• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.378-381
• /
• 2001

The electron drift mobility of poly(4,4'-cyclohexylidenediphenyl carbonate)(PC-Z) doped with 3,5-dimethy-3,5-di-t-butylstilbenequinone(MBSQ), 3,5,3,5-tetra-t-butyl stilbenequinone(TMSQ) and 3,5,3,5-tetra-methyl stilbenequinone(TMSQ) was measured by the time-of-flight technique. The electric field and temperature dependences of the electron drift mobility were discussed with Poole-Frenkel, Arrhenius formulations and non-Arrhenius type of temperature dependence. It was assumed that the hopping sites were Gaussian distribution. Mobility and activation energy of MBSQ were increased with increasing dopant. However, mobilities and activation energy of TBSQ and TMSQ were increased and decreased, respectively.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.8
• /
• pp.2291-2296
• /
• 2013

An efficient carbon monoxide (CO) sensor was developed based on poly(3,4-ethylenedioxy)thiophenepoly(styrenesulfonate) (PEDOT:PSS) modified with a new pyrimidine-fused heterocyclic compound, bis(2-hydroxyphenyl)dihydropyrido[2,3-d:6,5-d]dipyrimidine-tetraone (B2HDDT). B2HDDT remains stable in the polymer matrix through interactions with functional groups of the polymer. It created prominent sites that captured CO gas, and the experimental parameters, including the amount of doped B2HDDT in the PEDOT:PSS film, were optimized. The sensor probe was also examined to verify its reliability for detecting CO in the presence of atmospheric gases in a discriminating manner. NMR, AFM, and FT-IR spectra were obtained to evaluate the structure and morphology of the B2HDDT-doped PEDOT:PSS (PEDOT:PSS/B2HDDT) film. The content of 35 vol % B2HDDT (7.0 mM) in PEDOT:PSS provided the largest response factor (${\Delta}R/R_o$) for the CO gas. The sensor response was reproducible, with a relative standard deviation < 5% (n = 5). The detection limit was determined to be $0.44{\pm}0.05$ vol %.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.3
• /
• pp.252-256
• /
• 2013

We introduced sensitizing dyes into the bulk-heterojunction (BHJ) photovoltaic (PV) layer of polymer solar cells (PSCs). The sensitizing dyes doped were Bis(tetra butyl ammonium) cis-dithio cyanato bis(2,2'-bipyridine-4-carboxylicacid-4'-carboxylate) ruthenium (II) (N719 dye) and the BHJ PV layer used was made of poly (3-hexylthiophene) (P3HT) and phenyl $C_{61}$-butyric acid methyl ester (PCBM). It was found that the N719 dyes increase the photovoltaic performance, i.e., increasing open-circuit voltage and short-circuit current density with improved fill factor. For the P3HT:PCBM PV cells doped with the N719 dyes (0.24 wt%), an increase in power conversion efficiency of 4.0% was achieved, compared to that of the control cells (3.6%) without the N719 dyes.

• Macromolecular Research
• /
• v.17 no.11
• /
• pp.874-878
• /
• 2009

Photorefractive polymer composites were synthesized based on poly (N-vinylcazbazole) (PVK) doped with liquid nonlinear optical chromophores and a sensitizer $C_{60}$. PVK/liquid NLO chromophores/$C_{60}$ devices showed no signs of phase separation and did not require a plasticizer, such as ethylcarbazole. The composites showed 69% diffraction efficiency (C3) and a rapid response time of 46 ms (C1) in four-wave mixing experiments at a light intensity of $60\;mW/cm^2$ and a wavelength of 633 nm.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.6
• /
• pp.562-567
• /
• 2022

Novel self-illuminated smart windows were fabricated consisting of Cu-doped ZnS (ZnS:Cu) powder and polymer-dispersed liquid crystal (PDLC). This smart window shows not only switchable transparency but also self-illumination without any attachable luminous body. Its electro-optical characteristics, transmittance, and luminance were investigated in relation to various applied voltages and composition ratios. The optical transmittance and luminous intensity increased with increasing applied voltages. However, the optical transmittance decreased with increasing ZnS:Cu powder content. One of the self-illuminated smart windows, which was fabricated with 9 wt% of ZnS:Cu, achieved the optical transmittance of 60.5% (at 550 nm) and the luminance of 11.0 cd/m² at 100 V. This smart window could be used as a normal switchable smart window in daytime and light-emitting signage at night.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.10
• /
• pp.3279-3284
• /
• 2012

