• Research in Plant Disease
• /
• v.20 no.2
• /
• pp.79-86
• /
• 2014

In order to seek more eco-friend, economic and safer quarantine method than current methyl bromide fumigation, the convergent treatment with 200 Gy of gamma irradiation and several chemicals such as nano-siver particles (NSS), sodium dichloroisocyanurate (NaDCC) was tried on the cuttings of lily in the packing of catonnage box for export. With 6 independent experiments of gamma irradiation on the three lily cultivars, cvs. Siberia, Le reve and Sorbonne, incidence and severity of lily leaf blight was investigated on leaves and petals at 8-d after infection. 200 Gy of gamma irradiation decreased at 13-25% of severity on the leaf of Sorbonne, but it increased at 2-5% of severity on the leaf of Siberia and Le reve. Chemical substitutes such as NSS and NaDCC were not effective to control of lily blight on cuttings. By 200 Gy of gamma irradiation treatment, chlorophyll contents were statistically significantly decreased at 12-d after irradiation and the longevities vaselife of fully open flower of Siberia and Sorbonne were increased at 0.4 to 1.2 days. In addition, the relative fresh weights of the gamma irradiated cuttings were severely dried compared to the non-irradiated control. On the other hands, the symptoms of phyto-toxicity of high dose gamma irradiation at 1 or 2 kGy on cv. Siberia were to be blight at the tip of bloom, bent necks of flower, and delayed the process of flowering.

• Applied Chemistry for Engineering
• /
• v.28 no.5
• /
• pp.501-505
• /
• 2017

Due to the rapid urbanization and increased population, there is an increase in airtight nature of buildings which causes serious indoor air pollution. Among several indoor air pollutants, volatile organic compounds (VOCs) emitted from paint are of major concern. Therefore, there is an urge for the development of environmental friendly paint products. In this wok, a natural wall paint (NWP) was prepared by utilizing a natural clay material "sericite" as a main component. A small chamber test was carried out to identify the toxic substances release from NWP and the results were compared with two eco-friendly commercial paints. The total VOCs were detected in trace level inside the test chamber and their concentrations were below the recommended indoor air quality standards. Toluene was not detected for NWP, whereas formaldehyde was observed in trace level. The toxicity index results were compared with two commercial paints and found that NWP exhibited less harmful gas emission. Based on certification rating of building materials, NWP can be classified as the first grade of building materials. Due to the above advantages, the use of sericite as a major component in NWP will be a useful technique to maintain the indoor air quality.

• Korean Journal of Ecology and Environment
• /
• v.43 no.1
• /
• pp.11-18
• /
• 2010

The contamination of a suite of heavy metals were evaluated in water and sediments of urban stream, Tancheon down the stream. Tancheon is a urban stream which goes all the way across the urban area where various pollution sources are present. The sixteen study sites from seven different areas were designated down the stream. The heavy metal levels of the streams were detected in the order of Zn>Cu>Ni>Pb>Cd>Cr>Sb. There was a difference in the relative order of the concentration ranking in lake sediments. There is a trend that the heavy metal levels are higher at the sites where the construction causes inflow of soil particles to stream. Toxicity tests using pore-water in sediments were conducted for samples collected in some study sites, and pore-water in one site was proven to be toxic to Japanes medaka (Oryzias latipes). The reason may be the fecal pollution rather than heavy metal effect. Strong odor was detected in the sediment whose pore-water samples showed ecotoxicity. We did not observed the increasing concentration of heavy metals down to stream since the soil texture varied in the stream area of our study. Further study is needed to find quantitative relations between the level of contamination and its eco-effect.

• Journal of Applied Biological Chemistry
• /
• v.55 no.2
• /
• pp.123-127
• /
• 2012

In order to develop eco-friendly biopesticide, an entomopathogenic bacterium Photorhabdus temperata M1021 has been lyophilized via freeze-drying along with protective agents such as skim milk, starch, sodium alginate, glucose and sodium glutamate to protect cells from lysis. Freeze-drying powder of P. temperata M1021 containing 7% skim milk (w/v) showed highest survival rate of 63% among all the protective agents used in trials. Furthermore, the freeze-dried microbial powder showed 75% of survival rate after stored at $4^{\circ}C$ for 4 weeks at air contact conditions. Injection toxicity of the freeze-dried sample was tested against larvae of Galleria mellonella. A dose of $2.0{\times}10^1$ cells of P. temperata M1021 killed 100% of the G. mellonella larvae within 4 days after injection. Moreover, $2.0{\times}10^0$ cells caused 50% mortality within the 4 days after injection. Freeze-dried P. temperata M1021 strains exhibited effective insecticidal activity and could be a better candidate for being used as a biopesticide.

