• 제목/요약/키워드: downhill section

검색결과 8건 처리시간 0.019초

Analysis and design of inclined piles used to prevent downhill creep of unsaturated clay formations

  • Poorooshasb, H.B.;Miura, N.;Noorzad, Ali
    • Structural Engineering and Mechanics
    • /
    • 제6권3호
    • /
    • pp.245-257
    • /
    • 1998
  • This paper present an analysis which may be used to obtain a rational design of a system of inclined piles used in preventing downhill creep of unsaturated clay formations. It uses two simple and relatively easy to measure parameters (an estimate of the maximum downhill creep together with a knowledge of the depth of the so called active zone) to calculate the required section size and the optimal spacing (pitch) of the piles for a desired efficiency of the system as a whole. Design charts are provided to facilitate the process.

도로 종단선형에 따른 도로교통 소음 특성 분석 (Characteristic of Road Traffic Noise According to Road Vertical Alignment)

  • 문학룡;한대철;강원평
    • 한국도로학회논문집
    • /
    • 제15권4호
    • /
    • pp.95-105
    • /
    • 2013
  • PURPOSES: The purpose of this study is to research the influence of road traffic noise by road slope through the analysis of the field road traffic noise and determine consideration of road slope in the case of appling active noise cancellation. METHODS: This study measures vehicle's noise by the NCPX method at the three field sections such as uphill, downhill, and flatland. Total sound pressure and sound pressure level by the 1/3 octave band frequency are calculated through the raw field data. Total sound pressure level is compared by ANOVA test and T test statistically. The results obtained are compared in accordance with the road slope and the progress of the uphill section. RESULTS : The noise characteristic of early, medium, and last parts of uphill was found to be consistent when the vehicle was travelling uphill section. The result of statistical test, it was shown that total sound pressures are not different each other. According to the comparison by the geometry, sound pressure of the uphill section was higher than those of the flatland and downhill section in high frequency band. By the result of statistical test, total sound pressure are different according to geometry in the case of high vehicle speed. In the comparison result by road slope, each sound pressure level was found to be consistent in total frequency. However, total sound pressure proportionally increased according to road slope. CONCLUSIONS: It is found that the effect of road slope on noise generation was little in this experimental sites.

연료차단 주행에 의한 연비 개선 효과에 대한 연구 (A study on the improvement of vehicle fuel economy by fuel-cut driving)

  • 고광호;최성철
    • 한국산학기술학회논문지
    • /
    • 제13권2호
    • /
    • pp.498-503
    • /
    • 2012
  • 엔진 회전속도가 1,500rpm 이상 일 때 차량의 가속 페달을 놓은 경우 인젝터 연료분사가 중지된다. 이것을 연료차단(fuel-cut) 기능이라 부르고, 현대의 대부분의 차량들은 이 기능을 장착하고 있다. 이 기능은 많은 경우 고속도로의 내리막 구간에서 작동된다. 이렇게 연료차단이 발생하는 경우 차량의 $CO_2$ 배출 가스는 '0'이 된다. 서해안 고속도로에서 이 연료 차단 기능을 사용하면 2,000cc 승용차의 $CO_2$ 배출량은 4% 감소한다. 그리고 내리막 구간의 경우 가장 효율적인 운전 패턴을 찾기 위하여 연료차단 기능을 AVL사의 CRUISE 소프트웨어로 시뮬레이션 하였다. 연비향상을 위해서 급격한 내리막 구간일 경우 연료 차단을 위한 차량의 하한 속도를 높게 유지해야 한다는 것을 CRUISE 소프트웨어 시뮬레이션으로 알 수 있었다. 또한 가장 우수한 연비 성능은 내리막 구간 내에서 연료차단과 재가속이 완료되어야 함을 알 수 있었다.

도로 기하구조에 따른 차량 Microphone 위치별 소음 영향 분석 (Analysis of Vehicle Noise Effect by Microphone Position and Road Geometry)

  • 문학룡;한대철;강원평
    • 한국도로학회논문집
    • /
    • 제15권4호
    • /
    • pp.75-83
    • /
    • 2013
  • PURPOSES: The purpose of study is to understand the characteristic of driving noise from the front and rear tire for effective active noise cancellation application. METHODS : As literature review, noise measurement methods were reviewed. Noise measurement conducted at three kind of section by road slope using CPX(Close Proximity Method). Noise data was compared by total sound pressure level and 1/3 octave band frequency sound pressure level. Also, each section was compared by T-test using SPSS. RESULTS : In the case of the uphill section, it was shown that the sound pressure level of the front tire at Sugwang-Ri and Sinchon-RI sections was higher than that of the rear tire in low and high frequency band. In the case of high slope section of Sangsaek-Ri, the sound pressure level of the front tire was higher than that of the rear tire in high frequency. Also, in the case of the downhill section, it was shown that the sound pressure level of the front tire at Sugwang-Ri and Sinchon-RI sections was higher than that of the rear tire in low frequency band. However, the sound pressure levels of both the front and rear tires were approximately the same in the high slope section of Sangsaek-Ri. The result of T-test showed that total sound pressures of the front and rear tires were not different from each other in the case of high slope and high speed. CONCLUSIONS: Road slope was not an important variable for effective active noise cancellation.