Poly(benzimidazole-co-benzoxazole)s (PBI-co-PBO) are synthesized by polycondensation reaction with 3,3'-diaminobenzidine, terephthalic acid and 3,3'-dihydroxybenzidine or 4,6-diaminoresorcinol in polyphosphoric acid (PPA). All polymer membranes are prepared by the direct casting method (in-situ fabrication). The introduction of benzoxazole units (BO units) into a polymer backbone lowers the basic property and $H_3PO_4$ doping level of the copolymer membranes, resulting in the improvement of mechanical strength. The proton conductivity of $H_3PO_4$ doped PBI-co-PBO membranes decrease as a result of adding amounts of BO units. The maximum tensile strength reaches 4.1 MPa with a 10% molar ratio of BO units in the copolymer. As a result, the $H_3PO_4$ doped PBI-co-PBO membranes could be utilized as alternative proton exchange membranes in high temperature polymer electrolyte fuel cells.

• Macromolecular Research
• /
• v.15 no.1
• /
• pp.5-9
• /
• 2007

The attenuated total reflection infrared (ATR-IR) spectra of trans-polyacetylene (trans-PA) film doped with sodium (n-doping) were observed in the range of 1900 to $700cm^{-1}$. The observed IR bands were attributed to negatively charged domains created by n-doping electrons. The doping-induced IR bands showed considerable difference from its pristine film. After doping, the out-of-plane CH deformation band of the strong $1010cm^{-1}$ region in the pristine film disappeared while several new bands were observed at 1600 (due to C=C stretching), 1400 (due to in-plane CH bending), 1290 and 1174 (due to CH stretching), and $880cm^{-1}$ (due to CC stretching) regions for Na-doped PA. In particular, a weak band of C=C stretching at $1600cm^{-1}$ was newly obtained for the first time in the present study. The electro conductivity of the doped trans-PA film was $10^2S/cm$ and the origins of doping-induced IR bands are discussed in terms of solitons and polarons.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.61.2-61.2
• /
• 2015

In the past decades, green energy, such as solar energy, wind power, hydropower, biomass energy, geothermal energy, and so on, has been widely investigated and developed to solve energy shortage. Recently, organic solar cells have attracted much attention, because they have many advantages, including low-cost, flexibility, light weight, and easy fabrication [1-3]. Organic solar cells are as a potential candidate of the next generation solar cells. In this abstract, to improve the power conversion efficiency and the stability, the inverted polymer solar cells with various structures were developed [4-6]. The novel cell structures included the P3HT:PCBM inverted polymer solar cells with AZO nanorods array, with pentacene-doped active layer, and with extra P3HT interfacial layer and PCBM interfacial layer. These three difference structures could respectively improve the performance of the P3HT:PCBM inverted polymer solar cells. For the inverted polymer solar cells with AZO nanorods array as the electronic transportation layer, by using the nanorod structure, the improvement of carrier collection and carrier extraction capabilities could be expected due to an increase in contact area between the nanorod array and the active layer. For the inverted polymer solar cells with pentacene-doped active layer, the hole-electron mobility in the active layer could be balanced by doping pentacene contents. The active layer with the balanced hole-electron mobility could reduce the carrier recombination in the active layers to enhance the photocurrent of the resulting inverted polymer solar cells. For the inverted polymer solar cells with extra P3HT and PCBM interfacial layers, the extra PCBM and P3HT interfacial layers could respectively improve the electron transport and hole transport. The extra PCBM interfacial layer served another function was that led more P3HT moving to the top side of the absorption layer, which reduced the non-continuous pathways of P3HT. It indicated that the recombination centers could be further reduced in the absorption layer. The extra P3HT interfacial layer could let the hole be more easily transported to the MoO3 hole transport layer. The high performance of the novel P3HT:PCBM inverted polymer solar cells with various structures were obtained.

• Proceedings of the Korean Fiber Society Conference
• /
• 2007.11a
• /
• pp.503-504
• /
• 2007

• 한국전기화학회:학술대회논문집
• /
• 2005.07a
• /
• pp.83-86
• /
• 2005