• Particle and aerosol research
• /
• v.16 no.2
• /
• pp.31-47
• /
• 2020

Although interest in air quality has increased due to the frequent occurrence of high-concentration fine particulate matter recently, the official fine particulate matter measuring network has failed to provide spatial detailed air quality information. This is because current measurement equipment has a high cost of installation and maintenance, which limits the composition of the measuring network at high resolution. To compensate for the limitations of the current official measuring network, this study constructed a spatial high density measuring network using the fine particulate matter simple measuring device developed by Observer, W-Station. W-Station installed 48 units on Jeju Island and measured PM_2.5 for six months. The data collected in W-Station were corrected by applying the first regression equation for each section, and these measurements were compared and analyzed based on the official measurements installed in Jeju Island. As a result, the time series of PM_2.5 concentrations measured in W-Station showed concentration characteristics similar to those of the environmental pollution measuring network. In particular, the results of comparing the measurements of W-Station within a 2 km radius of the reference station and the reference station showed that the coefficient of determination (R²) was 0.79, 0.81, 0.67, respectively. In addition, for W-Station within a 1 km radius, the coefficient of determination was 0.85, 0.82, 0.68, respectively, showing slightly higher correlation. In addition, the local concentration deviation of some regions could be confirmed through 48 high density measuring networks. These results show that if a network of measurements is constructed with adequate spatial distribution using a number of simple meters with a certain degree of proven performance, the measurements are effective in monitoring local air quality and can be fully utilized to supplement or replace formal measurements.

• Journal of Navigation and Port Research
• /
• v.41 no.6
• /
• pp.395-400
• /
• 2017

As a serial communications protocol, Modbus has become a practically standard communication protocol and is now a commonly available means of connecting industrial electronic devices. Therefore, all devices can be connected using the Modbus protocol with the measurement and remote control on ships, buildings, trains, airplanes and more. The existing Modbus that has been used is based on serial communication. Modbus TCP uses Ethernet communication based on TCP / IP which is the most widely used Internet protocol today; so, it is faster than serial communication and can be connected to the Internet of Things. In this paper, we designed an algorithm to control LED lighting in a wireless Wi-Fi environment using the Modbus TCP communication protocol, and designed and implemented a LED controller circuit that can check external environmental factors and control remotely through the integrated management system of a ship. Temperature, humidity, current and illuminance values, which are external environmental factors, are received by the controller through the sensors, and these values are communicated to the ship's integrated management system via the Modbus protocol. The Modbus can be connected to Master devices via TCP communication to monitor temperature, humidity, current, illuminance status and LED output values, and also users can change the RGB value remotely in order to change to the desired color. In addition, in order to confirm the implementation of the controller, we developed a simulated ship management system to monitor the temperature, humidity, current and illumination conditions, and change the LED color of the controller by changing the RGB value remotely.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.463-466
• /
• 2010

In this paper, CCTV based fire surveillance system should aim to development. Advantages and Disadvantages analyzed of Existing sensor-based fire surveillance system and video-based fire surveillance system. To national support U-City, U-Home, U-Campus, etc, spread the ubiquitous environment appropriate to fire surveillance system model and a fire judgement technology. For this study, Microsoft LifeCam VX-1000 using through the capturing images and analyzed for apple and tomato, Finally we used H.264. The client uses the Linux OS with ARM9 S3C2440 board was manufactured, the client's role is passed to the server to processed capturing image. Client and the server is basically a 1:1 video communications. So to multiple receive to video multicast support will be a specification. Is fire surveillance system designed for multiple video communication. Video data from the RGB format to YUV format and transfer and fire detection for Y value. Y value is know movement data. The red color of the fire is determined to detect and calculate the value of Y at the fire continues to detect the movement of flame.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.11
• /
• pp.2603-2608
• /
• 2015

Mushroom is a high in protein, low calorie food and has dietary fiber, vitamins, iron and minerals such as zinc. It is called that mushroom is one of the biggest concerns for healthy foods. When we make the artificial cultivation of mushroom, one of the greatest influence element is temperature. In this regard, farmers passively measure temperatures in the greenhouse as inaccurate way such as by the naked eyes. In this paper, we constructed a display system in order to improve the efficiency of manual management of temperature based on the influence of temperature on the mushroom. In related to the methods of mushroom cultivation, the recent technology apply the new technology such as sensors and IT convergence services. And then cultivating mushroom is managed effectively. In this paper, we implement an automatic display system for sensing data. By using this function, farmers could effectively manage environment needed to be grown mushroom, and anticipate the improvement of sales by increasing quality of mushrooms as well.

