• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2003년도 봄 학술발표회 논문집
• /
• pp.277-280
• /
• 2003

Material, mix proportion, curing condition, temperature, humidity and wind velocity have an influence on drying shrinkage of concrete. In this paper, to evaluate the effect of curing condition at early age on the drying shrinkage of concrete was investigated varying curing age for different binder. The principal conclusions from this research were as follows: 1) In case of 14 days of water curing, the drying shrinkage of concrete is smaller than 7 days of water curing, independence of type of binder. 2) In case of 4 days of water curing, the ratio of increase of drying shrinkage of concrete using fly-ash and slag powder is more remarkable than using portland cement alone, comparing the drying shrinkage of 7 days of water curing.

• International Journal of Concrete Structures and Materials
• /
• 제7권1호
• /
• pp.79-93
• /
• 2013

One of the biggest problems affecting bridges is the transverse cracking and deterioration of concrete bridge decks. The causes of early age cracking are primarily attributed to plastic shrinkage, temperature effects, autogenous shrinkage, and drying shrinkage. The cracks can be influenced by material characteristics, casting sequence, formwork, climate conditions, geometry, and time dependent factors. The cracking of bridge decks not only creates unsightly aesthetic condition but also greatly reduces durability. It leads to a loss of functionality, loss of stiffness, and ultimately loss of structural safety. This investigation consists of field, laboratory, and analytical phases. The experimental and field testing investigate the early age transverse cracking of bridge decks and evaluate the use of sealant materials. The research identifies suitable materials, for crack sealing, with an ability to span cracks of various widths and to achieve performance criteria such as penetration depth, bond strength, and elongation. This paper also analytically examines the effect of a wide range of parameters on the development of cracking such as the number of spans, the span length, girder spacing, deck thickness, concrete compressive strength, dead load, hydration, temperature, shrinkage, and creep. The importance of each parameter is identified and then evaluated. Also, the AASHTO Standard Specification limits liveload deflections to L/800 for ordinary bridges and L/1000 for bridges in urban areas that are subject to pedestrian use. The deflection is found to be an important parameter to affect cracking. A set of recommendations to limit the transverse deck cracks in bridge decks is also presented.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2008년도 추계 학술발표회 제20권2호
• /
• pp.493-496
• /
• 2008

합성형교량의 바닥판 횡방향균열은 재료, 설계, 시공 등 다양한 요인에 의하여 영향을 받으며, 초기재령 콘크리트 바닥판 균열에 영향을 미치는 주요인자는 온도 및 수축변형에 기인한 것으로 알려져있다. 온도의 영향은 수화열과 복사열에 모두 영향을 받으며 일반적으로 보통강도콘크리트가 사용되는 바닥판은 건조수축, 고강도콘크리트 바닥판은 자기수축의 영향을 주로 받게 된다. 합성형교량을 범용 유한 요소 구조 해석 프로그램을 이용하여 수화열 및 복사열에 의한 온도응력, 자기 및 건조수축응력 해석을 수행하고, 이를 통하여 합성형교량 바닥판 콘크리트에서 발생한 균열의 원인을 규명하고자 한다. 균열 원인 분석으로 도출된 결과를 토대로 변수해석(parametric study)을 수행하여 향후 시공되는구조물의 균열제어대책을 제시하고자 한다.

• 대한토목학회논문집
• /
• 제32권5A호
• /
• pp.307-315
• /
• 2012

최근 국내에서도 압축강도 180 MPa, 인장강도 10 MPa 이상의 초고성능 섬유보강 콘크리트(Ultra High Performance Fiber Reinforced Concrete, UHPFRC)가 개발되었다. 그러나 UHPFRC는 물-결합재비가 낮고 다량의 고분말 혼화재료를 혼입하며, 굵은 골재를 사용하지 않기 때문에 초기 재령에서의 자기수축이 크고, 표면이 급격히 건조하는 등 기존의 일반 콘크리트(Normal Concrete, NC) 및 고성능 콘크리트(High Performance Concrete, HPC)와는 다른 재료적 특성을 보인다. 그러므로 본 연구에서는 UHPFRC에 적합한 재료 실험 방법과 규정을 제안하고 극 초기 재령에서의 강도 특성을 평가하기 위하여 응결 및 수축, 인장 실험을 수행하였다. 응결 실험 결과 파라핀 오일을 UHPFRC의 모르타르 표면에 적용할 경우 표면에서의 급격한 건조현상을 효율적으로 억제할 수 있는 것으로 나타났으며, 시멘트와 배합수의 수화반응을 지연 또는 촉진 시키지 않는 것으로 나타나 응결 실험 시 표면건조 방지제로 적합한 것으로 판단되었다. 또한, 링-테스트를 수행하여 내부 강재 링의 온도와 변형률의 경향이 달라지는 시점을 수축 응력 발현 시점으로 정의하였으며, 이를 응결 실험과 비교하여 본 결과 응결침에 걸리는 관입 저항력이 약 1.5 MPa일 때 수축 응력이 발현되는 것으로 나타났다. 이는 초결 및 종결보다 약 0.6시간, 2.1시간 빠른 것이며, 상기 시점을 UHPFRC의 자기수축 측정 시점(time-zero)으로 규정하였다. 마지막으로, 본 연구에서는 극 초기 재령 인장강도 측정 장비를 제작하여 초결시점에서부터 UHPFRC의 인장강도와 탄성계수를 측정하였으며, 이를 고려한 UHPFRC의 인장강도 및 탄성계수 예측식을 제안하였다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.61-64
• /
• 2006