• Journal of the Korean Applied Science and Technology
• /
• v.34 no.4
• /
• pp.1058-1065
• /
• 2017

Amino acid based surfactants as protein-surfactants is eco-friendly compound. So, amino acid based surfactants is expected as next generation surfactants. Amino acid based surfactants has high biodegradability, low toxicity and surface active properties. In this experiment, amino acid based surfactants, cocoyl glycine, was synthesized by glycine and triglyceride such as coconut oil and palm oil. And it was tested the surface tension, emulsifying properties, foam stability and HLB value. The synthesized surfactants was confirmed by FT-IR. Surface tension of surfactants synthesized by coconut oil on diluted aqueous solutions of surfactants was 31.2 dyne/cm at $1.0{\times}10^{-4}mol/L$. Surface tension of surfactants synthesized by palm oil on the diluted aqueous solutions of surfactants was 42.1 dyne/cm at $3.2{\times}10^{-5}mol/L$. Foam stability measured the foam height as time passed. Initial foam height of surfactants synthesized by coconut oil is 14.5 cm, and 10.7 cm after five minutes. Initial foam height of surfactants synthesized by palm oil is 3.0 cm, and 2.8 cm after five minutes. Foam height of surfactants synthesized by coconut oil was higher than surfactants synthesized by palm oil. But foam stability of surfactants synthesized by palm oil was better than surfactants synthesized by coconut oil. The emulsifying properties of synthesized surfactants are observed in benzene and soybean oil and emulsifying properties in organic solvent is better than in soybean oil.

• Korean Journal of Organic Agriculture
• /
• v.29 no.1
• /
• pp.97-109
• /
• 2021

Plant parasitic nematodes are causing significant damage in crop production. There is a need to develop eco-friendly nematicide that reduces the damage of nematode and has little effect on the environment and human. In this study, we have isolated a substance having nematicidal activity from Ginkgo biloba L. outer seedcoat. Studies of G. biloba L. outer seedcoat are insufficient compared to the seed and leaves due to their odor and toxicity. The dried G. biloba L. outer seedcoat was extracted with dichloromethane:methanol (1:1) and fractionated into hexane, ethyl acetate and H₂O. Four steps TLC were performed from EtOAc fraction to purely isolate GB4-3 with nematicidal activity. To compare nematicidal activity, G. biloba L. seedcoat methanol extract and purified GB4-3 were investigated in terms of treatment concentration and time. As a result, the nematicidal activity increased with concentration and time. In the place treated with 20 ㎍/mL of crude G. biloba L. seedcoat MeOH extract, strong activity appeared after 12 hours, and 46% nematicidal activity shown after 18 hours. About 69% of nematicidal activity was confirmed in the place where GB4-3 purified from outer seedcoat was treated with 20 ㎍/mL, and the possibility of development as nematicide was very high. This study could be used as a basic data for the development of a nematode preparation from G. biloba L. outer seedcoat.

• Korean journal of applied entomology
• /
• v.61 no.1
• /
• pp.101-108
• /
• 2022

Because of their specificity to target insects and relatively low toxicity to non-target organisms, insect growth regulators (IGRs) have been regarded as attractive alternatives to chemical insecticides. Commercially available IGRs are classified into juvenile hormone agonists (JHAs), ecdysone agonists (EAs), and chitin synthesis inhibitors (CSIs) according to their mode of action. Recently, JH-mediated interaction of methoprene-tolerant (Met), which is JH receptor, and its binding partners have been replicated in vitro using yeast cells transformed with the Met and FISC/CYC genes of A. aegypti. Using this in vitro yeast two-hybrid β-galactosidase assay, juvenile hormone antagonists (JHANs) have been identified from various sources including chemical libraries, plants, and microorganisms. As juvenile hormone (JH) is an insect specific hormone and regulates development, reproduction, diapause and other physiological processes, JHANs fatally disrupt the endocrine signals, which result in abnormal development and larval death. These results suggested that JHANs could be efficiently applied as IGR insecticides with a broad insecticidal spectrum. This review discuses JH signaling pathway mediated by Met and future prospects of JHANs as environmentally benign IGR insecticides.

