• 천문학회보
• /
• 제37권1호
• /
• pp.91.1-91.1
• /
• 2012

지구 자기권의 입자분포는 지구 자기권의 상태와 태양풍의 물리적 상황에 따라 다르다. 가령, 정지궤도에서 고에너지 입자의 flux가 낮아지는 것이 관측된다. 이러한 flux dropout 기간은 대부분 storm main phase에 해당된다. 반면 태양풍의 속력이 상대적으로 높은 HSS(high speed stream)기간 동안에는 대부분 정지궤도에서의 고에너지 입자 flux가 높아지며 radiation belt의 고에너지 입자들의 seed electron 역할을 할 것으로 예상하고 있다. 본 연구에서는 GOSE 11 위성의 electron flux data와 태양풍의 속도를 이용하여 HSS, quiet time, flux dropout 기간을 정의 하였다. 또한, 지구로부터 7~8Re 떨어진 night side지역을 radiation belt의 trapping boundary 바로 바깥 경계지역과 같다고 가정하였다. 그리고 각 기간 동안 이 경계지역에서 입자들의 분포와 관련된 물리적 조건을 결정하는 것을 목표로 하였다. 이는 방사선 벨트 내부에서의 역학적 진화에 영향을 미칠 수 있다. 2007년 6월부터 2010년 8월까지 이러한 경계지역에 THEMIS 위성이 위치했을 때 ESA와 SST의 omni-directional flux를 이용하여 에너지에 대한 입자플럭스 분포 함수를 산출하였다. 또한 각 기간에 평균한 분포 함수를 가장 잘 나타낼 수 있는 해석적 함수를 도출하였다. 추가로, 경계지역에서의 입자들의 pitch angle 분포 패턴도 결정 하였다. 이 결과는 방사선 벨트의 전산모사에서 실질적인 경계 조건으로 사용될 수 있다.

• 한국전산유체공학회지
• /
• 제12권2호
• /
• pp.26-31
• /
• 2007

A comparative study on the treatment of the turbulent heat flux with the elliptic blending second-moment closure for a natural convection flow is performed. Three cases of different treating the turbulent heat flux are considered. Those are the generalized gradient diffusion hypothesis (GGDH), the algebraic flux model (AFM) and the differential flux model (DFM). The constants in the models are adjusted with a primary emphasis placed on the accuracy of predicting the local Nusselt number. These models are implemented in a computer code specially designed for evaluation of turbulent models. Calculations are performed for a turbulent natural convection in the 1:5 rectangular cavity and the calculated results are compared with the available experimental data. The results show that the three models produce nearly the same accuracy of solutions. These results show that the GGDH, AFM and DFM models for treating the turbulent heat flux are sufficient for this simple shear flow where the shear production is dominant. It is observed that, in the weakly stratified region at the center zone of the cavity, the vertical velocity fluctuation is nearly zero in the GGDH solutions, which shows that the GGDH model may not be suitable for the strongly stratified flow. Thus, further study on the strongly stratified flow should be followed.

• Nuclear Engineering and Technology
• /
• 제33권4호
• /
• pp.409-422
• /
• 2001

The dynamic character of a system of the governing differential equations for the one- dimensional two-fluid model, where the momentum flux parameters are employed to consider the velocity and void fraction distribution in a flow channel, is investigated. In response to a perturbation in the form of a＇traveling wave, a linear stability analysis is peformed for the governing differential equations. The expression for the growth factor as a function of wave number and various flow parameters is analytically derived. It provides the necessary and sufficient conditions for the stability of the one-dimensional two-fluid model in terms of momentum flux parameters. It is demonstrated that the one-dimensional two-fluid model employing the physical momentum flux parameters for the whole range of dispersed flow regime, which are determined from the simplified velocity and void fraction profiles constructed from the available experimental data and $C_{o}$ correlation, is stable to the linear perturbations in all wave-lengths. As the basic form of the governing differential equations for the conventional one-dimensional two-fluid model is mathematically ill posed, it is suggested that the velocity and void distributions should be properly accounted for in the one-dimensional two-fluid model by use of momentum flux parameters.s.

