• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.1
• /
• pp.311-320
• /
• 2018

This study was conducted to investigate the relationship among major satisfaction (MS), clinical competence (CC), career decision-making self-efficacy (CDMS), and career decision level (CDL) for undergraduate nursing students. A self-report instrument was used to measure MS, CC, CDMS, and CDL. Questionnaires were completed by 307 nursing students in three nursing colleges, and path analysis was employed to validate the proposed model and analyze the causal relationships among variables. Four constructs (MS, CC, CDMS, and career decision) were analyzed. To build a path model, MS and CC were linked to CDMS and career decision. The initial analysis suggested that the modification needed modification; therefore, a covariance link was added. The overall goodness of fit for indices indicated satisfactory path analysis. The indices were revealed as $x^2=2412$, GFI=0.996, AGFI=0.961, and RMSEA=0.068. As a result, the proposed model was acceptable with a good fit, and there were significant direct and indirect effects of paths in the model. Specifically, MS and CC had a direct influence on CDMS, and MS and CDMS directly affected CDL. Moreover, MS and CC had indirect effects on CDL through CDMS. These results imply that students' CDMS should be seriously considered when designing counseling programs for career guidance, and substantiality of CC education is needed to improve CDMS. These results may provide a practical guideline to provide educational intervention for nursing students.

• Nuclear Engineering and Technology
• /
• v.53 no.8
• /
• pp.2534-2546
• /
• 2021

Nuclear emergency preparedness and response is an essential part to ensure the safety of nuclear power plant (NPP). Key support technologies of nuclear emergency decision-making usually consist of accident diagnosis, source term estimation, accident consequence assessment, and protective action recommendation. Source term estimation is almost the most difficult part among them. For example, bad communication, incomplete information, as well as complicated accident scenario make it hard to determine the reactor status and estimate the source term timely in the Fukushima accident. Subsequently, it leads to the hard decision on how to take appropriate emergency response actions. Hence, this paper aims to develop a method for rapid source term estimation to support nuclear emergency decision making in pressurized water reactor NPP. The method aims to make our knowledge on NPP provide better support nuclear emergency. Firstly, this paper studies how to build a Bayesian network model for the NPP based on professional knowledge and engineering knowledge. This paper presents a method transforming the PRA model (event trees and fault trees) into a corresponding Bayesian network model. To solve the problem that some physical phenomena which are modeled as pivotal events in level 2 PRA, cannot find sensors associated directly with their occurrence, a weighted assignment approach based on expert assessment is proposed in this paper. Secondly, the monitoring data of NPP are provided to the Bayesian network model, the real-time status of pivotal events and initiating events can be determined based on the junction tree algorithm. Thirdly, since PRA knowledge can link the accident sequences to the possible release categories, the proposed method is capable to find the most likely release category for the candidate accidents scenarios, namely the source term. The probabilities of possible accident sequences and the source term are calculated. Finally, the prototype software is checked against several sets of accident scenario data which are generated by the simulator of AP1000-NPP, including large loss of coolant accident, loss of main feedwater, main steam line break, and steam generator tube rupture. The results show that the proposed method for rapid source term estimation under nuclear emergency decision making is promising.

• Journal of Navigation and Port Research
• /
• v.42 no.2
• /
• pp.117-126
• /
• 2018

Container port is one of the most vital link of the transportation chain that plays an important role in trading with other countries. Having a proper understanding of port operations could change the role of the port from a transportation node to an efficient point in a transportation chain. Development of transportation chains, logistics and progress of these networks have enhanced the sustainable condition and level of transportation. Therefore, evaluating the competitiveness of ports is obligatory for port users to make a decision in investment or exploitation. This paper introduces the use of Fuzzy C-means and TOPSIS for competitiveness comparison among a sample of container terminals in Korea and China and determine how to improve Korean port competitiveness and particularly in Busan port.

• Journal of information and communication convergence engineering
• /
• v.9 no.5
• /
• pp.523-529
• /
• 2011

In this paper an inter-layer protocol, referred to as a Multi-Network Selector (MNS) is proposed for multiband maritime networks. A MNS is located between the data-link layer and the network layer and performs vertical handover when a ship moves another radio network. In order to provide seamless data transfer to different radio networks, the MNS uses received signal strength (RSS) and ship's location information as decision parameters for vertical handover, which can avoid ping-pong effect and reduces handover latency. In addition, we present related issues in order to implement the MNS for a multiband maritime network.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.817-824
• /
• 2016