Recursive 디지털 필터에 의한 전리층 채널 모델링 (A modeling for an ionospheric channel using recursive digital filter)

  • 김성진
    • 융합신호처리학회논문지
    • /
    • 제5권2호
    • /
    • pp.143-150
    • /
    • 2004
  • In this paper, a recursive digital filter realization for an ionospheric channel model is proposed. This realization is in the form of a cascade of identical second-order all-pass filters, and is determined by only three parameters; two coefficients of an all-pass section, and the number of sections. The values of these parameters are optimized by a nonlinear optimization algorithm called the "downhill simplex method", so that the resulting time delay function closely approximates that of the ionospheric channel model. Comparing with the nonrecursive digital filter realization, it can be shown that the proposed recursive-digital-filter-realization is advantageous in points of view for the numbers of filter coefficients and the realization.

  • PDF

판별분석을 활용한 노면요철포장의 교통사고감소 효과분석 (A Safety Evaluation of Shoulder Rumble Strips on Expressway using Discriminant Analysis)

  • 박제진;서임기;강동윤;이재훈
    • 한국안전학회지
    • /
    • 제31권1호
    • /
    • pp.95-104
    • /
    • 2016
  • In general, the crash reduction effect of the rumble strip is reported to be about 30% in Korea, while it is about 40-60% in the United States. However, the effect is erroneously overestimated because the simple comparison was only made before and after the installation. Accordingly, this study will reassess the crash reduction effect of the rumble strip. The study will also examine the former's geometric characteristics as well as its effect on the causes of the crash. This study analyzed the crash effect while taking into consideration the changes in the horizontal and vertical alignment, including the width of pavement shoulders, using the crash data for two years before and after the installation of the rumble strip. The types of crash caused by the rumble strip were identified using the classification discriminant function. The crash effect on the rumble strip is estimated to be 28.3%, but the pure effect, with the exception of the effect by other elements, was analyzed to be 7.4%. For each expressway design element, the downhill section (2.0-3.0%), the section with less than 3,000 m and more than 10,000 m of the curve radius, and the section with less than 3.0 m of the pavement shoulder width were found to be effective in crash reduction. For each cause of crash, the rumble strip was analyzed to be effective in the reduction of crash caused by "not keeping the safe distance", "sleeping", "negligence in keeping eyes forward", and "excessive handle operation". In particular, the rumble strip was analyzed and seen to be especially effective in preventing crash caused by "not keeping a safe distance," and "sleeping". The installation of the rumble strip was found to be effective in the prevention of crash caused by "not keeping the safe distance" and "sleeping". The results of this study may thus be used in deciding the causes of crash and the installation location of the tailored rumble strip that would be suitable for the geometric characteristics of the roads. This study will also be helpful in the establishment of future traffic safety measures.

차량에서 배출되는 대기 오염 물질의 빅 데이터에 대한 병렬 데이터 처리 모델의 강화 및 성능 최적화에 관한 연구 (A study on the enhancement and performance optimization of parallel data processing model for Big Data on Emissions of Air Pollutants Emitted from Vehicles)

  • 강성인;조성윤;김지환;김현정
    • 한국인터넷방송통신학회논문지
    • /
    • 제20권6호
    • /
    • pp.1-6
    • /
    • 2020
  • 도로이동 오염원 대기환경 빅데이터는 상시 교통량 조사장비인 AVC, VDS, WIM, DTG를 활용한 차종, 속도, 하중 등 실시간 교통류 데이터와 GIS를 활용한 도로형상(오르막, 내리막, 회전구간) 데이터를 연계한 교통류 데이터로 구성되어 있다. 또한, 일반적인 데이터와 달리 단위시간 당 데이터가 많이 발생하고, 다양한 포맷을 가지고 있다. 특히, 이들 상세 교통류 정보로 수집되는 대용량의 실시간 데이터들은 약 총 740만 건/시간 이상이 수집되어 저장 및 가공되기 때문에 효율적으로 데이터를 처리할 수 있는 시스템이 필요하다. 따라서 본 연구에서는 도로이동 오염뭔 대기환경 빅데이터 시각화를 위한 오픈소스 기반의 데이터 병렬처리 성능 최적화 연구를 수행한다.

Development of a Brain Phantom for Multimodal Image Registration in Radiotherapy Treatment Planning

  • H. S. Jin;T. S. Suh;R. H. Juh;J. Y. Song;C. B. Y. Choe;Lee, H .G.;C. Kwark
    • 한국의학물리학회:학술대회논문집
    • /
    • 한국의학물리학회 2002년도 Proceedings
    • /
    • pp.450-453
    • /
    • 2002
  • In radiotherapy treatment planning, it is critical to deliver the radiation dose to tumor and protect surrounding normal tissue. Recent developments in functional imaging and radiotherapy treatment technology have been raising chances to control tumor saving normal tissues. A brain phantom which could be used for image registration technique of CT-MR and CT-SPECT images using surface matching was developed. The brain phantom was specially designed to obtain imaging dataset of CT, MR, and SPECT. The phantom had an external frame with 4 N-shaped pipes filled with acryl rods, Pb rods for CT, MR, and SPECT imaging, respectively. 8 acrylic pipes were inserted into the empty space of the brain phantom to be imaged for geometric evaluation of the matching. For an optimization algorithm of image registration, we used Downhill simplex algorithm suggested as a fast surface matching algorithm. Accuracy of image fusion was assessed by the comparison between the center points of the section of N-shaped bars in the external frame and the inserted pipes of the phantom and minimized cost functions of the optimization algorithm. Technique with partially transparent, mixed images using color on gray was used for visual assessment of the image registration process. The errors of image registration of CT-MR and CT-SPECT were within 2mm and 4mm, respectively. Since these errors were considered within a reasonable margin from the phantom study, the phantom is expected to be used for conventional image registration between multimodal image datasets..

  • PDF