• Journal of the Korean GEO-environmental Society
• /
• v.21 no.1
• /
• pp.13-19
• /
• 2020

Recently, as the number of earthquakes increases in the Korean Peninsula and surrounding area, the importance of earthquake countermeasures and seismic design has been increasing. As a result, interest and concerns about liquefaction, which is one of the problems that concern the earthquake, are increasing. There are various methods that can assess the possibility of liquefaction by using geotechnical information for specific ground. However, direct comparisons of each method are not yet available. In this study, the two methods using the SPT-N value and the shear wave velocity among the methods for estimating the Cyclic Resistance Ratio (CRR) value required for the simplified liquefaction assessment method were compared. And the correction of the ground information required to use the two methods respectively was compared. As a result, more accurate evaluation results were obtained when the CRR value is calculated using the SPT-N values.

• Journal of computational fluids engineering
• /
• v.19 no.4
• /
• pp.52-60
• /
• 2014

Recently, coastal structures have been built to protect coastal areas. However, if a tidal wave caused by an earthquake hits the coast, it would cause catastrophic damages. It is important to analyze the basics and the characteristics of a tsunami to reduce damages caused by natural disasters. In this study, a tsunami passing over different topographical changes is simulated with VOF method based on FVM(Finite Volume Method). The reduction of both scale and velocity is accomplished by similarity analysis, and an initial energy is generated by increasing the water level as needed to create a tsunami as if it is caused by a crustal movement. It is found that the present method is appropriate to simulate the tsunami with its mechanism.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.7 s.100
• /
• pp.806-812
• /
• 2005

This paper adresses the shaking table tests with 1/100 scaled model followed similitude law for OOdam main designing section to understand nonlinear behavior characteristics of concrete dam body by ground motion. As earthquake wave, Hachinohe and El Centre waves were used and acceleration and displacements are measured to analyze behaviors of dam body. For maximum ground acceleration range $(0.3\~0.9 g)$, the results showed linear behavior regardless of maximum 9round acceleration and secured safety of structure. To analyze the behavior of dam after tension cracking, 3 cm-notch was placed at the critical section of over-flowing section. As results of applying Hachinohe wave(0.8 g), Even though tension cracks were formed at over-flowing section by Hachinohe wave(0.8 g), it showed that the dam is stable for supporting upper stream Part of water tank of dam.

• Journal of Korean Society of Steel Construction
• /
• v.8 no.3 s.28
• /
• pp.97-105
• /
• 1996

A Stochastic line source model is developed to simulate the seismic wave field generated during the rupture propagation process along a fault plane of which length is much larger than its width. The fault plane is assumed to consist of randomly distributed slip zones and barriers and each slip zone is modeled as a point source. By combining the newly developed source model with wave propagation analysis method in a layered 3-D visco-elastic half space, synthetic seismograms are obtained. The calculated accelerograms due to vertical dip slip and strike slip line sources are presented.

• Earthquakes and Structures
• /
• v.3 no.3_4
• /
• pp.383-411
• /
• 2012

The objective of the present paper is to review and implement the most recent developments in the Spectral Element Method (SEM), as well as improve aspects of its implementation in the study of wave propagation by numerical simulation in elastic unbounded domains. The classical formulation of the method is reviewed, and the construction of the mass matrix, stiffness matrix and the external force vector is expressed in terms of matrix operations that are familiar to earthquake engineers. To account for the radiation condition at the external boundaries of the domain, a new absorbing boundary condition, based on the Perfectly Matched Layer (PML) is proposed and implemented. The new formulation, referred to as the Multi-Axial Perfectly Matched Layer (M-PML), results from generalizing the classical Perfectly Matched Layer to a medium in which damping profiles are specified in more than one direction.

• Earthquakes and Structures
• /
• v.12 no.6
• /
• pp.619-628
• /
• 2017

The intent of this paper is to investigate the propagation of Love waves in a dry sandy medium sandwiched between fiber-reinforced layer and prestressed porous half-space. Separate displacement components have been deduced in order to characterize the dynamics of individual materials. Using suitable boundary conditions, the frequency equation has been derived by means of separation of variables which reveals the significant role of reinforcement parameters, sandiness, thickness of layers, porosity and prestress on the wave propagation. The phase velocity of the Love wave has been discussed in accordance with its typical cases. In both cases when fiber-reinforced and dry sandy media are absent, the derived equation of Love type wave coincides with the classical Love wave equation. Numerical computations have been performed in order to graphically illustrate the dependencies of different parameters on phase velocity of Love waves. It is observed that the phase velocity decreases with the increase of parameters pertaining to reinforcement and prestress. The results have certain potential applications in earthquake seismology and civil engineering.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.8 no.6
• /
• pp.73-79
• /
• 2008

