• 한국지구물리탐사학회:학술대회논문집
• /
• 2006.06a
• /
• pp.259-264
• /
• 2006

In MT and GDS survey for probing the deep structure of the Earth, surrounding seas play a critical role to distort the response of in-land geological structure. This study analyzed the sea effect in the Korean Peninsula and investigated the spatial and frequency dependency of it using 2-D MT modeling. Due to conductance difference between the Yellow Sea and the East Sea, the effect of each sea shows the dependence on frequency and spatial distance from each coastline. In general, TM mode responses are more severely affected by surrounding sea than TE mode one and the differences between 1-D model and TM mode responses are in inverse proportion to the frequency. Assuming that the lowest limit of acquired frequency is 0.001Hz for the given 1-D structure, the separation distance, where the sea effect can be negligible, is approximately 100km for the East Sea and 40-50km for the Yellow Sea, respectively. But, this separation distance is a function of the 1-D electrical structure of subsurface and the used frequency.

• Earthquakes and Structures
• /
• v.3 no.2
• /
• pp.169-180
• /
• 2012

The performance of pure friction isolation system with respect to the frequency bandwidth of excitation and the predominant frequency is investigated. A set of earthquake ground motions (artificial as well as recorded [with different combinations of magnitude-distance and local site geology]) is considered for investigating effectiveness of pure friction isolators. The results indicate the performance of pure friction base isolated system does not only depend upon coefficient of friction and mass ratio but the stick-slip behaviour depends upon the frequency content of the excitation as well. Slippage prevails if the excitation frequency lies in a suitable frequency range. This range widens with increasing mass ratio. For larger mass ratios, the sliding effect is more pronounced and the maximum acceleration response is further reduced in the neighbourhood of frequency ratio (${\omega}/{\omega}_n$) of unity. The pure friction isolation system is effective in the case of broadband excitations only and that too, in the acceleration sensitive range of periods. The pure friction system is not effective for protection against narrow band motions for which the system response is quasi-periodic.

• Computers and Concrete
• /
• v.17 no.2
• /
• pp.241-253
• /
• 2016

Depending on the researcher, the effect of prestressing on the natural frequency of a PSC (prestressed concrete) structure appear to have been interpreted differently. Most laboratory tests on PSC beams available showed that the natural frequency is increased appreciably by prestressing. On the other hand, some other references based on field experience argued that the dynamic response of a PSC structure does not change regardless of the prestressing applied. Therefore, the deduced conclusions are inconsistent. Because an experiment with and without prestressing is a difficult task on a full size PSC bridge, the change in natural frequency of a PSC bridge due to prestressing may not be examined through field measurements. The study examined analytically the effects of prestressing on the natural frequency of PSC bridges. A finite element program for an undamped dynamic motion of a beam-tendon system was developed with additional geometric stiffness. The analytical results confirm that a key parameter in changing the natural frequency due to prestressing is the relative ratio of prestressing to the total weight of the structure rather than the prestressing itself.

• The Journal of the Acoustical Society of Korea
• /
• v.9 no.3
• /
• pp.48-55
• /
• 1990

We analyze the effect of second-order sampling on estimating the mean frequency of the Doppler signal. In order to reduce the sampling frequency of analogue-to-digital converter, it is possible to obtain the Doppler signal by sampling the radio frequency echo signal with the low frequence of $4f_0$/5 or $4f_0$/9 instead of $4f_0$, where $f_0$ is the center frequency of the transmitted signal. The computer simulation and experiments show that if the narrowband signal is transmitted as is usual in the Doppler system, the error of the mean frequency estimates due to the low sampling frequency is negligible.

• Korean Journal of Applied Biomechanics
• /
• v.28 no.3
• /
• pp.187-191
• /
• 2018

Objective: The purpose of the present study is to investigate the effect of a muscle activity by applying the complex exercise method of sling in accordance with the provision of various vibration intensities for paraplegia-spinal cord injury. Method: The subjects of the study were 15 men in their 40s and 50s with lower limb disabilities and low potential risk, who were randomly divided into a sling exercise group (SG n=4), a sling with low frequency vibration group (SLVG n=4), a sling with mid-frequency vibration group (SMVG n=4), and a sling with high frequency group (SHVG n=4) in accordance with the provision of slings and vibration stimuli. The vibratory intensity provided was divided into low frequency (30 Hz), mid-frequency (50 Hz), and high frequency (70 Hz). The anterior deltoid (AD), the posterior deltoid (PD), the pectoralis major (PM), the upper trapezius (UT), the latissimus dorsi (LD), and the multifidus (MF) were measured to compare and analyze muscle activity. Results: The closed kinetic chain (CKC) exercise to the shoulder joint showed higher muscle activity in most muscles for the SMVG, and statistically significant differences in the anterior deltoid (AD), the pectoralis major (PM), and the multifidus (MF) in particular. Conclusion: The intermediate frequency (50 Hz) string vibration was the effective vibration stimuli for Closed kinetic chain (CKC) exercises.

