• Journal of Mechanical Science and Technology
• /
• v.15 no.9
• /
• pp.1319-1327
• /
• 2001

The results of stand and field testing of a combustion chamber for a heavy-duty 150 MW gas turbine are discussed. The model represented one of 14 identical segments of a tubular multican combustor constructed 1:1 scale. The model experiments were executed at a lower pressure than that in a real gas turbine. Combustion efficiency, pressure loss factor, pattern factor, liner wall temperature, flame radiation, fluctuating pressure and NOx emission were measured at partial and full loads for both model and on-site testing. The comparison of these items in the stand and field test results led to has the development of a method of calculation and the improvement of gas turbine combustors.

• Proceedings of the KIPE Conference
• /
• 2003.11a
• /
• pp.90-94
• /
• 2003

Recently, many nations have released standard such as IEC 1000-3-2 and IEEE 519 which impose a limit on the harmonic current drawn by equipment connected to AC line in order to prevent the distortion of an AC line. Among the wide variety of active methods for improving power factor and harmonic distortion, the boost converter is very effective because it has a continuous line current , small choke filter and high power factor. In high power application, however, the bridge diode loss in the boost converter has made the efficiency lower and the temperature of the board higher. A new approach without bridge diode to make the same characteristics of the conventional boost converter has also been developed. This paper present the comparisons between the continuous current mode(CCM) operated conventional boost converter and the boundary current mode(BCM) operated the bridgeless boost converter for high efficiency and high power factor.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2004.05a
• /
• pp.492-496
• /
• 2004

When using a conventional power factor correction circuit, a comparatively huge capacitor is used to boost-up output voltage. It has a large amount of harmonic distortion in the input current waveform. To improve the input current waveform of diode rectifiers, we propose a new operating principle for the power factor correction circuit. Due to the fact that the proposed circuit uses smaller ones and a smaller reactor, the output voltage increases and obtains higher input current waveforms. These are suitable for the harmonics guidelines. The proposed circuit is able to obtain higher power factor and efficiency. Also, it has reduced switching loss and held over-shooting by using an inverter of eliminated dead-time HPWM that has non-linear impedance circuits to make up diodes, capacitance and a reactor. We compared the conventional PWM inverter and proposed HPWM inverters and found that a high input power factor of 97[%] and an efficiency of 98[%] were also obtained.

• Asia-Pacific Journal of Business
• /
• v.10 no.3
• /
• pp.37-51
• /
• 2019

In this paper, we investigate the performance of anomaly factors in Asia-Pacific Stock market and show the higher Sharpe ratio of the volatility managed smart beta portfolio. The smart beta portfolio combines the benefit of passive strategy and active strategy. However, the smart beta portfolios are seems to be exposed to the risk of anomaly factors from the perspective of traditional financial equilibrium model. Therefore, the smart beta strategy may generate negatively skewed returns unappealing to investors having lower risk tolerance. Our empirical investigations find that the return of the Asia-Pacific region stock market is more volatile than other regions with the lower efficiency ratio. However, the value factor and the momentum factor of Asia-Pacific region both show good performances. More interestingly, we also find that managing the volatility of the momentum factor in Asia-Pacific stock market almost doubles the efficiency ratio.

• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.27-30
• /
• 1998

In this paper, the inverter air-conditioner with Power Factor Correction(PFC) circuit is Presented for obtaining the good system efficiency and cost merit compared with the conventional inverter air-conditioner. The detailed design procedures for getting the optimal passive components are implemented. Through the simulation and experimental results, it is shown that the system efficiency can be improved. Using the designed components, the prototype system is builted and tested to verify the additional good performances of the proposed circuit.

• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.418-422
• /
• 1998

A new single stage AC/DC converter based on the forward converter is proposed. The proposed converter offers both the high power factor and the direct conversion from ac line to dc output voltage. Also, the proposed converter reduces the diode conduction loss, so improves the overall efficiency of the converter, compared with other alternatives. The principles of operation and the simulation results of the proposed converter are presented. A 100 W prototype was built and tested to show the potential of applications of the proposed converter.