Economic growth, industrialization and urbanization have made society more vulnerable than ever to seismic hazard in Korea. Although Korea has not experienced severe damage due to earthquakes during the last few decades, there is little doubt of the potential for large earthquakes in Korea as documented in the historical literature. As we see no immediate promise of short-term earthquake prediction with current science and technology, earthquake early warning systems attract more and more attention as a practical measure to mitigate damage from earthquakes. Earthquake early warning systems provide a few seconds to tens of seconds of warning time before the onset of strong ground shaking. To achieve rapid earthquake location, we propose to take full advantage of information from existing seismic networks; by using P wave arrival times at two nearest stations from the earthquake hypocenter and also information that P waves have not yet arrived at other stations. Ten earthquakes in the Korean peninsula and its vicinity are selected for the feasibility study. We observed that location results are not reliable when earthquakes occur outside of the seismic network. Earthquakes inside the seismic network, however, can be located very rapidly for the purpose of earthquake early warning. Seoul metropolitan area may secure $10{\sim}50$ seconds of warning time before any strong shaking starts for certain events. Carefully orchestrated actions during the given warning time should be able to reduce hazard and mitigate damages due to potentially disastrous earthquakes.

• Geophysics and Geophysical Exploration
• /
• v.12 no.2
• /
• pp.183-191
• /
• 2009

Finite difference method using not general SSG (standard staggered grid) but RSG (rotated staggered grid) was applied to simulation of elastic wave propagation. Special free surface boundary condition such as imaging method is needed in finite difference method using SSG in elastic wave propagation. But free surface boundary condition in finite difference method using RSG is easily solved with adding air layer or vacuum layer. Recently PML (Perfectly Matched layer) is widely used to eliminate artificial reflection waves from finite boundary because of its' greate efficiency. Absorbing ability of CPML (convolutional Perfectly Matched Layer) that is more efficient than that of PML and CPML that don't use splitting of wave equation that should be adapted to PML was applied to FDM using RSG in this study. Frequency absorbing characteristic and energy absorbing ability in CPML layer were investigated and CPML eliminated artificial boundary waves very effectively in FDM using RSG in being compared with that of Cerjan's absorbing method. CPML method also diminished amplitude of waves in boundary layer of solid-liquid model very well.

• Journal of the Korean Geosynthetics Society
• /
• v.10 no.4
• /
• pp.49-59
• /
• 2011

In order to understand evaluation of the seismic stability of a reinforced earth retaining, we made chambers of 1:10 (the ratio of the miniature), considering the law of similarity based on drawings of representative cross sections. And we measured an increase in acceleration, earth pressure, and displacement after applying Hachinohe wave (long period), Ofunato wave (short period), and artificial wave, complying with the domestic standards, in order to evaluate the external stability of the reinforced earth retaining wall during earthquake based on the measurements. As a result, the unreinforced earth retaining wall collapsed at 2 g of seismic acceleration. But the reinforced earth retaining wall was evaluated to ensure proper stability as well, with respect to the earth pressure gauge, the increments of earth pressure tend to be raised significantly in the upper than the lower and showed a similar characteristic of behavior in previous theory.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.19 no.1
• /
• pp.37-43
• /
• 2015

This paper presents a detailed procedure for a nonlinear soil-structure interaction of a seismically isolated NPP(Nuclear Power Plant) structure using the boundary reaction method (BRM). The BRM offers a two-step method as follows: (1) the calculation of boundary reaction forces in the frequency domain on an interface of linear and nonlinear regions, (2) solving the wave radiation problem subjected to the boundary reaction forces in the time domain. For the purpose of calculating the boundary reaction forces at the base of the isolator, the KIESSI-3D program is employed in this study to solve soil-foundation interaction problem subjected to vertically incident seismic waves. Wave radiation analysis is also employed, in which the nonlinear structure and the linear soil region are modeled by finite elements and energy absorbing elements on the outer model boundary using a general purpose nonlinear FE program. In this study, the MIDAS/Civil program is employed for modeling the wave radiation problem. In order to absorb the outgoing elastic waves to the unbounded soil region, spring and viscous-damper elements are used at the outer FE boundary. The BRM technique utilizing KIESSI-3D and MIDAS/Civil programs is verified using a linear soil-structure analysis problem. Finally the method is applied to nonlinear seismic analysis of a base-isolated NPP structure. The results show that BRM can effectively be applied to nonlinear soil-structure interaction problems.