• International Journal of Aeronautical and Space Sciences
• /
• v.18 no.1
• /
• pp.8-16
• /
• 2017

Most of small air vehicles with moving wing fly at low Reynolds number condition and the reduced frequency of the moving wing ranges from 0.0 to 1.0. The physical phenomena over the wing dramatically vary with the reduced frequency. This study examines experimentally the effect of the reduced frequency at low Reynolds number. The NACA0012 airfoil performs sinusoidal pitching motion with respect to the quarter chord with the four reduced frequencies of 0.1, 0.2, 0.4 and 0.76 at the Reynolds number $2.3{\times}10^4$. Smoke-wire flow visualization, unsteady surface pressure measurement, and unsteady force calculation are conducted. At the reduced frequency of 0.1 and 0.2, various boundary layer events such as reverse flow, discrete vortices, separation and reattachment change the amplitude and the rotation direction of the unsteady force hysteresis. However, the boundary layer events abruptly disappear at the reduced frequency of 0.4 and 0.76. Especially at the reduced frequency of 0.76, the local variation of the unsteady force with respect to the angle of attack completely vanishes. These results lead us to the conclusion that the unsteady aerodynamic characteristics of the reduced frequency of 0.2 and 0.4 are clearly distinguishable and the unsteady aerodynamic characteristics below the reduced frequency of 0.2 are governed by the boundary layer events.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.12
• /
• pp.1335-1341
• /
• 2011

The purpose of this research is to investigate how separated and reattached flow affects mass transfer, by comparing the local mass transfer characteristics on an inclined flat plate with those on a parallel flat plate. The local mass transfer coefficients for the flat plate were measured using the naphthalene sublimation technique; the inclined angle of the flat plate was varied from $-10^{\circ}$ to $10^{\circ}$ at $5^{\circ}$ intervals, and the free-stream velocity was varied from 2m/s to 15m/s. At positive inclined angles, the local Sherwood numbers decreased gradually because the boundary-layer thickness increased. On the other hand, for negative inclined angles, the local Sherwood numbers assumed the minimum value at the separation point of the recirculation flow and the maximum value at the reattachment point. The average Sherwood numbers for both positive and negative inclined angles were lower than those in the case of the parallel plate.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.45-49
• /
• 2006

The flow around a foil with waterjet was investigated using the two-frame PIV(CACTUS 3.1) system. After separation, unsteady recirculation & reattachment region was shown as a result at reading edge. Separation area was decreased to 1/3 more by waterjet system with coanda effect. Angle of attack and waterjet velocity was a variable in the experiment. Each parameters was controlled to $0^{\circ}{\sim}35^{\circ}$ and 0[m/s]${\sim}$9.2[m/s]. The separation of flow appearanced at first when the angle of attack is $17^{\circ}{\sim}18^{\circ}$. However, according to grew up of velocity, beginning of the separation was delayed. In this experiment, vortex and separation region was disappeared by blown when each parameters are low level, and separation controlled more certainly.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2019.05a
• /
• pp.105-105
• /
• 2019

