• Structural Engineering and Mechanics
• /
• v.33 no.3
• /
• pp.325-337
• /
• 2009

Structural damage detection, damage localization and severity estimation of jacket platforms, based on calculating modal strain energy is presented in this paper. In the structure, damage often causes a loss of stiffness in some elements, so modal parameters; mode shapes and natural frequencies, in the damaged structure are different from the undamaged state. Geometrical location of damage is detected by computing modal strain energy change ratio (MSECR) for each structural element, which elements with higher MSECR are suspected to be damaged. For each suspected damaged element, by computing cross-modal strain energy (CMSE), damage severity as the stiffness reduction factor -that represented the ratios between the element stiffness changes to the undamaged element stiffness- is estimated. Numerical studies are demonstrated for a three dimensional, single bay, four stories frame of the existing jacket platform, based on the synthetic data that generated from finite element model. It is observed that this method can be used for damage detection of this kind of structures.

• The Journal of the Acoustical Society of Korea
• /
• v.31 no.7
• /
• pp.419-426
• /
• 2012

The pitch searching is a vital process in a vocoder. Generally, the method of pitch searching is employed after highlighting the periodicity, where a correlation is identified with the signal by changing the interval of two pulses. When the correlation value reaches the peak, the pitch can be found by the pulse interval because it is the repetition interval with most striking period. However if the identified period happens to be one of half period, double period or triple period, this cannot be considered as the pitch period. Many methods were suggested to solve this problem. An inaccurate pitch could be obtained as well, when there is an interval where signal amplitude is not constant but varies abruptly in the frame. To solve this matter, searching the pitch by dividing a frame into various subframes is adopted, but too much calculation has to be followed while it leads the correct value. This paper suggests an algorithm to resolve these two problems. First, to search the pitch after advance correction of the signal energy level with an estimated overall energy change ratio in the frame before pitch search to reduce half period, double period and triple period is suggested. Second, to vary the number of subframes by predicting the amplitude change rate in the frame by the energy ratio obtained by the above-mentioned method is advised. If these two methods are applied, the pitch searching time can be reduced and the general pitch searching performance can be improved without affecting the sound quality in the synthesized signal.

• Korean Journal of Community Nutrition
• /
• v.10 no.5
• /
• pp.592-602
• /
• 2005

This study was conducted to compare nutrient intakes regarding stages of change in dietary fiber increasing behavior. Subjects were consisted of healthy 383 college students (2S0 females and 133 males) in Kyunggi-Do. Stages of change classified by an algorithm based on 6 items were designed each subjects into one of the 5 stages: precontemplation (PC), contemplation (CO), preparation (PR), action (AC), maintenance (MA). Nutrient intakes were assessed by 24-hr recall method. Regarding the S stages of changes, PR stage comprised the largest group $(39.4\%)$, followed by AC $(33.7\%)$, MA$(14.6\%)$, PC$(7.6\%)$, CO$(34.7\%)$. Female were more belong to either AC or MA. The higher stage of change in dietary fiber increasing behavior, the higher self-efficacy. In all male and female, there were no differences in energy, protein, monounsaturated fatty acids, polyunsaturated fatty acids and cholesterol intakes across the 5 stages. But, fiber, postassuim (K), vitamin A and vitamin C intakes of AC or MA were higer than those of PC, CO and PR $Energy\%$ from fat of $PR(25.4\~26.5\%)$ was higher than $20\%$, and those of AC and MA was lower than the other groups. Dietary P/S and ${\varepsilon}6/{\varepsilon}$ 3 ratios of AC and MA were similar to the recommended ratio. Female of PR had the most total saturated fat and palmitic acid and those of MA had the least. Male of PR had the least $\alpha-LNA\;({\varepsilon}3)$ and total ${\varepsilon}3$ fatty acids and those of MA had the most. In male and female in AC or MA, fiber and K intakes from breakfast, dinner and snack and vitamin C intakes from all meals were higher than those of the other stages. These results of our study confirm differences in stages of change in fiber intake in terms of nutritional status. To have lower $energy\%$ from fat, higher intakes of K, fiber and vitamins, desirable ratio of dietary fatty acids, it needs consistent nutritional education leading to the AC or MA of fiber increasing behavior.

