• Electrical & Electronic Materials
• /
• v.8 no.1
• /
• pp.21-26
• /
• 1995

Highly sensitive and mechanically stable gas sensors have been fabricated using the microfabrication and micromaching techniques. The sensing material used to detect the offensive trimethylarnine ((CH$_{3}$)$_{3}$N) gas is 6 wt% $Al_{2}$O$_{3}$-doped, 1000.angs.-thick ZnO deposited by r. f. magnetron sputtering. The optimum operating temperature of the sensor is 350.deg.C and the corresponding heater power is about 85mW. Excellent thermal insulation is achieved by the use of a double-layer structure of 0.2.mu.m -thick silicon nitride and 1.4.mu.m-thick phosphosilicate glass(PSG) prepared by low pressure chemical vapor deposition(LPCVD) and atmospheric pressure chemical vapor deposition(APCVD), respectively. The sensors are mechanically stable enough to endure at least 43, 200 heat cycles between room temperature and 350.deg. C.

• Proceedings of the KIEE Conference
• /
• 1990.07a
• /
• pp.43-46
• /
• 1990

A general scheme for a discrete adaptive observer having exponetial weighting properties is presented for a single-input single-output linear system. In this scheme, all the past measurement data are weighted esponetially both with the weighting factor and the stable matrix F. This observer is then implemented in the design of an indirect adaptive pole placement contoller. To increase nemerical stability in getting the controller parameter, a recusive algorithm is introduced. It is shown that the overall control scheme is globally stable with the persistent excition

• Korean Journal of Materials Research
• /
• v.11 no.4
• /
• pp.294-299
• /
• 2001

Effects of the surface fluorination on the electrochemical charge-discharge properties of $Mg_2$Ni electrode in Ni-MH batteries fabricated by mechanical alloying were investigated. After 20h ball milling, Mg and Ni powder formed nanocrystalline $Mg_2$Ni. Discharge capacity of this alloy increased greatly at first one cycle, but due to the formation of Mg(OH)$_2$ passive layer, it showed a rapid degradation in alkaline solution within 10cyc1es. In case of 6N KOH +xN KF electrolyte (x = 0.5, 1, 2), a continuous and stable fluorinated layer formed by adding excess F$^{[-10]}$ ion, increased durability of $Mg_2$Ni electrode greatly and high rate discharge capability(90-100mAh/g). 2N KF addition led to the highest durability of all tested here. The reason of the improvement is due to thin MgF$_2$, which can prevent the $Mg_2$Ni electrode from forming Mg(OH)$_2$layer that is the main cause of degradation.

• Korean Journal of Animal Reproduction
• /
• v.20 no.4
• /
• pp.453-458
• /
• 1997

It is known that the incorporation of genes into transgenic mice is generally stable and is p passed on to succeeding generations in a Mendelian fashion. In this report, transgenic mice were set as a model to evaluate whether the transgenes are transmitted in a Mendelian principle in a successive generations and how they are tran s smitted into their offspring. A 3.0 kb linear DNA fragment, containing the MMTV LTR, bovine aSI casein cDNA and SV 40 splicing and polyadenylation site; was microinjected into fertilized mouse embryos. The tail DNAs of the resulting pups were subjected to dot and Southern hybridizations to screen transgenic founders. The DNAs of their offspring were anlyzed by PCR to confirm the transmission of the transgene from F0. Out of 72 live pups four pups (5.6%), 3 males and 1 female, were positive for the transgene. The rates of transmission from F0 into F1 were 33.3, 7.7, 0, and 62.5%. Those from F1 into F2 were 63.6, 5.9, and 68.8% and those from F2 into F3 were 85.7, and 88.2%. In this report, the transmission pattern of transgenes in transgenic mice into their offspring was demonstrated. It either follows or does not follow in a Mendelian fashion. Deletion or loss of the transgenes from F0 in some lines became apparant to the succeeding generations.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.40 no.2
• /
• pp.205-213
• /
• 2011

The Folin-Ciocalteu (F-C) reagent has been extensively used for quantifying total phenolic contents in many different types of food materials. Since several different procedures of the assay methods using the F-C reagent have been applied, we investigated changes in reactivity of various phenolic compounds with the F-C reagent under three different assay conditions and factors affecting reactivity. Among 10 standard compounds tested, compounds with high hydroxyl density (number of -OH/molecular weight) showed a largely different response according to addition sequence of the F-C reagent or $Na_2CO_3$. Preincubation in $Na_2CO_3$ significantly reduced the reactivity of the phenolic compounds bearing galloyl moiety (e.g. gallic acid, tannic acid, and epigallocatechin-3-gallate) with the F-C reagent, while monophenol compounds including ferulic acid and sinapinic acid were more stable as compared to diphenols. There was little change in response to the F-C reagent of all phenolic compounds incubated in acidic pH; their reactivity except ferulic acid was reduced significantly when incubated in neutral or alkaline pH. Changes in reactivity of gallic acid incubated in $Na_2CO_3$ or neutral/alkaline pH conditions were the most prominent. $H_2O_2$ generated from phenolic compounds did not affect the reaction with the F-C reagents. The present results suggest that reactivity of different phenolic compounds with F-C reagent was affected considerably by different procedures of the assay, and the total phenolic contents could be fluctuated according to standard compounds and assay scheme.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.8
• /
• pp.1505-1509
• /
• 2008