보나 여수로와 같은 수공구조물의 주변에서 발생하는 흐름 거동은 구조물 모서리에서 발생하는 흐름분리(flow separation)와 이에 따른 전단층(shear layer)과 재순환(recirculation) 흐름 영역의 발달 그리고 분리된 흐름의 재부착(reattachment)이 특징이다. 공학적으로 난류의 해석에 있어서 이러한 흐름 거동들을 정확하게 예측하는 것은 수공구조물 설계에 있어서 중요하다. 이 연구에서는 흐름 분리와 재순환 영역의 발달 그리고 흐름 재부착을 포함하는 후방계단(backward-facing step) 흐름을 155,000의 레이놀즈수 조건에서 하이브리드 RANS/LES 모델을 적용하여 해석결과를 평가한다. 하이브리드 모델로는 벽에 인접한 격자의 해상도에 상대적으로 민감하지 않은 SST(shear-stress transport) 난류 모델을 이용하는 DES(detached-eddy simulation) 기법을 적용하였다. 계단 높이가 h인 계산영역은 흐름방향 길이가 34h, 높이는 계단 상류와 하류에서 각각 1h와 2h 그리고 폭은 $2{\pi}$이다. 계단은 상류단으로부터 10h 하류부 지점에 위치한다. 경계조건으로 상부와 하부 벽면에 대해서는 비활조건을 적용한다. 상류부 수로에서 완전 발달한 흐름을 재현하기 위해서 유입경계조건은 유입부 하류 $2{\pi}h$ 지점에서 계산된 유속과 난류량을 매핑(mapping)기법을 이용하여 반복적으로 적용한다. 총 3.1백만개와 7.3백만개의 셀로 계산영역을 구현한 두 개의 계산격자 그리고 약 3.1백만개의 셀을 이용했지만 벽면 근처에서의 격자 구성을 다른 방식으로 설정한 두 가지 격자를 이용하여 격자 해상도가 DES 수치해석 결과에 미치는 영향을 분석하였다. 수치해석결과는 본 연구에서 상류단 조건으로 적용한 매핑기법이 대상 수로에서 완전 발달한 흐름을 잘 재현함을 보여주며, 합리적인 DES 해석 결과를 얻기 위해서는 벽에 수직한 방향으로 적절한 격자의 해상도와 분포가 필요함을 보여준다.

• Wind and Structures
• /
• v.38 no.1
• /
• pp.59-74
• /
• 2024

Large Eddy Simulation (LES) is used to explore the influence of vibration frequency and amplitude on the aerodynamic performance of a rectangular cylinder with an aspect ratio of B/D=5 (B: breadth; D: depth of cylinder) at a Reynolds number of 22,000 near resonance frequency. In smooth flow conditions, the research employs a sequence of three-dimensional simulations under forced vibration with diverse frequency ratios f_e / f_o = 0.8-1.2 (f_e : oscillation frequency; f_o : Strouhal frequency when the rectangular cylinder is stationary ) and oscillation amplitudes A_h/D = 0.05 - 0.3. The individual influences of f_e / f_o and A_h/D on the characteristics of integrated and distributed aerodynamic forces are the focal points of discussion. For the integrated aerodynamic force, particular emphasis is placed on the analysis of the dependence of velocity-proportional component C₁ and displacement-proportional component C₂ of unsteady aerodynamic force on amplitude and frequency ratio. Near the resonance frequency, the dependencies of C₁ and C₂ on amplitude are stronger than that of frequency ratio. For the distributed aerodynamic force, the increase in frequency and amplitude promotes the position of the main vortex core and reattachment to the leading edge in the streamwise direction. In the spanwise direction, vibration enhances the spanwise correlation of aerodynamic force to weaken the three-dimensional effect of the flow field, and a lower frequency ratio and larger amplitude amplify this effect.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.18 no.1
• /
• pp.1-7
• /
• 2014

In this study, the effect of velocity ratio and particle size on the flow mixing characteristics in the secondary combustor was investigated. Both PIV(Particle Image Velocimetry) technique and LES(Large Eddy Simulation) were applied. Two sizes of Polystyrene PIV seeding particle of 5 and $50{\mu}m$, and three velocity ratios of 5, 3, and 1.5 were considered. Results showed that the mixing of two air streams created reattachment and recirculation regions. The size of the recirculation region was decreased as the velocity ratio increased. For the larger particle cases, due to the increased momentum by the larger particles, the size of the recirculating regions were larger than that of the smaller particle cases and the effect of the velocity ratio was not as significant as in the smaller particle case.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.37 no.1
• /
• pp.69-75
• /
• 2009

