• Journal of the Korean Applied Science and Technology
• /
• v.34 no.4
• /
• pp.986-994
• /
• 2017

In this paper, $CO_2$ absorption of scrubber was tested for removal of high concentration $CO_2$. Liquid to gas ratio($18L/m^3$) and Superficial velocity(0.14 m/s) was determined through Lab-scale test. As flow rates increase 1, 2, 3, 4 and $5m^3/min$, $CO_2$ removal efficiency decrease 98.47%, 96.46%, 92.95%, 89.71% and 85.49%. Also, the scrubber operation made energy improvement(5.4%), energy saving(11.5 TOE/year) and greenhouse gases reduction(6.5 TC/year).

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.9
• /
• pp.961-972
• /
• 2008

In 2004, total emissions of Greenhouse Gases(GHGs) in Korea was estimated to be about 590 million metric tons, which is the world's 10th largest emissions. Considering the much amount of nation's GHG emissions and growing nation's position in the world, GHG emissions in Korea should be reduced in near future. The CO$_2$ emissions from two sub-sections of energy sector in Korea, such as thermal power plant and industry section(including manufacturing and construction industries), was about 300 million metric tons in 2004 and this is 53.3% of total GHG emissions in Korea. So, the mitigation of CO$_2$ emissions in these two section is more important and more effective to reduce the nation's total GHGs than any other fields. In addition, these two section have high potential to qualitatively and effectively apply the CCS(Carbon Capture and Storage) technologies due to the nature of their process. There are several CCS technologies applied to these two section. In short term, the chemical absorption technology using amine as a absorbent could be the most effectively used. In middle or long term, pre-combustion technology equipped with ATR(Autothermal reforming), or MSR-$H_2$(Methane steam reformer with hydrogen separation membrane reactor) unit and oxyfuel combustion such as SOFC+GT(Solid oxide fuel cell-Gas turbine) process would be the promising technologies to reduce the CO$_2$ emissions in two areas. It is expected that these advanced CCS technologies can reduce the CO$_2$ avoidance cost to $US 8.5-43.5/tCO$_2$. Using the CCS technologies, if the CO$_2$ emissions from two sub-sections of energy sector could be reduced to even 10% of total emissions, the amount of 30 million metric tons of CO$_2$ could be mitigated.

• Korean Chemical Engineering Research
• /
• v.49 no.2
• /
• pp.256-262
• /
• 2011

Amine can undergo irreversible reactions by $O_{2}$ and high temperature in amine scrubbing process and these phenomena are called "degradation". Degradation causes not only a loss of valuable amine, but also operational problems such as foaming, corrosion and fouling. In this study, using various chemical absorbents(MEA; monoethanolamine, AMP; 2-amino-2-methyl-1-propanol, DAM; 1,8-diamino-p-menthane), we examined the following variable. I) loading ratio of $CO_{2}$ at $50^{\circ}C$ and $120^{\circ}C$, ii) concentration variation and initial degradation rate constant of absorbent in $CO_{2}$ and $CO_{2}/O_{2}$ system, and iii) effect of degradation by $O_{2}$. The $CO_{2}$ loading of 20 wt% DAM was 400% and 270% higher than that of 20 wt% MEA and AMP at 50, respectively and was the largest the difference of $CO_{2}$ loading between absorption $(50^{\circ}C)$ and regeneration $(120^{\circ}C)$ condition. The initial degradation rate constant of 20 wt% DAM was $2.254{\times}10^{-4}cycle^{-1}$ which was slower than that of MEA $(2.761{\times}10^{-4}cycle^{-1})$ and AMP $(2.461{\times}10^{-4}cycle^{-1})$ in $CO_{2}$ system. Also, it was increased 30% by $O_{2}$ that effects on the degradation by $O_{2}$ was less than 100% increased. these degradation reactions was able to identify by formation of new peak in GC and FT-IR spectrum analysis.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.8 no.3
• /
• pp.81-88
• /
• 2000

