• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 하계종합학술대회 논문집(4)
• /
• pp.98-101
• /
• 2000

On CELP type Vocoders G.723.1 6.3kbps/5.3kbps Dual Rate Speech Codec, which is developed for Internet Phone and videoconferencing, uses VAD(Voice Activity Detection)/CNG (Comfort Noise Generator) in order to reduce the bit rate in a silence period. In order to reduce the bit rate effectively in this paper, we first set the boundary condition of the energy threshold to prevent the consumption of unnecessary processing time, and use three decision rules to detect an active frame by energy, pitch gain and LSP distance. To evaluate the performance of the proposed algorithm we use silence-inserted speech data with 0, 5, 10, 20dB of SNR. As a result when SNR is over 5dB, the bit rate is reduced up to about 40% without speech degradation and the processing time is additionally decreased.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1993년도 추계학술대회 논문집
• /
• pp.656-659
• /
• 1993

The failure phenomenon of Dual Basalt Fibers Reinforced Epoxy Composites(DFC) under tensile load was studied using acoustic emission(AE) technique. AE amplitude and AE energy were mainly associated with the internal microscopic failure mechanism of DFC specimen, such as fiber fracture, matrix cracking, and fiber/matrix debonding. Fiber failures in the DFC specimens were distinguishable by showing the highest AE energy amplitude. They were dependant on the fiber diameters. Matrix cracking was determined from the relatively lower AE amplitude and AE energy, whereas fiber/matrix debonding could not be successfully isolated. AE method, however, can be applicable to the fragmentation method for interfacial strength(IFSS) in DFC specimens with adjusting the threshold to isolate fiber breaks from matrix crack and debonding.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계학술발표회 논문집(I)
• /
• pp.438-441
• /
• 2006

Since the behavior of structural members subjected to blast load shows different responses, the effect of impulse as well as peak load should be considered in the damage analysis. The threshold on P-I diagram that causes specific damage level divides the diagram into the failure zone and the non-failure zones. In this study, numerical analysis is performed based on single-degree-of-freedom (SDOF) techniques to generate rational P-I diagram considering material non-linearity and dual failure modes (flexure and direct shear) of RC beams. From the comparison with existing test results it is concluded that proposed numerical method is good to derive failure mode of RC beam under blast load.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 추계종합학술대회 논문집
• /
• pp.191-194
• /
• 1999

Switching behaviour of the ferroelectric thin film and device characteristics of the MFSFET (Metal-Ferroelectric-Semiconductor FET) are simulated with taking into account the accumulation of oxygen vacancies near interface between the ferroelectric thin film and the bottom electrode caused by the progress of fatigue. We show net switching current decreases due fatigue in the switching model. It indicates that oxygen vacancy strongly suppresses polarization reversal. The difference of saturation drain current of the device before fatigue is shown by the dual threshold voltages in I$_{D}$-V$_{D}$ curve as 6㎃/$\textrm{cm}^2$ and decreases as much as 50% after fatigue. Our simulation model is expected to play an important role in estimation of the behavior of MFSFET device with various ferroelectric thin films.lms.

• International Journal of Aeronautical and Space Sciences
• /
• 제7권1호
• /
• pp.73-83
• /
• 2006

In this paper, a redundancy management system for aircraft is studied, and fault detection and isolation algorithms of inertial sensor system are proposed. Contrary to the conventional aircraft systems, UAV system cannot allow triple or quadruple hardware redundancy due to the limitations on space and weight. In the UAV system with dual sensors, it is very difficult to identify the faulty sensor. Also, conventional fault detection and isolation (FDI) method cannot isolate multiple faults in a triple redundancy system. In this paper, two FDI techniques are proposed. First, hardware based FDI technique is proposed, which combines a parity equation approach with a wavelet based technique. Second, analytic FDI technique based on the Kalman filter is proposed, which is a model-based FDI method utilizing the threshold value and the confirmation time. To provide the reference value for detecting the fault, residuals are calculated using the extended Kalman filter. To verify the effectiveness of the proposed FDI methods, numerical simulations are performed.