• Journal of radiological science and technology
• /
• v.28 no.3
• /
• pp.193-201
• /
• 2005

We are living in Ubiquitous society now. There is also trend of integration in medical field that is largely affected by outside environment. At this time, it is necessary to rightly understand the abstract, function, expected effect and management method of Integration Medical Information System(IMIS) to use this system effectively for solving many hospital information system problems and disadvantages. It is fact that large-sized hospitals are improving the quality of service for treatment of patients through building integrated Medical Information System. So it is necessary to change this individual system that is previously developed and used for treatment assistance, hospital affair or general management respectively to integrated management system, modify patient information or treatment information data to the data suitable for new system and build the integrated medical information system suitable for the hospital service with treatment data and integrated medical information. This paper suggested and designed abstract of integrated medical information system, the organization of system, the character of system and the plan and materialization of IMIS when building integrated medical information system. And the context of this paper is suggested trend of industry and solution of integration EMR, HIS, PACS. Therefore this paper is suggested development strategy, implemented integration medical information system.

• Korean Journal of Optics and Photonics
• /
• v.2 no.3
• /
• pp.139-148
• /
• 1991

A fiber-optic magnetic sensor system for the detection of small ac magnetic field(200Hz-2 kHz) was constructed. Magnetic field sensing part was fabricated by bonding a section of optical fiber to amorphous metallic glass(2605SC) having large magnetostriction effect. And with the directional coupler, all fiber type Mach-Zehnder interferometer was constructed to measure the variation of the external magnetic field by translating it into the optical phase shift in the interferometer. The signal fading problem of the interferometer, which is due to random phase drifts originated from the environment, i.e., temperature fluctuation, vibrations, etc., was elliminated by feedback phase compensation. This allows the sensitivity to be maintained at the maximum by keeping the interferometer in quadrature phase condition. The frequency response of metallic glass was found to be nearly flat in the range of 90 Hz-2 kHz and dc bias field for the maximum ac response was 3.5 Oe. The interferometer output showed good linearity over the range $\pm$0.5 Oe. For 1 kHz ac magnetic field the scale factor S and the minimum detectable magnetic field were measured to be 8.0 rad/Oe and $3X10^{-6} Oe/\sqrt{Hz}$at 1 Hz detection bandwidth respectively.

• Journal of KIISE:Databases
• /
• v.33 no.1
• /
• pp.138-149
• /
• 2006

As the environment with sensor network and ubiquitous computing is emerged, there are many demands of handling continuous, fast data such as streaming data. As work about streaming data has begun, work about management of streaming data in Publish-Subscribe system is started. The recent emergence of XML as a standard for information exchange on Internet has led to more interest in Publish - Subscribe system. A filtering technique of streaming XML data in the existing Publish- Subscribe system is using some schemes based on automata and YFilter, which is one of filtering techniques, is very popular. YFilter exploits commonality among path queries by sharing the common prefixes of the paths so that they are processed at most one and that is using the top-down approach. However, because partial matching path queries interrupt the common prefix sharing and don't calculate from root, throughput of YFilter decreases. So we use sharing of commonality among path queries with the common postfixes of the paths and use the bottom-up approach instead of the top-down approach. This filtering technique is called as PoSFilter. And we verify this technique through comparing with YFilter about throughput.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.9
• /
• pp.1703-1710
• /
• 2008

As the performance of digital camera keeps going on, the digital camera becomes into wide use recently so that the number of digital images taken by digital camera is increased rapidly. Given the augmentation of digital images, the digital photo frame has appeared for storing and enjoying the digital image and receives attention as the price of digital frame becomes down. However, users with the existing digital frame only could display the digital images and stream media stored in local disk. In the paper, we design and implement a new digital photo frame baled on ubiquitous which could provide a more variety of service to the user. With the proposed digital photo frame, the user could obtain the environment information and the digital image from multimedia sensor network. The users also could enjoy the various stream media stored in the remote streaming server seamlessly. In addition, the user could update the digital image through the web site at anywhere.