Composting of N-rich wastes such as food waste and wastewater sludges can be associated loss of with substantial gaseous N, which means loss of an essential plant nutrient but may also lead to environmental pollution. We investigated the behavior of nitrogenous materials during the first high-rate phase in composting of food waste. Air dried food waste was mixed with shredded waste paper or wood chip and reacted in a bench scale composting reactor. Samples were analyzed for pH, ammonia, oxidized nitrogen and organic nitrogen. The volatilized ammonia nitrogen was also analyzed using sulfuric acid as an absorbent solution. Initial progress of composting reaction greatly influenced the ammonification of organic nitrogen. A well-balanced composting reaction with an addition of active compost as an inoculum resulted in the promoted mineralization of organic nitrogen and volatilization of ammonia. The prolongation of initial low pH period delayed the production of ammonia. It was also found that nitrogen loss was highly dependent on the air flow supplied. With an increase in input air flow, the loss of nitrogen as an ammonia also increased, resulted in substantial reduction of ammonia content in compost. The conversion ratio of initial nitrogen into ammonia was in the range of 28 to 38% and about 77~94% of the ammonia produced was escaped as a gas. Material balance on the nitrogenous materials was demonstrated to provide an information of importance on the behavior of nitrogen in composting reaction.

• Clean Technology
• /
• v.24 no.1
• /
• pp.50-54
• /
• 2018

In this work, N-methyl-2-pyrrolidone (NMP) was added into diethylenetriamine (DETA) aqueous solution for high $CO_2$ loading via phase splitting of absorbents during $CO_2$ absorption. Immiscible two phases were formed in the range of more than 30 wt% of NMP in 2 M DETA + NMP + water absorbents because of low solubility of DETA-carbamate in NMP solution. As the composition of NMP in the absorbents increased, the difference of $CO_2$ loading between each phase increased and the volume of bottom phase decreased. In $CO_2$ absorption in packed column by 2 M DETA + NMP + water absorbents, the absorption rate decreased in the range of more than 40 wt% of NMP. It is due to the increasing of mass transfer resistance in liquid film of absorbents at the high concentration of NMP. DETA + NMP + water absorbent is expected as the promising one for reducing the regeneration energy of absorbents according to volume reduction of $CO_2-rich$ phase.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.18 no.4
• /
• pp.297-308
• /
• 1985

Differences in lipid composition including fatty acid, lipid class, sterol and especially carotenoid between fleshes of wild and cultured prawn, Penaeus japonicus, were studied. Total lipids were extracted from the flesh during the spawning period and fractionated into two lipid classes of polar and nonpolar lipids by silicic acid column chromatography. The fatty acid composition of each lipid classes, total lipid (TL), nonpolar lipid (NL) and polar lipid (PL) were analyzed by gas liquid chromatography. The sterol and carotenoid composition of total lipids were determined by using thin layer chromatography, gas liquid chromatography and column chromatography using MgO-celite 545 and silicic acid-celite 545 as an absorbent, and by UV spectrophotometry. Total lipid contents of both fleshes from the wild and cultured prawn were about $2.0\%$ on average, but the content of the unsaponifiable matters in the cultured prawn (about $16.2\%$ in total lipid) showed a little higher than that of the wild prawn (about $13.9\%$ in total lipid) and the ratio of NL to PL in total lipid was 1:1.7. In the fatty acid composition of TL, the contents of $Cl_{16:0}\;and\;C_{20:3}$ fatty acids were higher in wild prawn than in cultured prawn, while the contents of $Cl_{18:1}\;and\;C_{20:5}$ fatty acids in cultured prawn were higher than those in wild prawn. The cultured prawn contained higher amounts of monoenoic acids and lower amounts of polyenoic acids than the wild prawn. In the fatty acid composition of NL, the wild prawn showed higher levels in $Cl_{18:0}\;and\;C_{20:1}$ fatty acid contents than the cultured prawn, while the cultured prawn contained much amout of $Cl_{16:0}\;and\;C_{18:1}$ fatty acids. On the other hand, the fatty acid composition of PL showed that $Cl_{16:1}\;and\;C_{17:1}$ fatty acid were higher in the wild prawn than in the cultured prawn, but in $Cl_{16:0}\;and\;C_{18:1}$ fatty acids, the levels were reversed. Consequently, the cultured prawn contained higher amount of monoenoic acids, and similar amounts of saturated acids and polyenoic acids to the wild prawn in NL. And the cultured prawn contained lower amount of monoenoic acids, and similar amounts of saturated acids and polyenoic acids to the wild prawn in PL. In sterol composition of both the wild and cultured prawn, the predominant sterol was cholesterol with the proportion of $78.7{\sim}88.9\%$ to the total sterol. In addition to the cholesterol, the other minor sterols such as 24-methylene cholesterol and sitosterol were detected. Total carotenoid content in flesh of the wild prawn was relatively higher than that of the cultured prawn marking 70 mg/100g of lipid in wild prawn and 40 mg/100 g of lipid in cultured prawn, respectively. The main carotenoids of the both prawns were astaxanthin($54.1{\sim}60.8%$), phoenicoxanthin ($16.5{sim}22.9%$),${\bata}-carotene\;(20.0{\sim}22.0%)$.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.7
• /
• pp.505-514
• /
• 2009

