• 한국수소및신에너지학회논문집
• /
• 제22권6호
• /
• pp.787-793
• /
• 2011

A 76.5wt%Mg - 23.5wt%Ni (Mg-23.5Ni) sample was prepared by reactive mechanical grinding (RMG) and its hydriding and dehydriding properties were then investigated. Activation of the Mg-23.5Ni sample was completed only after two hydriding (under 12 bar $H_2$) - dehydriding (under 1.0 bar $H_2$) cycles at 593K. The reactive mechanical grinding of Mg with Ni is considered to facilitate nucleation and shorten diffusion distances of hydrogen atoms. After hydriding - dehydriding cycling, the Mg-23.5Ni sample contained Mg2Ni phase.

• 한국표면공학회지
• /
• 제50권2호
• /
• pp.119-124
• /
• 2017

Due to the high saturation magnetization (~2.4 T), $Fe_{16}N_2$ is interesting for the thin film application such as an actuator, data record storage and sensor etc. In this study, Fe-N thin films were deposited on Si(001) substrate with various power and deposition time by DC magnetron sputtering, in order to get high portion of $Fe_{16}N_2$ phase. Surface morphology, phase formation and magnetic properties were measured. As a result, Saturation magnetization and Remanence magnetization reach to ~2.45 T and 1.41T. But, Coercivity was not enough in this experiments. Its value lower than 100 Oe. Which is very close to theoretical value.

• Nuclear Engineering and Technology
• /
• 제54권2호
• /
• pp.429-436
• /
• 2022

Investigations of retrospective dosimetry have shown that components of mobile phones are suitable as emergency dosimeters in case of radiological incidents. For physical dosimetry, components can be read out using optically stimulated luminescence (OSL), thermoluminescence (TL) and phototransferred thermoluminescence (PTTL) methods to determine the absorbed dose. This paper deals with a feasibility study of display glass from modern mobile phones that are measured by thermally assisted (Ta) optically stimulated luminescence. Violet (VSL, 405 nm) and infrared (IRSL, 850 nm) LEDs were used for optical stimulation and two protocols (Ta-VSL and Ta-IRSL) were tested. The aim was to systematically investigate the luminescence properties, compare the results to blue stimulated Ta-BSL protocol (458 nm) and to develop a robust measurement protocol for the usage as an emergency dosimeter after an incident with ionizing radiation. First, the native signals were measured to calculate the zero dose signal. Next, the reproducibility and dose response of the luminescence signals were analyzed. Finally, the signal stability was tested after the storage of irradiated samples at room temperature. In general, the developed Ta-IRSL and Ta-VSL protocols indicate usability, however, further research is needed to test the potential of a new protocol for physical retrospective dosimetry.

• 한국수소및신에너지학회논문집
• /
• 제13권4호
• /
• pp.270-278
• /
• 2002

Mg and Mg alloys are attractive hydrogen storage materials because of their lightweight and high absorption capacity. Their range of applications could be further extended if their hydrogenation properties and degradation behavior could be improved, The main emphasis of this study was to find an economic manufacturing method for Mg-Ti-Ni-H systems, and to investigate their hydrogenation properties, In order to examine hydrogenation behavior, a Sieverts type automatic pressure-composition-isotherm(PCI) apparatus was used and the experiments were performed at 423, 473, 523, 573, 623 and 673K. The results of thermogravimetric analysis(TGA) reveal that the absorbed hydrogen contents are around 2.5 wt% for ($Mg_9Ti_1$)-10 wt% Ni. With increased Ni content, the absorbed hydrogen content decreases to 1.7 wt%, whereas the dehydriding starting temperatures are lowered by some 70-100K. The results of PCI on ($Mg_9Ti_1$)-20 wt% Ni show that its hydrogen capacity is around 5.3 wt% and its reversible capacity and plateau pressure are also excellent at 523K and 573K. In addition, the reaction enthalpy, $\Delta$HD.plateau, is $30.6{\pm}5.7kJ/molH_2$.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제43회 하계 정기 학술대회 초록집
• /
• pp.220-220
• /
• 2012

The supercapacitors with extraordinarily high capability for energy storage are attracting growing attention for their potential applications in portable electronic equipments, hybrid vehicles, cellular devices, and so on. The nanostructuring of the electrode surface can provide large surface area and consequently easy diffusion of ions in the capacitors. In addition, compared to two-dimensional nanostructures, the three-dimensional (3D) nano-architecture is expected to lead to significant enhancement of mechanical and electrical properties such as capacitance per unit area of the electrode. Polyaniline (PANi) is known as promising electrode material for supercapacitors due to its desirable properties such as high electro activity, high doping level and environmental stability. In this context, we fabricated well-ordered 3D PANi nanostructures on 3D polystyrene (PS) nanospheres which was arrayed by layer-by-layer stacking method. The height of the PANi nanostructures could be controlled by the number of PS layers stacked. 3D PANi hollow nanospheres were also fabricated by dissolving inner PS nanospheres, which resulted in further enhancement of the surface area and capacitance of the electrode.

