• Journal of the Korean earth science society
• /
• v.37 no.2
• /
• pp.89-106
• /
• 2016

The Gochang open-coast intertidal flat is located in the southwestern coast of Korea (the eastern part of the Yellow Sea), characterized by macro-tidal range, an open-coast type, and sand substrates. This study has investigated seasonal variation in sedimentary facies of surface sediments in the Gochang intertidal flat. In the four seasons of February, May, August, and November, 2014, surface sediments of 252 sites in total were sampled and analyzed along three survey lines. The surface sediments of the Gochang intertidal flat in 2014 consisted mainly of fine-grained sand sediments showing a trend in grain size to be coarser in winter and finer in summer. Based on seasonal wave and tidal level data recorded near the study area, it was interpreted that the seasonal effects of wave were stronger than those of tide as a factor controlling surface sedimentation. High waves in winter resulted in the coarsening trend of grain size in surface sediments, whereas, during summer time, the sediments became finer by relatively low waves. Spatial sedimentary facies of the Gochang intertidal flat in 2014 represented that seasonal deviation of the upper tidal zone was larger than that of the lower tidal zone, hence sediments getting coarser in grain size and poorly sorted in the upper tidal zone. From upper to lower tidal zone, the grain size became finer and sediments were better-sorted, showing smaller seasonal deviations.

• The Korean Journal of Malacology
• /
• v.28 no.3
• /
• pp.225-232
• /
• 2012

In order to evaluate the relationship of between the contents of inorganic elements in shellfish and surface sediments, we measured the concentration of inorganic elements (As, Ca, Cd, Cr, Fe, Hg, Li, Mn, Ni, P, Pb, Zn) in various shellfish and surface sediments of research area. The enrichment factor (EF) and the index of accumulation rate (Igeo) of the metals showed that the research areas can be classified as moderately polluted, or unpolluted. And also we measured the geochemical characteristics of surface sediments(grain size, chemical oxygen demand (COD), ignition loss (IL) and acid volatile sulfide (AVS). The grain sizes for research areas of surface sediment were similar the ratio of silt and clay in comparison with other sites. The COD and IL in surface sediment ranged from 5.41 to 14.06 mg/g. d.w. (mean $8.78{\pm}3.16$ mg/g d.w.) and from 0.92 to 3.17% (mean $2.08{\pm}0.86%$), respectively. Siginificant differences in metal concentrations also were determinated in the shellfish tissue among the different sites. However, except for metals(Mn, Zn), which showed some elevation of concentrations, the variations in the shellfish tissue were not related to variations in the sediment.

• Journal of Wetlands Research
• /
• v.6 no.1
• /
• pp.117-132
• /
• 2004

Despite its significance in understanding ecological structure and biogeochemical element cycles, there have been few studies on the microbial mineralization of organic matter and mineralization pathway in the intertidal flat of Korea. We measured anaerobic mineralization of organic matter and sulfate reduction rate, and evaluated the significance of sulfate reduction in total anaerobic carbon respiration at the southern part of Ganghwa Island. Depth-integrated carbon mineralization rate down to 6 cm depth ranged from 41.9 to $89.4mmol\;m^{-2}d^{-1}$, which accounted for approximately 216 tons of organic matter mineralization in entire intertidal flat area of Ganghwa($300km^2$). The results indicated that capacity for the organic matter mineralization in the Ganghwa tidal flat is comparable to highly productive salt marsh environments. Mineralization rates in the sediment amended with acetate were 2~5 times higher than in unamended sediment. The results implied that microbial mineralization was limited by the availability of organic substrates, and the organic matter mineralization capacity seems to be higher than estimated at ambient organic substrate level. Depth-integrated sulfate reduction rates within 6 cm depth of the sediment ranged from 20.7 to $45.1mmol\;SO{_4}^{2-}m^{-2}d^{-1}$, and sulfate reduction was mostly responsible for organic matter remineralization. It should be noticed that the increase of $H_2S$ in the sulfate reduction dominated tidal flat may result in the decrease of biological diversity.

