for F1, F2, and F3 after one year were 21, 30 and 43, respectively. From these result F3 was found best stable emulsion. The in-vitro SPF value for F3 was 35 for the initial product at room temperature and also, the in-vitro SPF values of F3 was 32 for after one year. Finally, the mean in-vivo SPF value of 10 volunteers for F3 was 27.3 by the Korea cosmetic association made the rules of SPF.

• Food Science of Animal Resources
• /
• v.34 no.2
• /
• pp.230-237
• /
• 2014

This study was designed to find the most suitable method and wall material for microencapsulation of the Lactobacillus plantarum to maintain cell viability in different environmental conditions. To improve the stability of L. plantarum, we developed an encapsulation system of L. plantarum, using water-in-oil emulsion system. For the encapsulation of L. plantarum, corn starch and glyceryl monostearate were selected to form gel beads. Then 10% (w/v) of starch was gelatinized by autoclaving to transit gel state, and cooled down at $60^{\circ}C$ and mixed with L. plantarum to encapsulate it. The encapsulated L. plantarum was tested for the tolerance of acidic conditions at different temperatures to investigate the encapsulation ability. The study indicated that the survival rate of the microencapsulated cells in starch matrix was significantly higher than that of free cells in low pH conditions with relatively higher temperature. The results showed that corn starch as a wall material and glycerol monostearate as a gelling agent in encapsulation could play a role in the viability of lactic acid bacteria in extreme conditions. Using the current study, it would be possible to formulate a new water-in-oil system as applied in the protection of L. plantarum from the gastric conditions for the encapsulation system used in chicken feed industry.

• Culinary science and hospitality research
• /
• v.15 no.4
• /
• pp.99-114
• /
• 2009

This study examined the optimal cooking condition for surimi-like material (SLM) derived from porcine semimembranosus (SM) muscle and the effects of the various cooking temperatures and the cooking time on the gel properties. The most noticeable change that occurred during the preparation of the SLM from the SM was the reduction in the fat content (about 1%) during the washing procedures. The hardness and gel strength value were increased significantly as the cooking temperature was increased by $75^{\circ}C$ for 20 min (p<0.05). The SLMG cooked above $75^{\circ}C$ had a significantly higher WHC than the SLMG cooked below $75^{\circ}C$ (p<0.05). The gelling property of SLMG was effected for different conditions of cooking time and temperatures by the result of SDS-PAGE. After 20 min cooking, some enzyme bands including phosphorylase disappeared. The loss of these bands (about 46 kDa and 60 kDa) was observed after 20 min of cooking time. The photographs of microscopy showed that the filaments of myofibrils did not disappear after a cooking time of 15 min, and that the gaps between the fibers or filament were close. A significant change in the fibers and filaments occurred from 30 min to 35 min of cooking time, and the gradual coagulation of the structure of the SLM was observed with cooking time increased. These results suggest that a desirable surimi gel could be obtained from pork by cooking at $75^{\circ}C$ for 25 min.