A simultaneous bidirectional transceiver over a single wire has been developed in a 65 nm CMOS technology for a command and control bus. The echo signals of the simultaneous bidirectional link are cancelled by controlling the decision level of receiver comparators without power-hungry operational amplifier (op-amp) based circuits. With the clock information embedded in the rising edges of the signals sent from the source side to the sink side, the data is recovered by an open-loop digital circuit with 20 times blind oversampling. The data rate of the simultaneous bidirectional transceiver in each direction is 75 Mbps and therefore the overall signaling bandwidth is 150 Mbps. The measured energy efficiency of the transceiver is 56.7 pJ/b and the bit-error-rate (BER) is less than $10^{-12}$ with $2^7-1$ pseudo-random binary sequence (PRBS) pattern for both signaling directions.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.4
• /
• pp.865-872
• /
• 1998

This paper proposes a multiuse detection system in a multi-cell M-ary Frequency Shift Keying(MFSK)/frequency hopping(FH)-Code Division Multiple Access(CDMA) environment, in which the channel model is an OR-channel and in the reverse link. We have proposed a multiuse detection system in a single cell. However, this sitye is not adequate to detect multiuser in a multi-cell environment. Therefore, we propose a multiuser detection system based on 3 level OR decision with two threholds. The proposed detection system can delete interference as well as intra-cell interference, receive the weakened desired signal and reject the false alarm. computer simulation shows the performance improvement.

• The Journal of Society for e-Business Studies
• /
• v.4 no.1
• /
• pp.21-36
• /
• 1999

Using user monitoring techniques on web, marketing decision makers in cyber shopping malls can gather customer behavior data as well as sales transaction data and customer profiles. In this paper, we present a marketing rule extraction technique for customer behavior analysis in cyber shopping malls, The technique is an application of market basket analysis which is a representative data mining technique for extracting association rules. The market basket analysis technique is applied on a customer behavior log table, which provide association rules about web pages in a cyber shopping mall. The extracted association rules can be used for mall layout design, product packaging, web page link design, and product recommendation. A prototype cyber shopping mall with customer monitoring features and a customer behavior analysis algorithm is implemented using Java Web Server, Servlet, JDBC(Java Database Connectivity), and relational database on windows NT.

• International Journal of Computer Science & Network Security
• /
• v.22 no.8
• /
• pp.275-279
• /
• 2022

The growth of technology nowadays has made many things easy for humans. These things are from everyday small task to more complex tasks. Such growth also comes with the illegal activities that are perform by using technology. These illegal activities can simple as displaying annoying message to big frauds. The easiest way for the attacker to perform such activities is to convenience user to click on the malicious link. It has been a great concern since a decay to classify URLs as malicious or benign. The blacklist has been used initially for that purpose and is it being used nowadays. It is efficient but has a drawback to update blacklist automatically. So, this method is replace by classification of URLs based on machine learning algorithms. In this paper we have use four machine learning classification algorithms to classify URLs as malicious or benign. These algorithms are support vector machine, random forest, n-nearest neighbor, and decision tree. The dataset that is used in this research has 36694 instances. A comparison of precision accuracy and recall values are shown for dataset with and without preprocessing.

• Proceedings of the Korean Operations and Management Science Society Conference
• /
• 1991.10a
• /
• pp.464-464
• /
• 1991

We address the problem of designing a physical CATV network with switched-star topology in which the broadband interactive service is provided. There are two types of decision variables: One is where to place conduit paths, and the other is how many cable units to be installed on each link traversed by an established conduit path. Due to the serious drawback of the conventional approach partitioning the problem into two subproblems, the unified approach handled in one setting is used here to attack the whole problem without dividing into two ones. In this paper, we present a mathematical design model and propose an efficient solution method exploiting the nice structure of it. In addition to this physical design, some results on logical network configuration have also been made. Finally, computaional experiments are conducted to illustrate the efficiency of our design approach.

• Journal of information and communication convergence engineering
• /
• v.9 no.6
• /
• pp.775-779
• /
• 2011

As the technology of multimedia sensor networks is desired in large numbers of applications nowadays, real-time service becomes one of the most important research challenges. Even though lots of related works have been conducted to meet this requirement in several ways, the specific traffic model for real-time has not been taken yet. Thus, it causes lack of adaptability of those approaches in real deployment. To solve this problem, in this paper, we model the application via (m,k)-firm streams which have weakly hard real-time property. And then, a novel forwarding scheme based on modified DBP (Distance-Based Priority) is proposed by considering local-DBP and stream DBP together. Local-DBP can contribute to identify the detailed causes of unsatisfied quality, that is, network congestion or wireless link failure. Simulation results reveal that (m,k)-firm is a good traffic model for multimedia sensor networks and the proposed scheme can contribute to guarantee real-time requirement well.