• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.37 no.1
• /
• pp.19-28
• /
• 2017

In this paper, detailed safety inspection reports on the 915 expressway bridges which had been published from 1996 to 2010 are collected and condition of these bridges are analyzed. Damages are categorized into 'damage by defect', 'damage by physical force', and 'damage by deterioration' and the concept of damage possession rate is introduced to investigate the occurrence time and the characteristics of damages. Based on the top 10 damage patterns of expressway bridges and the deterioration characteristics of heavy snow and freezing cold area, reasonable improvement direction of inspection activity is suggested. From this study, it is known that improvement of inspection regularization during construction or at completion stage of bridges is needed. Since the deterioration progress of the heavy snow and freezing cold area is faster than that of general area, environmental characteristics should be considered in inspection activity. The results of present study can be widely used for improvement of inspection activity of expressway bridges.

• Journal of Animal Science and Technology
• /
• v.48 no.6
• /
• pp.797-804
• /
• 2006

The present study was undertaken to investigate the post-thawed survivability of bovine embryo depending on different dose of ethylene glycol and sucrose. Ovaries were collected at local slaughterhouse and the cumulus-oocyte-complexes aspirated from ovaries were in vitro matured, fertilized and cultured at 39°C in an atmosphere of 5% CO2 incubator. For conventional slow-freezing, d 7 or 8 expanded blastocysts were collected. Embryos were equilibrated in 1.5 M and 1.8 M ethylene glycol(EG) with 0.1 M and 0.3 M sucrose in Dulbecco's phosphate-buffered saline(D-PBS) supplemented with 0.5% bovine serum albumin. Embryos were then loaded individually into 0.25ml-straw and placed directly into cooling chamber of programmable freezer precooled to 󰠏7°C, after 2 min, the straw was seeded, maintained at 󰠏7°C for 8 min, and then cooled to 󰠏35°C at 0.3°C/min, plunged and stored in liquid nitrogen for at least 3 days. For thawing, the straw containing embryos were warmed in air for 10 sec and exposed to 37°C water for 20 sec. Straws were then removed from 37°C water. Rates of blastocyst survive and hatching were evaluated at 24 to 72 h post-warming. No difference of the survivability was shown between 1.5 M and 1.8 M EG (71 and 70%, respectively). Addition of 0.1 M sucrose to 1.5 M and 1.8 M ethylene glycol in the freezing solution did not differ significantly embryo survival (74 and 77%, respectively), whereas survival rates was higher(89%) in freezing solution contained 0.3M sucrose to 1.8M EG compared with 0.3M sucrose to 1.5M EG group(71%). However, there was no difference in the overall total cell number between the two groups (122±1.8 vs 131±1.4, respectively). In conclusion, the results suggest that 0.3 M sucrose in 1.8 M EG may be optimal condition for freezing and thawing methods with in vitro produced embryos and may be applied to on-farm conditions for embryo transfer.

• Journal of Powder Materials
• /
• v.21 no.5
• /
• pp.366-370
• /
• 2014

The present study demonstrates the effect of solidification condition on the pore structure in freeze drying process using the slurries of CuO/sublimable vehicles. Camphene and Camphor-45 wt% naphthalene based slurries with 14 vol% CuO powder were frozen into a mold at $-25^{\circ}C$, followed by sublimation at room temperature. The green bodies were hydrogen-reduced and sintered at $500^{\circ}C$ for 1 h. The porous Cu specimen, frozen the CuO/camphene slurry into the heated mold of the upper part, showed large pores with unidirectional pore channels and small pores in their internal wall. Also, it was observed that the size of large pores was decreasing near the bottom part of specimen. The change of pore structure depending on the freezing condition was explained by the nucleation behavior of camphene crystals and rearrangement of solid powders during solidification. In case of porous Cu prepared from CuO/Camphor-naphthalene system, the pore structure exhibited plate shape as a replica of the original structure of crystallized vehicles with hypereutectic composition.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2002.10a
• /
• pp.829-834
• /
• 2002

Recently, research and development for a number of repairing material like an epoxy-based material and polymer-cementitious material as well as anti-washout underwater concrete have been carried out. But, the study on tile materials for the concrete structure exposed to a wetted condition is at a standstill and there are not any suitable reference data at a repairing work for the concrete structure at a splash as well as a structure under severe moisture condition. In this study, the material, called as “ceramic metal”, with an excellent mobility and plasticity as well as with a high bond strength and durability of freezing-thawing resistant properties under any environmental conditions was developed. And, the experimental evaluations for the utility wert widely performed.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.1
• /
• pp.117-124
• /
• 2003

Thermal design fur satellite propulsion system has been performed. Overall design requirements and the constitution for propulsion system is described. To meet the thermal design requirements, both a primary and a redundant heater circuit, each with two thermostats placed in series, will protect each hydrazine-wetted components, even if one heater circuit fails to operate. Heater power is turned off if any one of these thermostats is opened at its higher setpoint. Thus, even if one thermostat is failed closed, the second thermostat will turn off the heater. All such components shall be insulated with MLI. Propulsion heater sizing based on the constant worst cold case condition is conducted through thermal analysis. All heaters selected fur propulsion components operate to prevent propellant freezing satisfying the thermal requirements for the propulsion subsystem over the worst case average voltage, i.e. 25 volts.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.265-266
• /
• 2009

To know the thermal-moisture condition of the concrete is very important to expect the concrete durability such as chloride attack, carbonation, alkali-aggregate reaction, freezing damage. The purpose of this study is to establish the temperature-moisture coupled model which is based on the finite element method and measure temperature and relative humidity under the exposured condition.

