• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 1999.11b
• /
• pp.61-69
• /
• 1999

Contaminants such as fatty acids, triglycerides, resin acids and foam collected from a high yield sulfite weak liquor storage tank lowered the water surface tension and reduced inter-fibre bonding but also tended to benefit sheet opacity. Some common wet end additives such as defoamers and dispersants gave similar results. Lignosulfonate and naphthalene sulfonate showed little if any negative effect on both surface tension and sheet strength properties. Among the natural wood extractives. fatty acids were identified to be most detrimental followed by triglycerides and then resin acids. In order to alleviate the detrimental impact of these contaminants, membrane separation, air floatation and ozone treatment were carried out on paper machine white water samples. The effect of these treatments on removal of fatty and resin acids was quantified by a GC-Mass analysis. Reverse osmosis with a 1000 molecular weight cut off membrane failed to totally reject fatty and resin acids, but markedly reduced losses of sheet properties due to contaminants. Ozone treatment resulted in a significant increase of the surface tension and air floatation was considered to be a practical and useful method for removing fatty and resin acids from the machine white water.

• Membrane and Water Treatment
• /
• v.7 no.3
• /
• pp.193-207
• /
• 2016

Boron is one of the most problematic inorganic pollutants and is difficult to remove in water. Strict standards have been imposed for boron content in water because of their high toxicity at high concentrations. Technologies using membrane processes such as reverse osmosis (RO) and nanofiltration (NF) have increasingly been employed in many industrial sectors. In this work, removal of boron from model water solutions was investigated using polyamide reverse osmosis and nanofiltration membranes. RO-AG, RO-SG, NF-90 and NF-HL membranes were used to reduce the boron from model water at different operational conditions. To understand the boron separation properties a characterization of the four membranes was performed by determining the pure water permeability, surface charge and molecular weight cut-off. Thereafter, the effect of feed pressure, concentration, ionic strength, nature of ions in solution and pH on the rejection of boron were studied. The rejection of boron can reach up to 90% for the three membranes AG, SG and NF-90 at pH = 11. The Spiegler-Kedem model was applied to experimental results to determine the reflection coefficient of the membrane ${\sigma}$ and the solute permeability $P_s$.

• Journal of Environmental Science International
• /
• v.17 no.1
• /
• pp.113-118
• /
• 2008

[ $6{\sim}13mg/L$ ] base water concentration on monthly BOD has been kept at the Geukrak bridge point for this research target and it indicates the water quality under the existed rank. Due to this present condition of water quality, the demage of ecology from the upper stream to the lower one of the bridge could be conjectured. Moreover, nonstructural extinction of the ecology seems to have gotten worse between both the streams of Yeoungsan River. On this research, eco-corridor between the upper stream and the lower stream of the river should be ensured, the ecological demage needs to be cut off, a dispersed discharge method which the existed method of the 1st sewage plant in Gwangju was enhanced to should be inducted for the procuring of various water ecosystem, and the conditions by the scenario suggested from this research could be applied to a water quality model. then, analysis the improvement effect of the water quality adjacent the river. From the test result, Case3-Type1 scenario is thought to be the best one. From the test result with Case3-Type1 when the concentrated discharge was never done, 0.07 mg/L of BOD concentration was increased at the lower stream where Yeoungbon B point (Haksan Bridge) is but the water improvement effect of $0.24{\sim}2.87mg/L$ is thought to have been done at the area of water deterioration.

• Membrane and Water Treatment
• /
• v.9 no.2
• /
• pp.87-94
• /
• 2018

The interactions of water soluble polymers with dye are studied by ultrafiltration using a molecular weight cut off of 10 KDa regenerated cellulose ultrafiltration membrane. Two water-soluble polymers, namely Poly (Sodium-4 Styrenesulfonate) (PSS) and Poly (Vinyl Alcohol) (PVA) were selected for this study. The effects of process parameters, such as, polyelectrolyte concentrations, transmembrane pressure, ionic strength and pH of solution on dye retention and permeation flux were examined. PSS enhanced ultrafiltration achieved dye retention as high as 99% as a result of complexation between polyanion containing aromatic groups and cationic dye. This result was confirmed by the red shift. The retention of dye decreases as the salt concentration increases, a high retention was obtained at pH above 4. However, in case of PVA, relatively low retention (50%) was observed. Ionic strength and pH has no significant effect on the removal of MB. The permeate flux depended slightly on polyelectrolytes concentrations, transmembrane pressure, salt concentration and pH.

• Land and Housing Review
• /
• v.8 no.4
• /
• pp.267-274
• /
• 2017

Since LID design process for the urban regeneration has not yet been established in Korea, this study was extablished in LID design process through reterauture reviews and expert opinions. But the extablished LID design processes have many limitations to be applied to proper LID facilities to the site because of not considering characteristics and water flow of the site. To solve the limitations of existing design processes, it is necessary for analysis of water flow through GIS analysis at the site. After analysis of water flow, it is important to find areas cut off water flow and to install LID facilities at those points. Through these considerations, this study present the improved LID design process to apply to urban regeneration.

• Membrane Journal
• /
• v.9 no.4
• /
• pp.193-201
• /
• 1999

The object of study were the development of membrane process and the optimization of operation condition for membrane system, which was used the pre-treatment system of tap water treatment in steady of conventional process such as coagulation, sedimentation. The higher steady flux is very important factor, by a suitable pre-treatment and optimization of operating condition such as fouling control, crossflow and backwashing method, in membrane system. So, we were observed the effect of flux decline for membrane used by 4 type ultrafiltration(UF) membrane pre-treatment process, and optimized the operation condition of filtration system under various MWCO(Molecular weight cut-off), operation pressure, linear velocity and temperature to maintain higher flux. From these experiment, we were identified that UF process showed a slower flux decline rate and a higher flux recovery than microfiltration(MF) membrane. The water quality of UF permeate was better than that of MF, and was not effected pre-treatment process. In the operation condition, the rate of flux decline was diminished by a higher linear velocity and operation temperature, lower pressure.

