• Journal of the Korean Ceramic Society
• /
• v.34 no.3
• /
• pp.289-295
• /
• 1997

Effect of ceramic processing was investigated on the microstructure and electronic properties of low loss Mn-Zn ferrite. Addition of CaO and SiO2 to calcined powder rather than to raw materials mixtured resulted in finer-grained microstructure. Higher oxygen pressure during sintering caused microstructural inhomogeneity and the increase in power loss and disaccommodation factor. Relatively low power loss was found for sintering up to 130$0^{\circ}C$ from powders calcined at high temperature and milled shortly. It was caused by slow densification rate and normal grain growth up to 130$0^{\circ}C$. Calcination at low temperature and prolonged milling enhanced den-sification, which gave a fine grained microstructure and low powder loss at sintering temperture below 120$0^{\circ}C$. Sintering temperature above 125$0^{\circ}C$, however, showed abnormal grain growth.

• Journal of Korean Society for Atmospheric Environment
• /
• v.28 no.4
• /
• pp.374-383
• /
• 2012

In this study, we have observed the airborne radon levels in the subway cabins before and after platform screen doors (PSD) installation. The measurements have been conducted at Seoul metropolitan subway lines in 2008, 2009 and 2010. The mean concentration of the radon inside subway cabins were increased by approximately 53% from $20.1Bq/m^3$ to $30.8Bq/m^3$ by installing PSD. After PSD installation, measured values for the different lines were rather different, and varied between 8.2 and $76.5Bq/m^3$. And mean radon concentrations were in the decreasing order for subway lines 5, 6, 7, 8, 3, 4, 2, 9 and 1. It was also found that the indoor radon concentrations in the subway cabins were highly dependent on the management approach of a ventilation system at the subway stations. By assuming an average of $720\;h\;year^{-1}$ and $2,880\;h\;year^{-1}$ spent in subway cabin, effective doses to passengers and employee were estimated. The expected annual effective dose, in case of an equilibrium factor of 0.4, were $0.07mSv\;y^{-1}$ and $0.26mSv\;y^{-1}$, respectively.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.36 no.4
• /
• pp.659-665
• /
• 2016

The limit equilibrium method (LEM) is commonly used for slope design and stability analysis because it is easy to simulate slope and requires short calculating time. However, LEM cannot adequately simulate ploughing failure in a footwall slope with a joint set dipping parallel with slope, e.g. bedding joint set. This study performed parametric study to analyze the influence factors on ploughing failure using UDEC which is a commercial two-dimensional DEM (Distinct Element Method)-based numerical program. The influence of joint structure and properties on stability of a footwall slope against ploughing failure was investigated, and the factor of safety was estimated using the shear strength reduction method. It was found that the stability of footwall slope against ploughing failure strongly relies on dip angle of conjugate joint, and the critical bedding joint spacing and the critical length of slab triggering ploughing failure are also affected by dip angle of conjugate joint. The results obtained from this study can be used for effective slope design and construction including reinforcement.

• Steel and Composite Structures
• /
• v.28 no.5
• /
• pp.589-606
• /
• 2018

The previous studies reflected the significant effect of neutral-axis position and coupling of in-plane and out-of-plane displacements on behavior of functionally graded (FG) nanobeams. In thin FG beam, this coupling can be eliminated by a proper choice of the reference axis. In shear deformable FG nanobeam, not only this coupling can't be eliminated but also the position of neutral-axis is dependent on through-thickness distribution of shear strain. For the first time, in this paper it is avoided to guess a shear strain shape function and the exact shape function and consequently the exact position of neutral axis for arbitrary gradation of higher order nanobeam are obtained. This paper presents new methodology based on differential transform and collocation methods to solve coupled partial differential equations of motion without any simplifications. Using exact position of neutral axis and higher order beam kinematics as well as satisfying equilibrium equations and traction-free conditions without shear correction factor requirement yields to better results in comparison to the previously published results in literature. The classical rule of mixture and Mori-Tanaka homogenization scheme are considered. The Eringen's nonlocal continuum theory is applied to capture the small scale effects. For the first time, the dependency of exact position of neutral axis on length to thickness ratio is investigated. The effects of small scale, length to thickness ratio, Poisson's ratio, inhomogeneity of materials and various end conditions on vibration and buckling of local and nonlocal FG beams are investigated. Moreover, the effect of axial load on natural frequencies of the first modes is examined. After degeneration of the governing equations, the exact new formulas for homogeneous nanobeams are computed.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.48 no.7
• /
• pp.55-63
• /
• 2006

Bacterial transport models were evaluated in this study to determine the suitable model at describing bacterial transport in saturated column experiments. Four models used in the evaluation were: advective-dispersive equation (ADE) + equilibrium sorption/retardation (ER) + kinetic reversible sorption (KR) (Model I), ADE + two-site sorption (Model 2), ADE + ER + kinetic irreversible sorption (KI) (Model 3), ADE + KR + KI (Model 4). Firstly, analyses were performed with the first experimental data, showing that Model 4 is appropriate for describing bacterial transport. Even if Model 1 and 2 fit well to the observed data, they have a defect of not including the irreversible sorption, which is directly related to mass loss of bacteria. Model 3 can not properly describe the tailing observed in the data. However, further analysis with the second data indicates that Model 4 can not describe retardation of bacteria, even if the sorption-related parameters are varied. Therefore, Model 4 is modified by incorporating retardation factor into the model, resulting in the improved fitting to the data. It indicates that the transport model, into which retardation, kinetic reversible sorption, and kinetic irreversible sorption are incorporated, is suitable at describing bacterial transport in saturated column experiments. It is expected that the selected transport model could be applied to properly analyze the bacterial transport in saturated porous media.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.1
• /
• pp.181-187
• /
• 2011

This paper deals with the job creation effect of economic growth by focusing on the types of technological progress. The hypothesis is that labor-saving technological change may create less job than capital-saving or factor-neutral ones. The hypothesis is proved theoretically using an equilibrium model of labor market. Empirically, first, a simulation experiment is performed to check the hypothesis empirically and confirms it. Secondly, we look at labor/capital ratio since it may be affected by the type of technological improvement. One important policy implication is that job creation effect of economic growth depends on the structure of labor supply as well as that of labor demand.

