• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.03a
• /
• pp.486-493
• /
• 2006

This paper deals with the procedure and the results on the dynamic loading tests of two large diameter - long drilled shafts (diameter=2.0m, length=75m) which were embedded into weathered rocks through thick soft marine clays and sandy gravels. Prior to the real dynamic loading test, the numerical simulation for the test procedure was performed to check the structural stability of the main pile body using equivalent static elastic analysis and the application of the hammer system using WEAP (Wave Equation Analysis of Pile Driving). Through these preliminary analyses the dynamic loading tests on large diameter - long drilled shafts have been successfully achieved.

• Journal of the Korean Society of Safety
• /
• v.14 no.4
• /
• pp.148-157
• /
• 1999

Dynamic structural behavior in long span bridges, especially cable structures, is very sophisticated due to their flexibility and structural members are sequentially erected in each construction step. In this study, the consistent mass matrix for dynamic analysis is formulated and computational program considering construction sequences is developed where structural members can be builded or removed by command language and automatically reanalyzed in the moment when structural system is changed. The dynamic analysis, i.e. eigenvalue and time series analysis and the geometrically nonlinear analysis considering construction sequence are conducted to the Namhae Bridge. The analytical results are satisfactory compared with measuring values and the developed computational program can successfully be applied to design and safety check.

• Journal of Drive and Control
• /
• v.20 no.4
• /
• pp.9-16
• /
• 2023

This paper analyzed a drainage tower used to drain water in flooded areas. Multi-body dynamics simulation was used to analyze the dynamic behavior of the drainage tower. Structural analysis, flexible-body dynamic analysis, and rigid body dynamic analysis were done to study the maximum Von-Mises stress of the drainage tower. The results showed that the maximum Von-Mises stress occurs at the turn table, and it decreases when the angle of the boom is increased. Also, the rate of the change of angle affects the maximum stress so that the maximum stress changes more when the angular velocity of the boom increases. Based on the rigid body dynamic analysis and the theoretical analysis results, the centrifugal force from the angular velocity makes the difference in the maximum stress at the turn table because of the difference in their direction. Consequently, it was concluded that the centrifugal force should be considered when designing construction machinerythat can rotate.

• Computers and Concrete
• /
• v.17 no.4
• /
• pp.455-475
• /
• 2016

Dynamic characteristics, named as natural frequencies, damping ratios and mode shapes, affect the dynamic behavior of buildings and they vary depending on the construction stages. It is aimed to present the effects of construction stages on the dynamic characteristics of reinforced concrete (RC) buildings considering theoretical and experimental investigations. For this purpose, a three-storey RC building model with a 1/2 scale was constructed in the laboratory of Civil Engineering Department at Karadeniz Technical University. The modal testing measurements were performed by using Operational Modal Analysis (OMA) method for the bare frame, brick walled and coated cases of the building model. Randomly generated loads by impact hammer were used to vibrate the building model; the responses were measured by uni-axial seismic accelerometers as acceleration. The building's modal parameters at these construction stages were extracted from the processed signals using the Enhanced Frequency Domain Decomposition (EFDD) technique. Also, the finite element models of each case were developed and modal analyses were performed. It was observed from the experimental and theoretical investigations that the natural frequencies of the building model varied depending on the construction stages considerably.

• Earthquakes and Structures
• /
• v.23 no.4
• /
• pp.353-361
• /
• 2022

The dynamic behavior of a single pile was investigated by using analytical and numerical studies. The focus of this study was to develop the dynamic p-y curve of a pile for pseudo-static analysis considering the shear wave velocity of the soil by using three-dimensional numerical analyses. Numerical analyses were conducted for a single pile in dry sand under changing conditions such as the shear wave velocity of the soil and the acceleration amplitudes. The proposed dynamic p-y curve is a shape of hyperbolic function that was developed to take into account the influence of the shear wave velocity of soil. The applicability of pseudo-static analysis using the proposed dynamic p-y curve shows good agreement with the general trends observed by dynamic analysis. Therefore, the proposed dynamic p-y curve represents practical improvements for the seismic design of piles.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.09a
• /
• pp.967-975
• /
• 2009

In order to control differential settlement and to secure the safety of super structure on a high rock embankment the designed static compaction is changed with dynamic compaction and piled raft method. The parameters for dynamic compaction design are obtained from a pilot test. In addition, numerical analyses are also carried out to figure out the length and quantity of piled raft that can restraint the differential settlement within allowance range.

• The KSFM Journal of Fluid Machinery
• /
• v.17 no.4
• /
• pp.70-75
• /
• 2014

In this paper a analysis method is presented to obtain the steady state dynamic response from the finite element based equations of a rotor-bearing system with initial deflection. The method has been applied to analyze the dynamic response of the two-shaft rotor-bearing system with rigid coupling offset in a heavy duty gas turbine-generator. Bumps in the dynamic response of each rotor system have been observed at each critical speed due to the effect of initial deflection for rigid coupling offset. And, the dynamic responses have been shown to reduce for operating condition changes from cold to hot.

• Structural Engineering and Mechanics
• /
• v.8 no.5
• /
• pp.477-490
• /
• 1999

The uncertainties associated with structural parameters and dynamic loading are identified and discussed. Structural parametric uncertainties are treated as random variables and dynamic wind load is simulated as a random process. Dynamic wind-induced responses of structures with parametric uncertainties are investigated by using stochastic finite element method. The formulas for structural dynamic reliability analysis considering the randomness of structural resistance and loading are proposed. Two numerical examples of high-rise structures are presented to illustrate the proposed methodology. The calculated results demonstrate that the variation in structural parameters indeed influences the dynamic response and the first passage probability evaluation of structures.

• Transactions of the Korean hydrogen and new energy society
• /
• v.28 no.1
• /
• pp.47-55
• /
• 2017

This paper deals with the after-tax economic feasibility analysis of the hydrogen fueling station considering dynamic utilization. We selected an off-site hydrogen station in which the hydrogen is supplied by a central by-product hydrogen plant as a case study. Also, we made some sensitivity analysis by changing input factors such as the discount rate, the hydrogen station construction cost, the hydrogen demand and the hydrogen sale price. As a result, the hydrogen station will not be economical in 2020 due to the relatively high price of the hydrogen station construction cost and the low price of hydrogen sale price. In order to realize the economic feasibility of the hydrogen station in the early stage of the hydrogen economy, the subsidies on the annual operating cost as well as the construction cost are needed.

• Korean Journal of Construction Engineering and Management
• /
• v.20 no.1
• /
• pp.124-132
• /
• 2019

Notwithstanding the crucial contribution of international construction industry in the national economy, previous studies on international construction contracts had mainly focused either on trend investigation or market share analysis at a point of time. Fundamentally, the international construction industry is fragmented due to its project-based nature, is heterogeneous that has to involve different firms from diverse fields, and tends to be dynamic according to macroeconomic conditions. Therefore, the combination of static and dynamic analyses is necessary to understand its underlying structure. This study analyzes the market structure of international construction contracts using the data of 9,173 projects awarded by Korean construction firms from 2000 to 2017. Industry-level performance data is analyzed both in static (market concentration) and dynamic (market mobility and instability) methods, and detailed methodology is also provided. Consequently, the static analysis result shows that the competition among Korean construction firms has been more intensified, and the dynamic analysis result indicates that market positions of Korean construction firms are unstable and vulnerable in most of the regions and the sectors. The combination of static and dynamic indices is found to be helpful to understand the underlying aspects of market structure and can be utilized as an effective strategic reference in the highly competitive market.