• Journal of Drive and Control
• /
• v.15 no.1
• /
• pp.1-9
• /
• 2018

The spool displacement of directional control valve can be considered as the standard signal to measure the bandwidth frequency of a directional control valve. When the spool displacement is not available, the metering-orifice system is implemented in this research as an alternative way of measuring the 90 degrees phase bandwidth frequency of the hydraulic directional control valve. The inertia effect on the transmission line oil induces the phase lead of the valve load pressure when compared with the phase of spool displacement. The capacitance effect of the oil induces the phase lag of the valve load pressure. The phase of the load pressure can be adjusted to be the same as that of the spool displacement by controlling the opening area of the metering orifice. A series of experiments were conducted to verify the effectiveness of the metering orifice. The 90 degrees phase bandwidth frequency measured from the valve load pressure was significantly deviated in some cases from the frequency of the spool displacement. The metering orifice was hard to be applied to measure the -90 degrees phase bandwidth frequency of the high precision.

• Journal of Korean Physical Therapy Science
• /
• v.13 no.2
• /
• pp.27-36
• /
• 2006

The purpose of this study would like to analyze statically significant difference for low back-pain frequency of mother after development-disability children. Seven nursery children with disability conducted survey from 122 mothers cared children with disability. Survey data was obtained from April 14. 2006 to May 23. 2006. The results were as follows: According to walking-existence, assistance walking, and disability-degree, low back pain incidence frequency of mothers were statically significant difference, (p<0.05). Low back pain incidence frequency of walker-ability population was 51.4%, but low back pain incidence frequency of walker-disability population was 80.0%. then low back pain incidence frequency of mothers to walking-existence was differed amount. Disabled not statically significant difference to encephalopathy and disability-type1 and disability -type2 (p>0.05). children with disability-degree and assistance walking benchmarked low back pain disability-measure. Low back pain degree not relevancy statically significant. Physical load was statically significant difference between Oswestry's low back pain score and reach effect to child-cared(p<0.05). As development-children with disability of disable degree, Mother appeared to highly low back pain frequency rate and appeared to large reach effect child-cared owing to physical load of low back pain. So hereafter, location and person request to approach with more clinical and objectively. As approach result, it will help to stress solution of children with disability owing to develop to low back pain class and family capable strengthening program and so on.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.200-200
• /
• 2011

Although the cut-off probe, a precise measurement method for the electron density, is widely used in the industry, the physics on the wave spectrum of the cut-off is not understood yet, only cut-off point frequency containing the information of electron density has been analyzed well. This paper analyzes the microwave frequency spectrum of the cut-off probe to see the physics behind using both microwave field simulation (CST Microwave Studio) and simplified circuit simulation. The result shows that the circuit model well reproduces the cut-off wave spectrum especially in the low frequency regime where the wavelength of the driving frequency is larger than the characteristic length and reveals the physics of transmission characteristics with frequency as resonances between vacuum, plasma and sheath. Furthermore, by controlling the time domain in solver of the microwave simulator, the cut-off like transmission peaks above the cut-off frequency which has been believed as cavity effect is verified as chamber geometry effect. The result of this paper can be used as the basis for the improvement of cut-off probe.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.41 no.3
• /
• pp.207-212
• /
• 2005

Dual frequency acoustic pinger(AP) was manufactured to reduce study effect by long-term use of developed single frequency AP to prevent cetacean bycatch. Directivity characteristic of transducer was the omnidirectional pattern which showed less than ${\pm}3dB$ the change range of sensitivity on the beam pattern of right and left. Source power level(SPL) was 1384311pa with epoxy window before casing however after casing 1170B11Pa at sea. Dual frequency Af was tested to identify the avoidance behavior of bottlenose dolphin by its working. However the efficiency of dual frequency AP about the study effect was verified experiment repeatedly using single and dual frequency AP.

• Journal of the Korea Safety Management & Science
• /
• v.16 no.4
• /
• pp.305-311
• /
• 2014

Recently, though it was developed several services using the context-awareness technology of IoT, there exist also obstacles for high quality service. Specifically it is short the study for uncertainty of context-awareness. This study focused on understanding the effect of frequency interference among several environmental factors for location determination to increase precision of location determination. It was found that frequency interference between devices using 2.4Ghz frequency effect on the location determination precision. It was resulted that frequency interference increase the error of location determination precision. Then, we confirmed that it was required the suitable compensation method corresponding to frequency interference.