• Journal of the Korean Electrochemical Society
• /
• v.7 no.2
• /
• pp.94-99
• /
• 2004

Anode-supported flat tubular solid oxide fuel cell (SOFC) was investigated to increase the cell power density. The anode-supported flat tube was fabricated by extrusion process. The porosity and pore size of Ni/YSZ ($8mol\%$ yttria-stabilized zirconia) cermet anode were $50.6\%\;and\;0.23{\mu}m$, respectively. The Ni particles in the anode were distributed uniformly and connected well to each other particles in the cermet anode. YSZ electrolyte layer and multilayered cathode composed of $LSM(La_{0.85}Sr_{0.15})_{0.9}MnO_3)/YSZ$ composite, LSM, and $LSCF(La_{0.6}Sr_{0.4}Co_{0.2}Fe_{0.7}O_3)$ were coated onto the anode substrate by slurry dip coating, subsequently. The anode-supported flat tubular cell showed a performance of $300mW/cm^2 (0.6V,\; 500 mA/cm^2)\;at\;500^{\circ}C$. The electrochemical characteristics of the flat tubular cell were examined by ac impedance method and the humidified fuel enhanced the cell performance. Areal specific resistance of the LSM-coated SUS430 by slurry dipping process as metallic interconnect was $148m{\Omega}cm^2\;at\;750^{\circ}C$ and then decreased to $148m{\Omega}cm^2$ after 450hr. On the other hand, the LSM-coated Fecralloy by slurry dipping process showed a high area specific resistance.

• Current Research on Agriculture and Life Sciences
• /
• v.15
• /
• pp.33-38
• /
• 1997

This investigation was attemped to know fruit quality of apple 'Fuji' grown at three different areas of Taegu. Fruits were gathered from hill side area : Kyungsangpookdo yongchongun chongtongmynn synwonri, flat area : Kyungsangpookdo yongchongun synyoungmyun youujeongri and river side area : Kyungsangpookdo yongchongun kewmhoyeub naenhchundong. Results were as follows: 1. In fruit sampling, we made an effort to select the same size of fruit from all areas, However, the size at river side area was about 40g lighter and minimum length was shorter than those of the other areas. On the other hand, maximum and minimum diameter of the fruit at flat and river side areas were longer than hill side area. Accordingly, shape index of the fruit in river side area was flatter than the other areas. This difference may be due to temperture, soil moisture content, etc. In squeeze rate of the fruit, no significant difference was recognized among areas. 2. Though, rate of fructose in total sugar was almost 50% in all areas, sucrose, fructose and sorbitol concentration of hill side area were higher than the other areas. however glucose was reverse amd brix was almost same as total sugar concentration. 3. Rate of malic acid in total acid was almost 98% and citric acid was only 2% in all areas. Malic acid concentration of hill side area was higher than the other areas and titratable acid concentration was almost same as total acid.

• Ocean and Polar Research
• /
• v.23 no.2
• /
• pp.109-119
• /
• 2001

Meiobenthic community structure of tidal flats near the Yeonggwang Nuclear Power Plant have studied during summer (June) and fall (October) 1997. Examination of sediment samples collected along the transects showed that there were 18 different types of meiobenthos in the study area. The most abundant meiobenthic animals belonged to Phylum Nematoda in both seasons and all transects. However, sediment samples collected near discharge areas, transects A and B, showed relatively lower abundance than other general coastal areas. Another abundant meiobenthic organism is benthic Harpacticoids which is very sensitive to any environmental changes. Polycheats and Ostracods were next abundant meiobenthos which also showed the difference between the study area and other general coastal areas. Only transect C maintained similar meiobenthic abundance and diversity to other coastal areas. Horizontal distribution for transects A and B showed higher densities in upper and mid tidal flat zones. On the other hand, transect C which is located furtherest from the discharges showed an increasing trend in abundance from upper to lower areas. For size distribution analyses showed that animals which fit into the meshsize of 0.125 mm were abundant, Vertical distribution of meiobenthic animals within the sediments for both sampling seasons showed the highest individual numbers in the surface sediment layers of 0-1 cm depth and showed a decreasing trend as sediment gets deeper. Each class of meiobenthos had different vertical profiles. When comparing survey transects A and B with other similar tidal flat areas, this sites seems to a very unstable environment of tidal flats near the Yeonggwang Nuclear Power Plant.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.6 no.1
• /
• pp.27-34
• /
• 2001