• Proceedings of the KSME Conference
• /
• 2001.11b
• /
• pp.77-82
• /
• 2001

Thermal design for KOMPSAT-2 propulsion system has been performed. Overall design requirements and the constitution for propulsion system is described. To meet the thermal design requirements, both a primary and a redundant heater circuit, each with two thermostats placed in series, will protect each hydrazine-wetted components, even if one heater circuit fails to operate. Heater power is turned off if any one of these thermostats is opened at its higher setpoint. Thus, even if one thermostat is failed closed, the second thermostat will turn off the heater. All such components shall be insulated with MLI. Propulsion heater sizing based on the constant worst cold case condition is conducted through thermal analysis. All heaters selected for propulsion components operate to prevent propellant freezing satisfying the thermal requirements for the propulsion subsystem over the worst case average voltage, i.e. 25 volts.

• Journal of Korean Neurosurgical Society
• /
• v.39 no.3
• /
• pp.228-230
• /
• 2006

Hypothermia is relatively a common condition and most cases involve mild hypothermia. But severe hypothermia below $30^{\circ}C$ is medical an emergency condition. We report the case of a 41-year-old man who had been left in a manhole for more than 9 hours on a freezing cold water. He was transported to our emergency room in semicomatose state with a body temperature $26.5^{\circ}C$. The patient was warmed with active rewarming. After initial stabilization, the patient was taken for a brain computed tomography and found to have large fronto-temporo-parietal[FTP] subdural hemorrhage. The patient underwent an emergent decompressive craniectomy and hematoma evacuation. After surgery, he recovered to drowsy mentation and vital signs were stable.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.8
• /
• pp.75-84
• /
• 2013

Soil freezing is a phenomenon arising due to temperature difference between atmosphere and ground, and physical properties of soils vary upon the phase change of soil void from liquid to solid (ice). A heat-transfer mechanism for this case can be explained by the conduction in soil layers and the convection on ground surface. Accordingly, the evaluation of proper thermal properties of soils and the convective condition of ground surface is an important task for understanding freezing phenomenon. To describe convection on ground surface, simplified coefficient methods can be applied to deal with various conditions, such as atmospheric temperature, surface vegetation conditions, and soil constituents. In this study, two methods such as n-factor and convection coefficient for the convective ground surface boundary were applied within a commercial numerical program (TEMP/W) for modeling soil freezing phenomenon. Furthermore, the numerical results were compared to laboratory testing results. In the series of the comparison results, the convection coefficient is more appropriate than n-factor method to model the convective boundary condition.

• Journal of Veterinary Clinics
• /
• v.19 no.1
• /
• pp.80-85
• /
• 2002

This study was performed to investigate the freezomg condition especially focused on extender composition to achieve good post-thaw viability and motility of canine sperm. Semen were collected from 6 male dogs which had been proved to be fertile in the past and were treated for freezing. Equex-STM paste was contained in both the 1st(3%) and the 2nd(7%) diluent and the 2nd diluent was added to the 1st diluent following glycerol equilibration for an hour and a half. To investigate the effect of Equex-STM paste in the extender on post-thaw canine sperm characteristics, the post-thaw viability, motility, and HOS(Hypoosmotic swelling) values were evaluated according to the different composition of extender with or without Equex-STM paste, thawing conditions, and different thawing media added to thawed semen. 1. Canine sperm removed from seminal plasma and frozen )n Sweden extender containing Equex showed higher post-thaw viability, motility, and HOS values than those frozen in the extender containing Equex-STM paste with seminal plasma and those frozen in the extender without Equex and seminal plasma. 2. Canine sperm frozen in Sweden extender containing Equex-STM paste with 5% glycerol showed higher post-thaw viability, motility, and HOS values than those frozen with 3%, 8% glycerol or 5% DMSO. 3. The canine semen frozen in Sweden extender with 5% glycerol and Equex-STM paste showed higher viability, motility, and HOS values when thawed at $70^{\circ}C$ for 8 seconds than when thawed at $37.5^{\circ}C$ for 1 min and at $18-20^{\circ}C$ for 5 min. 4. TFC (tris -fructose-citrate) and PB S (phosphate buffered saline) medium added immediately to thawed canine semen brought better viability, motility, and HOS values for the sperm than those semen added with TGC(tris-glucose-citrate) and no medium. These results indicated that Equex-STM paste in Sweden extender for freezing the canine sperm which were removed from seminal plasma brought good post-thaw viability and motility of canine sperm. Also of the freezing conditions of canine sperm with the same extender containing Equex, the concentration of 5% glycerol, the thawing condition at $70^{\circ}C$ for 8 sec, and TFC and PBS medium added to the thawed semen brought better post-thaw viability and motility of canine sperm than the other conditions used in this study.