• 한국전자파학회논문지
• /
• 제10권4호
• /
• pp.594-606
• /
• 1999

접지돈 유전체슬랩 위에 주기적으로 스트립이 놓여 있는 격자구조에 대한 전자파 산란특성을 TE 편파의 경우에 대하여 반사격자(reflection grating)관점과 누설파안테나(leaky wave antenna)관점에서 조사하였다. 수치해석 결과로 Bragg blazing현상을 두가지 형태(공진형과 비공진형)로 구분하였으며 그 특성(복소전파상수, 산란특성, 전류밀도분포)에 대하여 논의하였다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2008년도 춘계학술대회논문집
• /
• pp.196-201
• /
• 2008

This paper is about electromagnetic vibration source in outer rotor type of BLDC motors. Experiments are carried out with three pole-slot combinations which are 6 slots, 12 slots, and 24 slots with 4 poles rotor. According to results, vibration sources separate into electromagnetic and mechanical factors. Using the finite element method (FEM), It is analyed that vibration characteristics of electromagnetic source in each type. This paper shows electromagnetic sensitivity to vibration, and introduces necessary point in lower vibration motors. Also rotor balance is important to prevent uneven distribution of magnetic flux between rotor and stator.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 C
• /
• pp.1670-1672
• /
• 2001

In compared with air insulated switchgear GIS has a high efficiency and confidence. Insulation method using $SF_6$ gas has a very excellent insulation characteristics for high voltage equipment but has a characteristics that insulation heredity is changed for internal unequal electric field. So analysis of electromagnetic field in GIS is very important basic data for structure design and trouble diagnosis process. In compared with established method, SNM in this paper observes variation of the electromagnetic field with real time and get result very similar to measurement. In order to know the variation of electromagnetic field distribution for transient response for time and position, variations are observed when metal particles are moving fast.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.129-131
• /
• 2005

This paper deals with an electromagnetic analysis and control parameter estimation of a moving-coil linear oscillatory actuator (MCLOA). Analytical solutions for electromagnetic characteristics of the MCLOA are obtained from transfer relations derived in terms of a magnetic vector potential and two-dimensional (2-d) rectangular coordinate systems. And then, on the basis of 2-d analytical solutions, control parameters such as the thrust constant, the back-emf constant and winding inductances are estimated. Finally, analytical results for both electromagnetic characteristics and control parameters of the MCLOA are validated extensively by finite element (FE) analyses. In particular, test results such as static thrust, resistance and inductance measurements are given to confirm the analyses.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2001년도 종합학술발표회 논문집 Vol.11 No.1
• /
• pp.304-309
• /
• 2001

With the development of electromagnetic communication technology and increased use of electromagnetic wave, the countermeasure of EMI(Electromagnetic Interference) becomes more important socially, and interest for the electromagnetic wave absorber has also increased. In this paper, we have studied characteristics of frequency dependency on complex permittivity and complex permeability according to the changes of composition rate and sintering temperature of NiCuZn ferrite also known as electromagnetic wave absorber and further looked into effect of electromagnetic wave absorption properties. From the measurement where the composition of Fe$_2$O$_3$ and ZnO of NiCuZn ferrite was fixed at 49 and 34 mol% respectively while composition of NiO and CuO has been varied at each test, we found out that initial permeability and permittivity were high and the absorbing ability of electromagnetic wave recorded best with loss tangent(${\mu}$r"/${\mu}$r′) displays more than 1 within the frequency band of 2MHz～9.5MHz when the composition ratio of NiO was ranged around 8.5～9.5 mol% and the sintering temperature was 1,080$^{\circ}C$.

• 한국항해학회지
• /
• 제17권3호
• /
• pp.77-83
• /
• 1993

The goal of this research is to get a measuring system for absorption characteristics over the frequency band with 30MHz to 1, 000MHz concerning the ferrite electromagnetic wave absorbers, for example, grid-type and sintered flat type, etc. It is, however, very difficult to measure the absorption characteristics as in low frequency as in 30 MHz. In this research, therefore, we propose a standing wave method using parallel striplines, fabricate the measuring system, and measure the characteristic of ferrite microwave absorbers using the proposed mea-suring system.

• 한국전자파학회지:전자파기술
• /
• 제3권2호
• /
• pp.10-15
• /
• 1992

The electromagentic characteristics of antennas in the complicated metallic structures were analyzed using the electric field integral equation. The accurancy of computer program was confirmed by comparing the computation result with NELC brass model study. And computation result of antenna characteristics in metallic structures was in good argreement with our measuring result.

• Journal of electromagnetic engineering and science
• /
• 제1권1호
• /
• pp.24-29
• /
• 2001

In this paper, the wideband microstrip antennas for the PCS & IMT-200O dual band are studied. Experimental and simulation results on the dual band antenna are presented. Simulation results are in good agreement with measurements. The experimental and simulation results confirm the wideband characteristics of the antenna. The studied antenna satisfies the wideband characteristics that are required characteristics for above 420 MHz impedance bandwidth for the PCS & IMT-2OO0 dual band antenna. In this paper, through the designing of a dual band antenna, we have presented the availability for PCS & IMT-20O0 base station antenna.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.80-82
• /
• 2005

This paper presents the characteristics analysis of an electromagnetic pump using a linear induction motor(LTM). The characteristics of the pump for three molten metals Is analyzed by the magneto hydro dynamics: flow velocity, flow mass and etc. The result of the analysis is that the flow velocity for three molten metals is over 0.3[m/s] at the center of duct.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 A
• /
• pp.62-64
• /
• 1995

This paper describes the characteristics of electromagnetic forces of Combined superconducting maglev system. Generation of the levitation, the propulsion and the guidance force by a single coil is proved by the phasor- analysis. It is also shown that double-layered configuration has better characteristics in efficiency, pulsation of the forces and drag ratio than single-layered configuration.