• Journal of Environmental Impact Assessment
• /
• v.32 no.6
• /
• pp.431-436
• /
• 2023

As the industry develops, the amount of heavy metals flowing into the ecosystem is increasing. Heavy metals are difficult to decompose and remain in the ecosystem for a long time and cause toxicity, which is removed by physicochemical methods such as adsorption, filtration, and chemical precipitation during water treatment. In this study, Alginate bead was selected as a chelating resin for adsorbing and removing heavy metals, and the Jellyfish Extract at Immunity reaction (JEI) were mixed to evaluate the adsorption efficiency of heavy metals accordingly. beads mixed with JEI showed high adsorption efficiency in lead (79-99%) and copper (64-70%) according to the characteristics of Alginate, and low adsorption efficiency in cadmium (25-37%) and zinc (5-6%). Although heavy metal adsorption did not increase in proportion to the content of JEI, 50% and 100% JEI beads showed significant increases. As a result of applying the reaction rate equation, it was found that it was more suitable for the pseudo-secondary reaction equation than the pseudo-first reaction equation.

• Clean Technology
• /
• v.25 no.3
• /
• pp.256-262
• /
• 2019

Hydroxylammonium nitrate (HAN)-based liquid propellants are attracting attention as environmentally friendly propellants because they are not carcinogens and the combustion gases have little toxicity. The catalyst used to decompose the HAN-based liquid propellant in a thruster must have both low temperature activity and high heat resistance. The objective of this study is to prepare an Ru/alumina/metal foam catalyst by supporting alumina slurry on the surface of NiCrAl metal foam using a washing coating method and then to support a ruthenium precursor thereon. The decomposition activity of a HAN aqueous solution of the Ru/alumina/metal foam catalyst was evaluated. The effect of the number of repetitive coatings of alumina slurry on the physical properties of the alumina/metal foam was analyzed. As the number of alumina wash coatings increased, mesopores with a diameter of about 7 nm were well-developed, thereby increasing the surface area and pore volume. It was optimal to repeat the wash coating alumina on the metal foam 12 times to maximize the surface area and pore volume of the alumina/metal foam. Mesopores were also well developed on the surface of the Ru/alumina/metal foam catalyst. It was found that the metal form itself without the active metal and alumina can promote the decomposition reaction of the HAN aqueous solution. In the case of the Ru/alumina/metal foam-550 catalyst, the decomposition onset temperature was significantly lowered compared with that of the thermal decomposition reaction, and ${\Delta}P$ could be greatly increased in the decomposition of the HAN aqueous solution. However, when the catalyst was calcined at $1,200^{\circ}C$, the catalytic activity was lowered inevitably because the surface area and pore volume of the catalyst were drastically reduced and Ru was sintered. Further research is needed to improve the heat resistance of Ru/alumina/metal foam catalysts.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.4
• /
• pp.286-294
• /
• 2014

The purpose of this study is to investigate the effects of applying density current generator (hereafter referred to as DCG to large lakes on the operating conditions of DCG, de-stratification, water quality improvement and inhibition of algae occurrence. As a result of a survey conducted to derive the optimum operating parameters of DCG in a condition to minimize eco-toxicity, the following conclusions were obtained. During the survey period, a marked stratification appeared in September to October 2011 and May 2012. At this time, the average depth of water to form thermocline was found to be $5{\pm}2$ m, so the location of discharge port for the operation of DCG was determined to be about 5 m below from the surface. To minimize the adverse effects of benthos and obtain the effect of water mixture at the time of water circulation, the mixing ratio of surface water and deep water was designed to be 3:1 by means of ecotoxicological assessment on the DCG operating characteristics. To select the appropriate operating hours for DCG, DCG was operated by 12 hr, 24 hr, 36 hr and 48 hr. As its result, the formation of thermocline did not occur during the operation of 36 hr. Also, It was effected that start reoperating from 3rd day after stop 2days under the condition of operated during 36 hr with calculated power consumption. Under the above conditions, the results of DO and water temperature analysis during the operation of DCG showed that the stratification, which was distinct previously, appeared to be weak, and relatively lower levels than those before operation were found as a result of water quality analysis on COD and chlorophyll-a, which leads to the conclusion that the water body is maintained at a stable condition due to the circulation of water by the occurrence of density current resulting from the operation of DCG.