• Journal of Ginseng Research
• /
• v.28 no.3
• /
• pp.127-131
• /
• 2004

This study was carried out to investigate the effect of red ginseng water extract (RGWE) on trypsin activity. After extraction of fat soluble and saponin component from red ginseng powder by methyl alcohol, the residue was extracted with distilled water, and manufactured to water extract. The extract was dialyzed with different molecular cut off membrane. Trypsin activity demonstrated the highest level at the RGWE concentration of 9${\times}$10$\^$-2/% in reaction mixture, and also increased to 15% at 2.9${\times}$10$\^$-3/%. Km value was decreased and Vmax was increased in the present of red ginseng water extract. Red ginseng water extract was partially purified by dialysis, Bio-Gel P-I0 and DEAE-cellulose column chromatography. The active fraction demonstrated positive reaction to ninhydrin, DNS and folin reaction.

• Preventive Nutrition and Food Science
• /
• v.5 no.4
• /
• pp.225-229
• /
• 2000

The antioxidative and protective activities of kefir, low-fat dry milk (NFDM) extract and fractions on SFME cells in serum-free medium were investigated. Kefir and low-fat kefir and NFDM extract were made by solubilizing the freeze dried powder forms in deionized water, filtering through glass prefilter, 12 ㎛ and 2 ㎛ membrane, and demineraling with chelating resin. Kefir, low-fat kefir and NFDM extract were fractioned into dialyzate and retentate by dialysis with membrane tube having the molecular cut-off of 3,500 Dalton. An antioxidative activity was analyzed by the in vitro model system using a linoleic acid. In the case of kefir an antioxidative activity was detected only in the retentate of kefir extract. On the other hand NFDM showed an antioxidative activity in extract, demineralized extract, dialyzate and retentate. The retentate of kefir extract had the higher antioxidative activity than that of NFDM extract. Kefir showed the protective effect of SFME cells in serum-free medium in extract, demineralized extract and retentate, but low-fat kefir didn't. NFDM had the similar protective effect on SFME cells as extract, demineralized extract and retentate of kefir.

• Geotechnical Engineering
• /
• v.14 no.5
• /
• pp.191-204
• /
• 1998

The feasibility of fly ash was evaluated as an alternative liner material to the conventional clay liner of landfills through modeling and laboratory experiments. In order to consider the effect of unsaturation on water flow through the liner, analyses were made to compare flow characteristics in saturated liner with that of unsaturated one. Contaminant migration characteristics in liners were investigated by batch experiment and modeling, in which phenol was employed as a model was solved by numerical techniques of finite difference method and predictor-corrector method to deal with high non-linearity. Sequential method was used to handle the system of differential equations. Results show that the alternative liner material is more capable of cutting off water flow in unsaturated condition and in preventing phenol from passing through it. It can be seen that, under the flow conditions considered in this study, the conventional saturation approach underestimates the amount of water passing through the liner and doers the cut-off capability against phenol significantly.

• Journal of Haehwa Medicine
• /
• v.13 no.2
• /
• pp.187-196
• /
• 2004

Now many sustitution and false articles is used in korea instead of shanyao. To use shanyao correctly, we will make a quilitative certificational plan of shanyao to investigate all of lieraturea, records and documents. And we could reach conclusions as folloews. 1) Source About a source of shanyao, though korea and china has a each other source, we think there is no problem in use of both. 2) Process In our country producing shanyao as medical use is a 'duanma', we can divide into peeling and non-peeling, drying at bulks and at briquets, steaming shanyao and fresh shanyao. Regardless of existence for peeling and steaming, a distributing shanyao is received a proper judgment. Like this result was expressed by insufficiency of standards about medical components or indicating components. We detected a reminding S02 more than 10 ppm. And this expresses that there ia a problum at a drying method. To suggest proper processing methods, a standard of quility will have to be made which the existence of peeling, difference of quility between 'changma' and 'duanma', drying method and exudation test with cutted thickness are adaptable. Besides, 'maoshanyao' and 'guangshanyao' of china is processed by various methods which decrease a medical effect such as too much soaking shanyao in water, steaming with a sulfur, too much peeling, So we must process shanyao like the next methods. (1) When harvesting, dig deeply not to cut off roots. (2) Not to peel, wash shanyao in a washing machine. (3) Dry to 50-60% degree at sunny place or drying machine. (4) To be easy for drying and exudation, cut off a thick piece with 5 mm (5) Dry perfectly at ding machine. 3) Quality3) Quality (1) Functional standards It is not Proper that 'guangshanyao' is used in china because it has a problem with quility on process of working, If they did not soak shanyao in water or heat with steam, it is the real situation that they cannot cutt off shanyao evenly. In conclusion, shanyao must be heavy, powdery with a perfectly non-peeling surface, section surface is yellow-white color, unequal and has no holes. (2) Physicochemical standards It is the real situation that we can not distinguish into quility of shanyao with established test because various workings which decrease medical effects is used. Therefore we suggest a testing standard of S02 which is used in bleaching. And testing standards relatived with decrease of medical effects must be established at once. It must that Dry on loss is less than 14.0%, content of ash is less than 6.0%. Content of acid-nonsoluble ash is less than 0.5%. Contens of heavy metal has to detect less than 30 ppm and there is no reminding agricultural medince.