• Journal of the Korean Society of Costume
• /
• v.16
• /
• pp.173-185
• /
• 1991

We measured change of peripheral skin temperature and mean skin temperature when the upper arm and thigh pressured in order to know the effect of skin pressure applied by clothing on blood circulation. After release from pressure, we observed also recovery condition. At the same time, we examined relation between pressure and a feeling of tightness. Three physiques of healthy females, namely slender, standard and plump, served as subjects. We used intermittent method with skin pressure applied by experimental fabric at l-minute intervals. Besides we made a comparative study with results according to different restraint method (continuous method and intermittent method). As a result of this experiment, we obtained following findings. 1. The significant difference was marked at the pressure, measuring time, physique and measuring region with change of skin temperature under upper arm and thigh restraint by intermittent method. The peripheral skin temperature decreased with the lapse of restraint time. A remarkable tendency observed according to the. increase of restraint pressure. Recovery condition after release from pressure not yet recovered to original state, for all after a lapse of 10 min. The mean skin temperature decreased with the lapse of restraint time in case of upper arm restraint, it was not an obvious tendency except 60mmHg under thigh restraint. 2. Main factor affecting the evaluation of a feeling of tightness was restraint pressure, when the upper arm and thigh restraint by intermittent method. The respondence rate of 'very tight' grew larger according to the increase of restraint pressure. The value of pressure sensation declined after restraint ten times as compared with one time, but there was difference according to restraint pressure. 3. We reexamined change of skin temperature and feeling of tightness by different restraint method(continuous method and intermittent method). The results were as follows. 1) The skin temperature decreased more greatly during skin pressure by continuous method than intermittent method, especially in the peripheral. Without different restraint method, the skin temperature of slender plysique decreased more greatly than that of plump physique. 2) The value of pressure sensation by intermittent method was highly on both sites of upper arm and thigh.

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2009.03a
• /
• pp.14-20
• /
• 2009

Atmospheric pressure air plasma was applied for treatment of different kinds of natural bamboo fiber to improve their mechanical properties and surface characteristics, which are suitable for adhesion and dyeing. The tensile strength and Young modulus of bamboo fiber were significantly improved; SEM and AFM study show that the surface of fiber became cleaner and rougher after plasma treatment. Plasma treatment caused the cracking, removing of the protective skin of alkali-untreated fiber and etching to form a cleaner and rougher surface. The dyeability of both groups of bamboo fiber which are used for composite and textile purposes is significantly enhanced after treatment.

• Journal of the Korea Fashion and Costume Design Association
• /
• v.17 no.1
• /
• pp.105-115
• /
• 2015

This study aims to compare the ease of men's single-pleated pants patterns, and to analyze the fit and appearance through the 3D virtual garment system. The researchers selected five(four educational materials and one industrial pattern) slim-fit single-pleated pants which is the current fashion trend in menswear. The CLO 3D Modelist program was utilized to carry out the appearance evaluation through virtual wearing, opacity, and clothing pressure. The results showed that D pants had the greatest ease on the waist circumference, while C pants had the least ease. The E pants had the greatest ease on the hip circumference, then B pants and C pants showed less ease. Also, the E pants had the longest on the pants length, then D pants showed the shortest. In the appearance evaluation, A pants received the most favorable results, followed by D, B, E, and C pants, in descending order. The clothing pressure appeared to be mainly red on the waist, crotch, and hem in all pants, so the clothing pressure was high. From the results, we can understand that each of the 5 single-pleated pants patterns has different ease amount and silhouette.

• Fashion & Textile Research Journal
• /
• v.6 no.4
• /
• pp.485-491
• /
• 2004

The purpose of this study is to analyze the wearing fitness of middle aged women's jacket with non-Stretchable Fabric and stretchable fabric. We surveyed the size of jackets and process of pattern making with stretchable fabric in companies which produce the clothing mainly for middle aged women. Based upon the result of process of pattern making, two kind of experimental jacket with non-stretchable and stretchable fabric were made. We measured space length between body and garment using 3D scanner and analyzed the clothing pressure 7 parts of body with 3 kinds of arm raising. The result were as follows : 1. Most parts of space length except bust were higher in non-stretchable jacket than in stretchable jacket. 2. Clothing pressure showed greater value with non-stretchable fabric jacket than with stretchable fabric jacket. Clothing pressure in upper arm point areas increased as the angle of the arm raising increased. Therefore, the sleeve width and armhole depth should he considered when the amount of wearing ease were reduced in jacket with stretchable fabric.