Comparing with traditional high performance concrete, ultra high performance concrete (UHPC) has the property of high-tenacity. However, drying shrinkage and autogenous shrinkage can be arisen as the major defect to UHPC. In this study, therefore, it was tested to reduce drying shrinkage and autogeneous shrinkage by adding expanding admixture (EA) and shrinkage reducing agent (SRA). As a result, for a case drying shrinkage, the shrinkage was decreased by 94% when EA was exchanged, and it was decreased by 64% when SRA was added. For the case of autogenous shrinkage, the mortar was expanded at early age and the shrinkage was decreased by 87% when EA was exchanged, and the shrinkage was decreased by 70% when SRA was added.

• 한국건축시공학회지
• /
• 제3권3호
• /
• pp.121-126
• /
• 2003

This study investigated about several mix factors came up to drying shrinkage and carbonation of high flowing concrete using viscosity. The results are as follows; Drying shrinkage ratio of high flowing concrete using viscosity showed higher for early age, but lower than normal concrete as long age. Also, drying shrinkage ratio and reduction ratio of mass showed higher and relative dynamic modulus of elasticty showed lower as W/C was higher generally. And in case of high flowing concrete using viscosity, carbonation wasn't confirmed without the kinds of cement and viscosity except 50C.

• 한국구조물진단유지관리공학회 논문집
• /
• 제13권3호통권55호
• /
• pp.188-196
• /
• 2009

콘크리트는 초기재령에 있어서 수분의 증발 및 이동으로 소성 및 건조수축 등의 수축현상이 발생한 다. 국내에서는 아령형 구속건조수축몰드를 활용한 콘크리트의 건조수축 균열 평가방법을 KS에서 규격화하여 활용하고 있으나 이는 균열발생시점 및 구속수축응력을 평가하는 방법으로 균열발생량에 관한 정량적 평가는 어려운 실정이다. 이에 본 연구에서는 콘크리트의 수축변형거동 및 균열발생량에 대한 정량적 데이터를 확보하기 위하여 판상-링형 구속시험방법을 개발하고 시험체 치수가 콘크리트의 수축균열에 미치는 영향을 검토하여 판상-링형 구속시험방법의 최적 시험체 치수 도출 및 수축균열특성에 관한 정량적 평가방법을 제안하고 그 적용성을 검증하고자 한다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2010년도 춘계 학술대회 제22권1호
• /
• pp.465-466
• /
• 2010

In this paper, an integrated system is proposed which can evaluate both the early-age properties and durability performance of concrete structures. This integrated system starts with a hydration model which considers both Portland cement hydration and chemical reactions of supplementary cementing materials (SCM). Based on the degree of hydration of cement and mineral admixtures, the amount of reaction products, the early age heat evolution, chemically bound water, porosity, the early age short-term mechanical behaviors, shrinkage and early-age creep are evaluated as a function of curing age and curing conditions. Furthermore, the durability aspect, such as carbonation of blended concrete and chloride attack, are evaluated considering both the material properties and surrounding environments. The prediction results are verified through experimental results.

• Structural Monitoring and Maintenance
• /
• 제10권2호
• /
• pp.155-174
• /
• 2023

High performance concrete (HPC) has been extensively used in thin overlay for repair purpose due to its excellent strength and durability. This paper presents an experiment, where the sensor-instrumented HPC overlays have been followed by dynamic strain and moisture content monitoring for 1 year, under normal traffic. The vibrating wire and soil moisture sensors were embedded in overlay before construction. Four given HPC mixes (2 original mixes and their shrinkage-modified mixes) were used for overlays to contrast the strain and moisture results. A calibration method to accurately measure the moisture content for a given concrete mixture using soil moisture sensor was established. The monitoring results indicated that the modified mixes performed much better than the original mixes in shrinkage cracking control. Weather condition and concrete maturity at early age greatly affected the strain in concrete. The strain in HPC overlay was primarily in longitudinal direction, leading to transverse cracks. Additionally, the most moisture loss in concrete occurred at early age. Its rate was very dependent on weather. After one year, cracking survey was carried out by vision to verify the strain direction and no cracks observed in shrinkage modified mixes.

• 한국재료학회지
• /
• 제23권12호
• /
• pp.687-694
• /
• 2013

This study was performed with an aim to improve the early-age strength of concrete containing fly ash, which is known to increase the long-age strength of concrete, reduce drying shrinkage, and enhance water tightness. The composition was partially substituted with calcium sulfoaluminate (CSA), from which ettringite is actively produced, in the early stages of hydration to verify its effect on improving the early-age strength and to determine the optimal mixing ratio. For this purpose, up to 30 % of the cement weight was substituted with fly ash, and the amount of CSA substitution was 8% of the fly ash weight. The mixtures were then fabricated into concrete specimens for compressive strength measurement and analysis of the correlation between the hydration products and the compressive strength.