• 한국가구학회지
• /
• 제10권1호
• /
• pp.57-63
• /
• 1999

This study was carried out to analyze the relationship between basic physical properties and acoustical characteristics of imported violin wood and to offer the information on raw material procurement and incoming-material quality control to domestic violin makers which have purchased most raw materials from European exporting countries at high expense. Equilibrium moisture content of European spruce with lower specific gravity after the prolonged storage was rather higher than that of European maple with higher specific gravity. The specific gravity of spruce increased with decreasing annual ring width, however, that of narrower annual ring. Increasement in specific gravity enhanced the dynamic Young's modulus of both wood species, but influenced the vibration energy loss by internal friction differently between two species. For dynamic MOE, qurater-sawn spruce was higher than the flat-sawn, but maple showed the reverse directional characteristics. Consequently, it would be well for violin makers to establish the standard for materials and quality control system to assure the quality of their violin products.

• Carbon letters
• /
• 제12권4호
• /
• pp.252-255
• /
• 2011

Carbon-based electric double-layer capacitors are being evaluated as potential energy-storage devices in an expanding number of applications. In this study, samples of carbon black (CB) treated at different temperatures ranging from $650^{\circ}C$ to $1100^{\circ}C$ were used as electrodes to improve the efficiency of a capacitor. The surface properties of the heat-treated CB samples were characterized by X-ray photoelectron spectroscopy and X-ray diffraction. The effect of the heat-treatment temperature on the electrochemical behaviors was investigated by cyclic voltammetry and in galvanostatic charge-discharge experiments. The experimental results showed that the crystallinity of the CBs increased as the heat-treatment temperature increased. In addition, the specific capacitance of the CBs was found to increase with the increase in the heat-treatment temperature. The maximum specific capacitance was 165 $F{\cdot}g-1$ for the CB sample treated at $1000^{\circ}C$.

• 대한전기학회논문지
• /
• 제37권11호
• /
• pp.762-771
• /
• 1988

This paper presents the experimental study to confirm the basic properties extract the operating problems of SMES. A new fast control system including u-computer and 12pulse power converter are designed and fabricated. The experiment of 25KJ SMES discharge and charge is carried out by I-C (Inductor-Converter) unit using a new proposed control system. The proposed control algorithm is proved by the simulations and control properties tests. It is also confirmed experimetally that SMES connected I-C unit controlled by this control scheme has an effects on compansating freguency fluctuation by independent active power control.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.181.1-181.1
• /
• 2014

Supercapacitor is attracting growing attention for a promising energy conversion and storage device because of its desirable electrochemical properties such as rapid charge-discharge rate, high power density and long cycle life. Three-dimensional (3D) metal nanostructure has been widely studied since it can provide efficient charge transport along the 3D network in many device applications. In this work, we fabricated well-ordered 3D nickel (Ni) nanostructures using 3D-arrayed polystyrene nano-opal substrates. We also fabricated half-cell supercapacitors by electrodepositing $RuO_2$ onto these nanostructured Ni current collectors and investigated their morphological and electrochemical properties.

• Bulletin of the Korean Chemical Society
• /
• 제35권2호
• /
• pp.401-406
• /
• 2014

Metal-containing carbon nanocomposites have shown significance promise in the area of energy storage, heterogeneous catalysis and material science because of their morphology and combined properties. Phosphorus-doped carbon nanocomposites with gold nanoparticles were developed by applying a simple impregnation method and metal deposition technique. Gold-phosphorus supported carbon nanocomposites with two sized (25 and 170 nm) were prepared from economical petroleum pitch residue as the carbon source using an advanced silica template method. These nanocomposites will lead to the novel applications in the field of material science with the combined properties of gold, phosphorus and carbon. The newly prepared gold phosphorus supported carbon nanocomposites were fully characterized using a range of different physico-chemical techniques.