• Journal of Power Electronics
• /
• v.6 no.2
• /
• pp.121-130
• /
• 2006

This paper presents the performance and efficiency of a drive system incorporating a switched-reluctance motor (SRM) with input power factor correction (PFC). The proposed system consists of a PFC, bi-directional converter, an inverter, and a SRM operating as based voltage source drives (VSD). First, theoretical analysis is made for each identified mode of operation in the drive system. This is followed by comparing the performance of the SRM drive system with and without a PFC circuit. The losses are also calculated for both systems and overall efficiency. Experimental results are presented to prove the theoretical analysis.

• Journal of Information Technology Services
• /
• v.16 no.4
• /
• pp.1-13
• /
• 2017

This study examines how specific technology from Information and Communications Technology (ICT)-which plays a critical role in increasing productivity by promoting a spread of technology across the society though the use of big data, mobile or wearable devices-impacts of the productivity of society and productivity of added values, respectively. The impact of technology was studied from the perspective of efficiency levels of input. In order to provide an analysis, we have categorized ICT into 16 specific technologies and have set the number of companies and number of employees each as an input factor while setting the respective output and the output of added values as an output factor. Afterwards, we have applied data envelopment analysis (DEA) which is a form of nonparametric frontier analysis and measured the productivity and efficiency of added values for each technology. According to the analysis results, there were 2 technologies by the CRS standards, and 3 technologies by the VRS standards that showed relative efficiency levels. We have also presented some efficiency improvement strategies for specific technologies that revealed relative inefficiency and offered a reference set and projection point. In addition, we provide an analysis on scale efficiencies (SE), diminishing returns to scale (DRS), and increasing returns to scale (IRS) of each ICT.

• Journal of Electrochemical Science and Technology
• /
• v.7 no.3
• /
• pp.218-227
• /
• 2016

The light harvesting efficiency is counted as an important factor in the power conversion efficiency of DSSCs. There are two measures to improve this parameter, including enhancing the dye-loading capacity and increasing the light trapping in the photoanode structure. In this paper, these tasks are addressed by introducing a macro-porous silicon (PSi) substrate as photoanode. The effects of the novel photoanode structure on the DSSC performance have been investigated by using energy dispersive X-ray spectroscopy, photocurrent-voltage, UV-visible spectroscopy, reflectance spectroscopy, and electrochemical impedance spectroscopy measurements. The results indicated that bigger porosity percentage of the PSi structure improved the both anti-reflective/light-trapping and dye-loading capacity properties. PSi based DSSCs own higher power conversion efficiency due to its remarkable higher photocurrent, open circuit voltage, and fill factor. Percent porosity of 64%, PSi(III), resulted in nearly 50 percent increment in power conversion efficiency compared with conventional DSSC. This paper showed that PSi can be a good candidate for the improvement of light harvesting efficiency in DSSCs. Furthermore, this study can be considered a valuable reference for more investigations in the design of multifunctional devices which will profit from integrated on-chip solar power.

• The Journal of Fisheries Business Administration
• /
• v.43 no.1
• /
• pp.11-18
• /
• 2012

This study is aimed to estimate a dynamic productive efficiency by vessel of large purse seine fishery and analyze changes of them over times using a window/DEA method. In addition, based on estimation results, it aims to suggest production management implications for an viable development of fisheries. Results indicated that an annual efficiency change of large purse seine fishery was estimated at 0.77 for 2007~2008, 0.83 for 2008~2009, and 0.77 for 2009~2010, showing a decreasing trend. As returns on sales of vessels of large purse seine fishery showed a decreasing trend, the degree of efficiency of a vessel might be closely related to the fishing profitability. The Window/DEA method was used in this study to estimate the efficiencies of vessels for large purse seine fishery. This method is well known and widely used to analyze the dynamic efficiency and it can provide useful implications for management of input factors. As a limitation of this study, it was not able to provide detailed management ways to reduce inefficiencies. However, they can be investigated with data on managerial factor, human factor, distribution factors as a future study.