• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.4
• /
• pp.108-120
• /
• 1998

A theoretical study of three-dimensional unsteady compressible non-reacting flow inside double flow of monolith catalytic converter system attached to 6-cylinder engine was performed for the achievement of performance improvement, reduction of light-off time, and longer service life by improving the flow distribution of pulsating exhaust gases. The differences between unsteady and steady-state flow were evaluated through the numerical computations. To obtains the boundary conditions to a numerical analysis, one dimensional non-steady gas dynamic calculation was also performed by using the method of characteristics in intake and exhaust system. Studies indicate that unsteady representation is necessary because pulsation of gas velocity may affect gas flow uniformity within the monolith. The simulation results also show that the level of flow maldistribution in the monolith heavily depends on curvature and angles of separation streamline of mixing pipe that homogenizes the exhaust gas from individual cylinders. It is also found that on dual flow converter systems, there is severe interactions of each pulsating exhaust gas flow and the length of mixing pipe and junction geometry influence greatly on the degree of flow distribution.

• Journal of Aerospace System Engineering
• /
• v.8 no.2
• /
• pp.7-13
• /
• 2014

In order to enable fail-safe operation the electro-hydrostatic actuators can be dualized. When a symmetrical actuator is combined in series with an asymmetrical actuator with single rod cylinder, the flow rates of their cylinders are unmatched. If their position controller has same configuration, one of their pumps can supply too much flow rate under particular load conditions, which should be bypassed into low pressure side e.g. by a relief valve. In this paper it is shown how the hydraulic circuit for the asymmetrically combined electro-hydrostatic actuator can be designed without sacrificing power consumption.

• Journal of Power System Engineering
• /
• v.16 no.5
• /
• pp.76-82
• /
• 2012

Duplex stainless steels have the dual microstructure of austenite and ferrite phases. This steel exhibits generally a high corrosion resistance and higher mechanical strength compared with austenitic stainless steels. The steels used in the investigation have the chemical composition of Fe-22Cr-xNi-yMn-0.2N in which the contents of Ni and Mn were varied with maintaining the equal [Ni/Cr] equivalent. The fraction of ferrite phase was increased with the increase of annealing temperature. The impact factor of Mn element on the [Ni] equivalent was amended on the basis of the results of the investigation. 4Mn-2Ni alloy showed the highest pitting corrosion resistance. The fraction ratio, grain size and misorientation angle between grains were measured, and the correlation with pitting potential was investigated.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.E3
• /
• pp.165-174
• /
• 2002

A dual -column biofilter system with two different composts was used to investigate the macro-kinetics of dim-ethyl disulfide (DMDS) degradation. The biofilter columns were filled with compost mixtures up to one meter, The gas How rate and DMDS concentration to the biofilters were varied to study their effect on the removal characteris-tics of DMDS. It was found that the biodegradation of DMDS was governed by zero-order reaction -limited macro-kinetics for inlet DMDS concentrations between 10 and 55 ppmv. The overall average zero-order kinetic coeffi-cient for DMDS removal by compost was 0.50 ($\pm$0.1) ppm/sec for both compost mixtures studied. Variations in individual kinetic coefficients were observed due to varying environmental conditions, such as pH and temperature. The kinetic coefficients determined are specific to the system discussed in this work. During high acidity conditions in the filter beds, methyl mercaptan (MM) was observed in the gas samples collected. Appearance of MM was pro-bably due to decreased microbial activity in the lower portions of the biofilter. Considering the neutral pH range required and the presence of methyl mercaptan, it is likely that the microorganisms present in the biofilters used in this research are similar to the T. thioparus (strain E6) species.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.193-193
• /
• 2008

In this paper, a MMIC diplexer with a low pass and high pass filter are designed and fabricated using an InGaP/GaAs process. The design of this diplexer is based on its stabilization of the low insertion loss since it is important in the in-building system (IBS). The IBS integrates wire and wireless signal between the cable television (CATV) and the personal communication system. In this design, a dual-mode operation of diplexer is fabricated with the frequency of 0 Hz to 900 MHz and 1.7 GHz to 2.2 GHz for CATV and personal communication. respectively. The topolygy of the designed diplexer is based on the L-C filter. This diplexer fabricated by nanoENS Inc. which is foundry service company, was measured by using the facilities of the Kwangwoon University RFIC center. The fabricated chip size is $1.6\times1.4mm^2$ and it has abroad frequency range from 0 Hz to 2.2 GHz.