To investigate the processes governing the distribution of elements in the tidal flat, thirty-eight sediment samples collected from the Saemangeum tidal flat of the Korean west coast were analyzed for their contents of major (Al, Fe, Mg, Ca, Na, K, Ti) and trace (P, Mn, Ba, Sr, V, Cr, Co, Cu, Ni, Zn, Pb) elements. Most elements showed generally lower contents compared to data published for other tidal flats of Korea, and the effect of anthropogenic input could not be recognized in the sediments. The relative abundance and distribution of most of the elements varied significantly with the grain size of sediments. High contents of Al, Fe, Mg, Ti, P, Mn, V, Co, Cr, Cu, Ni and Zn were found in the finer sediments in the upper tidal flat of the study area, suggesting that tidal sedimentation processes play an important role in controlling the distribution of these elements. However, sediment grain size does not impose any significant effect on the abundance and distribution of Ca, Na, K, Ba, Sr and Pb. It appears that the clastic mineralogy in the coarse-grained fractions is the dominant factor determining the distribution of these elements in the study area.

• Membrane Journal
• /
• v.34 no.1
• /
• pp.79-86
• /
• 2024

The flat sheet membrane, one of the representative forms of polymeric membranes, is widely used from material research in laboratories to commercial membrane production due to its ease of fabrication. Porous polymeric flat sheet membranes used in microfiltration and ultrafiltration are mainly fabricated through phase separation processes, utilizing non-solvent-induced and vapor-induced phase separation methods. However, due to the nature of phase separation processes, variations between samples can easily occur depending on the surrounding environment and the experimenter, making it difficult to ensure reproducibility. Therefore, for scaling up and ensuring reproducibility of developed membrane fabrication technologies, there is a need for a controlled environment continuous large-area production device, such as a roll-to-roll manufacturing system. This research compared the changes in membrane characteristics due to differences in manufacturing environments when scaling up laboratory-scale fabrication technologies to roll-to-roll processes using knife and slot die coaters. By optimizing the continuous manufacturing process factors, uniformity of the membrane was ensured during large-area production.

• Journal of the Korean earth science society
• /
• v.28 no.1
• /
• pp.64-74
• /
• 2007

The marine seismic prospecting using a research vessel in the shallow sea near the coastal area has certain limits according to the water depth and survey environment. Also, for the electrical resistivity survey at seashore area, one may need a specially designed high-voltage source to penetrate the very conductive surface layer. Therefore, we have conducted a feasibility study on the application of magnetotelluric method (MT), a passive geophysical method, on investigating of shallow marine environment geology. Our study involves both theoretical modeling and field survey at the tidal flat area which represent the very shallow marine environment. We have applied the audio-frequency magnetotelluric (AMT) method to the intertidal deposits of Gunhung Bay, west coast of Korea, and analysed the field data both qualitatively and quantitatively to investigate the morphology and sedimentary stratigraphy of the tidal flat. The inversion of AMT data well reveals the upper sedimentary layer of Holocene intertidal sediments having a range of 13-20 m thickness and the erosional patterns at the unconformable contact boundary. However, the AMT inversion results tend to overestimate the depth of basement (30-50 m) when compared with the seismic section (27-33 m). Since MT responses are not significantly sensitive to the resistivity of middle layer or the depth of basement, the AMT inversion result for basement may have to be adjusted using the comparison with other geophysical information like seismic section or logging data if possible. But, the AMT method can be an effective alternative choice for investigating the seashore area to get important basic informations such as the depositional environment of the tidal flat, sea-water intrusion and the basement structure near the sea shore.

• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1544-1546
• /
• 1999

The fabrication process for ceramic fuel cell with a large electrode area was investigated. A cofired cell of two layer, electrolyte/anode, yielded a power of $200mW/cm^2$. Its performance loss was mainly due to iR drop in the anode side. The performance of the cofired of three layer. cathode/electrolyte/ anode, was much lower than that of two layer, which resulted from the large iR drop and overvoltage at the cathode side. Also a flat cell with a large area of $7.7{\times}10.8cm^2$ was fabricated successfully and tested using ceramic and metallic interconnectors. The large cell with metallic interconnectror showed a good performance of 0.6 V, 4.5 A.