• 분석과학
• /
• 제10권3호
• /
• pp.187-195
• /
• 1997

[16]-ane-$S_4$/탄소분말 함량비를 50%로 하여 nujol oil과 혼합하여 수식전극을 제조하였다. $5.0{\times}10^{-4}M$ $Ag^+$를 포함하는 pH 4.5인 아세트 완충용액에 수식전극을 담가 $Ag^+$를 전극 표면에 흡착시켰다. 이 때 흡착시간을 15분으로 하고 전해환원시키는 시간은 -0.3V vs S.C.E에서 2분으로 하였다. 또한 0.1M $HNO_3$ 용액으로 전극을 활성화시켰으며 한번 활성화한 전극은 10회까지 사용이 가능하였다. 최적 분석조건에서 미분펄스 전압전류법으로 $5.0{\times}10^{-7}{\sim}1.5{\times}10^{-6}M$ 사이의 농도 범위에서 정량해 보았을 때 직선성이 잘 성립하였으며, 검출한계는 $2.0{\times}10^{-7}M$이었다. 대부분의 금속들은 방해를 주지 않았으나, Cu(II)은 방해를 나타내었다.

• 설비공학논문집
• /
• 제21권10호
• /
• pp.583-589
• /
• 2009

Activated carbon has long been used in purification processes for indoor air quality. However, the bioaerosol removal by activated carbon is not often sufficient to be used in an air control devise. In order to overcome these problems, silver nano-particles have been proposed as an antibacterial agent on the surface of activated carbon. Silver or silver ions have been known for antimicrobial activities. In this study, bioaerosol generated by using an Escherichia coli culture was introduced to a lab-scale column packed with activated carbon (AC) and silver nano-particles attached to activated carbon (Ag-AC). E. coli was almost completely removed in the Ag-AC column, whereas bioaerosol penetrated through the AC column. To determine the antibacterial effect of different filter materials in a full-scale air-handling system, another experiment was conducted using a wind tunnel equipped with a heat exchanger and three filter materials including commercial fabric, AC and Ag-AC. It was found that E. coli proliferated on the surface of the heat exchanger after 5 days, which dramatically increased bioaerosol counts in the effluent air stream. The fabric filter could not control the increased bioaerosol and most of the E. coli penetrated the filter. The bacterial removal efficiency was found to be approximately 45% in the AC filter, while the antibacterial efficiency increased to 70% using the Ag-AC filter. Consequently, the Ag-AC filter can be an effective method to control bioaerosol and improve indoor air quality.

• Corrosion Science and Technology
• /
• 제20권5호
• /
• pp.289-294
• /
• 2021

In this study, after measuring polarization characteristics of 97.3 wt% Ag, Au-Coated 97.3 wt% Ag (ACA) and 100 wt% Au wires in 1 wt% H₂SO₄ and 1 wt% HCl electrolytes at 25 ℃, corrosion rate and corrosion characteristics were comparatively analyzed. Comparing corrosion potential (E_CORR) values in sulfuric acid solution, ACA wire had more than six times higher E_CORR value than Au wire. Thus, it seems possible to use a broad applied voltage range of bonding wire for semiconductor packaging which ACA wire could be substituted for the Au wire. However, since the E_CORR value of ACA wire was three times lower than that of the Au wire in a hydrochloric acid solution, it was judged that the use range of the applied voltage and current of the bonding wire should be considered. In hydrochloric acid solution, 97.3 wt% Ag wire showed the highest corrosion rate, while ACA and Au showed similar corrosion rates. Additionally, in the case of sulfuric acid solution, all three types showed lower corrosion rates than those under the hydrochloric acid solution environment. The corrosion rate was higher in the order of 97.3 wt% Ag > ACA > 100 wt% Au wires.

• 한국분말재료학회지
• /
• 제8권3호
• /
• pp.192-196
• /
• 2001

Ag doped Hydroxyapatite powder in nano-scale was successfully synthesized either by co-precipitation or by ion exchange route. The fabricated powder was successfully dispersed through freeze drying due to the prevention of secondary particles. The antimicrobial effects of nano-HAp against E.coli was superior to micron ones not only in its strength but also in duration.

• 대한환경공학회지
• /
• 제27권5호
• /
• pp.549-554
• /
• 2005

골격 구조를 가진 다공성 세라믹 비드에 질산은 용액을 이용하여 Ag를 담지 하였으며, Ag 담지된 비드의 대장균, 포도상구균에 대한 항균 특성을 평가하였다. 또한, 상용화된 Ag-활성탄과 항균 특성에 대해 비교실험도 진행하였다. 질산은 용액의 농도가 높을수록, 비드의 내 외부 표면의 Ag 함량이 증가하였으며, 담지된 Ag 입자의 크기는 $0.5{\sim}2.0\;{\mu}m$ 범위로 나타났다. Ag 담지된 비드의 항균 특성은 다음과 같이 관찰되었다 : i) 질산은 용액 농도 및 반응시간이 증가할수록 높은 활성을 나타내었다. ii) 포도상구균에 비해 대장균의 경우 더 좋은 제거율을 나타내었다.