• 천문학회보
• /
• 제39권1호
• /
• pp.75.2-75.2
• /
• 2014

We have developed a set of daily solar flare peak flux forecast models using the multiple linear regression (MLR), the auto regression (AR), and artificial neural network (ANN) methods. We consider input parameters as solar activity data from January 1996 to December 2013 such as sunspot area, X-ray flare peak flux, weighted total flux $T_F=1{\times}F_C+10{\times}F_M+100{\times}F_X$ of previous day, mean flare rates of a given McIntosh sunspot group (Zpc), and a Mount Wilson magnetic classification. We compute the hitting rate that is defined as the fraction of the events whose absolute differences between the observed and predicted flare fluxes in a logarithm scale are ${\leq}$ 0.5. The best three parameters related to the observed flare peak flux are as follows: weighted total flare flux of previous day (r=0.5), Mount Wilson magnetic classification (r=0.33), and McIntosh sunspot group (r=0.3). The hitting rates of flares stronger than the M5 class, which is regarded to be significant for space weather forecast, are as follows: 30% for the auto regression method and 69% for the neural network method.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2007년도 동계학술발표대회 논문집
• /
• pp.176-181
• /
• 2007

This study aims to evaluate theoretically heat transfer characteristics and heat flux performance in ondol system of dried type is composed of panel of ceramics to improve of thermal conductivity and fin to expand heat. To this end, we analyzed effect of design factors(temperature of hot water, set temperature of room and thermal conductivity of finishing materials) in ondol system of dried type by heat transfer analysis. The main results of this study are summarized as follows; The deviation of heat flux and temperature was reduced by heat expansion from fin decreasing heat loss generated in air layer. The temperature and heat flux in upper finishing materials surface linearly increased according to temperature increment of hot water, but the temperature distribution in upper surface was assessed uneven. The greater heat resistance value of upper finishing materials, the deviation of maximum temperature and minimum temperature was decreased. Also, we suggested a basic design data about ondol system of dried type through an analysis of simulation results on heat transfer characteristics and heat flux performance.

• 설비공학논문집
• /
• 제12권3호
• /
• pp.284-291
• /
• 2000

A basic pulse tube refrigerator has been constructed with extensive instrumentation to study the characteristics of the heat exchanger experimentally under the oscillating pressure and the oscillating flow. This paper describes the sequential experiments with the basic pulse tube refrigerator. The experiments were performed for various cycle frequencies under the square pressure wave forms. First, the heat flux was measured through the cycle at the both cold and warm end heat exchangers without the regenerator. In order to enhance the thermal communication capability of the heat exchanger with the gas at low operating frequencies, a unique design of the triangular shape radial fin concept was applied to the heat exchangers. For the fin heat exchanger, the measured heat flux and the calculated heat flux from the two well-known oscillating heat transfer correlations were compared and discussed. Second, the regenerator was added to the pulse tube to make a basic pulse tube refrigerator configuration. The experiment showed the great impact of the regenerator on the temperature and the heat flux profiles. At the warm-end, the cyclic averaged heat flux had its maximum value at the specific operating frequency. The paper presents the explanation of the surface heat pumping effect as well as the experimental data.

• 한국수소및신에너지학회논문집
• /
• 제25권1호
• /
• pp.59-71
• /
• 2014

An experimental study has been conducted to investigate the heat transfer characteristics of laminar syngas/air mixture with 10% hydrogen content impinging normally to a flat plate of cylinder. Effects of impinging distance, Reynolds number and equivalence ratio as major parameters on heat fluxes of stagnation point and radial direction were examined experimentally by the direct photos and data acquisitions from heat flux sensor. In this work, we could find the incurved flame behavior of line shaped inner top-flame in very closed distance between flat plate and burner exit, which has been not reported from general gas-fuels. There were 3 times of maximum and 2 times minimum heat flux of stagnation point with respect to the impinging distance for the investigation of Reynolds number and equivalence ratio effect. It was confirmed that the maximum heat flux of stagnation point in 1'st and 2'nd peaks increased with the increase of the Reynolds number due to the Nusselt number increment. There was a third maximum rise in the heat flux of stagnation point for larger separation distances and this phenomenon was different each for laminar and turbulent condition. The heat transfer characteristics between the stagnation and wall jet region in radial heat flux profiles was investigated by the averaged heat flux value. It has been observed that the values of averaged heat flux traced well with the characteristics of major parameters and the decreasing of averaged heat flux was coincided with the decreasing trend of adiabatic temperature in spite of the same flow condition, especially for impinging distance and equivalence ratio effects.