Aqueous potassium salt of serine was proposed as an alternative $CO_2$ absorbent to monoethanolamine (MEA) and its $CO_2$ absorption characteristics were studied. The experiment has been conducted using screening test equipment with NDIR type gas analyzer and vapor-liquid equilibrium apparatus. $CO_2$ absorption/desorption rate and net amount of $CO_2$ absorbed in cyclic process are the criteria to assess the $CO_2$ absorption characteristics in this study. Effective $CO_2$ loading of potassium salt of serine and MEA are 0.425 and 0.230 respectively. Cyclic capacities are 0.354 and 0.298 for potassium salt of serine and MEA. The absorption rate of the potassium serinate decreased sharply at $CO_2$ loading is 0.1 and were maintained approximately at half of MEA. To enhance the absorption rate of aqueous potassium salt of serine, small quantities of rate promoters, namely piperazine and tetraethylenepentamine were blended, so that rich $CO_2$ loading were increased by 13.7% and 18.7% respectively. The rich $CO_2$ loading of potassium salt of serine was 29.2% and 35.0% higher than those of aqueous sodium and lithium salt of serine, respectively. The absorption rate of potassium salt of valine and isoleucine which have similar molecular structures to serine were lower than that of serine because of the presence of bulky side group. Precipitation phenomena during $CO_2$ absorption were discussed by the aid of literatures.

• Journal of the Mineralogical Society of Korea
• /
• v.30 no.4
• /
• pp.149-159
• /
• 2017

We investigated the mineralogical and chemical characteristics of oyster shell as the possible substitute for the limestone used as an absorbent of $SO_2$ gas. The oyster shells from Taean and Tongyeong were used for the comparison with limestone and those from Boyreong and Yeosu were additionally investigated. XRD results show that all shells are composed of calcite with the exception of the myostracum layer attached to adductor muscle and ligament, which is composed of aragonite. The marine sediments as impurities exist on the surface of shells or as inclusions in the shells. Calcite is the main mineral composition of the shell of barnacle which is also one of the impurities. The oyster shell is composed of three main layers; prismatic, foliated, and chalk. The oyster shell from Tongyeong with the largest shell size, has the smallest thickness of prismatic and foliated layers which contain protein called conchiolin, whereas that from Taean with the smallest shell size has the largest prismatic and foliated layers. The sizes of those two layers of the shells from Boryeong and Yeosu are larger than that from Tongyeong but smaller than Taean. Those differences are supposed to be due to the different growth environments because the oysters from Tongyeong are cultured under the sea while those from Taean are in the tidal zone. The oyster shells generally show higher amount of sulfur and phosphorus than limestone, mainly due to the composition of protein. Some elements such as Mg show significant variations in different layers. As for trace elements, Li shows much higher amount in oyster shells than limestone, suggesting the influence of the composition of the sea water on the formation of the oyster shells.

• Economic and Environmental Geology
• /
• v.52 no.3
• /
• pp.223-230
• /
• 2019

The calcination of oyster shells have been studied as the possible substitute for the limestone used as an absorbent of $SO_2$ gas. However, since pure shells can not be used in calcination process, some impurities are contained and the changes in the characteristics of the calcination products are expected. In this study, the surface characteristics of the calcination products are investigated by mineralogical analysis according to the contents of NaCl, which can be derived from sea water, and sediments on the surface of the shell as impurities. The marine sediments on the shells were mainly composed of quartz, albite, calcite, small amounts of amphibole and clay minerals such as ilite, chlorite and smectite. After calcination of oyster shells mixed with 0.2-4.0 wt% sediments at $900^{\circ}C$ for 2 hours, regardless of the dehydration, dehydroxylation, and phase change of these minerals at the lower temperature than this experiment, no noticeable changes were observed on the specific surface area of the calcined product. However, when mixed with 0.1 to 2.0 wt% NaCl, the specific surface area generally increases as compared with the shell sample before calcination. The specific surface area increases with increasing amount of salt, and then decreases again. This is closely related to the changes of surface morphology. As the amount of NaCl increases, the morphology of the surface is similar to that of gel. It changes into a slightly angular, smaller particle and again looks like gel with increasing amount of NaCl. Our results show that NaCl affects morphological changes probably caused by melting of some oyster shells, but may have different effects on the specific surface area of calcination product depending on the NaCl contents.