This paper studies the aerodynamic performance that the vent mixer-new conceptual supersonic mixer-showed with its geometric characteristics. The hole is 2 mm with 2 mm's distance from the wall in case 1 and with no distance in case 2. In case 3 die hole is 1 mm. Case 1 and case 2 showed the same total pressure recovery ratio, of which the case 3 was lower than that. While cases 1-3 had the same reattachment length, the shear layer was thicker in cases 1 and 2 than in case 3. Within the recirculation zone, cases 1 and 2 had lower pressure loss and higher velocity gradient difference than case 3-they enhance mixing between air and fuel. Separation bubble which is developed by the inflow into the recirculation zone has a significant effect on the total pressure recovery ratio in the combustor. Also separation bubble influences pressure distributions and recirculation flows in the recirculation zone. Therefore, inflow rate of air into the recirculation zone mainly affects the performance of vent mixer.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.11 no.3
• /
• pp.444-453
• /
• 1987

In the present study, a new computational closure model is proposed in order to contain physical models in the k- and .epsilon.- equations. The time scale of the third-order diffusive transport of turbulent kinetic energy in a curved streamline flow field is assumed as a function of a velocity time scale and a curvature time scale, the latter being derived from the analogy between buoyancy and streamline curvature effects on turbulence. The curvature time scale is represented by a combination of Brunt-Vaisala frequency of the curvature instability and the velocity time scale. Besides the modification of diffusive transport time scale, the destruction term in the dissipation rate equation is modeled to incorporate the streamline curvature effect on the dissipation rate of turbulent kinetic energy as a function of the ratio between velocity time scale and curvature time scale. The new curvature dependent 2-equation model is found to yield very good prediction accuracy for the various turbulent recirculating flows. Particurarly, the recovery of the mean velocity profile in the redeveloping region after the reattachment is correctly simulated by the present model.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.13 no.1
• /
• pp.236-245
• /
• 2021

In this study, direct numerical and large eddy simulations of transitional flows around studs were conducted to investigate the effectiveness of turbulence stimulators at very low speeds for the minimum propulsion power condition of four knots. For simplicity, the studs were assumed to be installed on a flat plate, while the wake was observed up to 0.23 m downstream behind the second stud. For applicability to a model ship, we also studied the flow characteristics behind the first and second studs installed on a curved plate, which was designed to describe the geometry of a bulbous bow. A laminar-to-turbulent transition was observed in the wake at Re_D ≥ 921 (U_∞≥0.290 m/s), and the wall shear stress at Re_D = 1162 (U_∞ = 0.366 m/s) in the second wake was similar to that of the fully developed turbulent boundary layer after a laminar-to-turbulent transition in the first wake. At Re_D = 581 (U_∞ = 0.183 m/s), no turbulence was stimulated in the wake behind the first and second studs on the flat plate, while a cluster of vortical structures was observed in the first wake over the curved plate. However, a cluster of vortical structures was revealed to be generated by the reattachment process of the separated shear layer, which was disturbed by the first stud rather than directly initiated by the first stud. It was quite different from a typical process of transition, which was observed at relatively high Re_D that the spanwise scope of the turbulent vortical structures expanded gradually as it went downstream.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.6
• /
• pp.729-736
• /
• 2016

It is necessary to recycle and reuse waste paper for preservation of the global environment. Instead of a solid deinking agent, liquid deinking agents have been made using various fatty acids with EO/PO added for higher deinking effect. The removal efficiency of ink on waste paper was evaluated by the ERIC and brightness properties after processes of recycling pulping (sample composition ONP: OMG = 5:5, concentration 15%, temperature $45^{\circ}C$, pulping time 20 min.) and flotation (concentration 1%, temperature $45^{\circ}C$, air flow 7 L/min, time 8 min.). Also, the ink reattachment of paper was evaluated by hyperwashing. The results show that it is effective for mass-preparation to saponify oleic acid with KOH at $80^{\circ}C$ and to add EO/PO. This deinking agent was used in a paper plant, and we evaluated the brightness, color, and ERIC. The deinking agent showed excellent performance.