• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.5A
• /
• pp.401-407
• /
• 2009

The multi-band (MB) ultra-wideband (UWB) communication system divides its available frequency spectrum in 3.1 to 10.6GHz into 16 sub-bands, which leads to inherent disparities between carrier frequencies of each sub-band. For instance, the highest carrier frequency is 2.65 times higher than the lowest one. Since the propagation loss is proportional to the square of the transmission frequency, the propagation loss on the sub-band having the highest carrier frequency is approximately 7 times larger than that on the sub-band having the lowest carrier frequency, which results in disparities between received signal powers on each sub-band. In this paper, we propose a novel correlation scheme for frequency hopping (FH) MB UWB communications, where the correlation time is adaptively adjusted relative to the sub-band, which reduces the disparity between the received signal energies on each sub-band. Such compensation for lower received powers on sub-bands having higher carrier frequency leads to an improvement on the total average bit error rate (BER) of the entire FH MB UWB communication system. We analyze the performance of the proposed correlation scheme in Nakagami fading channels, and it is shown that the performance gain provided by the proposed correlator is more significant as the Nakagami fading index n increases (i.e., better channel conditions).

• Journal of electromagnetic engineering and science
• /
• v.6 no.2
• /
• pp.117-122
• /
• 2006

This paper presents the impacts of Ultra-wideband(UWB) applied in the communication applications using frequency band from 3.1 GHz to 10.6 GHz on Broadband Wireless Access(BWA) based on orthogonal frequency division multiplexing(OFDM) using frequency band of 3.5 GHz. It proposes low duty cycle(LDC) for enabling UWB to mitigate strong interference to BWA. The effects of interference mitigation are evaluated and analyzed in the environment of UWB coexistence with BWA. UWB with LDC scheme will be given to bring higher transmit power level corresponding to Federal Communications Commission(FCC) provisional limit for enabling UWB operation at 3.5 GHz bands.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.11 no.1
• /
• pp.10-15
• /
• 2012

Ultra wideband (UWB) technologies have been developed to exploit a new spectrum resource in substances and to realize ultra-high-speed communication, high precision geo-location, and other applications. The energy of UWB signal is extremely spread from near DC (Direct Current) to a few GHz. This means that the interference between conventional narrowband systems and UWB systems is inevitable. However, the interference effects had not previously been studied from UWB wireless systems to conventional wireless systems sharing the frequency bands such as broadcasting system. This paper experimentally evaluates the interference from two kinds of UWB sources, namely an orthogonal frequency division multiplex UWB source and an impulse radio UWB source, to a broadcasting transmission system. The S/N ratio degradation of broadcasting system is presented. From these experimental results, we show that in all practical cases UWB system can be coexisted 35m distance in-band broadcasting network.

• Phonetics and Speech Sciences
• /
• v.4 no.3
• /
• pp.119-125
• /
• 2012

This paper describes a new algorithm for encoding spectral shape and envelope in the generic mode of G.718 super-wide band (SWB). In the G.718 SWB coder, generic mode coding and sinusoidal enhancement are used for the quantization of modified discrete cosine transform (MDCT)-based parameters in the high frequency band. In the generic mode, the high frequency band is divided into sub-bands and for every sub-band the most similar match with the selected similarity criteria is searched from the coded and envelope normalized wideband content. In order to improve the quantization scheme in high frequency region of speech/audio signals, the modified generic mode by the improvement of the generic mode in G.718 SWB is proposed. In the proposed generic mode, perceptual vector quantization of spectral envelopes and the resolution increase for spectral copy are used. The performance of the proposed algorithm is evaluated in terms of objective quality. Experimental results show that the proposed algorithm increases the quality of sounds significantly.

• Composites Research
• /
• v.30 no.5
• /
• pp.267-272
• /
• 2017

In this study, SiC powder was added to twill woven carbon fiber reinforced plastic (CFRP) composites to improve its mechanical properties. An acoustic emission (AE) frequency analysis method was suggested for the prediction of failure behaviors. Tensile tests were conducted and the fracture characteristics of each component of the SiC reinforced composite were evaluated using AE. The results showed that SiC powder improved the strength of twill woven CFRP composites and the fracture behavior of the SiC reinforced CFRP composite and its crack extension could be effectively evaluated on the basis of the specific AE frequency bands which are 100 to 228 kHz and 428 to 536 kHz upon the resin failure and 232 to 424 kHz due to addition of SiC powder and 576 to 864 kHz at the fiber breakage.

• ETRI Journal
• /
• v.30 no.5
• /
• pp.735-737
• /
• 2008

We propose a novel spatial multi-band-stop filter using modified multiple loop array elements to block electromagnetic waves or signals of mobile phones in public facilities. It operates at the following frequency bands: Korean cellular (824 MHz to 894 MHz), Personal Communication Service (PCS) (1.75 GHz to 1.87 GHz), and IMT-2000 (1.92 GHz to 2.17 GHz). Two frequency selective surfaces with modified multiple-loop elements are printed on the top and bottom of a pair-glass pane, which is a pair of glass panes with an air gap between them. A modified multiple-loop element with a meander line is used to make the size of the filter compact. The simulated and measured results show good agreement, which confirms the usefulness of the proposed tri-band spatial filter.

• Proceedings of the KIEE Conference
• /
• 1998.07f
• /
• pp.2106-2107
• /
• 1998

This paper analyzes the sources of EMI noise, and Presents the noise reduction method using the modulation of switching frequency. Modulating the switching frequency makes the noise of side bands by shattering emission spectrum, and then can reduce the size of EMI filter at input line of power supply.

• Proceedings of the Korea Contents Association Conference
• /
• 2009.05a
• /
• pp.648-651
• /
• 2009

Using a mode-matching technique, a waveguide structure with multiple stubs which is utilized as the component of various communication systems has frequency filtering characteristics. We define a proper fitness function to automatically design the pass and stop bands of a waveguide structure with multiple stubs for frequency filtering and the genetic algorithm can be implemented with the fitness function proposed in this paper. The frequency filtering characteristics are numerically computed and parametric sweeps are also performed.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.7
• /
• pp.111-120
• /
• 1996

In this paper, we proposed an inductance loaded small type open-loop travelling wave antenna model for the suitable VHF/UHF frequency bands moisture measurement systems and analyzed its operating characteristics by galerkin's solution method. This antenna model enables to change the oeprating rsonance frequency from the frequency range 150 Mhz to 1.0 Ghz without changing the antenna design dimensions by only varing the load inductance values and it showed the similar operating charcteristics and narrowband resonance characteristics at each resonance frequencies. Also this model showed the uniformly distriubte dpower radiation characteristics above the loop axis and it can effectively suppress the spurious radiations from its narrowband resonance characteristics.

• Proceedings of the KIEE Conference
• /
• 2002.07a
• /
• pp.560-562
• /
• 2002

This paper describes measurement and diagnosis methods for electromagnetic wave using a VHF(Very High Frequency) antenna. In the laboratory partial discharges are generated on a needle-plate and a plate-plate configuration. The detected electromagnetic wave is analyzed by FFT(Fast Fourier Transform). We propose a methode to classify creeping partial discharge and corona partial discharge that are detected in three frequency bands.