• Journal of Ginseng Research
• /
• v.18 no.2
• /
• pp.128-133
• /
• 1994

Color characteristics were investigated for white ginseng powder immediately and during storage following treatments of gamma ray or ethylene oxide (EO) for microbial decontamination. The variation in fatand water-soluble pigments of the sample was negligible immediately after both treatments, however an apparent increase was observed in the samples stored for four months at $25^{\circ}C$ and RH 90%, in the order of nontreated control, EO-fumigated, and 5 key-irradiated samples. Hunter's color a and b values of white ginseng powder increased slightly in proportion to irradiation doses, whereas EO fumigation caused a decrease in L value and an increase in a and b values of the sample, showing overall color difference (${\delta}^E$) of 1.8. Considering the higher ${\delta}^E$ in the higher RH conditions, airtight packaging and sterilization using like gamma ray were considered an effective means for maintaining high quality of color characteristics in stored white ginseng powder.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 1998.11a
• /
• pp.138-141
• /
• 1998

To evaluate the color change of the opaque resin materials, a measuring system including PAS(photodegradation acceleration system) was constructed. Xenon lamp is used as a light source in the PAS, and the radiant energy from the lamp is irradiated to the samples through serveral high-pass filters with cut-off wavelength in UV and visible region. The color difference of the samples were measured by using the measuring system with a spectrophotometer(CM-2002) and a computer. The result showed that the opaque resin materials changed severely in their color in the wavelength of UV region and changed a little in the wavelength of visible region.

• Journal of the Korea Furniture Society
• /
• v.28 no.3
• /
• pp.224-232
• /
• 2017

Building energy saving have been put effort in a long time since buildings consume about 40.6% of total energy use, where heating, cooling and electrical lighting requirement results in energy consumption of building significantly. The window is an important part of building envelope, it usually brings a certain heat load from solar radiation while it allows light passing through, and properly leads to overheating in summer, hence the cooling load increase sand cause of thermal uncomfortable factor. The purpose of this study was to evaluate internal shade performance according to color and materials. There is growing interest in improving the sense of comfort among students who spend most of their time in the classroom. The study examined thermal environment and light environmental performance according to the color and materials of internal blinds to the school classroom. The results of this study were as follows; Among wooden blinds, aluminium blinds, and polyester blinds, the aluminium blinds were most excellent. In addition, among white blinds, light brown blinds, dark brown blinds, the light brown were most excellent.

• Journal of the Semiconductor & Display Technology
• /
• v.16 no.4
• /
• pp.11-15
• /
• 2017

Red phosphors, $Sr_2Si_5N_8:Eu^{2+}$, were synthesized as a single-phase crystal structure by optimizing carbon and $Eu^{2+}$ contents in a carbothermal reduction nitridation method. With increasing $Eu^{2+}$ contents, the photoluminescence spectra were red-shifted from 600 nm peak for 1 mol% for to 700 nm for 7 mol%. It was suggested that this red shift is attributed to the energy transfer from one low-energy sited $Eu^{2+}$ (1) to other high-energy sited $Eu^{2+}$ (2). Finally, the best red sample (620 nm emission peak and 80 nm half width for 3 mole% of $Eu^{2+}$) was packaged on a Blue LED together with two additional green and yellow phosphors, the fabricated White LED showed a high color-rendering index of 90 and white color coordinates of x= 0.321 and y = 0.305.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.1120-1123
• /
• 2008

Efficient, color stable multi-EML WOLED have been fabricated using newly synthesized yellowish green dopant Ir(chpy)3 or Ir(mchpy)3. The devices have high external quantum efficiency of 11.7%, color rendering index of 87, variation of CIE coordinate of (0.02, 0.01) between 10 to 5000 cd/m2, and low roll-off in efficiency with increasing brightness.