• Korean Journal of Human Ecology
• /
• v.15 no.3
• /
• pp.481-490
• /
• 2006

Adjusting pressure level in the construction of athletes' tight-fitting garments by reducing the elastic knit pattern is a challenging subject, which influences the performance of the wearer directly. Therefore, in this study, relationship between the reduction rates of the basic pattern obtained from 3D human scan data and resultant clothing pressure was explored to improve the fit and pressure exerted by clothing. 3D scan data were obtained using Cyberware and they were transformed into a flat pattern using software based on Runge-Kutta method. Reduction rate was examined by subjective wear test as well as objective pressure measurement. As a result, difference in the length between the original 3D body scan data and the 2D tight-fitting pattern was 0.02$\sim$0.50cm (0.05$\sim$1.06%), which was within the range of tolerable limits in making clothes. Among the five garments, the 3T-pattern was superior in terms of subjective sensation and fit. The pressure of the 3T pattern was 2$\sim$4 gf/cm2 at five locations on the body, which is almost the same or a bit higher than that of Z-pattern. In the case of tight-fitting overall garment, the reduction rate of the pattern in the wale direction is more critical to the subjective sensation than the course direction. It is recommended that the reduction grading rules of course direction should be larger than that of Ziegert for a better fit of tight-fitting garments. In the case of wale direction, however, reduction grading rule should be kept the same as suggested earlier by Ziegert (1988).

• Journal of the Korean Society of Clothing and Textiles
• /
• v.18 no.3
• /
• pp.387-394
• /
• 1994

Journal of the Korean Society of Clothing and Textiles Vol. 18, No. 3 (1994) p. 387∼394 In this study, the restriction of slacks (blue jean) versus box pleats skirt was investigated, from the view point of peripheral blood flow at the toe according to motion variation and E.M.G. analysis of leg muscles after walking on the flat or going up and down stairways. Besides, the pressure of slacks on the lower extrimity was measured statically and dynamically. The main results were summerized as follows; 1. The clothing pressure applied by slacks was; each one of thigh and lower leg was 18.2 g/ cm2 and 22.1 g/cm2 in upright, 63.4 g/cm2 and 26.6 g/cm2 in sitting on the chair, on both sides of thigh and lower leg 272.0 g/cm2 over in squatting. 2. When the motion starts from upright, the dynamic clothing pressure reach their peak before the motions end. When the motion ends and the body comes to a still condition, the clothing pressure grow lower and indicate a constant value. but when the body starts moving again to return to upright, the pressures once grow higher and go to zero value after reaching the peak. The pressure on the knee show much greater than those on the hip. This can be because these pressures depend on the degree of skin stretching motion and of its curvature. 3. The surface E.M.G. in leg muscles M. rectus femoris and M. gastrocnemius were recoreded. In the case of wearing slacks, two muscles were activated much more than wearing skirt. 4. The peripheral blood flow at the toe by wearing slacks was lower than wearing skirt. Also the case when squatting, the peripheral blood flow at the toe was low.

• The Research Journal of the Costume Culture
• /
• v.24 no.1
• /
• pp.114-117
• /
• 2016

It is recognized that the global apparel market of the twenty-first century is largely profit driven, and that the majority of producers and retailers have sourced products from the lowest cost locations. Purchase tickets of fashion goods available from 'fast' fashion retailers (at least within the UK) refrain from providing the consumer with details of the full circumstances of production. It seems that the majority of major retailers and producers are not willing to engage in levels of self-regulation which could ensure that the products offered to consumers are ethically produced and offer acceptable levels of sustainability. Meanwhile many fashion consumers have the desire to purchase sustainable products, produced ethically by workers paid fair wages in safe working environments. Consumer demand could be a powerful tool to adjust the behaviour of manufacturers and buyers. This paper proposes the introduction of international legislation demanding greater degrees of transparency than exist currently and that the full sourcing and production details of fashion products are stated clearly on the product's purchase ticket within its retail setting. With the introduction of such legislation, consumers could thus be given the opportunity of purchasing goods which they feel accommodate their own views on ethical manufacture and sustainable products. In turn, consumer pressure could ensure indirectly that retail buyers consider all ethical and sustainable aspects of production when negotiating with garment producers/suppliers. Further to this, such a negotiating stance could ensure the improvement of the terms and conditions of employment of the numerous garment workers worldwide.