• Industrial Engineering and Management Systems
• /
• v.9 no.1
• /
• pp.10-19
• /
• 2010

This paper presents an extended computing procedure for the global optimization of the triple response system (TRS) where the response functions are nonconvex (nonconcave) quadratics and the input factors satisfy a radial region of interest. The TRS arising from response surface modeling can be approximated using a nonlinear mathematical program involving one primary (objective) function and two secondary (constraints) functions. An optimization algorithm named triple response surface algorithm (TRSALG) is proposed to determine the global optimum for the nondegenerate TRS. In TRSALG, the Lagrange multipliers of target (secondary) functions are computed by using the Hooke-Jeeves search method, and the Lagrange multiplier of the radial constraint is located by using the trust region (TR) method at the same time. To ensure global optimality that can be attained by TRSALG, included is the means for detecting the degenerate case. In the field of numerical optimization, as the family of TR approach always exhibits excellent mathematical properties during optimization steps, thus the proposed algorithm can guarantee the global optimal solution where the optimality conditions are satisfied for the nondegenerate TRS. The computing procedure is illustrated in terms of examples found in the quality literature where the comparison results with a gradient-based method are used to calibrate TRSALG.

• 대한공업교육학회지
• /
• v.30 no.2
• /
• pp.12-22
• /
• 2005

This study analyzes the requests by the people-in-charge in industries and presents methods to improve field practice systems for technical highschools. Requests from 43 industries in Korea were analyzed. The results about improvement methods for field practices are as follows: First of all, the study suggests the same educational curriculums and number of courses for the 10th grade (National Manditory and Basic Curriculum) and the 11th grade (Elective Program) both in general technical highschools and in "2+1 system" technical highschools. The school offers a dual program: completion and continuation curriculums. In the 12th grade, students choose their careers. Students can participate in field practice as a completion education. In other words, the same curriculums are operated in 10th and 11th grades for students who want to go to college and to get jobs. The different curriculum is arranged for the 12th grade. This system can allow flexibility in curriculum operation for students who want to change their careers or who drop in the middle of filed practice. Students who come back to schools in the middle of field practice are asked to complete technical courses and evaluated like in general technical highschools.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.2
• /
• pp.540-549
• /
• 2018

This paper proposes the method of active distribution network expansion planning considering distributed generation integration and distribution network reconfiguration. The distribution network reconfiguration is taken as the expansion planning alternative with zero investment cost of the branches. During the process of the reconfiguration in expansion planning, all the branches are taken as the alternative branches. The objective is to minimize the total costs of the distribution network in the planning period. The expansion alternatives such as active management, new lines, new substations, substation expansion and Distributed Generation (DG) installation are considered. Distribution network reconfiguration is a complex mixed-integer nonlinear programming problem, with integration of DGs and active managements, the active distribution network expansion planning considering distribution network reconfiguration becomes much more complex. This paper converts the dual-level expansion model to Second-Order Cone Programming (SOCP) model, which can be solved with commercial solver GUROBI. The proposed model and method are tested on the modified IEEE 33-bus system and Portugal 54-bus system.

• Progress in Superconductivity and Cryogenics
• /
• v.19 no.3
• /
• pp.49-53
• /
• 2017

The superconducting magnets have a large inductance as well as high operating current. Therefore, mega-joule scale energy can be stored in the magnet. The energy stored in the magnet is sufficient to damage the magnet when a quench occurs. Quench heater and dump resistor can be used to protect the magnet. However, using quench heater to create quench resistors through heat transfer can be slower than instantly switching resistors. Also, electrical short, overheating and breakdown can occur due to quench heater. Moreover, the number of dump resistor should be limited to avoid large terminal voltage. Therefore, in this paper, we propose a quench protection method for extracting the energy stored in a magnet by charging and discharging energy through a capacitor switching without increasing resistance. The simulation results show that the proposed system has a faster current decay within the allowable voltage level.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.4
• /
• pp.18-25
• /
• 2012

As the demand for smart phone user is rapidly increasing in recent years, the development of new mobile communication system which provides more improved quality compared to existing 3G standard is highly requested. In this point, the long-term evolution (LTE) system, which was being developed in mid of 2000's, has attracted a considerable attention. The LTE has been developed continuously to result a release 10 which is called as LTE-Advanced (LTE-A) in 2010. Among various features in LTE-A, the multiuser MIMO (MU-MIMO) design is expected to give better quality for throughput, spectral efficiency, and latency. In this paper, we first review the development process from LTE to LTE-A. We also provide the overview of design challenges and specific solutions for MU-MIMO systems developed in LTE-Advanced standard.