• KSBB Journal
• /
• 제14권2호
• /
• pp.230-234
• /
• 1999

한외여과공정에서 압력구배를 주기적으로 변화시켜 막 표면의 용질층을 불안정화시켜 여과 flux의 총괄적 향상을 유도한 실험을 수행하였다. 일정압력에서의 여과 flux 감소현상을 Hernia 식을 사용하여 모사하였고, 또한 압력구배의 주기적 변화를 Fourer series로 표현하여 압력구배의 변화에 따른 flux 변화를 수학적으로 모사하였고 이 결과를 실제의 실험결과와 비교하여 보았다. 수학적 모사결과 압력변화의 형태, 진폭, 주기 등의 변화에 따른 평균 flux의 변화는 미미하였다. 하지만 실제실험결과 주기적으로 압력구배를 변화시킨 경우 약 11%의 향상을 관찰할 수 있었다. 이는 압력구배가 주기적으로 변하는 과정에서의 응질층의 압축이완속도가 다른 것에 기인하는 것으로 유추된다. 주기적 압력구배변화외에 feed pump interruption을 이용하여 평균총괄 flux를 약 32%까지 향상 시켰다. 역확산에 의한 용질층의 이완에는 일정한 시간이 필요함을 찾아내었고 interruption은 용질층이 형성되기 전부터 시작하는 것이 유리하다고 판단되었다. 본 실험을 위하여 한외여과의 자동제어 시스템을 설계제작하여 다양한 압력함수를 이용할 수 있었고, 공정운영 중 압력구매와 여과 flux를 실시간 모니터링 및 제어할 수 있었다. 자동제어 시스템을 통해 압력구매를 주기적으로 변화시켜 총괄 flux의 극대화를 도모하는 기법은 기존장치를 최소로 변경시키면서 한외여과성능을 극대화시킬 수 있는 방법으로 기대된다.

• 수산해양교육연구
• /
• 제27권5호
• /
• pp.1310-1317
• /
• 2015

Two-phase flow boiling heat transfer in micro-channels was experimently investigated. The test section consisted of 15 rectangular micro-channels with a depth of 0.45mm, width of 0.20mm. The experiments were performed for heat fluxes ranging from 5.6 to 46.1kW/m2 and mass fluxes from 150 to 450kg/m2s using FC-72 as the working fluid. According to the results, at the low heat flux region, heat transfer coefficient strongly depends on the heat flux, while heat transfer coefficient at the high heat flux region was independent on the heat flux. Four correlations were used to predict the heat transfer coefficient. The measured heat transfer coefficient was compared with four correlations. It was found that Kaew-On and Wongwises's correlation well predicted the measured data, within the MAE of 40.3%.

• Biotechnology and Bioprocess Engineering:BBE
• /
• 제10권5호
• /
• pp.462-469
• /
• 2005

A top-down approach is known to be a useful and effective technique for the design and analysis of metabolic systems. In this Study, we have constructed a grouped metabolic network for Lactococcus lactis under aerobic conditions using grouped enzyme kinetics. To test the usefulness of grouping work, a non-grouped system and grouped systems were compared quantitatively with each other. Here, grouped Systems were designed as two groups according to the extent of grouping. The overall simulated flux values in grouped and non-grouped models had pretty similar distribution trends, but the details on flux ratio at the pyruvate branch point showed a little difference. This result indicates that our grouping technique can be used as a good model for complicated metabolic networks, however, for detailed analysis of metabolic network, a more robust mechanism Should be considered. In addition to the data for the pyruvate branch point analysis, Some major flux control coefficients were obtained in this research.