• Current Photovoltaic Research
• /
• 제3권1호
• /
• pp.16-20
• /
• 2015

Ag addition in chalcopyrite materials is known to lead beneficial changes in aspects of structural and electronic properties. In this work, the effects of Ag alloying of $Cu(In,Ga)Se_2$-based solar cells has been investigated. Wide bandgap $(Ag,Cu)(In_{1-x},Ga_x)Se_2$ (x = 0.75~0.8) films have been deposited using a three-stage co-evaporation with various Ag/(Ag+Cu) ratios. With Ag alloying the $(Ag,Cu)(In_{1-x},Ga_x)Se_2$ (x~0.8) films were found to have greater grainsize and film thickness. Device were also fabricated with the $(Ag,Cu)(In_{1-x},Ga_x)Se_2$ (x~0.8) films and their J-V and quantum efficiency measurements were carried out. The highest-efficiency $(Ag,Cu)(In_{1-x},Ga_x)Se_2$ solar cell with Eg > 1.5 eV had an efficiency of 12.2% with device parameters $V_{OC}=0.810V$, $J_{SC}=21.7mA/cm^2$, and FF = 69.0%.

• 한국재료학회지
• /
• 제10권12호
• /
• pp.853-863
• /
• 2000

Cu 칩의 Cu 패드 위에 솔더 플립칩 공정에 응용하기 위한 무전해 구리/니켈 UBM (Under Bump Metallurgy) 층을 형성하고 그 특성을 조사하였다. Sn-36Pb-2Ag 솔더 범프와 무전해 구리 및 무전해 니켈 충의 사이의 계면 반응을 이해하고, UBM의 종류와 두계에 따른 솔더 범프 접합(joint) 강도 특성의 변화를 살펴보았다. UBM의 종류에 따른 계면 미세 구조, 특히 금속간 화합물 상 및 형태가 솔더 접합 강도에 크게 영향을 미치는 것을 확인하였다. 무전해 구리 UBM의 경우에는 솔더와의 계면에서 연속적인 조가비 모양의 Cu$_{6}$Sn$_{5}$상이 빠르게 형성되어 파단이 이 계면에서 발생하여 낮은 범프 접합 강도 값을 나타내었다. 무전해 니켈/무전해 구리 UBM에서는 금속간 화합물 성장이 느리고, 비정질로 도금되는 무전해 Ni의 륵성으로 인해 금속간 화합물과의 결정학적 불일치가 커져 다각형의 Ni$_3$Sn$_4$상이 형성되어 무전해 구리 UBM의 경우에 비해 범프 접합 강도가 높게 나타났다. 따라서 무전해 도금을 이용하여 Cu 칩의 Cu pad 위에 솔더 플립칩 공정에 응용하기 위한 UBM 제작시 무전해 니켈/무전해 구리 UBM을 선택하는 것이 접합 강도 측면에서 유리하다는 것을 확인하였다.다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 추계학술대회 논문집
• /
• pp.46-46
• /
• 2009

The photoconductive $AgGaSe_2$(AGS) layers were grown by the hot wall epitaxy method. The AGS layer was confirmed to be the epitaxially grown layer along the <112> direction onto the GaAs(100) substrate. The band-gap variation as a function of temperature on AGS was well fitted by $E_8(T)=1.9501-8.37{\times}10^{-4}T^2/(T+224)$. The band-gap energy of AGS obtained at 293 K was determined to be 1.8111 eV.

• 한국전기전자재료학회논문지
• /
• 제26권4호
• /
• pp.321-324
• /
• 2013

In this study, The RF magnetron sputter and evaporator was on glass substrates 30 mm ${\times}$ 30 mm OMO multilayer thin film structure is applied to the low-e. Structural and optical properties, a thin film was produced, the variable was placed into a variable deposition time of the oxide layer. According to the XRD measurement results there is no peak that satisfies the Bragg's law ($2dsin{\theta}=n{\lambda}$) which confirmed that it is an amorphous structure. RMS value of the results of the AFM measurement, has a roughness of less than 2 nm. transmittance measurements results, visible light region an average 80%, IR region 40% showed.

• 한국포장학회:학술대회논문집
• /
• 한국포장학회 2006년도 정기총회 및 추계학술발표대회
• /
• pp.54-73
• /
• 2006

Four different types of chitosan-based nanocomposite films were prepared using a solvent casting method by incorporating with four types of nanoparticles, i.e., an unmodified montmorillonite (Na-MMT), an organically modified montmorillonite (Cloisite 30B), a Nano-silver, and a Ag-zeolite (Ag-Ion). X-ray diffraction patterns of the nanocomposite films indicated that a certain degree of intercalation was formed in the nanocomposite films, with the highest intercalation in the Na-MMT-incorporated films followed by films with Cloisite 30B and Ag-Ion. SEM micrographs showed that in all the nanocomposite films, except the Nanosilver-incorporated one, nanoparticles were dispersed homogeneously throughout the chitosan polymer matrix. Consequently, mechanical and barrier properties of chitosan films were affected through intercalation of nanoparticles, i.e., tensile strength (TS) increased by 7-16%, while water vapor permeability (WVP) decreased by 25-30% depending on the nanoparticle material tested. In addition, chitosan-based nanocomposite films, especially silver-containing ones, showed a promising range of antimicrobial activity.