• Wind and Structures
• /
• v.9 no.2
• /
• pp.109-124
• /
• 2006

This paper describes the characteristics of the fluctuating lift forces when a circular cylinder vibrates in the cross-flow direction. The response characteristics on elastically supported the circular cylinder was first examined by a free-vibration test. Next, flow-induced vibrations obtained by the free-vibration test were reproduced by a forced-vibration test, and then the characteristics of the fluctuating lift forces, the work done by the fluctuating lift, the behavior of the rolling-up of the separated shear layers were investigated on the basis of the visualized flow patterns. The main findings were that (i) the fluctuating lift forces become considerably large than those of a stationary circular cylinder, (ii) negative pressure generates on the surface of the circular cylinder when the rolling-up of separated shear layer begins, (iii) the phase between the fluctuating lift force and the cylinder displacement changes abruptly as the reduced velocity $U_r$ increases, and (iv) whether the generating cross-flow vibration becomes divergent or convergent can be described based on the work done by the fluctuating lift force. Furthermore, it was found that the generation of cross-flow vibration can be perfectly suppressed when the small tripping rods are installed on the surface of the circular cylinder.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2009.09a
• /
• pp.59-64
• /
• 2009

The propeller induced forces acting on a hull are surface forces and bearing forces. The bearing forces are the forces acting directly on the propeller which are transferred to the hull through the propeller bearings. The surface forces are those which act by fluid pressure directly on the various hull surfaces. Because the surface force is main source to oscillate stern constructions and deckhouse, the estimation of surface force is very important to predict response of forced vibration of that. The estimation methods were statistical analysis method, theoretical analysis method and method through model test.

• Wind and Structures
• /
• v.32 no.4
• /
• pp.371-391
• /
• 2021

Tornadoes are the most devastating meteorological natural hazards. Many empirical and theoretical numerical models of tornado vortex have been proposed, because it is difficult to carry out direct measurements of tornado velocity components. However, most of existing numerical models fail to explain the physical structure of tornado vortices. The present paper proposes a new empirical numerical model for a tornado vortex, and its load effects on a low-rise and a tall building are calculated and compared with those for existing numerical models. The velocity components of the proposed model show clear variations with radius and height, showing good agreement with the results of field measurements, wind tunnel experiments and computational fluid dynamics. Normal stresses in the columns of a low-rise building obtained from the proposed model show intermediate values when compared with those obtained from existing numerical models. Local forces on a tall building show clear variation with height and the largest local forces show similar values to most existing numerical models. Local forces increase with increasing turbulence intensity and are found to depend mainly on reference velocity Uref and moving velocity Umov. However, they collapse to one curve for the same normalized velocity Uref / Umov. The effects of reference radius and reference height are found to be small. Resultant fluctuating force of generalized forces obtained from the modified Rankine model is considered to be larger than those obtained from the proposed model. Fluctuating force increases as the integral length scale increases for the modified Rankine model, while they remain almost constant regardless of the integral length scale for the proposed model.

• The Bulletin of The Korean Astronomical Society
• /
• v.42 no.2
• /
• pp.37.1-37.1
• /
• 2017

Since the seminal work of Perrin, physicists have understood in the context of kinetic theory how ink slowly diffuses in a glass of water. The fluctuations of the stochastic forces acting on water molecules drive the diffusion of the ink in the fluid. This is the archetype of a process described by the so-called fluctuation-dissipation theorem, which universally relates the rate of diffusion to the power spectrum of the fluctuating forces. For stars in galaxies, a similar process occurs but with two significant differences, due to the long-range nature of the gravitational interaction: (i) for the diffusion to be effective, stars need to resonate, i.e. present commensurable frequencies, otherwise they only follow the orbit imposed by their mean field; (ii) the amplitudes of the induced fluctuating forces are significantly boosted by collective effects, i.e. by the fact that, because of self-gravity, each star generates a wake in its neighbours. In the expanding universe, an overdense perturbation passing a critical threshold will collapse onto itself and, through violent relaxation and mergers, rapidly converge towards a stationary, phase-mixed and highly symmetric state, with a partially frozen orbital structure. The object is then locked in a quasi-stationary state imposed by its mean gravitational field. Of particular interests are strongly responsive colder systems which, given time and kicks, find the opportunity to significantly reshuffle their orbital structure towards more likely configurations. This presentation aims to explain this long-term reshuffling called gravity-driven secular evolution on cosmic timescales, described by extended kinetic theory. I will illustrate this with radial migration, disc thickening and the stellar cluster in the galactic centre.