• 천문학회보
• /
• 제36권2호
• /
• pp.60.1-60.1
• /
• 2011

We present the preliminary results of the pilot observations for the fringe survey at 43 GHz with the VLBI Exploration of Radio Astrometry (VERA). The main goals of the fringe survey are to establish a full list of phase calibrators for the VERA dual-beam astrometric observations, and for the KVN multi-frequency phase referencing observations. We performed two 24 hours experiments as a pilot observation to test the feasibility of the fringe survey. Each source from a list of 220 sources has been observed in one scan for 2 minutes. 67 sources were detected with the SNR threshold of 3.5. The correlated flux densities of the detected sources are presented in four ranges of projected baseline lengths.

• 대한기계학회논문집
• /
• 제12권6호
• /
• pp.1343-1349
• /
• 1988

In this study, it is investigated for the effects of stress ratio and grain size on fatigue crack growth behavior and crack closure, in ferrite-martensite dual phase steels. The results obtained are as follows ; .DELTA. $K_{th}$ is independent of the ferrite grain size, but decreases with increasing stress ratio. The relation between .DELTA. $K_{th}$ and stress ratio R is as follows : .DELTA. $K_{th}$ =15.1(1-0.95R). But (.DELTA. $K_{eff}$)$_{th}$ in terms of crack closure is approximately 2.5 MPa.root.m. Also, variation of the degree of crack deflection to crack tip opening displacement at the minimum load is considered as a parameter of crack closure.e.e.

• 한국정보통신학회논문지
• /
• 제26권5호
• /
• pp.808-811
• /
• 2022

In this paper, a wide-range microphone system for lectures using dual 3D sensors is proposed. A previous work using a single sensor had lowering the detecting threshold to support wide-area. However it was found that an error occurred when lecturer wears clothes with low reflectivity or has small body size. When multiple sensors are used to expand the coverage it could be cause various problems. Each sensor could show different distance to the same target. We derive the rotation angle and and compensate for lecturing microphone system using sensors on the line. The proposed method shows a little improvement in performance by about 1dB compared to the previous works but the performance is uniform in all areas regardless of reflectivity.

• Journal of electromagnetic engineering and science
• /
• 제19권2호
• /
• pp.107-114
• /
• 2019

Alert-confirm detection is a highly efficient method to improve phased array radar search performance. It comprises sequential detection in two steps: alert detection, in which a target is detected at a low detection threshold, and confirm detection, which is triggered by alert detection with a longer dwell time to minimize false alarms. This paper provides a design method for applying the alert-confirm detection to multifunctional radars. We find optimum dwell times and false alarm probabilities for each alert detection and confirm detection under the dual constraints of total false alarm probability and maximum allowable dwell time per position. These optimum values are expressed as a function of the mean new target appearance rate. The proposed alert-confirm detection increases the maximum detection range even with a shorter frame time than that of uniform scanning.

• 동의생리병리학회지
• /
• 제18권4호
• /
• pp.1001-1006
• /
• 2004

In order to examine the anti-arthritic properties of ShinEumHur(SEH)-herbal acupuncture, an adjuvant-induced arthritic rat was generated by the intra-articular injection of dried cells of Mycobacterium tuberculosis emulsified in squalene into the right knee joint. Fifty microliter of SEH extract was injected into Zusanli(ST36) acupoint on the ipsilateral hind paw every other day for 2 weeks. The body weight, knee circumference, squeak threshold, and weight distribution ratio were analyzed as the assessment methods addressing arthritic symptoms such as arthritic pain, edema, and tenderness. The weight distribution ratio was measured by a digital-type analgesia instrument using the dual channel scale that separately measures the weight the arthritic rat distributes to each hind paw, and thus quantifies both of swelling and pain severities at once. The therapeutic effects of SEH-herbal acupuncture, assessed by squeaking threshold and weight distribution ratio, were observed on 8th day after the arthritis induction as compared to saline group and control group. On 10th day, SEH-herbal acupuncture therapy significantly started to alleviate the growing pattern of knee circumference of an arthritic rat in the range of 0.2㎝. However, the loss of body weight was not significantly recovered. Taken together, the SEH-herbal acupuncture exhibited the significant therapeutic efficiency to treat adjuvant-induced monoarthritis in rat.