• Korean Journal of Remote Sensing
• /
• v.21 no.4
• /
• pp.341-369
• /
• 2005

Hyperspectral images have emerged as a new and promising remote sensing data that can overcome the limitations of existing optical image data. This study was designed to provide a comprehensive review on definition, data processing methods, and applications of hyperspectral data. Various types of airborne, spaceborne, and field hyperspectral image sensors were surveyed from the available literatures and internet search. To understand the current status of hyperspectral remote sensing technology and research development, we collected several hundreds research papers from international journals (IEEE Transactions on Geoscience and Remote Sensing, International Journal of Remote Sensing, Remote Sensing of Environment and AVIRIS Workshop Proceedings), and categorized them by sensor types, data processing techniques, and applications. Although several hyperspectral sensors have been developing, AVIRIS has been a primary data source that the most hyperspectral remote sensing researches were relied on. Since hyperspectral data have very large data volume with many spectral bands, several data processing techniques that are particularly oriented to hyperspectral data have been developed. Although atmospheric correction, spectral mixture analysis, and spectral feature extraction are among those processing techniques, they are still in experimental stage and need further refinement until the fully operational adaptation. Geology and mineral exploration were major application in early stage of hyperspectral sensing because of the distinct spectral features of rock and minerals that could be easily observed with hyperspectral data. The applications of hyperspectral sensing have been expanding to vegetation, water resources, and military areas where the multispectral sensing was not very effective to extract necessary information.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.1-1
• /
• 2016

Many of the world's large ecosystems are severely stressed due to population growth, water quality and quantity problems, vulnerability to flood and drought, and the loss of native species and cultural resources. Consequences of climate change further increase uncertainties about the future. These major societal challenges must be addressed through innovations in governance, policy, and ways of implementing management strategies. Science and engineering play a critical role in helping define possible alternative futures that could be achieved and the possible consequences to economic development, quality of life, and sustainability of ecosystem services. Science has advanced rapidly during the past decade with the emergence of science communities coalescing around 'Grand Challenges' and the maturation of how these communities function has resulted in large interdisciplinary research networks. An example is the River Experiment Center of KICT that engages researchers from throughout Korea and the world. This trend has been complemented by major advances in sensor technologies and data synthesis to accelerate knowledge discovery. These factors combine to allow scientific debate to occur in a more open and transparent manner. The availability of information and improved communication of scientific and engineering issues is raising the level of dialogue at the science-policy interface. However, severe challenges persist since scientific discovery does not occur on the same timeframe as management actions, policy decisions or at the pace sometimes expected by elected officials. Common challenges include the need to make decisions in the face of considerable uncertainty, ensuring research results are actionable and preventing science being used by special interests to delay or obsfucate decisions. These challenges are explored in the context of examples from the United States, including the California Bay-Delta system. California transfers water from the wetter northern part of the state to the drier southern part of the state through the Central Valley Project since 1940 and this was supplemented by the State Water Project in 1973. The scale of these activities is remarkable: approximately two thirds of the population of Californians rely on water from the Delta, these waters also irrigate up to 45% of the fruits & vegetables produced in the US, and about 80% of California's commercial fishery species live in or migrate through the Bay-Delta. This Delta region is a global hotspot for biodiversity that provides habitat for over 700 species, but is also a hotspot for the loss of biodiversity with more than 25 species currently listed by the Endangered Species Act. Understanding the decline of the fragile ecosystem of the Bay-Delta system and the potential consequences to economic growth if water transfers are reduced for the environment, the California State Legislature passed landmark legislation in 2009 (CA Water Code SS 85054) that established "Coequal goals of providing a more reliable water supply for California and protecting, restoring, and enhancing the Delta ecosystem". The legislation also stated that "The coequal goals shall be achieved in a manner that protects and enhances the unique cultural, recreational, natural resource, and agricultural values of the Delta as an evolving place." The challenges of integrating policy, management and scientific research will be described through this and other international examples.