• Wind and Structures
• /
• v.23 no.2
• /
• pp.143-155
• /
• 2016

The interaction between two different shaped structures is very important to be understood. Fluid-structure interactions and aerodynamics of a circular cylinder in the wake of a V-shaped cylinder are examined experimentally, including forces, shedding frequencies, lock-in process, etc., with the V-shaped cylinder width d varying from d/D = 0.6 to 2, where D is the circular cylinder diameter. While the streamwise separation between the circular cylinder and V-shaped cylinder was 10D fixed, the transverse distance T between them was varied from T/D = 0 to 1.5. While fluid force and shedding frequency of the circular cylinder were measured using a load cell installed in the circular cylinder, measurement of shedding frequency of the V-shaped cylinder was done by a hotwire. The major findings are: (i) a larger d begets a larger velocity deficit in the wake; (ii) with increase in d/D, the lock-in between the shedding from the two cylinders is centered at d/D = 1.1, occurring at $d/D{\approx}0.95-1.35$ depending on T/D; (iii) at a given T/D, when d/D is increased, the fluctuating lift grows and reaches a maximum before decaying; the d/D corresponding to the maximum fluctuating lift is dependent on T/D, and the relationship between them is linear, expressed as $d/D=1.2+{\frac{1}{e}}T/D$; that is, a larger d/D corresponds to a greater T/D for the maximum fluctuating lift.

• Wind and Structures
• /
• v.7 no.1
• /
• pp.29-40
• /
• 2004

This study has focused on aerodynamics for a wind-resistance design about the single and tandem box girder sections to realize a super-long span bridge in the near future. Three-dimensional static analysis of flows around the fundamental single and tandem box girder sections with fairing is carried out by means of the IBTD/FS finite element technique with LES turbulence model. As the results of the analysis, computations have verified aerodynamic characteristics of both sections by the histories of aerodynamic forces, the separation and reattachment flow patterns and the surface pressure distributions. The relationship between the section shapes and the aerodynamic characteristics is also investigated in both sections. And the mechanism about the generation of fluctuating aerodynamic forces is discussed.

• Journal of Korean Association for Spatial Structures
• /
• v.17 no.1
• /
• pp.77-84
• /
• 2017

Vortex-induced vibration and instability vibration of tall buildings are very important fluid-structure interaction phenomenon, and many fundamental questions concerning the influence of body movement on the unsteady aerodynamic force remain unanswered. For tall buildings, there are two experimental methods to investigate the characteristics of unsteady aerodynamic forces, one is forced vibration method and the other is free vibration method. In the present paper, a free vibration method was used to investigate the unsteady aerodynamic force on tall building whose aspect ratio is 9 under boundary layer simulating city area. Wind pressures on surfaces and tip displacements were measured simultaneously, and the characteristics of tip displacements and generalized forces were discussed. It was found that variation of across-wind displacements showed different trend between the case when wind speed increases and wind speed decreases, and the fluctuating generalize forces in across-wind direction of vibrating model are larger than that of static model near the resonant wind speed and approach to the static value. And for higher wind speed range, there were two peaks in across-wind power spectra of generalize forces of vibrating model, which means that two frequency components are predominant in unsteady aerodynamic forces.

• 한국기계연구소 소보
• /
• v.4 no.2
• /
• pp.49-63
• /
• 1982

In this paper, a classical gust problem is treated by using the numerical lifting¬-surface theory to verify the effect of gust-a sudden fluctuating fluid velocity around an object, which is normal to the main stream direction-on the hydrody¬namic forces, especially the mean thrust in upstream direction, acting on the two¬-dimensional flat plate. In this case, the mean thrust wholly resorts to the leading edge suction, and it is the same situation to the case of the heaving plate in uniform flow. The ph¬enomenon of leading edge suction is very important for the flapping propulsion of animals, typical to fish and birds, and can be related to the prediction of the hydrodynamic forces acting on marine propellers operating in gustlike wakes of ships. The results of this paper can be easily superposed to those of the reference [1J in order to solve the problem of the two-dimensional oscillacting plate in gust

• Wind and Structures
• /
• v.29 no.1
• /
• pp.1-13
• /
• 2019

A numerical investigation on forces and flow around three square cylinders in side-by-side arrangement is conducted at a Reynolds number Re = 150 with the cylinder center-to-center spacing ratio L/W = 1.1 ~ 9.0, where W is the cylinder side width. The flowat this Re is assumed to be two-dimensional, incompressible, and Newtonian. The flow simulation is conducted by using ANSYS-Fluent. The flow around the three side-by-side cylinders entails some novel flow physics, involving the interaction between the gap and free-stream side flows as well as that between the two gap flows. An increase in L/W from 1.1 to 9.0 leads to five distinct flow regimes, viz., base-bleed flow (L/W < 1.4), flip-flopping flow (1.4 < L/W < 2.1), symmetrically biased beat flow (2.1 < L/W < 2.6), non-biased beat flow (2.6 < L/W < 7.25) and weak interaction flow (7.25 < L/W < 9.0). The gap flow behaviors, time-averaged and fluctuating fluid forces, time-averaged pressure, recirculation bubble, formation length, and wake width in each flow regime are discussed in detail.

• 한국전산유체공학회:학술대회논문집
• /
• 2003.10a
• /
• pp.164-165
• /
• 2003

The problem of a bluff body oscillating in a fluid flow has been receiving a great deal of attention. When a bluff body is placed in a flow, it experiences fluctuating hydraulic forces in both transverse and stream-wise directions. It is caused by the formation of vortices behind the body, which could cause large damages of structures. It is called the flow-induced vibrations. In this article, it is investigated the effects of that side-jets and rear-jet, which is applied to control the vortex shedding. The rear-jet is available to control the flow-induced vibrations according as the body shapes and the velocity of fluid flow in which the galloping phenomena is not appeared.