• Korean Journal of Community Nutrition
• /
• v.18 no.4
• /
• pp.333-343
• /
• 2013

It is important to prepare and execute the menu plan for proper and balanced intake of nutrients in the adolescence. This study investigated the new approach for planning menu by ordinary meal pattern based on cooked foods groups. The amounts of cooked foods in the menu plan assumed to be single serving size. The middle school second graders participated for the study. A total of 313 questionnaires were analyzed using CAN-pro 3.0 and SPSS WIN 12.0 program. The average content of energy in the menu plan was 2,453 kcal, the average ratios of energy contribution by carbohydrate, protein and fat were 54.3%, 17.9%, 27.8%, respectively. A total of 56.9% menu plans (94.9% of male and 8.7% of female students') were below the lowest limit of optimum carbohydrate energy ratio of 55%. A total of 29.1% menu plans (33.1% of male and 23.9% of female students') were exceed the highest limit of optimum fat energy ratio of 30%. The NAR of minerals and vitamins were all 1.0 except for calcium (0.92) and folate (0.88). When INQ of the individual cooked food groups were calculated, kimch was the highest in all minerals and vitamins examined, suggesting that kimch may be the best source for all minerals and vitamins, including calcium and folate with the minimum change in energy content. In conclusion, the menu plan by ordinary meal pattern in this study was low in carbohydrate, high in fat, and contained enough minerals and vitamins except for calcium and folate for middle school students.

• Journal of the Korean Solar Energy Society
• /
• v.33 no.2
• /
• pp.11-17
• /
• 2013

Silicon nitride($SiN_x:H$) deposited by radio frequency plasma enhanced chemical vapor deposition(RF-PECVD) is commonly used for anti-reflection coating and passivation in crystalline silicon solar cell fabrication. In this paper, characteristics of the deposited silicon nitride was studied with change of working pressure, deposition temperature, gas ratio of $NH_3$ and $SiH_4$, and RF power during deposition. The deposition rate, refractive index and effective lifetime were analyzed. The (100) p-type silicon wafers with one-side polished, $660-690{\mu}m$, and resistivity $1-10{\Omega}{\cdot}cm$ were used. As a result, when the working pressure increased, the deposition rate of SiNx was increased while the effective life time for the $SiN_x$-deposited wafer was decreased. The result regarding deposition temperature, gas ratio and RF power changes would be explained in detail below. In this paper, the optimized condition in silicon nitride deposition for silicon solar cell was obtained as 1.0 Torr for the working pressure, $400^{\circ}C$ for deposition temperature, 500 W for RF power and 0.88 for $NH_3/SiH_4$ gas ratio. The silicon nitride layer deposited in this condition showed the effective life time of > $1400{\mu}s$ and the surface recombination rate of 25 cm/s. The crystalline silicon solar cell fabricated with this SiNx coating showed 18.1% conversion efficiency.

• Transactions of the Korean hydrogen and new energy society
• /
• v.23 no.3
• /
• pp.199-206
• /
• 2012

HC-SCR was conducted over Co-Pt/ZSM5 catalyst coated over 200 cpsi cordierite in the condition of atomspheric pressure and $200^{\circ}C-500^{\circ}C$. Weight ratio of Co/Pt determined from EDX analysis was 8/2, which was almost equal to the weight ratio at preparation step. XPS showed that nitrates within cobalt precursor and chlorine withn Pt precursor were removed. TEM result demonstrated that crystallite size of cobalt and Pt was under 5nm. Among these tested hydrocarbon reductants, isobutane ($i-C_4H_{10}$) showed the highest de-$NO_x$ yield of 80% under the condition of the mole ratio of reductant/NOx=1.0 at $180^{\circ}C$. De-$NO_x$ yield from HC-SCR was increased as the carbon number of hydrocarbon reductant was increased. The decrease of bonding energy between C and H of HC reductant played a role to increase of de-$NO_x$ yield, which indicated that the dissociation step of C-H bond of hydrocarbon molecule might be the rate determining step of HC-SCR. The increase of oxygen concentration in the feed resulted in the decrease of de-$NO_x$ yield but the increase of CO and $N_2O$ yield.