• Korean Journal of Food Science and Technology
• /
• v.25 no.5
• /
• pp.417-420
• /
• 1993

Changes in color intensity of Hololeion maximowiczii(HM) roots which were treated with freeze drying (FD), $50^{\circ}C$ hot air drying (HAD) and $50^{\circ}C$ hot air drying after steam blanching (HADB) were investigated in this study. Color of HADB was yellow-green while other treatments showed bright brown color. In brown color intensity, optical density at 420 nm of FD treatment was highest but HADB treatment showed the highest value in ultra violet spectrum. Water soluble pigment of HM in state of aquous solution was more unstable for heat treatment than that in state of powder. Activation energy for decomposition of the pigment was 20.9 kcal/mole between $90{\sim}100^{\circ}C$ but 50.6 kcal/mole between $80{\sim}90^{\circ}C$.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.10 no.5
• /
• pp.43-51
• /
• 1996

An appropriate lighting standard for the museum is needed to minimize the deterioration of the exhibits by the light. To obtain the basic data for the standard, a system to measure the color change of the artifacts as a function of the radiation energy frequency was constructed. Xenon lamp is used as a light source, and the light is irradiated to the samples through serveral cut-off filters. Measuring the colors of the samples under each filters, color change of the samples is estimated for each frequency ranges of radiation energy. As a result, natural dyes show severe color change in a short time, but traditional papers shows relatively small color change. Using measured results, color change due to other light sources can be calculated and this will be the base of the standard.

• KIEAE Journal
• /
• v.12 no.3
• /
• pp.101-106
• /
• 2012

Lighting energy accounts for approximately 20% of the electrical energy used worldwide. Thus, High efficiency Light emitting diode(LED)lighting is getting more popular as the next generation lighting replaced to traditional lighting fixtures. Also, LED lighting not only has a long lifetime but also can realize a variety visual environments through the wavelengh control. The lighting energy varies depending on the Spectral Power Distribution(SPD) even though the Illuminance level is same. Therefore, This study indicates that the difference of indoor energy consumption under the same illuminance level when Spectral Power Distribution(SPD) is different. As a result, Lighting energy consumption under red-color emphasizing SPD is about 10% lower than under blue-color emphasizing SPDs.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.5
• /
• pp.3579-3586
• /
• 2015

In this study, EEG, HRV, and Vibra image were compared and analyzed in the environmental test room due to stimulation of aroma and color temperature. The condition of the environmental test room was in temperature $25[^{\circ}C]$, relative humidity 50[RH%], air current speed 0.02[m/s] and illuminance 1000[lux] with setting up different sensory stimulation condition which are before exposure, single-sensory stimulation of Jasmine scent, single-sensory stimulation of RED color lighting, and multi-sensory stimulation of Jasmine scent and RED color lighting. The result of this study, at multi-sensory stimulation of Jasmine scent and RED color lighting, relative $S{\alpha}$ wave, SEF50, $SMR/{\theta}$ and SDNN were revitalized, and both sides ${\alpha}$ wave asymmetry index, stress index, fatigue degree, and HRT were decreased. Also, Viba image of tension/anxiety and stress were declined. Therefore multi-sensory stimulation of Jasmine scent and RED color lighting effects to increase the Neuro-energy like amenity, productivity of work efficiency, and concentration.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.45 no.1
• /
• pp.1-10
• /
• 2008

Coloriztion algorithms, which hide color information into gray images and find them to recover color images, have been developed recently. In these methods, it is important to minimize the loss of original information while the color components are embedded and extracted. In this paper, we propose a colorization method using a wavelet packet transform in order to embed color components with minimum loss of original information. In addition, the compensation processing of color saturation in the recovered color images is achieved. In the color-to-gray process, an input RGB image is converted into Y, Cb, and Cr images, and a wavelet packet transform is applied to the Y image. After analyzing the amounts of total energy for each sub-band, color components are embedded into two sub-bands including minimum amount of energy on the Y image. This makes it possible not only to hide color components in the Y image, but to recover the Y image with minimum loss of original information. In the gray-to-color process, the color saturation of the recovered color images is decreased by printing and scanning process. To increase color saturation, the characteristic curve between printer and scanner, which can estimate the change of pixel values before and after printing and scanning process, is used to compensate the pixel values of printed and scanned gray images. In addition, the scaling method of the Cb and Cr components is applied to the gray-to-color process. Through the experiments, it is shown that the proposed method improves both boundary details and color saturation in the recovered color images.