• Environmental Analysis Health and Toxicology
• /
• v.24 no.2
• /
• pp.137-148
• /
• 2009

This study quantitatively investigated the emissions of indoor air pollutants associated with the utilization of air fresheners indoors, and evaluated individual exposure to five specified indoor air pollutants, which were chosen on the basis of selection criteria. An electrically-polished stainless steel chamber (50L) was employed to achieve this purpose. Test air fresheners were selected through three steps: first, on the basis of market sales; second, on the basis on a preliminary head-space study; and lastly, on the basis of emissions of toxic compounds (benzene, ethyl benzene, limonene, toluene, and xylene). The empirical mathematical model fitted well with the time-series concentrations in the environmental chamber (in most cases, determination coefficient, $R^2{\gtrsim}$0.9), thereby suggesting that the empirical model was suitable for testing emissions. The concentration equilibrium appeared 180 min after the introduction of sample air fresheners into the chamber. Both the chamber concentrations of emission rates or factors varied greatly according to air freshener type. It is noteworthy that although benzene, ethyl benzene, toluene, and xylene were emitted from all test air fresheners, their exposure levels were not significant enough to result in any significant health risk. However, certain type of air fresheners were observed to emit significant amount of limonene, which is potentially reactive with ozone to generate secondary pollutants with oxidants such as ozone, hydroxyl radicals, and nitrogen oxides. The exposure levels to limonene associated with the utilization of three air fresheners were estimated to be 13 to 175 times higher than that of other air fresheners. This information can help consumers to select low-pollutant-emitting air fresheners.

• Korean Journal of Applied Biomechanics
• /
• v.30 no.1
• /
• pp.121-129
• /
• 2020

Objective: This study was conducted with the aim of verifying the effectiveness of the duocock exercise, which is being utilized at the newly developed site to promote balance maintenance, basic physical strength and muscle strength among various age groups, in order to prevent fall and successfully age. Method: In this study, we conducted the duocock Exercise Program for 12 weeks (twice a week for an hour) for 10 senior citizens aged 65 or older (68.8±4.76 yrs, height: 15±6.00 cm) using Western-based health institutions in Daejeon, and compared the pre- and post- effects on basic physical strength and posture balance. All the data obtained from this study were used in statistical program SPSS 24 to perform paired t-test. The significance level for all statistical analyses was set at the level of p<0.05. Results: The 12 week duocock program showed statistically significant improvements in lower extremity muscle strength, equilibrium, agility, balance, and coordination in the basic fitness factors underlying successful aging (p<0.05). In addition, the trunk imbalance, which acts as a factor of falls and body balance, was statistically significant (p<0.05) and the posture balance of the sagittal plane also showed the effect of proper body adjustment. Conclusion: Based on the results of this study, duocock provides a new exercise program in the form of a sustainable sport as a two-handed exercise, and is very effective for the elderly to improve their basic physical strength as well as to control postural imbalances, strengthen and increase muscle strength.

• Journal of Hydrogen and New Energy
• /
• v.18 no.4
• /
• pp.391-398
• /
• 2007

The covalently cross-linked sulfonated polyetheretherketone (CL-SPEEK) membrane was prepared by four-step synthesis of sulfonation-sulfochlorination, partial reduction, lithiation, and cross-linking, and its electrochemical and mechanical properties were investigated for water electrolysis application. The prepared ion exchange membranes showed good electrochemical and mechanical properties; proton conductivity of 0.116 S/cm at $80^{\circ}C$, water uptake of 44.6%, ion exchange capacity of 1.75 meq/g-dry-memb., tensile strength of 64.25 MPa and elongation of 61.11%. The membrane electrode assembly (MEA) with homemade membranes were prepared by non-equilibrium impregnation-reduction (I-R) method. Especially, the electrochemical surface area (ESA) and roughness factor of CL-SPEEK electrolyte by cyclic voltammetry method were 23.46 $m^2/g$ and 307.3 $cm^2-Pt/cm^2$, respectively. The prepared MEA was used in the unit cell of water electrolysis and the cell voltage was 1.81 V at 1 A/$cm^2$ and $80^{\circ}C$, with platinum loadings of 1.31 mg/$cm^2$.

• Korean Chemical Engineering Research
• /
• v.53 no.1
• /
• pp.64-70
• /
• 2015

Batch experiment studies were carried out for adsorption of congo red using granular activated carbon with various parameters such as activated carbon dose, pH, initial dye concentration, temperature and contact time. Equilibrium experimental data are fitted to the Langmuir, Freundlich, Temkin and Dubin-Radushkevich isotherm equations. From Freundlich's separation factor (1/n) estimated, adsorption could be employed as effective treatment method for adsorption of congo red from aqueous solution. Base on Temkin constant (B) and Dubinin-Radushkevich constant (E), this adsorption process is physical adsorption. Adsorption kinetics has been tested using pseudo-first order and pseudo second order models. The results followed pseudo second order model with good correlation. Adsorption process of congo red on granular activated carbon was endothermic (${\Delta}H$=42.036 kJ/mol) and was accompanied by decrease in Gibbs free energy (${\Delta}G$=-2.414 to -4.596 kJ/mol) with increasing adsorption temperature.