• Land and Housing Review
• /
• v.8 no.3
• /
• pp.171-180
• /
• 2017

In 1990s, as the extreme weather events according to the global warming climate change are occurred frequently all around the world and the scale of the damage increases, the developed countries are promoting various policies for reducing greenhouse gas emissions setting the goal of greenhouse gas reduction with the level of State and local government. Especially for the greenhouse gas reduction of buildings and the inducement of eco-friendly design, the green certification system is strengthened with the assessment of energy and greenhouse management, and recently, according to the policy change of climate and energy, the certification system expanded from the buildings to the level of city and district is piloted. So this research is to understand the main contents and the assessment system of domestic green building certification system implemented in March 2013 in response to the policy change of climate and energy and to suggest the basic data for the improvement of present domestic greenhouse certification standard through the analysis of actual certification and the main case analysis of international green certification system. Recently in developed countries, in 1990s, for the reduction of building's greenhouse gas emission and the inducement of eco-friendly design, from the building of LEED, BREEAM, DGNB to the level of city and district such as LEED Neighborhood Development, BREEAM Communities, DGNB Stadtquartiere, the system is expanded and piloted. On the contrary, as for the domestic standard of green building certification system, the distribution ratio according to the assessment items in each category consists of the assessment system based on the buildings, and just the simple adjustment of some items and the improvement of weighted value are performed. Actually, as a result of selecting the 30 districts of apartment housing with the most certification performance by use among the 49 buildings certified by Institute of Land & Housing from December 2014 to July 2016 and analyzing the assessment score, the certification level is determined by the sectors of high distribution like indoor environment and energy not by the ineffective sector of external environment with low distribution so this system has a limitation to perform the practical means for the policy change of climate and energy. Thus for the national green building certification standards, the assessment system in the sector of external environment is to complemented and furthermore, reflecting domestic reality, through the introduction of certification system and the assessment system with the level of city and district, this system should be improved to meet the international certification standard.

• Journal of Climate Change Research
• /
• v.8 no.2
• /
• pp.81-89
• /
• 2017

In this study CALPUFF was used to estimate the influence of temperature rise, according to the observation value of temperature rise based RCP scenario, on meteorological elements (wind direction, wind speed, mixing height) and the change of pollutant diffusion. According to the result. applying estimated value of year 2050 temperature rise, the mixing height is increased as per the temperature rise, so the range of atmospheric diffusion is widened. In summer case, by applying temperature rise of $4^{\circ}C$ and comparing with before applying temperature rise, there was change of diffusion range as per the change of temperature between 10 AM to 11 PM. And the range of diffusion was wider than that of before temperature rise. In winter case, by applying estimated value of temperature rise, $2.3^{\circ}C$, diffusion range has been changed between 8 AM to 4 PM, showing different diffusion aspect from summer. Also, according to the result of air pollution level assessment with temperature rise, it was proved that the ratio of area with increasing air pollution level has been getting higher by increase of temperature.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.12 no.2
• /
• pp.79-88
• /
• 2017

One of the important applications of activity sensing in the home is energy monitoring. Many previous methodologies for detecting and recognizing household appliances have been proposed. This paper presents an approach that uses an energy metering circuit (EMC) to classify and identify the various electrical devices in home based on root-mean-square (RMS) consumed current value. EMC gathers the RMS current values created by appliance state transition (e.g., on to off) and apparatus operating process. In this paper, an identification algorithm is proposed to detect a change in current levels using the standard deviation of current signals and their average values. In addition, characteristic of the appliance is extracted concerning four feature parameters concerning the number of current levels, the minimum level, the maximum level, and signal-to-noise ratio (SNR) of them. Experiment results validate the reliable performance of the proposed identification method for 11 representative appliances.

• Journal of the Korean Solar Energy Society
• /
• v.32 no.6
• /
• pp.60-67
• /
• 2012

Government Geothermal Cooling-Heating Projects has made efforts to reduce GHG(Greenhouse Gas) emissions and to manage cost of greenhouse farm households. This study evaluated the economic benefits of heating load rate of change by comparing Geothermal Cooling-Heating System with the existing system(greenhouse diesel heating) in the Government Geothermal Cooling-Heating Projects. Economic analysis results shows that, 1) When installing the Cooling-Heating system according to the ratio of 70% heating load in policy standards, the geothermal cooling-heating system has economic efficiency with greenhouse type or scale independent because the investment cost is recovered within 7 years. And It was more economic efficiency the ratio of 50% heating load than70% heating load. 2) When installing the Cooling-Heating system according to the glass greenhouse of the ratio of 90% heating load, pay period of investment cost is recovered within 5 years. Therefore it is necessary to apply flexible heating sharing according to greenhouse type or scale.