Comparative molecular simulations were performed to establish molecular interaction and inhibitory effect of flavonoid myricetin on formation of amyloid fibris. For computational comparison, the conformational stability of myricetin with amyloid $\beta$ -peptide (A$\beta$ ) and $\beta$ -amyloid fibrils (fA$\beta$) were traced with multiple molecular dynamics simulations (MD) using the CHARMM program from Monte Carlo docked structures. Simulations showed that the inhibition by myricetin involves binding of the flavonoid to fA$\beta$ rather than A$\beta$ . Even in MD simulations over 5 ns at 300 K, myricetin/fA$\beta$ complex remained stable in compact conformation for multiple trajectories. In contrast, myricetin/A$\beta$ complex mostly turned into the dissociated conformation during the MD simulations at 300 K. These multiple MD simulations provide a theoretical basis for the higher inhibitory effect of myricetin on fibrillogenesis of fA$\beta$ relative to A$\beta$ . Significant binding between myricetin and fA$\beta$ observed from the computational simulations clearly reflects the previous experimental results in which only fA$\beta$ had bound to the myricetin molecules.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.8 no.2
• /
• pp.10-17
• /
• 2004

The results of the combustion performance tests of gas generator which supplies hot gas into the turbine of turbo-pump for liquid rocket engine and uses LOx and kerosene as propellant are described. The gas generator consists of a injector head with F-O-F impinging injector, a water cooled combustion chamber, a gas torch igniter, a turbulence ring and an instrument ring. The effect of turbulence ring and combustion chamber length on performance of gas generator are investigated. The ignition and combustion at design point are stable and the pressure and gas temperature at gas generator exit meets the target. The turbulence ring installed at middle of chamber effectively mixes hot gas with cold gas and the effect of residence time of hot gas in gas generator on combustion efficiency is small. Test results show that the main parameter controlling the gas temperature at gas generator exit is overall O/F ratio.

• Korean Journal of Materials Research
• /
• v.25 no.12
• /
• pp.694-702
• /
• 2015

Nd-Fe-B permanent magnets have been used in a wide variety of applications because of their high magnetic flux density. So, demand for neodymium has been increasing in worldwide. In this study, an electrowinning process was performed in $LiF-NdF_3-Nd_2O_3$ high temperature molten salts. However, a corrosion resistant material for use in the molten salt must be found for stable operation because of the harsh corrosion environment of the electrowinning process. Therefore, for this paper, boron nitride(BN), aluminum nitride(AlN), and silicon nitride($Si_3N_4$) were selected as protective and structural materials in the high temperature electrolyte. To investigate the characteristics of BN, AlN, and $Si_3N_4$, in molten salts, materials were immersed in the molten salts for 24, 72, 120, and 192 hours. Also, surface condition and stability were investigated by SEM and EDS and corrosion products were calculated by HSC chemistry. As a result, among BN, AlN, and $Si_3N_4$, AlN was found to show the best protective material properties.

• Polymer(Korea)
• /
• v.26 no.2
• /
• pp.179-184
• /
• 2002

Polymer electrolyte films consisting of poly (vinylidenefluoride-hexafluoro-propylene) (PVdF-HFP) $H_3PO_4$and a mixture of ethylene carbonate(EC), $\gamma$-butyrolactone(BL) and dimethylcarbonate (DMC) were examined in order to obtain the best compromise between high protonic conductivity, homogeniety and dimensional stability. Measurements of differential scanning calorimetry and ionic conductivity have been carried out for various compositions. The highest proton conductivity of 7.3 $\times$$10^{-3}Sm^{-1}$ at $30^{\circ}C$ were obtained for a film of 30(PVdF-HFP) + 50EC/DMC + 20H$_3$PO$_4$. From the thermal study, it has been found that the PVdF-HFP gels are stable up to $80^{\circ}C$, and the $H_3PO_4$ enhances the miscibility of the polymer and the solvent by interacting sensitively with polymer segments.

• Journal of the Korean Society of Groundwater Environment
• /
• v.6 no.3
• /
• pp.107-110
• /
• 1999

18 boreholes with nitrate contaminated were selected. Samples were collected 4 times between both 1995 and 1996. Stable nitrogen isotope ratio for them all was measured and the contribution to contamination from several sources like fertilizer, sewage, cropland. and landfill was analysed. Nitrogen source for 11 sampling sites of T-3, L-1. O-1∼O-4, F-2∼F-5, and G-2 considered to come from chemical fertilizer and its contribution was around 60% or more. T-4. T-5 were located downward the downtown, which were influenced bydomestic sewage and its contribution were 70.7% and 54.7%. Nitrate concentration of G-2 was 17.7 mg/L, among which 60.7% was estimated to come from landfill leachate. T-1 and T-2 were located in the small village, in which 42.2 and 43.4% of nitrogen was to come from domestic sewage but 52.8% and 56.0% were from fertilizer sprayed in the cropland. L-2 was near livestock by which it was estimated to be influenced, in which 59.9% of nitrogen was from cropland. F-1 was in the cropland, by which 50.0% was influenced and 49.5% was estimated from organic matter of animals.