• Fashion & Textile Research Journal
• /
• v.22 no.2
• /
• pp.250-260
• /
• 2020

The purpose of the present study was to explore the most effective body region and cooling temperature to alleviate heat strain of workers in hot environments. We developed liquid cooling hood, vest, sleeves and socks and applied the water temperatures of 10, 15, 20, and 25℃ through the liquid cooling garments in a hot and humid environment (33℃ air temperature and 70% RH air humidity). A healthy young male participated in a total of 16 experimental trials (four cooling garments × four cooling temperatures) with the following protocol: 10-min rest, 40-min exercise on a treadmill and 10-min recovery. The results showed that rectal temperature, mean skin temperature, and ratings of perceived exertion during exercise; heart rate and diastolic blood pressure during recovery; and total sweat rate were lower for the vest condition than other garment conditions(p < .05). However, there was no differences in mean skin temperature among the four cooling garments when we compared the values converted by covering area(%BSA). When we classified the results by cooling temperature, there were no consistent differences in thermoregulatory and cardiovascular responses among the four temperatures, but 25℃ water temperature was evaluated as being the most ineffective cooling temperature in terms of subjective responses. In conclusion, the results indicated that wearing cooling vest with < 20℃ cooling temperature can alleviate heat strain of workers in hot and humid environments. If the peripheral body regions are cooled with liquid cooling garments, larger cooling area with lower cooling temperature than 10℃ would be effective to reduce heat strain of workers. Further studies with a vaild number of subjects are required.

• International Journal of Internet, Broadcasting and Communication
• /
• v.12 no.1
• /
• pp.81-89
• /
• 2020

The purpose of this study is to investigation the effects of functional compression clothing on muscle function by comparing the iEMG response of muscle during exercise according to the wearing of taping applied functional clothing. Six men in their twenties in Chungcheongnam-do were selected for the study. Resistance exercise was performed by cross-distributing the conditions of wearing and not wearing functional clothing. Resistance exercises for iEMG measurements are biceps curl, wrist curl, reverse wrist curl, kickback and push-up. iEMG measurement muscles were the biceps brachii, triceps brachii, extensor carpi ulnaris, flexor carpi radialis. During biceps curl exercise, the iEMG of triceps brachii, biceps brachii wearing condition was lower than the non-wearing condition. During kickback exercise, the iEMG of triceps brachii, extensor carpi ulnaris wearing condition was lower than the non-wearing condition. During reverse wrist curl exercise, the iEMG of extensor carpi ulnaris wearing condition was lower than the non-wearing condition. During wrist curl exercise, the iEMG of flexsor biceps brachii, carpi radialis wearing condition was lower than the non-wearing condition. During push-up exercise, the iEMG of triceps flexsor biceps brachii, carpi radialis, brachii, biceps brachii non-wearing condition was lower than the wearing condition.

• Fashion & Textile Research Journal
• /
• v.18 no.4
• /
• pp.457-467
• /
• 2016

This study aimed to develop functional underwear for elderly women in their sixties in terms of good fit, wear comfort and body temperature regulation. To satisfy elderly women's physical and metabolical needs, an automatic temperature control system via PCM treatment was applied. Underwear pattern was produced by producing body surface replica, which was derived from 3D body parametric model. Differential ratios of outline length and area between 3D surface and 2D plane were 1.4% and 0.5%, respectively. The reduction rate was determined as 10% through the expert's evaluation. PCM treated fabric showed higher Q-max, meaning that it can facilitate the thermal transition in hot situation. Moreover, it also showed higher insulation to preserve heat and keep warm microclimate in a cold weather. Heat distribution measurements on various body parts revealed that the temperature after PCM treatment was significantly higher. The clothing pressure after 10% pattern reduction showed higher before reduction, at the same time, even lower than the comfort clothing pressure range of $5{\sim}10gf/cm^2$, implying that experimental garment of this research is acceptable in terms of clothing pressure. Evaluation results on the comfort to move in various motions proved that adequate clothing pressure improved the wear comfort in various motions.